956 resultados para Paper weight
Resumo:
The availability of water for seeds is closely related to their germination, since hydration is a limiting factor for their metabolic processes. Therefore, in tests carried out in laboratory, substrate must be sufficiently moistened, in order to assure both the embryo growth and seedling formation. This research was carried out to evaluate the influence of different quantities of water, in different substrates, for cabbage (Brassica oleracea var. capitata) seeds germination. The seeds, processed with Thiran 0.1%, were obtained in shops located in Jaboticabal, São Paulo State, Brazil. Germination tests were made in germitest rolled paper towel substrates, between and on draft paper, moistened with quantities of water equivalent to 1.0; 1.5; 2.0; 2.5; 3.0; 3.5; and 4.0 times the dry substrate weight. For each treatment, four repetitions of 50 seeds were used. The seeds were kept in a germinator, at an alternate temperature of 20-30°C, without further addition of water to the substrate. The evaluations were made on the fifth and tenth days after the experiment preparation. The results obtained revealed that the quantities of water ranging from 1.5 to 2.5 times the paper weight were favorable for seeds germination, mainly in the substrate on and between the paper, while water levels above 3.0 times the substrate weight were harmful for cabbage seeds germination in the rolled paper towel substrates and between the paper.
Resumo:
The determination of loin eye area (LEA) is one of the most common methods to assess carcass quality and it is possible to adjust calculations to predict meat amount in the carcass which is one of the important features in the classification process. The aim of this study was to compare different methodologies used to determine LEA in swine. Fifteen crossbred pigs, Landrace x Large White, males and females, were slaughtered at 140 days of age. After 24 hours of cooling at 4°C, the Longissimus dorsi muscle was removed from the left half part of carcasses for evaluation of LEA between the 12th and 13th rib. The methods were: point counting on plastic grid of 1 cm2 and 0.25 cm2 (PCGP 1 cm2 and PCGC 0.25 cm2 ), circumference method by Echo Image Viewer (ECHO), circumference method using AutoCad ® program (CAD) and method of weighing paper (WP). The design was completely randomized with 15 replications per treatment and the data were subjected to Pearson correlation and variance analysis. Averages were compared by Tukey test at a significance level of 5%. LEA values were: 35.84, 35.69, 33.86, 34.22 and 36.71 cm2 , for the PCGP 1 cm2 , PCGP 0.25 cm2 , ECHO, CAD and WP methods, respectively. The LEA values determined by methods PCGP 1 cm2 , PCGP 0.25 cm2 and WP were similar; however they were higher than those obtained by the ECHO and CAD methodologies (P<0.0001). PCGP 1 cm2 , PCGP 0.25 cm2 and WP methods may overestimate LEA values. The choice of method to be used should be based on its practicality and availability of resources, since the difference obtained between them is low.
Resumo:
The impact of ozone oxidation on removing high molecular weight (HMW) organics in order to improve the biodegradability of alkaline bleach plant effluent was investigated using a semi-batch reactor under different initial pH (12 and 7). After the ozonation process, the ratio of BOD5/COD increased from 0.07 to 0.16 and 0.22 for initial pH 12 and 7, respectively. Also, the effluent color decreased by 48% and 61% at initial pH 12 and pH 7, respectively. These changes were primarily driven by reductions of the HMW fractions of the effluent during ozonation.
Resumo:
Online data collection is becoming increasingly common and has some advantages compared to traditional paper-and-pencil formats, such as reducing loss of data, increasing participants' privacy, and decreasing the effect of social desirability. However, the validity and reliability of this administration format must be established before results can be considered acceptable. The aim of this study was to evaluate the validity, reliability, and equivalence of paper-and-pencil and online versions of the Weight Concerns Scale (WCS) when applied to Brazilian university students. A crossover design was used, and the Portuguese version of the WCS (in both paper-and-pencil and online formats) was completed by 100 college students. The results indicated adequate fit in both formats. The simultaneous fit of data for both groups was excellent, with strong invariance between models. Adequate convergent validity, internal consistency, and mean score equivalence of the WCS in both formats were observed. Thus, the WCS presented adequate reliability and validity in both administration formats, with equivalence/stability between answers.
