Estudo da remoção de compostos orgânicos, benzeno e tolueno, em solução aquosa por processo oxidativo avançado do tipo Fenton

The oil and petrochemical industry is responsable to generate a large amount of waste and wastewater. Among some efluents, is possible find the benzene, toluene, ethilbenze and isomers of xilenes compounds, known as BTEX. These compounds are very volatily, toxic for environment and potencially cancerigenous in man. Oxidative advanced processes, OAP, are unconventional waste treatment, wich may be apply on treatment and remotion this compounds. Fenton is a type of OAPs, wich uses the Fenton s reactant, hydrogen peroxide and ferrous salt, to promove the organic degradation. While the Photo-Fenton type uses the Fenton s reactant plus UV radiation (ultraviolet). These two types of OAP, according to literature, may be apply on BTEX complex system. This project consists on the consideration of the utilization of technologies Fenton and Photo-Fenton in aqueous solution in concentration of 100 ppm of BTEX, each, on simulation of condition near of petrochemical effluents. Different reactors were used for each type of OAP. For the analyticals results of amount of remotion were used the SPME technique (solid phase microextraction) for extraction in gaseous phase of these analytes and the gas chromatography/mass espectrometry The arrangement mechanical of Photo-Fenton system has been shown big loss by volatilization of these compounds. The Fenton system has been shown capable of degradate benzene and toluene compounds, with massic percentage of remotion near the 99%.

Influência de complexantes de ferro na degradação de compostos orgânicos por processo foto-Fenton/solar

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Potencial de aplicação do processo foto-fenton/solar como pré-tratamento de efluente da indústria de laticínios

Dairy wastewater is characterized by frequent episodes of drastic increases of organic content, giving rise to bulking filamentous bacteria and compromising the biological treatment process. This study reports the reduction of organic content of such wastewater by the application of the solar photo-Fenton process. For a wastewater containing 335, 2627 or 5400 mg C L-1 between 90% and 50% of the organic carbon content were removed after 3.5 h irradiation. The results show that the solar photo-Fenton process can be a good alternative for the abatement of organic content of dairy wastewater, especially in cases of organic content fluctuation, allowing an efficient biological treatment.

Degradação de corantes reativos por processo foto-fenton envolvendo o uso de peneira molecular 4A modificada com Fe3+

In this work the preparation and characterization of a supported catalyst intended for degradation of reactive dyes by Fenton-like processes is described. The photocatalyst was prepared by immobilization of Fe3+ into the molecular sieve (4A type) surface and characterized by x-ray diffractometry and infrared, Mössbauer and EPR spectroscopy. The solid containing 0.94% (w/w) of ferric ions was used in degradation studies of aqueous reactive-dyes samples with really promissory results. Generally, Vis-assisted photochemical processes leads to almost total decolorization of all tested dyes at reaction times lower than 30 min. It was also observed that the iron-molecular sieve matrix can be reused.

Fotodegradação de fenol e clorofenóis por processo foto-Fenton mediado por ferrioxalato

A influência de parâmetros operacionais como a agitação da solução durante irradiação solar e a vazão de alimentação de um fotorreator com irradiação artificial foi avaliada na fotodegradação de 2-clorofenol (2CF) e 2,4-diclorofenol (DCF) por processo foto-Fenton mediado por ferrioxalato. Após avaliação destes parâmetros, os sistemas foram aplicados na fotodegradação de fenol e de mono, (2-clorofenol e 4-clorofenol), di (2,4-diclorofenol) e tri (2,4,6-triclorofenol) clorofenóis a fim de avaliar a eficiência de fotodegradação destes compostos sob irradiação solar e artificial. Foi observada pequena diferença nas porcentagens de remoção de carbono orgânico total (COT) e de geração de íons cloreto nos experimentos de fotodegradação de 2CF sem agitação e com agitação sob irradiação solar. Sob irradiação artificial, um aumento da vazão de alimentação do sistema resultou em menor porcentagem de remoção de COT, ao passo que uma maior velocidade de remoção foi obtida devido a um menor tempo de irradiação. Foi então utilizada uma vazão intermediária de 33,4 mL min-1. Sob irradiação solar, foram necessários 15 minutos de irradiação para a completa remoção de todos os clorofenóis, entretanto para fenol, a completa remoção foi atingida em 20 minutos. Sob irradiação artificial, os clorofenóis foram removidos entre 4,5 e 6,5 minutos de irradiação. A velocidade de degradação aumenta ligeiramente com o aumento do número de cloros ligados ao anel aromático tanto sob irradiação artificial como solar.

