Multi-harmonic optical comb generation

We present a novel optical comb generation technique based on the use of a multi-harmonic electrical signal for driving the MZM. The proposed scheme is highly power efficient and gives rise to square shaped combs of advanced flatness and side mode suppression ratio while maintaining a stable performance over a long time period. © 2012 OSA.

Study of AC losses in medium-sized high temperature superconducting coils

The study of AC losses in superconducting pancake coils is of utmost importance for the development of superconducting devices. Due to different technical difficulties this study is usually performed considering one of two approaches: considering superconducting coils of few turns and studying AC losses in a large frequency range vs. superconducting coils with a large number of turns but measuring AC losses only in low frequencies. In this work, a study of AC losses in 128 turn superconducting coils is performed, considering frequencies ranging from 50 Hz till 1152 Hz and currents ranging from zero till the critical current of the coils. Moreover, the study of AC losses considering two different simultaneous harmonic components is also performed and results are compared to the behaviour presented by the coils when operating in a single frequency regime. Different electrical methods are used to verify the total amount of AC losses in the coil and a simple calorimetric method is presented, in order to measure AC losses in a multi-harmonic context. Different analytical and numerical methods are implemented and/or used, to design the superconducting coils and to compute the total amount of AC losses in the superconducting system and a comparison is performed to verify the advantages and drawbacks of each method.

Fifth harmonic and sag impact on PMSG wind turbines with a balancing new strategy for capacitor voltages

This paper deals with the computing simulation of the impact on permanent magnet synchronous generator wind turbines due to fifth harmonic content and grid voltage decrease. Power converter topologies considered in the simulations are the two-level and the three-level ones. The three-level converters are limited by unbalance voltages in the DC-link capacitors. In order to lessen this limitation, a new control strategy for the selection of the output voltage vectors is proposed. Controller strategies considered in the simulation are respectively based on proportional integral and fractional-order controllers. Finally, a comparison between the results of the simulations with the two controller strategies is presented in order to show the main advantage of the proposed strategy. (C) 2014 Elsevier Ltd. All rights reserved.

Robust Adaptive Control with Applications to Multi-Agent Systems and Mobile Robotics

This thesis deals with robust adaptive control and its applications, and it is divided into three main parts. The first part is about the design of robust estimation algorithms based on recursive least squares. First, we present an estimator for the frequencies of biased multi-harmonic signals, and then an algorithm for distributed estimation of an unknown parameter over a network of adaptive agents. In the second part of this thesis, we consider a cooperative control problem over uncertain networks of linear systems and Kuramoto systems, in which the agents have to track the reference generated by a leader exosystem. Since the reference signal is not available to each network node, novel distributed observers are designed so as to reconstruct the reference signal locally for each agent, and therefore decentralizing the problem. In the third and final part of this thesis, we consider robust estimation tasks for mobile robotics applications. In particular, we first consider the problem of slip estimation for agricultural tracked vehicles. Then, we consider a search and rescue application in which we need to drive an unmanned aerial vehicle as close as possible to the unknown (and to be estimated) position of a victim, who is buried under the snow after an avalanche event. In this thesis, robustness is intended as an input-to-state stability property of the proposed identifiers (sometimes referred to as adaptive laws), with respect to additive disturbances, and relative to a steady-state trajectory that is associated with a correct estimation of the unknown parameter to be found.

Experimental Vibration Characteristics of a Beam with Nonlinear Support Using Receptance Coupling Analysis

This paper applies the Multi-Harmonic Nonlinear Receptance Coupling Approach (MUHANORCA) (Ferreira 1998) to evaluate the frequency response characteristics of a beam which is clamped at one end and supported at the other end by a nonlinear cubic stiffness joint. In order to apply the substructure coupling technique, the problem was characterised by coupling a clamped linear beam with a nonlinear cubic stiffness joint. The experimental results were obtained by a sinusoidal excitation with a special force control algorithm where the level of the fundamental force is kept constant and the level of the harmonics is kept zero for all the frequencies measured.

Evaluation of a treatment program for individuals with an intellectual disability who have high risk behaviours

