Positiones historico-politicae e Chronico episcoporum m.scr. Pauli Justen. excerptae, quas consentiente [et] approbante ampliss. facult. philosoph. Acad. Aboensis, praeside viro cl. mag. Algotho A. Scarin histor. & polit profess. ord. Pro obtinendis honoribus philosophicis in auditorio supremo & maximo ad diem IX Jun. MDCCXXVI. Publice examinandas sistit Israel Escholin v. pastor in Sagu

Invokaatio: Q.B.V.

[Grève des cheminots en Angleterre, train à l'arrêt portant l'inscription LB&SCR, London, Brighton & South Coast Railway] : [photographie de presse] / [Agence Rol]

Référence bibliographique : Rol, 56126

Parameter identification of a copper-zeolite SCR catalyst model using reactor data

The selective catalytic reduction system is a well established technology for NOx emissions control in diesel engines. A one dimensional, single channel selective catalytic reduction (SCR) model was previously developed using Oak Ridge National Laboratory (ORNL) generated reactor data for an iron-zeolite catalyst system. Calibration of this model to fit the experimental reactor data collected at ORNL for a copper-zeolite SCR catalyst is presented. Initially a test protocol was developed in order to investigate the different phenomena responsible for the SCR system response. A SCR model with two distinct types of storage sites was used. The calibration process was started with storage capacity calculations for the catalyst sample. Then the chemical kinetics occurring at each segment of the protocol was investigated. The reactions included in this model were adsorption, desorption, standard SCR, fast SCR, slow SCR, NH3 Oxidation, NO oxidation and N2O formation. The reaction rates were identified for each temperature using a time domain optimization approach. Assuming an Arrhenius form of the reaction rates, activation energies and pre-exponential parameters were fit to the reaction rates. The results indicate that the Arrhenius form is appropriate and the reaction scheme used allows the model to fit to the experimental data and also for use in real world engine studies.

Fall-related emergency department admission: fall environment and settings and related injury patterns in 6357 patients with special emphasis on the elderly

PRINCIPALS Throughout the world, falls are a major public health problem and a socioeconomic burden. Nevertheless there is little knowledge about how the injury types may be related to the aetiology and setting of the fall, especially in the elderly. We have therefore analysed all patients presenting with a fall to our Emergency Department (ED) over the past five years. METHODS Our retrospective data analysis comprised adult patients admitted to our Emergency Department between January 1, 2006, and December 31, 2010, in relation to a fall. RESULTS Of a total of 6357 patients 78% (n = 4957) patients were younger than 75 years. The main setting for falls was patients home (n = 2239, 35.3%). In contrast to the younger patients, the older population was predominantly female (56.3% versus 38.6%; P < 0.0001). Older patients were more likely to fall at home and suffer from medical conditions (all P < 0.0001). Injuries to the head (P < 0.0001) and to the lower extremity (P < 0.019) occurred predominantly in the older population. Age was the sole predictor for recurrent falls (OR 1.2, P < 0.0001). CONCLUSION Falls at home are the main class of falls for all age groups, particularly in the elderly. Fall prevention strategies must therefore target activities of daily living. Even though falls related to sports mostly take place in the younger cohort, a significant percentage of elderly patients present with falls related to sporting activity. Falls due to medical conditions were most likely to result in mild traumatic brain injury.

Valutazione sperimentale degli effetti della pressione d'iniezione dell'AdBlue sull'efficienza di abbattimento degli NOx nei sistemi SCR

In questo lavoro vengono indagati i benefici dell’aumento della pressione d’iniezione dell’AdBlue nei sistemi SCR. Dopo aver esposto le ipotesi teoriche a supporto della tesi, si passa all’allestimento del veicolo dimostrativo impiegato per l’attività sperimentale. In questa fase viene illustrato tutto il processo di preparazione, che comprende: la messa a punto del circuito idraulico, la caratterizzazione degli iniettori impiegati, la strumentazione della linea di scarico, e il software INCA impiegato per il comando delle centraline. Dopodiché vengono descritti nel dettaglio i test, condotti con il veicolo sperimentale, sul banco a rulli. Attraverso le prove, eseguite su due differenti punti motore, si è potuto dimostrare l’effettivo aumento di efficienza di abbattimento degli NOx, da parte del sistema SCR, all’aumentare della pressione d’iniezione dell’AdBlue. Inoltre si hanno effetti positivi anche in merito al fenomeno dell’ammonia slip, che viene sensibilmente ridotto ai livelli di pressione più alti.

