Self-organized criticality in MHD driven plasma edge turbulence

We analyze long-range time correlations and self-similar characteristics of the electrostatic turbulence at the plasma edge and scrape-off layer in the Tokamak Chauffage Alfven Bresillien (TCABR), with low and high Magnetohydrodynamics (MHD) activity. We find evidence of self-organized criticality (SOC), mainly in the region near the tokamak limiter. Comparative analyses of data before and during the MHD activity reveals that during the high mHD activity the Hurst parameter decreases. Finally, we present a cellular automaton whose parameters are adjusted to simulate the analyzed turbulence SOC change with the MHD activity variation. (C) 2011 Published by Elsevier B.V.

Long-distance correlations in TCABR biasing experiments

Long-distance correlations (LDCs) of plasma potential fluctuations in the plasma edge have been investigated in the TCABR tokamak in the regime of edge biasing H-mode using an array of multi-pin Langmuir probes. This activity was carried out as part of the scientific programme of the 4th IAEA Joint Experiment (2009). The experimental data confirm the effect of amplification of LDCs in potential fluctuations during biasing recently observed in stellarators and tokamaks. For long toroidal distances between probes, the cross-spectrum is concentrated at low frequencies f < 60 kHz with peaks at f < 5 kHz, f = 13-15 kHz and f similar to 40 kHz and low wave numbers with a maximum at k = 0. The effects of MHD activity on the LDCs in potential fluctuation are investigated.

Estudo de efeitos da polarização eletrostática periférica no Tokamak TCABR

Efeitos da polarização eletrostática de eletrodos na periferia de tokamaks têm sido investigados em pequenos tokamaks e mesmo em alguns tokamaks de grande porte. Em geral as experiências são realizadas em condições em que bifurcação do campo elétrico radial é obtida, processo este identificado como modo H de polarização. No Tokamak TCABR, as experiências indicam que o confinamento aumenta para tensões aplicadas até +300 volts, atingindo um máximo de duas vezes o tempo de confinamento do modo L, mas sem bifurcação. Indícios de bifurcação foram notados com +400 V de polarização, mas a descarga termina devido à excitação da atividade MHD, ainda sob investigação. No presente trabalho, a pesquisa é aprofundada com a utilização de uma sonda de Langmuir com 18 pinos dispostos em duas fileiras sob a forma de um ancinho (rake probe) o que permite a medição da temperatura, densidade e flutuação de potencial ao longo do raio menor na periferia do Tokamak. A resolução temporal desse sistema é de cerca de 0,5 ms, para a temperatura, e 5 microssegundos para densidade e potencial flutuante do plasma. Outra sonda eletrostática com 5-pinos na mesma posição radial, mas em diferentes posições poloidal e toroidal foi usada para medições de turbulência e transporte de partículas. Os efeitos da polarização foram investigados e indicam que os níveis de turbulência e transporte começam a diminuir entre +150 e +200 V e para +300 V chegam a atingir uma quase supressão. Nesse mesmo intervalo de tensão a densidade começa a aumentar e para +300 V chega a ser um fator de aproximadamente 2. Quanto ao perfil de temperatura a variação é pouco significativa, mas as incertezas das medidas são maiores. Esses dados são compatíveis com a criação de uma barreira de transporte na região entre o eletrodo em r = 17 cm e o limitador em a = 18 cm. Além disso, o campo elétrico radial mostra forte cisalhamento nessa região. Tomando o início da subida do potencial flutuante como origem de uma escala de tempo, o atraso temporal do início da subida da densidade de elétrons e o atraso do início do decréscimo do transporte de partículas foram medidos. Os resultados são 50 microssegundos para a densidade de elétrons e 60 microssegundos para o transporte de partículas. A questão dos limiares de potência é discutida no texto. Os dados desta experiência indicam que o campo elétrico radial desempenha o papel principal para a melhoria do confinamento.

The development and validation of computational MHD techniques for the modelling of metal production processes

Magnetic fields are used in a number of processes related to the extraction of metals, production of alloys and the shaping of metal components. Computational techniques have an increasingly important role to play in the simulation of such processes, since it is often difficult or very costly to conduct experiments in the high temperature conditions encountered and the complex interaction of fluid flow, heat transfer and magnetic fields means simple analytic models are often far removed from reality. In this paper an overview of the computational activity at the University of Greenwich is given in this area, covering the past ten years. The overview is given from the point of view of the modeller and within the space limitations imposed by the format it covers the numerical methods used, attempts at validation against experiments or analytic procedures; it highlights successes, but also some failures. A broad range of models is covered in the review (and accompanying lecture), used to simulate (a) A-C field applications: induction melting, magnetic confinement and levitation, casting and (b) D-C field applications such as: arc welding and aluminium electroloysis. Most of these processes involve phase change of the metal (melting or solidification), the presence of a dynamic free surface and turbulent flow. These issues affect accuracy and need to be address by the modeller.

