Biohydrogen production in anaerobic fluidized bed reactors: Effect of support material and hydraulic retention time

This study evaluated two different support materials (polystyrene and expanded clay) for biohydrogen production in an anaerobic fluidized bed reactor (AFBR) treating synthetic wastewater containing glucose (4000 mg L(-1)). The AFBRs contained either polystyrene (R1) or expanded clay (R2) as support materials were inoculated with thermally pre-treated anaerobic sludge and operated at a temperature of 30 degrees C and a pH of approximately 5.5. The AFBRs were operated with a range of hydraulic retention times (HRTs) between 1 and 8 h. For R1 with an HRT of 2 h, the maximum hydrogen yield (HY) was 1.90 mol H(2) mol(-1) glucose, with 0.805 mg of biomass (as total volatile solids, or TVS) attached to each g of polystyrene. For R2 operated at an HRT of 2 h, the maximum HY was 2.59 mol H(2) moll glucose, with 1.100 mg of attached biomass (as TVS) g(-1) expanded clay. The highest hydrogen production rates (HPR) were 0.95 and 1.21 L h(-1) L(-1) for R1 and R2, respectively, using an HRT of 1 h. The H(2) content increased from 16-47% for R1 and from 22-51% for R2. No methane was detected in the biogas produced throughout the period of AFBR operation. These results show that the values of HY, HPR, H(2) content, and g of attached biomass g(-1) support material were all higher for AFBRs containing expanded clay than for reactors containing polystyrene. (C) 2010 Professor T. Nejat Veziroglu. Published by Elsevier Ltd. All rights reserved.

Development and Validation of a Simple Method for Routine Analysis of Ractopamine Hydrochloride in Raw Material and Feed Additives by HPLC

A simple method was optimized and validated for determination of ractopamine hydrochloride (RAC) in raw material and feed additives by HPLC for use in quality control in veterinary industries. The best-optimized conditions were a C8 column (250 x 4.6 mm id, 5.0 mu m particle size) at room temperature with acetonitrile-100 mM sodium acetate buffer (pH 5.0; 75 + 25, v/v) mobile phase at a flow rate of 1.0 mL/min and UV detection at 275 nm. With these conditions, the retention time of RAC was around 5.2 min, and standard curves were linear in the concentration range of 160-240 mu g/mL (correlation coefficient >= 0.999). Validation parameters, such as selectivity, linearity, limit of detection (ranged from 1.60 to 2.05 mu g/mL), limit of quantification (ranged from 4.26 to 6.84 mu g/mL), precision (relative standard deviation <= 1.87%), accuracy (ranged from 96.97 to 100.54%), and robustness, gave results within acceptable ranges. Therefore, the developed method can be successfully applied for the routine quality control analysis of raw material and feed additives.

Synthesis of titanate nanostructures using amorphous precursor material and their adsorption/photocatalytic properties

This article reports on a new and swift hydrothermal chemical route to prepare titanate nanostructures (TNS) avoiding the use of crystalline TiO2 as starting material. The synthesis approach uses a commercial solution of TiCl3 as titanium source to prepare an amorphous precursor, circumventing the use of hazardous chemical compounds. The influence of the reaction temperature and dwell autoclave time on the structure and morphology of the synthesised materials was studied. Homogeneous titanate nanotubes with a high length/diameter aspect ratio were synthesised at 160 degrees C and 24 h. A band gap of 3.06 +/- 0.03 eV was determined for the TNS samples prepared in these experimental conditions. This value is red shifted by 0.14 eV compared to the band gap value usually reported for the TiO2 anatase. Moreover, such samples show better adsorption capacity and photocatalytic performance on the dye rhodamine 6G (R6G) photodegradation process than TiO2 nanoparticles. A 98% reduction of the R6G concentration was achieved after 45 min of irradiation of a 10 ppm dye aqueous solution and 1 g L-1 of TNS catalyst.