Estudo da aplicação do processo foto-Fenton solar na degradação de efluentes de indústria de tintas

Neste trabalho estudou-se a aplicabilidade do processo foto-Fenton utilizando irradiação solar no tratamento de dois efluentes (A e B) de uma indústria de tintas. Foi avaliada a influência da concentração inicial de peróxido de hidrogênio e ferro na remoção de carbono orgânico dissolvido (COD). Nos primeiros minutos de irradiação foi observada a descoloração e a remoção de odores. Para o efluente A, atingiu-se 75 % de remoção de COD durante 60 minutos de irradiação. Para o efluente B, adições múltiplas de peróxido de hidrogênio foram necessárias para aumentar a remoção de COD, 43 % em 60 minutos de irradiação. Os resultados obtidos mostram que o processo foto-Fenton solar pode ser aplicado ao tratamento dos efluentes gerados na indústria de tintas.

Degradação do fungicida tiofanato metílico pelo processo foto-Fenton em reatores anular e solar

Effluents from pesticide industries have great difficulty to decontaminate the environment and, moreover, are characterized by high organic charge and toxicity. The research group Center for Chemical Systems Engineering (CESQ) at the Department of Chemical Engineering of Polytechnical School of University of São Paulo and Department of Chemical Engineering, Federal University of Rio Grande do Norte have been applying the Advanced Oxidation Processes (AOP's) for the degradation of various types of pollutants. These processes are based on the generation of hydroxyl radicals, highly reactive substances. Thus, this dissertation aims to explore this process, since it has been proven to be quite effective in removing organic charge. Therefore, it was decided by photo-Fenton process applied to the degradation of the fungicide Thiophanate methyl in aqueous system using annular reactor (with lamp Philips HPLN 125W) and solar. The samples were collected during the experiment and analyzed for dissolved organic carbon (TOC) using a Shimadzu TOC (Shimadzu 5050A e VCP). The Doehlert experimental design has been used to evaluate the influence of ultraviolet radiation, the concentrations of methyl thiophanate (C12H14N4O4S2), hydrogen peroxide (H2O2) and iron ions (Fe2+), among these parameters, was considered the best experimental conditions, [Fe2+] = 0.6 mmol/L and [H2O2] = 0.038 mol/L in EXP 5 experiment and in SOL 5 experiment, obtaining a percentage of TOC removal of 60% in the annular reactor and 75% in the solar reactor

Potencial de aplicação do processo foto-fenton/solar como pré-tratamento de efluente da indústria de laticínios

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Fotodegradação de fenol e clorofenóis por processo foto-Fenton mediado por ferrioxalato

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Estudo da aplicação do processo foto-Fenton solar na degradação de efluentes de indústria de tintas

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Síntese do complexo ferro (III) com ácido pirazina tetracarboxílico e aplicação como catalisador em reação fenton

