Determination of carbaryl in tomato ""in natura"" using an amperometric biosensor based on the inhibition of acetylcholinesterase activity

This work reports the utilization of two methodologies for carbaryl determination in tomatoes. The measurements were carried out using an amperometric biosensor technique based on the inhibition of acetylcholinesterase activity due to carbaryl adsorption and a HPLC procedure. The electrochemical experiments were performed in 0.1 mol L-1 phosphate buffer solutions at pH 7.4 with an incubation time of 8 min. The analytical curve obtained in pure solutions showed excellent linearity in the 5.0 x 10(-5) to 75 x 10(-5) mol L-1 range, with the limit of detection at 0.4 x 10(-3) gL(-1). The application of such a methodology in tomato samples involved solely liquidising the samples, which were spiked with 6.0 x 10(-6) and 5.0 x 10(-5) mol L-1 carbaryl. Recovery in such samples presented values of 99.0 and 92.4%, respectively. In order to obtain a comparison, HPLC experiments were also conducted under similar conditions. However, the tomato samples have to be manipulated by an extraction procedure (MSPD), which yielded much lower recovery values (78.3 and 84.8%, respectively). On the other hand, the detection limit obtained was much lower than that for the biosensor, i.e., 3.2 x 10(-6) g L-1. Finally, the biosensor methodology was employed to analyze carbaryl directly inside the tomato, without any previous manipulation. In this case, the biosensor was immersed in the tomato pulp, which had previously been spiked with the pesticide for 8 min, removed and inserted in the electrochemical cell. A recovery of 83.4% was obtained, showing very low interference of the matrix constituents. (C) 2007 Elsevier B.V. All rights reserved.

Comparison of different clean-up procedures for the determination of N-methylcarbamate insecticides in vegetable matrices by high-performance liquid chromatography with UV detection

Several clean-up procedures which included the use of glass chromatography columns (silica gel, alumina, Florisil, silanized Celite-charcoal), Sep-Pak cartridges and standard solutions were compared for the determination of the following N-methylcarbamate (NMC) insecticides: aldicarb, carbaryl, carbofuran, methomyl and propoxur. According to recovery results of the compounds after elution in a glass column, the most efficient systems employed 4.6% deactivated alumina and a silanized Celite-charcoal (4:1) as adsorbents, using dichloromethane-methanol (99:1) and toluene-acetonitrile (75:25) mixtures, respectively, as binary eluents. The recoveries of the compounds studied varied from 84 to 120%. Comparable recoveries (75-100%) for Sep-Pak cartridges in normal phase (NH2, CN) and reversed phase (C-8) were observed. Different temperatures were tested during the concentration step in a rotary evaporator, and we verified a strong influence of this parameter on the stability of some compounds, such as carbofuran and carbaryl. Recovery studies employing the best clean up procedures were performed at the Brazilian agricultural level in potato and carrot samples; Validation methodology of the US Food and Drug Administration was adapted for the N-methylcarbamate analysis. Their recoveries ranged between 79 and 93% with coefficients of variation of 2.3-8%. (C) 1998 Elsevier B.V. B.V.

Exposure to pesticides, ill health and averting behaviour : costs and determining the relationship

Farmers' exposure to pesticides is high in developing countries. As a result many farmers suffer from ill-health, both short and long term. Deaths are not uncommon. This paper addresses this issue. Field survey data from Sri Lanka are used to estimate farmers' expenditure on defensive behavior (DE) and to determine factors that influence DE. The avertive behavior approach is used to estimate costs. Tobit regression analysis is used to determine factors that influence DE. Field survey data show that farmers' expenditures on DE are low. This is inversely related to high incidence of ill health among farmers using pesticides.

Determinants of health costs due to farmers’ exposure to pesticides : an empirical analysis

It is now well known that pesticide spraying by farmers has an adverse impact on their health. This is especially so in developing countries where pesticide spraying is undertaken manually. The estimated health costs are large. Studies to date have examined farmers’ exposure to pesticides, the costs of ill-health and their determinants based on information provided by farmers. Hence, some doubt has been cast on the reliability of such studies. In this study, we rectify this situation by conducting surveys among two groups of farmers. Farmers who perceive that their ill-health is due to exposure to pesticides and obtained treatment and farmers whose ill-health have been diagnosed by doctors and who have been treated in hospital for exposure to pesticides. In the paper, cost comparisons between the two groups of farmers are made. Furthermore, regression analysis of the determinants of health costs show that the quantity of pesticides used per acre per month, frequency of pesticide use and number of pesticides used per hour per day are the most important determinants of medical costs for both samples. The results have important policy implications.