Estudio de la micobiota y sus micotoxinas en ingredientes y raciones de animales domésticos. Estrategias orientadas a la prevención de las micotoxicosis. Studies on mycobiota and incidence of mycotoxins in raw material and feedstuff for domestic animals. Different strategies for mycotoxicosis prevention.

Numerosas investigaciones han desarrollado estrategias para la remoción de micotoxinas en alimentos por diferentes métodos, aunque muchos de ellos no han llegado a ser utilizados debido a los elevados costos o a las dificultades prácticas involucradas en el proceso de detoxificación. Estos argumentos estimulan a los investigadores a desarrollar nuevas estrategias de decontaminación que eviten el uso de agentes químicos y que reduzcan las pérdidas en el valor nutritivo y la palatabilidad de los alimentos decontaminados. Una de las alternativas promisorias es la detoxificación biológica. Las levaduras capaces de adsorber micotoxinas y con habilidades probióticas o prebióticas son promisorias para reducir la exposición humana a las micotoxinas. En el tracto gastrointestinal se encuentra normalmente un gran número de especies de bacterias comensales y patógenas; sin embargo, cuando se incrementa la cantidad de microorganismos patógenos se pueden producir alteraciones de la salud y muerte. La industria argentina de alimentos destinados a animales necesita reducir los niveles de micotoxinas presentes en ingredientes o en insumos terminados. Si bien los resultados obtenidos en el mundo en la temática son preliminares y promisorios, en nuestro país aún no se han desarrollado estrategias biológicas de decontaminación de micotoxinas aplicadas a estos alimentos. Estudios de incidencia de micoflora y detección de micotoxinas en alimentos balanceados para aves, llevados a cabo por nuestro grupo de investigación en la región del sur de Córdoba demostraron la presencia de los principales géneros toxicogénicos (Aspergillus, Penicillium y Fusarium) y sus micotoxinas asociadas (aflatoxinas, zearalenona y fumonisinas). En relación a porcinotecnia, la zona sur de la provincia de Córdoba es considerada una de las tres zonas de mayor densidad porcina en Argentina. Sin embargo, la contaminación de los granos con micotoxinas representa un serio problema debido a que producen rechazo del alimento, disminución de la tasa de crecimiento y reducción inmunológica. Si consideramos la evolución en la producción lechera en los últimos años ha seguido una línea de intensificación que ha conllevado un cambio en la utilización de los alimentos, evolucionando del simple pastoreo a los sistemas de alimentación única, basados en la formulación de alimentos balanceados que constituyen la clave de la alimentación de los animales. Diferentes estudios epidemiológicos usando técnicas moleculares han demostrado que con frecuencia la infección por A. fumigatus ocurre como consecuencia de la adquisición exógena del hongo. La magnitud del problema se manifiesta en la continua búsqueda de medidas de prevención y control de estas micotoxicosis. Debido a este impacto negativo que ejercen las toxinas fúngicas lo cual, afecta los parámetros productivos como ganancia de peso y conversión alimenticia con graves pérdidas a la industria animal tanto en el mercado interno como externo.

Anthropometric observations on the Eskimos and Indians of Labrador / by T. Dale Stewart --. Material and data collected by William Duncan Strong --. Chicago, 1939.

v.31:no.1(1939)

Statistical similarity between the compression of a porous material and earthquakes

It has been long stated that there are profound analogies between fracture experiments and earthquakes; however, few works attempt a complete characterization of the parallelisms between these so separate phenomena. We study the Acoustic Emission events produced during the compression of Vycor (SiO&sub&2&/sub&). The Gutenberg-Richter law, the modified Omori's law, and the law of aftershock productivity hold for a minimum of 5 decades, are independent of the compression rate, and keep stationary for all the duration of the experiments. The waiting-time distribution fulfills a unified scaling law with a power-law exponent close to 2.45 for long times, which is explained in terms of the temporal variations of the activity rate.

