Degradation of 17 alpha-ethinylestradiol in aqueous solution by ozonation

This study investigates the ozonation of 17 alpha-ethinylestradiol (EE2) in aqueous solution. The affecting factors on the degradation of EE2 were studied and described in details, such as initial EE2 concentration, initial pH value and ozone concentration. In addition, some parameters such as pH. electrical conductivity, mineralization efficiency and degradation products were monitored during the process. The mineralization efficiency of EE2 could reach 53.9%. During the ozonation process the rapid decrease of pH and the sharp increase of electrical conductivity indicated the fort-nation of acidic by-products, small fragments and ions which were confirmed by high performance liquid chromatography (HPLC) and gas chromatography-mass spectrometry (GUMS) analysis. Results showed that there were intermediate products of smaller molecule with higher polarity produced during the course of EE2 degradation. Then a possible reaction pathway for EE2 degradation involving all intermediates detected is proposed. During the ozonation process EE2 was first oxidized into hydroxyl-semiquinone isomers which were subsequently degraded into low molecular weight compounds such as oxalic acid, malonate, glutarate, and so on. Furthermore. these organic acids are easily oxidized by ozone into carbon dioxide (CO2). This work shows that ozonation process is promising for the removal of EE2. The results can provide some useful information for the potential treatment of EE2 by ozonation in aqueous solution. (c) 2005 Elsevier B.V. All rights reserved.

Synthesis, characterization and catalytic evaluation of cubic ordered mesoporous iron-silicon oxides

Iron was successfully incorporated in FDU-1 type cubic ordered mesoporous silica by a simple direct synthesis route. The (Fe/FDU-1) samples were characterized by Rutherford back-scattering spectrometry (RBS), small angle X-ray scattering (SAXS). N(2) sorption isotherm, X-ray diffraction (XRD) and X-ray absorption spectroscopy (XAS). The resulting material presented an iron content of about 5%. Prepared at the usual acid pH of -0.3, the composite was mostly formed by amorphous silica and hematite with a quantity of Fe(2+) present in the structure. The samples prepared with adjusted pH values (2 and 3.5) were amorphous. The samples` average pore diameter was around 12.0 nm and BET specific surface area was of 680 m(2) g(-1). Although the iron-incorporated material presented larger lattice parameter, about 25 nm compared to pure FDU-1, the Fe/FDU-1 composite still maintained its cubic ordered fcc mesoporous structure before and after the template removal at 540 degrees C. The catalytic performance of Fe/FDU-1 was investigated in the catalytic oxidation of Black Remazol B dye using a catalytic ozonation process. The results indicated that Fe/FDU-1 prepared at the usual acid pH exhibited high catalytic activity in the mineralization of this pollutant when compared to the pure FDU-1. Fe(2)O(3) and Fe/FDU-1 prepared with higher pH of 2 and 3.5. (C) 2010 Elsevier B.V. All rights reserved.

Procesos de depuración de los efluentes líquidos de actividades petrolíferas

La Tesis Doctoral surge debida de los problemas de contaminación ambientales que presentan los efluentes líquidos refinería del petróleo y las industrias de extracción del petróleo crudo en la zona costera de Angola principalmente en las provincias de Cabinda, Zaire y Luanda, en las cuales sus vertidos destruyen la flora y fauna acuática. El objetivo de este trabajo consiste en implementar nuevas técnicas de los procesos de oxidación avanzada para el tratamiento de los efluentes líquidos de refinerías de petróleo, que permitan conseguir una calidad adecuada de los vertidos. Este sector se considera como una fuente de contaminación del medio ambiente, que requiere un control estricto y un tratamiento adecuado para la eliminación de los contaminantes existente en este tipo de agua y posteriormente poder reutilizar estas aguas tratadas para otros fines industriales o verter a los cauces receptores que al menos no perjudique a los ecosistemas. En esta tesis se ha investigado las técnicas más modernas de los procesos de oxidación avanzada para el tratamiento de agua residual de refinería de petróleo, así como: 1) ozonización, 2) peróxido de hidrógeno con ozono, y 3) ultravioleta con ozono. Los resultados obtenidos en este trabajo muestran que el proceso de ozonización simple, ha dado mejores resultados para el tratamiento de este tipo agua residual de petróleo, tanto, en la eliminación de materia orgánica y los fenoles presentes en el agua residual. En la primera fase, con 1 litro de muestra, se alcanzó un rendimiento del 80% en la eliminación de la DQO utilizando 5,97 mg/l de dosis de ozono, con 11 minutos de tiempo de contacto. Respecto a los fenoles se alcanzó una eliminación del 100 % con la misma dosis de ozono y con 11 minutos de tiempo de contacto. En la segunda fase, con 4 litros de muestra, se alcanzó un rendimiento del 66% de la DQO utilizando 22,21 mg/l de dosis de ozono, con 15 minutos de tiempo de contacto y el rendimiento en la eliminación de los fenoles fue de 90 % a las mismas condiciones. The doctoral thesis arises because of environmental pollution problems posed by liquid effluents and oil refinery industries extraction of crude oil in the coastal area of Angola mainly in the provinces of Cabinda, Zaire and Luanda, in which their discharges destroy aquatic flora and fauna. The objective of this work is to implement new techniques of advanced oxidation processes for the treatment of liquid effluents of oil refineries that will achieve an adequate quality of discharges. This sector is considered as a source of environmental pollution, which requires close monitoring and appropriate treatment for the removal of existing contaminants in this water and then treated to reuse this water for other industrial purposes or discharging into streams receptors that at least does not harm ecosystems. In this thesis we investigate the most modern techniques of advanced oxidation processes for treatment of wastewater from oil refinery and: 1) ozonation, 2) hydrogen peroxide, ozone, and 3) radiation with ozone. The results obtained in this study show that the ozonation process simple, has yielded better results for treating wastewater of this type of oil, so the removal of phenols and organic matter present in the wastewater. In the first phase, with 1 liter of sample was reached in 80% yield COD removal using 5.97 mg/l ozone dosage, with 11 minutes of contact time. Regarding phenols elimination was achieved of 100% with the same dose of ozone and 11 minutes contact time In the second phase, with sample 4 liters was reached in 66% yield using 22.21 COD mg / l ozone dosage, with 15 minutes of contact time and the performance in the removal of phenols was of 90% at the same conditions.