Influence of parameters on the heterogeneous photocatalytic degradation of pesticides and phenolic contaminants in wastewater : a short review

In recent years, the application of heterogeneous photocatalytic water purification process has gained wide attention due to its effectiveness in degrading and mineralizing the recalcitrant organic compounds as well as the possibility of utilizing the solar UV and visible light spectrum. This paper aims to review and summarize the recently published works on the titanium dioxide (TiO2) photocatalytic oxidation of pesticides and phenolic compounds, predominant in storm and waste water effluents. The effect of various operating parameters on the photocatalytic degradation of pesticides and phenols are discussed. Results reported here suggested that the photocatalytic degradation of organic compounds depends on the type of photocatalyst and composition, light intensity, initial substrate concentration, amount of catalyst, pH of the reaction medium, ionic components in water, solvent types, oxidizing agents/electron acceptors, catalyst application mode, and calcinations temperature in water environment. A substantial amount of research has focused on the enhancement of TiO2 photocatalysis by modification with metal, non-metal and ion doping. Recent developments in TiO2 photocatalysis for the degradation of various pesticides and phenols are also highlighted in this review. It is evident from the literature survey that photocatalysis has shown good potential for the removal of various organic pollutants. However, still there is a need to find out the practical utility of this technique on commercial scale.

Recent developments in photocatalytic degradation of pesticides and phenols in storm and wastewater effluent

The heterogeneous photocatalytic oxidation process offers a versatile promise in the detoxification and disinfection of wastewater containing hazardous organic compounds such as pesticides and phenolic compounds in storm and wastewater effluent. This process has gained wide attention due to its effectiveness in degrading and mineralizing the organic compounds into harmless and often useful components. To develop an efficient photocatalytic process, titanium dioxide has been actively studied in recent years due to its excellent performance as a photocatalyst under UV light irradiation. This paper aims at critically evaluating and highlighting the recent developments of the heterogeneous photocatalytic systems with a special focus on storm and wastewater treatment applications.

Determinants of health costs due to farmers’ exposure to pesticides: an empirical analysis

Pesticide spraying by farmers has an adverse impact on their health. However, in studies to date examining farmers’ exposure to pesticides, the costs of ill health and their determinants have been based on information provided by farmers themselves. Some doubt has therefore been cast on the reliability of these estimates. In this study, we address this by conducting surveys among two groups of farmers who use pesticides on a regular basis. The first group is made up of farmers who perceive that their ill health is due to exposure to pesticides and have obtained at least some form of treatment (described in this article as the ‘general farmer group’). The second group is composed of farmers whose ill health has been diagnosed by doctors and who have been treated in hospital for exposure to pesticides (described here as the ‘hospitalised farmer group’). Cost comparisons are made between the two groups of farmers. Regression analysis of the determinants of health costs show that the most important determinants of medical costs for both samples are the defensive expenditure, the quantity of pesticides used per acre per month, frequency of pesticide use and number of pesticides used per hour per day. The results have important policy implications.

Temporal trend of organochlorine pesticides in Australia

Persistent, lipophilic organochlorine pesticides (OCPs) such as dichlorodiphenyltrichloroethane (DDT), hexachlorocyclohexanes (HCHs), dieldrin, chlordanes, hexachlorobenzene (HCB) and mirex are known to accumulate in human samples [1, 2]. Persistent OCPs are among the chemicals that are covered under the Stockholm Convention on persistent organic pollutants [3]. Exceptions to this include relatively less lipophillic compounds like HCH (KOW<10^5). In Australia, OCPs such as DDT and HCHs were introduced in the 1940s. This followed a period of widespread use until the 1970s when recognition of risks related to OCPs resulted in reduced use and their ultimate ban in the 1980s. Mirex, however, remained in very restricted use in Northern Australia for treatment of one species of termites (the Giant Termite (Mastotermes darwinensis)) but this use was phased out in 2007.

Decoration of titania nanofibres with anatase nanoparticles as efficient photocatalysts for decomposing pesticides and phenols

Using a series of partial phase transitions, an effective photocatalyst with fibril morphology was prepared. The catalytic activities of these materials were tested against phenol and herbicide in water. Both H-titanate and TiO2-(B) fibres decorated with anatase nanocrystals were studied. It was found that anatase coated TiO2-(B) fibres prepared by a 45 h hydrothermal treatment followed by calcination were not only superior photocatalysts but could also be readily separated from the slurry after photocatalytic reactions due to its fibril morphology.