Resumo:
The purpose of this study was to improve PM7’s basis weight CD profile in Stora Enso’s Berghuizer mill and to search mechanical defects which affect to the formation of the basis weight CD profile. In the theoretical part PM7’s structure was presented and the formation of the basis weight and caliper CD profiles was examined as well as disturbances which are affecting to the formation. The function of the control system was scrutinised for the side of CD profiles as well as the formation of the measured CD profiles. Tuning of the control system was examined through the response model and filtering. Specification of the response model and filtering was explained and how to determine 2sigma statistical number. In the end of the theoretical part ATPA hardware and a new profile browser were introduced. In the experimental part focus was in the beginning to search and remove mechanical defects which are affecting to CD profiles. The next step was to verify the reliability of the online measurements, to study the stability of the basis weight CD profile and to find out so called fingerprint, a basis weight CD profile which is unique for each paper machine. New response model and filtering value for basis weight CD profile was determined by bump tests. After a follow up period the affect of the new response model and filtering was analysed.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
No abstract.
Resumo:
Isosorbide succinate moieties were incorporated into poly(L-lactide) (PLLA) backbone in order to obtain a new class of biodegradable polymer with enhanced properties. This paper describes the synthesis and characterization of four types of low molecular weight copolymers. Copolymer I was obtained from monomer mixtures of L-lactide, isosorbide, and succinic anhydride; II from oligo(L-lactide) (PLLA), isosorbide, and succinic anhydride; III from oligo(isosorbide succinate) (PIS) and L-lactide; and IV from transesterification reactions between PLLA and PIS. MALDI-TOFMS and 13C-NMR analyses gave evidence that co-oligomerization was successfully attained in all cases. The data suggested that the product I is a random co-oligomer and the products II-IV are block co-oligomers.
Resumo:
This paper describes a new and simple method to determine the molecular weight of proteins in dilute solution, with an error smaller than similar to 10%, by using the experimental data of a single small-angle X-ray scattering (SAXS) curve measured on a relative scale. This procedure does not require the measurement of SAXS intensity on an absolute scale and does not involve a comparison with another SAXS curve determined from a known standard protein. The proposed procedure can be applied to monodisperse systems of proteins in dilute solution, either in monomeric or multimeric state, and it has been successfully tested on SAXS data experimentally determined for proteins with known molecular weights. It is shown here that the molecular weights determined by this procedure deviate from the known values by less than 10% in each case and the average error for the test set of 21 proteins was 5.3%. Importantly, this method allows for an unambiguous determination of the multimeric state of proteins with known molecular weights.
Resumo:
Hepatitis C virus (HCV) is a major cause of chronic liver disease that may progress to cirrhosis. Antiviral treatment is successful in less than 50% of patients, is costly and causes debilitating side effects. For these reasons, additional therapies to limit the progression of liver disease are urgently required. Steatosis is found in 60% of patients with HCV and is strongly associated with more severe fibrosis. Improvements in biochemical parameters may be seen with weight reduction, however the effects on liver histology have not been investigated. We propose that in patients with chronic HCV and steatosis, obesity contributes to fat in the liver, which results in increased fibrosis and progression to cirrhosis. This study investigated the effect of weight reduction on liver biochemistry and histology in patients with HCV and the success of weight maintenance after an intensive intervention. We examined the effect of a 12 week diet and exercise program where all subjects were seen weekly by the Dietician, with the goal of achieving a 0.5 kg weight loss per week. Biochemistry was monitored monthly and a liver biopsy was performed prior to and 3-6 months after the intervention period. Patients then entered a 12 month weight maintenance program with monthly dietetic review. After 12 weeks there was a mean weight loss of 5.9 ± 3.2 kg and a mean reduction in waist circumference of 9.0 ± 5.0 cm. In 16 of the 19 patients, serum ALT levels fell progressively with weight loss. Mean fasting insulin fell from 16 to 11 mmol/L (p