Modélisation MHD tridimensionnelle de tubes de flux coronaux utilisant l'assimilation des donnés 4D-VAR

Mémoire numérisé par la Division de la gestion de documents et des archives de l'Université de Montréal

Ground-based and satellite observations of high-latitude auroral activity in the dusk sector of the auroral oval

On 7 December 2000, during 13:30-15:30 UT the MIRACLE all-sky camera at Ny Alesund observed auroras at high-latitudes (MLAT similar to 76) simultaneously when the Cluster spacecraft were skimming the magnetopause in the same MLT sector (at similar to 16:00-18:00 MLT). The location of the auroras (near the ionospheric convection reversal boundary) and the clear correlation between their dynamics and IMF variations suggests their close relationship with R1 currents. Consequently, we can assume that the Cluster spacecraft were making observations in the magnetospheric region associated with the auroras, although exact magnetic conjugacy between the ground-based and satellite observations did not exist. The solar wind variations appeared to control both the behaviour of the auroras and the magnetopause dynamics. Auroral structures were observed at Ny Alesund especially during periods of negative IMF B-Z. In addition, the Cluster spacecraft experienced periodic (T similar to 4 - 6 min) encounters between magnetospheric and magnetosheath plasmas. These undulations of the boundary can be interpreted as a consequence of tailward propagating magnetopause surface waves. Simultaneous dusk sector ground-based observations show weak, but discernible magnetic pulsations (Pc 5) and occasionally periodic variations (T - 2 - 3 min) in the high-latitude auroras. In the dusk sector, Pc 5 activity was stronger and had characteristics that were consistent with a field line resonance type of activity. When IMF BZ stayed positive for a longer period, the auroras were dimmer and the spacecraft stayed at the outer edge of the magnetopause where they observed electromagnetic pulsations with T similar to 1 min. We find these observations interesting especially from the viewpoint of previously presented studies relating poleward-moving high-latitude auroras with pulsation activity and MHD waves propagating at the magnetospheric boundary layers.

Batroxase, a new metalloproteinase from B. atrox snake venom with strong fibrinolytic activity

The structures and functional activities of metalloproteinases from snake venoms have been widely studied because of the importance of these molecules in envenomation. Batroxase, which is a metalloproteinase isolated from Bothrops atrox (Para) snake venom, was obtained by gel filtration and anion exchange chromatography. The enzyme is a single protein chain composed of 202 amino acid residues with a molecular mass of 22.9 kDa, as determined by mass spectrometry analysis, showing an isoelectric point of 7.5. The primary sequence analysis indicates that the proteinase contains a zinc ligand motif (HELGHNLGISH) and a sequence C164I165M166 motif that is associated with a "Met-turn" structure. The protein lacks N-glycosylation sites and contains seven half cystine residues, six of which are conserved as pairs to form disulfide bridges. The three-dimensional structure of Batroxase was modeled based on the crystal structure of BmooMP alpha-I from Bothrops moojeni. The model revealed that the zinc binding site has a high structural similarity to the binding site of other metalloproteinases. Batroxase presented weak hemorrhagic activity, with a MHD of 10 mu g, and was able to hydrolyze extracellular matrix components, such as type IV collagen and fibronectin. The toxin cleaves both a and beta-chains of the fibrinogen molecule, and it can be inhibited by EDTA. EGTA and beta-mercaptoethanol. Batroxase was able to dissolve fibrin clots independently of plasminogen activation. These results demonstrate that Batroxase is a zinc-dependent hemorrhagic metalloproteinase with fibrin(ogen)olytic and thrombolytic activity. Published by Elsevier Ltd.

Plasma environment of a weak comet – Predictions for Comet 67P/Churyumov–Gerasimenko from multifluid-MHD and Hybrid models

The interaction of a comet with the solar wind undergoes various stages as the comet’s activity varies along its orbit. For a comet like 67P/Churyumov–Gerasimenko, the target comet of ESA’s Rosetta mission, the various features include the formation of a Mach cone, the bow shock, and close to perihelion even a diamagnetic cavity. There are different approaches to simulate this complex interplay between the solar wind and the comet’s extended neutral gas coma which include magnetohydrodynamics (MHD) and hybrid-type models. The first treats the plasma as fluids (one fluid in basic single fluid MHD) and the latter treats the ions as individual particles under the influence of the local electric and magnetic fields. The electrons are treated as a charge-neutralizing fluid in both cases. Given the different approaches both models yield different results, in particular for a low production rate comet. In this paper we will show that these differences can be reduced when using a multifluid instead of a single-fluid MHD model and increase the resolution of the Hybrid model. We will show that some major features obtained with a hybrid type approach like the gyration of the cometary heavy ions and the formation of the Mach cone can be partially reproduced with the multifluid-type model.