Transmitting components of Radio Set SCR-197-C, Radio Set SCR-197-D and Radio Set SCR-197-F.

"June 8, 1942."

A SCR Model based on Reactor and Engine Experimental Studies for a Cu-zeolite Catalyst

A NOx reduction efficiency higher than 95% with NH3 slip less than 30 ppm is desirable for heavy-duty diesel (HDD) engines using selective catalytic reduction (SCR) systems to meet the US EPA 2010 NOx standard and the 2014-2018 fuel consumption regulation. The SCR performance needs to be improved through experimental and modeling studies. In this research, a high fidelity global kinetic 1-dimensional 2-site SCR model with mass transfer, heat transfer and global reaction mechanisms was developed for a Cu-zeolite catalyst. The model simulates the SCR performance for the engine exhaust conditions with NH3 maldistribution and aging effects, and the details are presented. SCR experimental data were collected for the model development, calibration and validation from a reactor at Oak Ridge National Laboratory (ORNL) and an engine experimental setup at Michigan Technological University (MTU) with a Cummins 2010 ISB engine. The model was calibrated separately to the reactor and engine data. The experimental setup, test procedures including a surrogate HD-FTP cycle developed for transient studies and the model calibration process are described. Differences in the model parameters were determined between the calibrations developed from the reactor and the engine data. It was determined that the SCR inlet NH3 maldistribution is one of the reasons causing the differences. The model calibrated to the engine data served as a basis for developing a reduced order SCR estimator model. The effect of the SCR inlet NO2/NOx ratio on the SCR performance was studied through simulations using the surrogate HD-FTP cycle. The cumulative outlet NOx and the overall NOx conversion efficiency of the cycle are highest with a NO2/NOx ratio of 0.5. The outlet NH3 is lowest for the NO2/NOx ratio greater than 0.6. A combined engine experimental and simulation study was performed to quantify the NH3 maldistribution at the SCR inlet and its effects on the SCR performance and kinetics. The uniformity index (UI) of the SCR inlet NH3 and NH3/NOx ratio (ANR) was determined to be below 0.8 for the production system. The UI was improved to 0.9 after installation of a swirl mixer into the SCR inlet cone. A multi-channel model was developed to simulate the maldistribution effects. The results showed that reducing the UI of the inlet ANR from 1.0 to 0.7 caused a 5-10% decrease in NOx reduction efficiency and 10-20 ppm increase in the NH3 slip. The simulations of the steady-state engine data with the multi-channel model showed that the NH3 maldistribution is a factor causing the differences in the calibrations developed from the engine and the reactor data. The Reactor experiments were performed at ORNL using a Spaci-IR technique to study the thermal aging effects. The test results showed that the thermal aging (at 800°C for 16 hours) caused a 30% reduction in the NH3 stored on the catalyst under NH3 saturation conditions and different axial concentration profiles under SCR reaction conditions. The kinetics analysis showed that the thermal aging caused a reduction in total NH3 storage capacity (94.6 compared to 138 gmol/m3), different NH3 adsorption/desorption properties and a decrease in activation energy and the pre-exponential factor for NH3 oxidation, standard and fast SCR reactions. Both reduction in the storage capability and the change in kinetics of the major reactions contributed to the change in the axial storage and concentration profiles observed from the experiments.

Increased Circulating Pedf And Low Sicam-1 Are Associated With Sickle Cell Retinopathy.

