Using hybrid knowledge engineering and image processing in color virtual restoration of ancient murals

IEEE Transactions on Knowledge and Data Engineering, vol. 15, no. 5, pp. 1338-1343, 2003.

Dual-DSP system for signal and image processing

The design of a dual-DSP microprocessor system and its application for parallel FFT and two-dimensional convolution are explained. The system is based on a master-salve configuration. Two ADSP-2101s are configured as slave processors and a PC/AT serves as the master. The master serves as a control processor to transfer the program code and data to the DSPs. The system architecture and the algorithms for the two applications, viz. FFT and two-dimensional convolutions, are discussed.

BIT-LEVEL SYSTOLIC ARRAYS FOR SIGNAL AND IMAGE PROCESSING.

This paper describes the design and the architecture of a bit-level systolic array processor. The bit-level systolic array described is directly applicable to a wide range of image processing operations where high performance and throughput are essential. The architecture is illustrated by describing the operation of the correlator and convolver chips which are being developed. The advantage of the system is also discussed.

Microstructural analysis of non-woven fabrics using scanning electron microscopy and image processing. Part 1:Development and verification of the methods

This paper reports image analysis methods that have been developed to study the microstructural changes of non-wovens made by the hydroentanglement process. The validity of the image processing techniques has been ascertained by applying them to test images with known properties. The parameters in preprocessing of the scanning electron microscope (SEM) images used in image processing have been tested and optimized. The fibre orientation distribution is estimated using fast Fourier transform (FFT) and Hough transform (HT) methods. The results obtained using these two methods are in good agreement. The HT method is more demanding in computational time compared with the Fourier transform (FT) method. However, the advantage of the HT method is that the actual orientation of the lines can be concluded directly from the result of the transform without the need for any further computation. The distribution of the length of the straight fibre segments of the fabrics is evaluated by the HT method. The effect of curl of the fibres on the result of this evaluation is shown.