922 resultados para Passive part of stance
Resumo:
In our research we have attempted to find out and compare force and time characteristics of gait in women. We measured and compare women in two age groups - 18-30 (group 1) a 46-60 (group 2). The average height of both groups was same, 167 cm, while the average weight and average body mass index were different (group 1 - weight 62 kg, BMI 22,3, group 2 - weight 68 kg, BMI 24,6). For measuring, pressure shoe insoles were used (Pedar Mobile, Novel Munich, 99 sensors, 100 Hz). Each person had three attempts: two trial attempts, the third one was measured. For observation, we selected three stances of each leg, always between the third and eighth stride. We measured force characteristics F1, F2, F3 and time characteristics t, t1, t2, t3. Significant differences between both groups were found in t3 on the left leg (time between peak force in active part of stance and peak force in passive part of stance). With applied force (F1, F2, F3) during stance, after recalculating per a kilogram of weight, no statistically significant differences were found.
Resumo:
For the last two decades heart disease has been the highest single cause of death for the human population. With an alarming number of patients requiring heart transplant, and donations not able to satisfy the demand, treatment looks to mechanical alternatives. Rotary Ventricular Assist Devices, VADs, are miniature pumps which can be implanted alongside the heart to assist its pumping function. These constant flow devices are smaller, more efficient and promise a longer operational life than more traditional pulsatile VADs. The development of rotary VADs has focused on single pumps assisting the left ventricle only to supply blood for the body. In many patients however, failure of both ventricles demands that an additional pulsatile device be used to support the failing right ventricle. This condition renders them hospital bound while they wait for an unlikely heart donation. Reported attempts to use two rotary pumps to support both ventricles concurrently have warned of inherent haemodynamic instability. Poor balancing of the pumps’ flow rates quickly leads to vascular congestion increasing the risk of oedema and ventricular ‘suckdown’ occluding the inlet to the pump. This thesis introduces a novel Bi-Ventricular Assist Device (BiVAD) configuration where the pump outputs are passively balanced by vascular pressure. The BiVAD consists of two rotary pumps straddling the mechanical passive controller. Fluctuations in vascular pressure induce small deflections within both pumps adjusting their outputs allowing them to maintain arterial pressure. To optimise the passive controller’s interaction with the circulation, the controller’s dynamic response is optimised with a spring, mass, damper arrangement. This two part study presents a comprehensive assessment of the prototype’s ‘viability’ as a support device. Its ‘viability’ was considered based on its sensitivity to pathogenic haemodynamics and the ability of the passive response to maintain healthy circulation. The first part of the study is an experimental investigation where a prototype device was designed and built, and then tested in a pulsatile mock circulation loop. The BiVAD was subjected to a range of haemodynamic imbalances as well as a dynamic analysis to assess the functionality of the mechanical damper. The second part introduces the development of a numerical program to simulate human circulation supported by the passively controlled BiVAD. Both investigations showed that the prototype was able to mimic the native baroreceptor response. Simulating hypertension, poor flow balancing and subsequent ventricular failure during BiVAD support allowed the passive controller’s response to be assessed. Triggered by the resulting pressure imbalance, the controller responded by passively adjusting the VAD outputs in order to maintain healthy arterial pressures. This baroreceptor-like response demonstrated the inherent stability of the auto regulating BiVAD prototype. Simulating pulmonary hypertension in the more observable numerical model, however, revealed a serious issue with the passive response. The subsequent decrease in venous return into the left heart went unnoticed by the passive controller. Meanwhile the coupled nature of the passive response not only decreased RVAD output to reduce pulmonary arterial pressure, but it also increased LVAD output. Consequently, the LVAD increased fluid evacuation from the left ventricle, LV, and so actually accelerated the onset of LV collapse. It was concluded that despite the inherently stable baroreceptor-like response of the passive controller, its lack of sensitivity to venous return made it unviable in its present configuration. The study revealed a number of other important findings. Perhaps the most significant was that the reduced pulse experienced during constant flow support unbalanced the ratio of effective resistances of both vascular circuits. Even during steady rotary support therefore, the resulting ventricle volume imbalance increased the likelihood of suckdown. Additionally, mechanical damping of the passive controller’s response successfully filtered out pressure fluctuations from residual ventricular function. Finally, the importance of recognising inertial contributions to blood flow in the atria and ventricles in a numerical simulation were highlighted. This thesis documents the first attempt to create a fully auto regulated rotary cardiac assist device. Initial results encourage development of an inlet configuration sensitive to low flow such as collapsible inlet cannulae. Combining this with the existing baroreceptor-like response of the passive controller will render a highly stable passively controlled BiVAD configuration. The prototype controller’s passive interaction with the vasculature is a significant step towards a highly stable new generation of artificial heart.
Resumo:
Synchronous distributed generators are prone to operate islanded after contingencies, which is usually not allowed due to safety and power-quality issues. Thus, there are several anti-islanding techniques; however, most of them present technical limitations so that they are likely to fail in certain situations. Therefore, it is important to quantify and determine whether the scheme under study is adequate or not. In this context, this paper proposes an index to evaluate the effectiveness of anti-islanding frequency-based relays commonly used to protect synchronous distributed generators. The method is based on the calculation of a numerical index that indicates the time period that the system is unprotected against islanding considering the global period of analysis. Although this index can precisely be calculated based on several electromagnetic transient simulations, a practical method is also proposed to calculate it directly from simple analytical formulas or lookup tables. The results have shown that the proposed approach can assist distribution engineers to assess and set anti-islanding protection schemes.