Sickle cell retinopathy (SCR) develops in up to 30% of sickle cell disease patients (SCD) during the second decade of life. Treatment for this affection remains palliative, so studies on its pathophysiology may contribute to the future development of novel therapies. SCR is more frequently observed in hemoglobin SC disease and derives from vaso-occlusion in the microvasculature of the retina leading to neovascularization and, eventually, to blindness. Circulating inflammatory cytokines, angiogenic factors, and their interaction may contribute to the pathophysiology of this complication. Angiopoietin (Ang)-1, Ang-2, soluble vascular cell adhesion molecule-1, intercellular adhesion molecule (ICAM)-1, E-selectin, P-selectin, IL1-β, TNF-α, pigment epithelium derived factor (PEDF) and vascular endothelial growth factor plasmatic levels were determined in 37 SCD patients with retinopathy, 34 without retinopathy, and healthy controls. We observed that sICAM-1 is significantly decreased, whereas PEDF is elevated in HbSC patients with retinopathy (P=0.012 and P=0.031, respectively). Ang-1, Ang-2 and IL1-β levels were elevated in SCD patients (P=0.001, P<0.001 and P=0.001, respectively), compared to controls, and HbSS patients presented higher levels of Ang-2 compared to HbSC (P<0.001). Our study supports the possible influence of sICAM-1 and PEDF on the pathophysiology of retinal neovascularization in SCD patients.

Influence of the reinforcement magnitude on omission effects

Reinforcement Omission Effects (ROEs), indicated by higher rate of responses after nonreinforced trials in a partial reinforcement schedule, have been interpreted as behavioral transient facilitation after nonreinforcement induced by primary frustration, and/or behavioral transient inhibition after reinforcement induced by demotivation or temporal control. The size of the ROEs should depend directly on the reinforcement magnitude. The present experiment aimed to clarify the relationship between reinforcement magnitude and the omission effects manipulating the magnitude linked to discriminative stimuli in a partial reinforcement FI schedule. The results showed that response rates were higher after omission than after reinforcement delivery. Besides, response rates were highest immediately after the reinforcement omission of a larger magnitude than of a smaller magnitude. These data are interpreted in terms of ROEs multiple process behavioral facilitation after nonreinforcement, and behavioral transient inhibition after reinforcement. (C) 2011 Elsevier B.V. All rights reserved.

Occasion setting in Pavlovian ambiguous target discriminations

Rats were trained in a Pavlovian serial ambiguous target discrimination, in which a target cue was reinforced if it was preceded by one stimulus (P -> T+) but was not reinforced if it was preceded by another stimulus (N -> T-). Test performance indicated that stimulus control by these features was weaker than that acquired by features trained within separate serial feature positive (P -> T+, T-) and serial feature negative (N -> W-, W+) discriminations. The form of conditioned responding and the patterns of transfer observed suggested that the serial ambiguous target discrimination was solved by occasion setting. The data are discussed in terms of the use of retrospective coding strategies when solving Pavlovian serial conditional discriminations, and the acquisition of special properties by both feature and target stimuli. (C) 2008 Published by Elsevier B.V.

Tooth loss in Brazilian middle-aged adults: multilevel effects

Objective. To examine the link between tooth loss and multilevel factors in a national sample of middle-aged adults in Brazil. Material and methods. Analyses were based on the 2003 cross-sectional national epidemiological survey of the oral health of the Brazilian population, which covered 13 431 individuals (age 35-44 years). Multistage cluster sampling was used. The dependent variable was tooth loss and the independent variables were classified according to the individual or contextual level. A multilevel negative binomial regression model was adopted. Results. The average tooth loss was 14 (standard deviation 9.5) teeth. Half of the individuals had lost 12 teeth. The contextual variables showed independent effects on tooth loss. It was found that having 9 years or more of schooling was associated with protection against tooth loss (means ratio range 0.68-0.76). Not having visited the dentist and not having visited in the last >= 3 years accounted for increases of 33.5% and 21.3%, respectively, in the risk of tooth loss (P < 0.05). The increase in tooth extraction ratio showed a strong contextual effect on increased risk of tooth loss, besides changing the effect of protective variables. Conclusions. Tooth loss in middle-aged adults has important associations with social determinants of health. This study points to the importance of the social context as the main cause of oral health injuries suffered by most middle-aged Brazilian adults.