(Table 1) Summary of magnetic properties and chemical composition of opaque minerals in DSDP Leg 58 Holes basallts

The Curie temperature and thermomagnetic behavior of wholerock samples were measured in basalts recovered from Sites 442, 443, and 444 of DSDP Leg 58 in the Shikoku Basin, and from Site 446 in the Daito Basin, north Philippine Sea. Chemical composition and microscopic features of opaque oxides in the same samples were also investigated. Degree and mode of oxidation of titanomagnetite vary irrespective of site, lithology, or magnetic polarity, and no systematic correlation has been found between any two of these characteristics. Magnetic properties are systematically different between massive flows recovered at Hole 444A (Shikoku Basin) and Hole 446A (Daito Basin), although the controlling factor is unknown.

Microscopical determination of opaque minerals : an aid to the study of ores /

Bibliography: p. 16-18.

(Table 1) Percentage of non-opaque heavy minerals, heavy residue, magnetite, and opaque heavy minerals, DSDP Sites 58-445 and 58-446

Heavy-mineral analyses were made for 39 samples, 27 from DSDP Site 445 and 12 from Site 446. About one-fourth of the samples were so loose that they were easily disaggregated in water. The amount of heavy residue and the magnetite content of the heavy fraction were very high, 0.2 to 44 per cent and (on the average) more than 20 per cent, respectively. Among the non-opaque heavy minerals, common hornblende (0 to 80%) and augite (0 to 98%) are most abundant. Pale-green and bluish-green amphiboles (around 10%) and the epidote group (a few to 48%) are next in abundance. Euhedral apatite and biotite and irregularly shaped chromite are not abundant, but are present throughout the sequence. Hacksaw structure is developed in pale-green amphibole and augite. At Site 445, a fair amount of chlorite and a few glauconite(?) grains are present from Core 445-81 downward. The content of common hornblende and opaque minerals also changes from Core 445-81 downward. A geological boundary may exist between Cores 445-77 and 445-81. Source rocks of the sediments at both sites were basaltic volcanic rocks (possibly alkali suite), schists, and ultramafic rocks. The degree of lithification and amount of heavy residue, and the content of magnetite, non-opaque heavy minerals (excluding mafic minerals), and mafic minerals in the cores were compared with Eocene, Oligocene, and Miocene sandstones of southwest Japan. In many respects, the sediments at Sites 445 and 446 are quite different from those of southwest Japan. From the early Eocene to the early Miocene, the area of these sites belonged to a different geologic province than southwest Japan.

Physical properties and minerals of Leg 65 Holes basalts

Velocities and densities of submarine basalts obtained during Leg 65 are distinguished by their relatively high values (about 6.3 km/s and 2.9 g/cm/**3, respectively). This is consistent with their low degree of alteration. The range of velocities covered by these samples correlates well with porosity, and a comparison with in situ velocities from refraction data suggests maximum porosities ih the upper 100 meters of the crust of about 10%.