Comparação de desempenho da deconvolução preditiva multicanal e da filtragem f-k na atenuação de múltiplas do fundo do mar

The seismic reflection is used on a large scale in oil exploration. In case of marine acquisition the presence of high impedance contrast at the interfaces water/air generates multiple reflections events. Such multiple events can mask primary events; thus from the interpretational viewpoint it is necessary to mitigate the multiples. In this manuscript we compare two methods of multiple attenuation: the predictive multichannel deconvolution (DPM) and the F-K filtering (FKF). DPM is based in the periodicity of the multiples while FKF is based in multiples and primaries splitting in F-K domain. DPM and FKF were applied in common-offset and CDP gathers, respectively. DPM is quite sensible to the correct identification of the period and size of the filter while FKF is quite sensible to an adequate choice of the velocity in order to split multiples and primaries events in the F-K domain. DPM is a method that is designed to act over a specific event. So, when the parameters are well selected, DPM is very efficient in removing the specified multiple. Then DPM can be optimized by applying it several times, each time with a different parameterization. A deficiency of DPM occurs when a multiple is superposed to a primary event: in this situation, DPM can attenuate also the primary event. On the other hand, FKF presents almost the same performance to all multiples that are localized in the same sector of the F-K domain. The two methods can be combined in order to take advantage of their associated potentials. In this situation, DPM is firstly applied, with a focus in the sea bed multiples. Then FKF is applied in order to attenuate the remaining multiples

How multiple repetitions influence the processing of self-, famous and unknown names and faces: an ERP study.

Because we live in an extremely complex social environment, people require the ability to memorize hundreds or thousands of social stimuli. The aim of this study was to investigate the effect of multiple repetitions on the processing of names and faces varying in terms of pre-experimental familiarity. We measured both behavioral and electrophysiological responses to self-, famous and unknown names and faces in three phases of the experiment (in every phase, each type of stimuli was repeated a pre-determined number of times). We found that the negative brain potential in posterior scalp sites observed approximately 170 ms after the stimulus onset (N170) was insensitive to pre-experimental familiarity but showed slight enhancement with each repetition. The negative wave in the inferior-temporal regions observed at approximately 250 ms (N250) was affected by both pre-experimental (famous>unknown) and intra-experimental familiarity (the more repetitions, the larger N250). In addition, N170 and N250 for names were larger in the left inferior-temporal region, whereas right-hemispheric or bilateral patterns of activity for faces were observed. The subsequent presentations of famous and unknown names and faces were also associated with higher amplitudes of the positive waveform in the central-parietal sites analyzed in the 320-900 ms time-window (P300). In contrast, P300 remained unchanged after the subsequent presentations of self-name and self-face. Moreover, the P300 for unknown faces grew more quickly than for unknown names. The latter suggests that the process of learning faces is more effective than learning names, possibly because faces carry more semantic information.

The cover basement contact beneath the Rawil axial depression (Western Alps) - True amplitude seismic processing, petrophysical properties, and modeling

Since 1986, several near-vertical seismic reflection profiles have been recorded in Switzerland in order to map the deep geologic structure of the Alps. One objective of this endeavour has been to determine the geometries of the autochthonous basement and of the external crystalline massifs, important elements for understanding the geodynamics of the Alpine orogeny. The PNR-20 seismic line W1, located in the Rawil depression of the western Swiss Alps, provides important information on this subject. It extends northward from the `'Penninic front'' across the Helvetic nappes to the Prealps. The crystalline massifs do not outcrop along this profile. Thus, the interpretation of `'near-basement'' reflections has to be constrained by down-dip projections of surface geology, `'true amplitude'' processing, rock physical property studies and modelling. 3-D seismic modelling has been used to evaluate the seismic response of two alternative down-dip projection models. To constrain the interpretation in the southern part of the profile, `'true amplitude'' processing has provided information on the strength of the reflections. Density and velocity measurements on core samples collected up-dip from the region of the seismic line have been used to evaluate reflection coefficients of typical lithologic boundaries in the region. The cover-basement contact itself is not a source of strong reflections, but strong reflections arise from within the overlaying metasedimentary cover sequence, allowing the geometry of the top of the basement to be determined on the basis of `'near-basement'' reflections. The front of the external crystalline massifs is shown to extend beneath the Prealps, about 6 km north of the expected position. A 2-D model whose seismic response shows reflection patterns very similar to the observed is proposed.