In the past two decades numerous programs have emerged to treat individuals with developmental disabilities who have sexual offending behaviours. There has, however been very few studies that systematically examine the effectiveness of long term treatment with this population. The present research examines the therapeutic outcomes of a multi-modal behaviour approach with six individuals with intellectual disabilities previously charged with sexual assault. The participants also exhibited severe behavioural challenges that included verbal aggression, physical aggression, destruction and self-injury. These six participants (5 males, 1 female) were admitted to a Long Term Residential Treatment Program (LTRTP), due to the severity of their behaviours and due to their lack of treatment success in other programs. Individualized treatment plans focused on the reduction of maladaptive behaviours and the enhancing of skills such as positive coping strategies, socio-sexual knowledge, life skills, recreation and leisure skills. The treatment program also included psychiatric, psychological, medical, behavioural and educational interventions. The participants remained in the Long Term Residential Treatment Program (LTRTP) program from 181 to 932 days (average of 1.5 years). Pre and post treatment evaluations were conducted using the following tools: frequency of target behaviours, Psychopathology Inventory for Mentally Retarded Adults (PIMRA), Emotional Problems Scale (EPS), Socio-Sexual Knowledge and Attitudes Assessment Tool (SSKAAT-R) and Quality of Life Questionnaire (QOL-Q). Recidivism rates and the need for re-hospitalization were also noted for each participant. By offering high levels of individualized interventions, all six participants showed a 37 % rate of reduction in maladaptive behaviours with zero to low rates of inappropriate sexualbehaviour, there were no psychiatric hospitalizations, and there was no recidivism for 5 of 6 participants. In addition, medication was reduced. Mental health scores on the PIMRA were reduced across all participants by 25 % and scores on the Quality of Life Questionnaire increased for all participants by an average of 72 %. These findings add to and build upon the existing literature on long term treatment benefits for individuals with a intellectual disability who sexually offend. By utilizing an individualized and multimodal treatment approach to reduce severe behavioural challenges, not only can the maladaptive behaviours be reduced, but adaptive behaviours can be increased, mental health concerns can be managed, and overall quality of life can be improved.

A numerical model for the description of the nonlinear behaviour of multi-leaf masonry walls

A nonlinear finite element model was developed to simulate the nonlinear response of three-leaf masonry specimens, which were subjected to laboratory tests with the aim of investigating the mechanical behaviour of multiple-leaf stone masonry walls up to failure. The specimens consisted of two external leaves made of stone bricks and mortar joints, and an internal leaf in mortar and stone aggregate. Different loading conditions, typologies of the collar joints, and stone types were taken into account. The constitutive law implemented in the model is characterized by a damage tensor, which allows the damage-induced anisotropy accompanying the cracking process to be described. To follow the post-peak behaviour of the specimens with sufficient accuracy it was necessary to make the damage model non-local, to avoid mesh-dependency effects related to the strain-softening behaviour of the material. Comparisons between the predicted and measured failure loads are quite satisfactory in most of the studied cases. (c) 2007 Elsevier Ltd. All rights reserved.

Dynamical behaviour of multi-particle large-scale systems

Collective behaviours can be observed in both natural and man-made systems composed of a large number of elemental subsystems. Typically, each elemental subsystem has its own dynamics but, whenever interaction between individuals occurs, the individual behaviours tend to be relaxed, and collective behaviours emerge. In this paper, the collective behaviour of a large-scale system composed of several coupled elemental particles is analysed. The dynamics of the particles are governed by the same type of equations but having different parameter values and initial conditions. Coupling between particles is based on statistical feedback, which means that each particle is affected by the average behaviour of its neighbours. It is shown that the global system may unveil several types of collective behaviours, corresponding to partial synchronisation, characterised by the existence of several clusters of synchronised subsystems, and global synchronisation between particles, where all the elemental particles synchronise completely.

Egalitarian behaviour in multi unit combinatorial auctions

En entornos donde los recursos son precederos y la asignación de recursos se repite en el tiempo con el mismo conjunto o un conjunto muy similar de agentes, las subastas recurrentes pueden ser utilizadas. Una subasta recurrente es una secuencia de subastas donde el resultado de una subasta puede influenciar en las siguientes. De todas formas, este tipo de subastas tienen problemas particulares cuando la riqueza de los agentes esta desequilibrada y los recursos son precederos. En esta tesis se proponen algunos mecanismos justos o equitativos para minimizar los efectos de estos problemas. En una subasta recurrente una solución justa significa que todos los participantes consiguen a largo plazo sus objetivos en el mismo grado o en el grado más parecido posible, independientemente de su riqueza. Hemos demostrado experimentalmente que la inclusión de justicia incentiva a los bidders en permanecer en la subasta minimizando los problemas de las subastas recurrentes.

Behaviour Driven Development for Multi-Agent Systems

This paper presents a testing methodology to apply Behaviour Driven Development (BDD) techniques while developing Multi-Agent Systems (MAS), so called BEhavioural Agent Simple Testing (BEAST) methodology. It is supported by the developed open source framework (BEAST Tool) which automatically generates test cases skeletons from BDD scenarios specifications. The developed framework allows testing MASs based on JADE or JADEX platforms and offers a set of configurable Mock Agents which allow the execution of tests while the system is under development. BEAST tool has been validated in the development of a MAS for fault diagnosis in FTTH (Fiber To The Home) networks.