Material and Construction Optimization for Prevention of Premature Pavement Distress in PCC Pavements, September 2004

The chemistry of today’s concrete mixture designs is complicated by many variables, including multiple sources of aggregate and cements and a plethora of sometimes incompatible mineral and chemical admixtures. Concrete paving has undergone significant changes in recent years as new materials have been introduced into concrete mixtures. Supplementary cementitious materials such as fly ash and ground granulated blast furnace slag are now regularly used. In addition, many new admixtures that were not even available a few years ago now have widespread usage. Adding to the complexity are construction variables such as weather, mix delivery times, finishing practices, and pavement opening schedules. Mixture materials, mix design, and pavement construction are not isolated steps in the concrete paving process. Each affects and is affected by the other in ways that determine overall pavement quality and long-term performance. Equipment and procedures commonly used to test concrete materials and concrete pavements have not changed in decades, leaving serious gaps in our ability to understand and control the factors that determine concrete durability. The concrete paving community needs tests that will adequately characterize the materials, predict interactions, and monitor the properties of the concrete.

Variations on the nutritional status of eucalypt as influenced by the genetic material and age of tree

The Diagnosis and Recommendation System (DRIS) was applied to eucalypt trees (hybrids of Eucalyptus grandis x E. urophylla) with different ages and growing under different environmental conditions for three different clones. The basic data were obtained from 1,986 trees of commercial stands cultivated in the states of Espírito Santo and south Bahia, Brazil. The DRIS indices were calculated using the Beaufils' Range formula and grouped according to the Nutrient Application Potential Response method. The objective of this paper was to evaluate the N, P and Ca status in eucalypt trees, regarding the tree ages and genetic materials. The DRIS indices discriminated differences in the nutritional status of the trees, both in relation to age and the genetic materials (clones). The results indicated that the deficiency of N and Ca tended to decrease with tree age, whereas the P deficiency tended to increase. Furthermore, of the three evaluated clones, those numbered 00014 and 00034 showed opposite trends regarding to N, P, and Ca nutrition, and the clone numbered 00021, in general, presented the highest degree of unbalanced nutrition of N, P and Ca.

Material and Construction Optimization for Prevention of Premature Pavement Distress in PCC Pavements, Phase III Final Report, 2008

Mixture materials, mix design, and pavement construction are not isolated steps in the concrete paving process. Each affects the other in ways that determine overall pavement quality and long-term performance. However, equipment and procedures commonly used to test concrete materials and concrete pavements have not changed in decades, leaving gaps in our ability to understand and control the factors that determine concrete durability. The concrete paving community needs tests that will adequately characterize the materials, predict interactions, and monitor the properties of the concrete. The overall objectives of this study are (1) to evaluate conventional and new methods for testing concrete and concrete materials to prevent material and construction problems that could lead to premature concrete pavement distress and (2) to examine and refine a suite of tests that can accurately evaluate concrete pavement properties. The project included three phases. In Phase I, the research team contacted each of 16 participating states to gather information about concrete and concrete material tests. A preliminary suite of tests to ensure long-term pavement performance was developed. The tests were selected to provide useful and easy-to-interpret results that can be performed reasonably and routinely in terms of time, expertise, training, and cost. The tests examine concrete pavement properties in five focal areas critical to the long life and durability of concrete pavements: (1) workability, (2) strength development, (3) air system, (4) permeability, and (5) shrinkage. The tests were relevant at three stages in the concrete paving process: mix design, preconstruction verification, and construction quality control. In Phase II, the research team conducted field testing in each participating state to evaluate the preliminary suite of tests and demonstrate the testing technologies and procedures using local materials. A Mobile Concrete Research Lab was designed and equipped to facilitate the demonstrations. This report documents the results of the 16 state projects. Phase III refined and finalized lab and field tests based on state project test data. The results of the overall project are detailed herein. The final suite of tests is detailed in the accompanying testing guide.