Atenuação de múltiplas pelo método WHLP-CRS

Nas bacias sedimentares da região Amazônica, a geração e o acúmulo de hidrocarboneto estão relacionados com a presença das soleiras de diabásio. Estas rochas magmáticas intrusivas possuem grandes contrastes de impedância com as rochas sedimentares encaixantes, resultando em múltiplas externas e internas, com amplitudes semelhantes às das reflexões sísmicas primárias. Estas múltiplas podem predominar sobre as informações oriundas de interfaces mais profundas, dificultando o processamento, a interpretação e o imageamento da seção de sísmica. O objetivo da presente tese é realizar a atenuação de múltiplas em seções sintéticas fontecomum (CS), através da combinação dos métodos Wiener-Hopf-Levinson de predição (WHLP) e o do empilhamento superfície-de-reflexão-comum (CRS), aqui denominando pela sigla WHLPCRS. O operador de deconvolução é calculado com as amplitudes reais do sinal sísmico e traço-a-traço, o que consideramos como uma melhor eficiência para a operação de atenuação. A identificação das múltiplas é feita na seção de afastamento-nulo (AN) simulada com o empilhamento CRS, utilizando o critério da periodicidade entre primária e suas múltiplas. Os atributos da frente de onda, obtidos através do empilhamento CRS, são utilizados na definição de janelas móveis no domínio tempo-espaço, e usados para calcular o operador WHLP-CRS. No desenvolvimento do presente trabalho, visamos evitar a inconveniência da seção processada ZO; desenhar e aplicar operadores na configuração CS; e estender o método WHL para camadas curvas.

Atenuação de ruídos coerentes utilizando decomposição em modos empíricos

The seismic processing technique has the main objective to provide adequate picture of geological structures from subsurface of sedimentary basins. Among the key steps of this process is the enhancement of seismic reflections by filtering unwanted signals, called seismic noise, the improvement of signals of interest and the application of imaging procedures. The seismic noise may appear random or coherent. This dissertation will present a technique to attenuate coherent noise, such as ground roll and multiple reflections, based on Empirical Mode Decomposition method. This method will be applied to decompose the seismic trace into Intrinsic Mode Functions. These functions have the properties of being symmetric, with local mean equals zero and the same number of zero-crossing and extremes. The developed technique was tested on synthetic and real data, and the results were considered encouraging

Atenuação de ruídos coerentes utilizando decomposição em modos empíricos

The seismic processing technique has the main objective to provide adequate picture of geological structures from subsurface of sedimentary basins. Among the key steps of this process is the enhancement of seismic reflections by filtering unwanted signals, called seismic noise, the improvement of signals of interest and the application of imaging procedures. The seismic noise may appear random or coherent. This dissertation will present a technique to attenuate coherent noise, such as ground roll and multiple reflections, based on Empirical Mode Decomposition method. This method will be applied to decompose the seismic trace into Intrinsic Mode Functions. These functions have the properties of being symmetric, with local mean equals zero and the same number of zero-crossing and extremes. The developed technique was tested on synthetic and real data, and the results were considered encouraging

Do seismic waves and fluid flow sense the same permeability?

We study the discrepancy between the effective flow permeability and the effective seismic permeability, that is, the effective permeability controlling seismic attenuation due to wave-induced fluid flow, in 2D rock samples having mesoscopic heterogeneities and in the presence of strong permeability fluctuations. In order to do so, we employ a numerical oscillatory compressibility test to determine attenuation and velocity dispersion due to wave-induced fluid flow in these kinds of media and compare the responses with those obtained by replacing the heterogeneous permeability field by constant values, including the average permeability as well as the effective flow permeability of the sample. The latter is estimated in a separate upscaling procedure by solving the steady-state flow equation in the rock sample under study. Numerical experiments let us verify that attenuation levels are less significant and the attenuation peak gets broader in the presence of such strong permeability fluctuations. Moreover, we observe that for very low frequencies the effective seismic permeability is similar to the effective flow permeability, while for very high frequencies it approaches the arithmetic average of the permeability field.

Supressão do ruído de rolamento superficial utilizando a transformada Curvelet

Among the many types of noise observed in seismic land acquisition there is one produced by surface waves called Ground Roll that is a particular type of Rayleigh wave which characteristics are high amplitude, low frequency and low velocity (generating a cone with high dip). Ground roll contaminates the relevant signals and can mask the relevant information, carried by waves scattered in deeper regions of the geological layers. In this thesis, we will present a method that attenuates the ground roll. The technique consists in to decompose the seismogram in a basis of curvelet functions that are localized in time, in frequency, and also, incorporate an angular orientation. These characteristics allow to construct a curvelet filter that takes in consideration the localization of denoise in scales, times and angles in the seismogram. The method was tested with real data and the results were very good

COX24 codes for a mitochondrial protein required for processing of the COX1 transcript