Treatment of rice straw hemicellulosic hydrolysates with advanced oxidative processes: a new and promising detoxification method to improve the bioconversion process

Abstract Background The use of lignocellulosic constituents in biotechnological processes requires a selective separation of the main fractions (cellulose, hemicellulose and lignin). During diluted acid hydrolysis for hemicellulose extraction, several toxic compounds are formed by the degradation of sugars and lignin, which have ability to inhibit microbial metabolism. Thus, the use of a detoxification step represents an important aspect to be considered for the improvement of fermentation processes from hydrolysates. In this paper, we evaluated the application of Advanced Oxidative Processes (AOPs) for the detoxification of rice straw hemicellulosic hydrolysate with the goal of improving ethanol bioproduction by Pichia stipitis yeast. Aiming to reduce the toxicity of the hemicellulosic hydrolysate, different treatment conditions were analyzed. The treatments were carried out according to a Taguchi L16 orthogonal array to evaluate the influence of Fe+2, H2O2, UV, O3 and pH on the concentration of aromatic compounds and the fermentative process. Results The results showed that the AOPs were able to remove aromatic compounds (furan and phenolic compounds derived from lignin) without affecting the sugar concentration in the hydrolysate. Ozonation in alkaline medium (pH 8) in the presence of H2O2 (treatment A3) or UV radiation (treatment A5) were the most effective for hydrolysate detoxification and had a positive effect on increasing the yeast fermentability of rice straw hemicellulose hydrolysate. Under these conditions, the higher removal of total phenols (above 40%), low molecular weight phenolic compounds (above 95%) and furans (above 52%) were observed. In addition, the ethanol volumetric productivity by P. stipitis was increased in approximately twice in relation the untreated hydrolysate. Conclusion These results demonstrate that AOPs are a promising methods to reduce toxicity and improve the fermentability of lignocellulosic hydrolysates.

Aerobic biodegradation of chlorinated solvents and plastics in batch and continuous-flow bioreactors: process development, and identification of suitable chemical pre-Treatments

The purpose of the first part of the research activity was to develop an aerobic cometabolic process in packed bed reactors (PBR) to treat real groundwater contaminated by trichloroethylene (TCE) and 1,1,2,2-tetrachloroethane (TeCA). In an initial screening conducted in batch bioreactors, different groundwater samples from 5 wells of the contaminated site were fed with 5 growth substrates. The work led to the selection of butane as the best growth substrate, and to the development and characterization from the site’s indigenous biomass of a suspended-cell consortium capable to degrade TCE with a 90 % mineralization of the organic chlorine. A kinetic study conducted in batch and continuous flow PBRs and led to the identification of the best carrier. A kinetic study of butane and TCE biodegradation indicated that the attached-cell consortium is characterized by a lower TCE specific degredation rates and by a lower level of mutual butane-TCE inhibition. A 31 L bioreactor was designed and set up for upscaling the experiment. The second part of the research focused on the biodegradation of 4 polymers, with and with-out chemical pre-treatments: linear low density polyethylene (LLDPE), polyethylene (PP), polystyrene (PS) and polyvinyl chloride (PVC). Initially, the 4 polymers were subjected to different chemical pre-treatments: ozonation and UV/ozonation, in gaseous and aqueous phase. It was found that, for LLDPE and PP, the coupling UV and ozone in gas phase is the most effective way to oxidize the polymers and to generate carbonyl groups on the polymer surface. In further tests, the effect of chemical pretreatment on polyner biodegrability was studied. Gas-phase ozonated and virgin polymers were incubated aerobically with: (a) a pure strain, (b) a mixed culture of bacteria; and (c) a fungal culture, together with saccharose as a co-substrate.