Resumo:
Steatosis occurs in >50% of patients with chronic HCV. In patients with viral genotype 3, steatosis may be a cytopathic effect of the virus. However in many patients with HCV, the pathogenesis of steatosis appears to be the same as for patients with non-alcoholic fatty liver disease (NAFLD) ie related to increased body mass index (BMI). We studied the effect of a 12 week weight reduction program on metabolic parameters in subjects with chronic HCV genotype 1 (Group 1, n = 16), genotype 3 (Group 2, n = 13) and patients with NAFLD (Group 3, n = 13). A liver biopsy was performed prior to and 3-6 months after the intervention period in 15 patients. The mean (SD) BMI of subjects in groups 1, 2 and 3 was 30.7 (4.0), 29.0 (5.2) and 33.3 (7.7), respectively. There was no significant difference in the amount of weight loss, change in waist circumference, change in ALT or reduction in steatosis between the 3 groups. Mean (SD) weight loss was 5.1 (3.7) kg. In those patients who lost weight, serum insulin (mean (SD) mU/L) changed from 17.8 (7.8) to 11.5 (4.8) (p = 0.003), 12.4 (5.0) to 8.4 (4.3) (p = 0.02), and 16.9 (7.3) to 17.8 (8.1) (p = 0.76) in Groups 1, 2 and 3, respectively. A small amount of weight loss is associated with a reduction in circulating insulin levels in patients with chronic HCV, particularly in genotype 1. In patients with NAFLD, the lack of a significant decrease in circulating insulin with weight reduction may reflect the higher initial BMI or may be due to the pathogenesis of this disorder.
Resumo:
Obesity is considered a worldwide public health problem showing an increased prevalence in developing countries, with urgent need for new and more efficient drugs and therapies. Enalapril, an angiotensin-I converting enzyme inhibitor (ACEi), is classically used in antihypertensive therapies, however, earlier publications have shown that this drug could also have significant impact on body weight in rats as well as in humans, besides reducing blood pressure. The effect of this drug in the white adipose tissue has been neglected for long time, even considering that most components of the renin-angiotensin and kallikrein-kinin system are expressed in this tissue. Furthermore, the adipose tissue is considered today as one of the most important sites for endocrine/inflammatory regulation of appetite and energy output and AngII has been linked to the metabolism in this tissue. Therefore, we analyzed the influence of chronic enalapril treatment in normotensive rats at earlier ages, evaluating body weight, energy homeostasis, lipid profile and serum levels of the hormones leptin and insulin, in the presence of a standard or a palatable hyperlipidic diet regimen for one month. Our results show that enalapril treatment is able to reduce body fat on both diets, without alteration in serum lipid profile. Furthermore, animals receiving enalapril showed reduction in food intake, leptin level and energy intake. In summary, these findings show for the first time that the ACEi enalapril reduces body fat in young normotensive rats and highlights a novel target to treat obesity and associated diseases. (c) 2007 Elsevier B.V. All rights reserved.
Resumo:
The standard approach to preventing acute coronary syndromes (ACSs)has been to inhibit platelet aggregation with aspirin and to inhibit blood coagulation with low molecular-weight heparin (LMWH). Even with this combination there is still a substantial short and long-term cardiovascular risk. The Clopidogrel in Unstable angina to prevent Recurrent Events (CURE) trial [1] compared clopidogrel plus aspirin against aspirin alone in patients with ACSs. The clopidogrel regimen was a loading dose of 300 mg p.o. followed by 75 mg/day and the recommended dose of aspirin was 75 - 325 mg/day. The first primary outcome was a composite of death from cardiovascular causes, non-fatal myocardial infarction (MI) or stroke and this occurred significantly less often in the clopidogrel than the placebo group (9.3 vs. 11.4%). Although there were more clopidogrel patients with life-threatening bleeding (clopidogrel 2.2%, placebo 1.8%), this represented GI haemorrhages and bleeding at sites of arterial puncture rather than fatal bleeding. This trial suggests a role for clopidogrel in the long-term treatment of ACSs