In most strains of Saccharomyces cerevisiae the mitochondrial gene COX1, for subunit 1 of cytochrome oxidase, contains multiple exons and introns. Processing of COX1 primary transcript requires accessory proteins factors, some of which are encoded by nuclear genes and others by reading frames residing in some of the introns of the COX1 and COB genes. Here we show that the low molecular weight protein product of open reading frame YLR204W, for which we propose the name COX24, is also involved in processing of COX1 RNA intermediates. The growth defect of cox24 mutants is partially rescued in strains harboring mitochondrial DNA lacking introns. Northern blot analyses of mitochondrial transcripts indicate cox24 null mutants to be blocked in processing of introns aI2 and aI3. The dependence of intron aI3 excision on Cox24p is also supported by the growth properties of the cox24 mutant harboring mitochondrial DNA with different intron compositions. The intermediate phenotype of the cox24 mutant in the background of intronless mitochondrial DNA, however, suggests that in addition to its role in splicing of the COX1 pre-mRNA, Cox24p still has another function. Based on the analysis of a cox14-cox24 double mutant, we propose that the other function of Cox24p is related to translation of the COX1 mRNA. © 2006 by The American Society for Biochemistry and Molecular Biology, Inc.

CRS seismic data imaging system: a case study for basib reevaluation

Este trabalho apresenta resultados práticos de uma atenção sistemática dada ao processamento e à interpretação sísmica de algumas linhas terrestres do conjunto de dados do gráben do Tacutu (Brasil), sobre os quais foram aplicadas etapas fundamentais do sistema WIT de imageamento do empilhamento CRS (Superfície de Reflexão Comum) vinculado a dados. Como resultado, esperamos estabelecer um fluxograma para a reavaliação sísmica de bacias sedimentares. Fundamentado nos atributos de frente de onda resultantes do empilhamento CRS, um macro-modelo suave de velocidades foi obtido através de inversão tomográfica. Usando este macro-modelo, foi realizado uma migração à profundidade pré- e pós-empilhamento. Além disso, outras técnicas baseadas no empilhamento CRS foram realizadas em paralelo como correção estática residual e migração de abertura-limitada baseada na zona de Fresnel projetada. Uma interpretação geológica sobre as seções empilhadas e migradas foi esboçada. A partir dos detalhes visuais dos painéis é possível interpretar desconformidades, afinamentos, um anticlinal principal falhado com conjuntos de horstes e grábens. Também, uma parte da linha selecionada precisa de processamento mais detalhado para evidenciar melhor qualquer estrutura presente na subsuperfície.

Avaliação geofísica e geológica de um porção de quebra de talude da Bacia do Jequitinhonha

A utilização dos métodos de reflexão sísmica na exploração e desenvolvimento de reservatórios de hidrocarbonetos ocorre devido à sua vasta e densa amostragem, tanto em área quanto em profundidade, aliada ao refinamento de técnicas para o tratamento dos dados de reflexão sísmica, a partir destes dados, são geradas seções sísmicas, que após a aplicação de tratamento adequado, são utilizadas na interpretação dos estratos e/ou estruturas geológicas da subsuperfície. Neste trabalho é feita uma análise Geofísica Geológica de duas linhas sísmicas reais 2D marinhas da porção de quebra de talude da Bacia do Jequitinhonha. Para tanto, foi realizado um conjunto de processamento sísmico com objetivo de atenuar as reflexões múltiplas comuns em dados marinhos, além disso, foram estimados os modelos de velocidade em profundidade, utilizados para determinação das seções sísmicas migradas em profundidade. Nestas foram identificadas as superfícies refletoras. Através da análise dessas superfícies foram feitas as marcações de sismofácies, com base nos conceitos iniciais da sismoestratigrafia, com a finalidade de avaliar a qualidade do produto derivado do processamento sísmico, empregado neste estudo, para uma interpretação sismoestratigráfica, a qual está fundamentada na análise dos padrões de terminações dos refletores e padrão interno das sismofácies.

Supressão do ruído de rolamento superficial utilizando a transformada Curvelet

Among the many types of noise observed in seismic land acquisition there is one produced by surface waves called Ground Roll that is a particular type of Rayleigh wave which characteristics are high amplitude, low frequency and low velocity (generating a cone with high dip). Ground roll contaminates the relevant signals and can mask the relevant information, carried by waves scattered in deeper regions of the geological layers. In this thesis, we will present a method that attenuates the ground roll. The technique consists in to decompose the seismogram in a basis of curvelet functions that are localized in time, in frequency, and also, incorporate an angular orientation. These characteristics allow to construct a curvelet filter that takes in consideration the localization of denoise in scales, times and angles in the seismogram. The method was tested with real data and the results were very good