Resumo:
When Federica Mogherini visited the South Caucasus in March, she was quoted as saying that the Nagorno-Karabakh conflict was a top priority for the EU. Facts, however, do not seem to match the words of the EU High Representative for Foreign Affairs and Security Policy. As violent clashes in the conflict zone unfolded over the past week, the EU was a passive observer, with few visible signs of engagement apart from a cursory phone call urging Armenia and Azerbaijan to show restraint. The escalation has shown how quickly and dangerously the situation can develop, and the unassailable nature of the Line of Contact (LoC). If the diplomatic efforts to resolve the conflict show no progress, a repetition is very probable. Furthermore, it is likely the next incident will be more devastating in human and material costs than this recent one, and may not be contained so quickly. The EU needs to be part of the renewed diplomatic effort.
Resumo:
Corrosion rates of 1020 steel in 2.75 M NaOH solution at a temperature of 160 degrees C and velocities of 0.32 and 2.5 m/s were studied. The focus was on the effect of the acid cleaning which was performed by using strong, inhibited sulphuric acid in between the exposures to caustic. In situ electrochemical methods were used to measure the corrosion rate such as the potentiodynamic sweep and the polarization resistance method. Also used were the weight-loss method and scanning electron microscopy (SEM). Eight electrodes/coupons were used to monitor the metal loss rate, four were placed at the low velocity section, while the other four were placed in the high velocity section of a high temperature flow. The first three coupons in each section were placed within the disturbed flow region, while the fourth was placed in a fully developed flow region. During the exposure of mild steel to the inhibited acid, following the first caustic period, the corrosion rate increased significantly to between 3 and 10mm/y with a few electrodes experiencing as high as 50 mm/y. The second caustic period following the acidic period typically started with very high corrosion rates (20-80 mm/y). The length of this corrosion period was typically 2-3 h with a few exceptions when the high corrosion period lasted 7-10 h. Following the very high corrosion rates experienced at the beginning of the second caustic period, the corrosion rates were reduced sharply (as the corrosion potential increased) to nearly the same levels as those observed during the passive part of the first caustic period. (c) 2005 Elsevier Ltd. All rights reserved.
Resumo:
Although Design Led Innovation activities aim to raise the value of design within the business, knowledge about which tools are available to support companies and how to apply them to make the connection between design for new product development and design as a strategic driver of growth is needed. This paper presents a conceptual method to supplement existing process and tools to assist companies to grow through design. The model extends the authors’ previous work to explore how through storytelling, customer observation can be captured and translated into new meaning, then creating new design propositions shaped into product needs, which can drive internal business activities, brand and the strategic vision. The paper contributes to a gap in the theoretical frameworks and literature by highlighting the need to align and scale design processes which match the needs of SME’s as they transition along a trajectory to become design led businesses.
Resumo:
Motivational deficits are generally accepted to be part of the behavioural phenotype associated with Down syndrome (DS). A motivational profile comprising low or inconsistent levels of task persistence, avoidance of challenging activities and over-dependence on adult direction has been described. However, comparisons are usually made between children with DS and those who are developing typically, without the inclusion of samples with intellectual disability (ID) from aetiologies other than DS. Such comparisons are needed to determine the extent to which motivational deficits are specific to DS, as opposed to being a feature of ID generally. Methods: The current study collected data about the personality-motivation profiles of children in three groups matched for mental age. They consisted of 80 typically developing (TD)3–7 year old children, 62 children with DS aged 7–15 years, and 54 children with moderate ID aged 7–15 years. Parents completed the 37-item EZ-Personality Questionnaire (EZPQ; Zigler et al., 2002), a measure of personality-motivational functioning. Results: There were significant differences between TD children and those with ID on all EZPQ scales. In most respects children with DS did not differ significantly from others with moderate ID, although they were rated as having greater expectancy of success and fewer negative reactions. Conclusion: The finding that children with DS are less motivated than TD children of the same mental age is consistent with previous studies in which parents have rated motivation. It seems, however, that motivation difficulties are associated with ID more generally, rather than being specific to those with DS. The study raises questions about phenotypic versus experiential effects on motivation for children with ID.
Resumo:
Pillar of salt: (3 hand-applied silver gelatin photographs) Statement: For women moving into new experiences and spaces, loss and hardship is often a price to be paid. These courageous women look back to things they have overcome in order to continue to grow.
Resumo:
Summary In late 2011 and early 2012, the People’s Republic of China drew on its most unique diplomatic tool: the giant panda. Although this phenomenon is widely covered by the global media, the practice of panda diplomacy is only barely discussed in diplomatic or international relations studies. This article uses the most recent revival of this diplomatic practice for a closer analysis and locates it as a special version of animal diplomacy within the frame of public diplomacy. It first argues that panda diplomacy is — besides all the efforts to promote and support animal conservation and biological research — a political undertaking, which is symbolically used by the Chinese government to win hearts and minds in selected foreign countries. Second, it highlights an important aspect of some Chinese public diplomacy initiatives, namely China’s ability to integrate international partners in its attempts to shape its global image.
Resumo:
In this paper we will outline a workshop that we conceived, developed, facilitated and evaluated especially for Aboriginal and Torres Strait Islander women. The Tiddas Writin’ Up Workshop specifically addressed the academic writing needs of Aboriginal and Torres Strait Islander women working in universities, institutes and TAFE colleges. We demonstrate how we can make the written word part of our toolbox for success.