The amount of waste generated by industries has increased gradually in recent years. The proper disposal of residues has been an area of study of many researchers. Several organic compounds are considered potential contaminants of natural waters due to their high toxicity, difficult natural degradation and long persistence in the environment. Ways of recovery and reutilization as well as concepts that minimize the generation of wastes have been increasing widely. Organometallic compound of pyrazine carboxylic acid has proven to be of great interest in many areas. Herein, we studied the use of pyrazine tetracarboxylic acid ligand for complex formation with iron (Fe). The binder (C 8H4N2O8) was synthetized with the addition of Fe (complex) and tested as a catalyst in oxidation reactions of the organic model compound methylene blue (MB). Tetramethyl pyrazine was used in the synthesis, which was oxidized with potassium permanganate in order to form the ligand. The ligand (C 8H4N2O8) was then characterized to validate its formation. For the complex solution, it was used (C 8H4N2O8) and Fe (NO3)3.9H2O 0,01molL-1. After preliminary tests, it was found that the best ratio of Fe and the ligand was 2: 1. Through the oxidation tests, it could be seen that the complex has great potential for the degradation of different concentrations of MB. During only 20 minutes of reaction, approximately 60% of MB 500 mgL -1 was oxidized. The use of the complex was found to be an attractive alternative for oxidation of effluents with high organic compounds levels and contributes to the minimization of organic contaminants hazards in the environment.

Degradação de tetraciclina utilizando o processo foto-fenton

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Degradação de fármacos por processo foto-Fenton e ferro metálico

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Degradação de atrazina por processo foto-Fenton monitorado por injeção seqüencial e cromatografia a líquido de alta eficiência

Processos de fotodegradação de compostos orgânicos tóxicos têm sido bastante estudados. Este trabalho trata da aplicação do processo foto-Fenton para a degradação de atrazina em água (composto modelo). O efeito das concentrações dos seguintes compostos foi avaliado: peróxido de hidrogênio (2 a 6 mmol L-1) e ferrioxalato de potássio (0,2 a 1 mmol L-1). Os experimentos foram realizados em um reator com lâmpada UV - 8W (254nm). O processo de fotodegradação foi monitorado por medidas de espectrofotometria de absorção molecular automatizada por injeção seqüencial (SIA) para determinação de peróxido de hidrogênio e por cromatografia a líquido de alta eficiência (CLAE) para determinação de atrazina e metabólitos. Os experimentos demonstram que o processo de foto-Fenton é viável para o tratamento de atrazina em água.

Síntese e caracterização de catalisadores baseados em vermiculita modificada com ferro: aplicação em processos do tipo foto-fenton

Clays are materials with specific properties that make them promising for various studies. In this work we used the vermiculite clay as support for iron compounds, in order to obtain promising materials for application in the heterogeneous type photo-Fenton process. In all, the study included six solid, starting from the vermiculite (V0) was obtained calcined vermiculite (V0-C), the mixed material (V0/β-FeOOH) formed by vermiculite more akaganeite, exchanged vermiculite (v0t-C), vermiculite impregnated Wet (V0u-C) and V0u-CL that is the solid obtained by impregnating with a back washing. The solids of the study had their physical and chemical characteristics investigated by the following characterization techniques: X-Ray Diffraction (XRD), Infrared Spectroscopy (IR), Energy Dispersive Spectroscopy (EDS), X-Ray Fluorescence Spectroscopy (XRF), UV-Vis by Diffuse Reflectance (DR UV-Vis), Thermogravimetric Analysis (TGA) and Scanning Electron Microscopy (SEM). The V0 material showed three distinct phases, which are the very vermiculite, hidrobiotite and biotite, the last two phases are part of the geological of formation process vermiculite. The solids obtained after the modification showed an increase in the amount of iron present in the clay, these being quantities important for application in photocatalysis. The micrographs and EDS data, show that after treatment of addition of the metal , the iron was intercalary in structure of vermiculite for solid V0t-C and V0u-C, however, this did not occur with mixed material. In the photoFenton process, was observed a maximum removal of 88.8% of the dye methylene blue coloring for the catalyst V0/β-FeOOH, while for the other solids was obtained values between 76.8 and 62.6%, compared to 37.8% of discoloration without the presence of catalyst. Therefore, it is concluded that the vermiculite clay presents as a good catalyst and iron support for the, beyond of presenting a low cost because of its high abundance.