Envelope Addressed to Noah Phelps, Lincoln Paper Mill Co.

Envelope addressed to Noah Phelps, Lincoln Paper Mill Co. with no postmarks, Merritton [In about 1877 Noah Phelps, Samuel Woodruff, Partrick Joseph Larkin and John Conlon were involved in the founding of a paper mill with Sylvester Neelon], n.d.

Determination of aliphatic amines from soil and wastewater of a paper mill by pre-column derivatization using HPLC and tandem mass spectrometry (HPLC-MS/MS)

A pre-column derivatization method for the sensitive determination of aliphatic amines using the labeling reagent 1,2-benzo-3,4-dihydrocarbazole-9-ethyl chloroformate (BCEOC) followed by HPLC with fluorescence detection and APCI/NIS identification in positive-ion mode has been developed. The chromophore of 2-(9-carbazole)-ethyl chloroformate (CEOC) reagent was replaced by the 1,2-benzo-3,4-dihydrocarbazole functional group, which resulted in a sensitive fluorescence derivatizing reagent, BCEOC, that could easily and quickly label amines. Derivatives were stable enough to be efficiently analyzed by HPLC and showed an intense protonated molecular ion corresponding m/z [M + H](+) with APCI/MS in positive-ion mode. The collision induced dissociation of the protonated molecular ion formed characteristic fragment ions at m/z 264.1, m/z 246.0 and m/z 218.1, corresponding to the cleavages of CH2CH2O-CO, CH2CH2-OCO, and N-CH2CH2O bonds. Studies on derivatization conditions demonstrated that excellent derivatization yields close to 100% were observed with a 3 to 4-fold molar reagent excess in acetonitrile solvent, in the presence of borate buffer (pH 9.0) at 40 degrees C for 10 min. In addition, the detection responses for BCEOC derivatives were compared with those obtained with CEOC and FMOC as labeling reagents. The ratios I-BCEOC/I-CEOC and I-BCEOC/I-FMOC were, respectively, 1.40-2.76 and 1.36-2.92 for fluorescence responses (here, I was the relative fluorescence intensity). Separation of the amine derivatives had been optimized on an Eclipse XDB-C-8 column. Detection limits calculated from an 0.10 pmol injection, at a signal-to-noise ratio of 3, were 18.65-38.82 fmol (injection volume 10 mu L for fluorescence detection. The relative standard deviations for intraday determination (n = 6) of standard amine derivatives (50 pmol) were 0.0063-0.037% for retention times and 3.36-6.93% for peak areas. The mean intra-and inter-assay precision for all amines were <5.4% and 5.8%, respectively. The recoveries of amines ranged from 96 to 113%. Excellent linear responses were observed with correlation coefficients of >0.9994. The established method provided a simple and highly sensitive technique for the quantitative analysis of trace amounts of aliphatic amines from biological and natural environmental samples.

The paper mill chemist,

Mode of access: Internet.

Optimisation of fuel usage and steam availability in the power and steam plant of a paper mill

This paper presents the results of a project aimed at minimising fuel usage while maximising steam availability in the power and steam plant of a large newsprint mill. The approach taken was to utilise the better regulation and plant wide optimisation capabilities of Advanced Process Control, especially Model Predictive Control (MPC) techniques. These have recently made their appearance in the pulp and paper industry but are better known in the oil and petrochemical industry where they have been used for nearly 30 years. The issue in the power and steam plant is to ensure that sufficient steam is available when the paper machines require it and yet not to have to waste too much steam when one or more of the machines suffers an outage. This is a problem for which MPC is well suited. It allows variables to be kept within declared constraint ranges, a feature which has been used, effectively, to increase the steam storage capacity of the existing plant. This has resulted in less steam being condensed when it is not required and in significant reductions in the need for supplementary firing. The incidence of steam being dump-condensed while also supplementary firing the Combined Heat & Power (CHP) plant has been reduced by 95% and the overall use of supplementary firing is less than 30% of what it was. In addition the plant runs more smoothly and requires less operator time. The yearly benefit provided by the control system is greater than £200,000, measured in terms of 2005 gas prices.

The application of colloidal gas aphrons in the recovery of fine cellulose fibres from paper mill wastewater

Colloidal gas aphrons (CGAs) are micron-sized gas bubbles of 25–30 µm in diameter produced by a high-speed stirrer in a vessel containing dilute surfactant solution. These bubbles, because of their small size, exhibit some colloidal properties. In this work, CGAs were used to separate fine fibres from a lean slurry of cellulosic pulp in a flotation column. The pulp fibres were recovered as foamate from the top. Sodium dodecyl sulphate at a concentration of 2.0 kg/m3 was used as a surfactant to generate the CGAs in a spinning disc apparatus. The results indicated that up to 70% flotation efficiency could be obtained within a short column height of 0.3–0.35 m. This technique can be applied to recover fine cellulosic pulp from paper-machine backwater.

A comparative study of biopolymers and alum in the separation and recovery of pulp fibres from paper mill effluent by flocculation

Recovery of cellulose fibres from paper mill effluent has been studied using common polysaccharides or biopolymers such as Guar gum, Xanthan gum and Locust bean gum as flocculent. Guar gum is commonly used in sizing paper and routinely used in paper making. The results have been compared with the performance of alum, which is a common coagulant and a key ingredient of the paper industry. Guar gum recovered about 3.86 mg/L of fibre and was most effective among the biopolymers. Settling velocity distribution curves demonstrated that Guar gum was able to settle the fibres faster than the other biopolymers; however, alum displayed the highest particle removal rate than all the biopolymers at any of the settling velocities. Alum, Guar gum, Xanthan gum and Locust bean gum removed 97.46%, 94.68%, 92.39% and 92.46% turbidity of raw effluent at a settling velocity of 0.5 cm/min, respectively. The conditions for obtaining the lowest sludge volume index such as pH, dose and mixing speed were optimised for guar gum which was the most effective among the biopolymers. Response surface methodology was used to design all experiments, and an optimum operational setting was proposed. The test results indicate similar performance of alum and Guar gum in terms of floc settling velocities and sludge volume index. Since Guar gum is a plant derived natural substance, it is environmentally benign and offers a green treatment option to the paper mills for pulp recycling.

Certificate for One Thousand Shares of Capital Stock in Lincoln-Nipissing Development Co. Ltd.

Certificate for 1,000 shares of capital stock in Lincoln-Nipissing Development Co. Ltd. to Hamilton K. Woodruff, Feb. 21, 1907.

Letter on Long Point Company letterhead addressed to W.D. Woodruff of Lincoln Paper Mills

Letter on Long Point Company letterhead addressed to W.D. Woodruff of Lincoln Paper Mills, Merritton, Ontario in which Frank Reid, secretary of Long Point Company encloses a copy of the by-laws and the dates of incorporation, as requested (1 page, typed) [by-laws are not included here], Jan. 18, 1916.

Letter to Mr. W.D. Woodruff of Lincoln Paper Mills, Merritton from P.J. Price of the United Gas Companies

Letter to Mr. W.D. Woodruff of Lincoln Paper Mills, Merritton from P.J. Price of the United Gas Companies, St. Catharines regarding a cheque received from E.J. McIntyre for $200. Included with this letter is an envelope addressed to W.D. Woodruff, Dec. 27, 1910.

Letter to the Estate of W.D. Woodruff from S. Mitchell, secretary of the Lincoln Paper Mills Company

Letter to the Estate of W.D. Woodruff from S. Mitchell, secretary of the Lincoln Paper Mills Company (1 page, printed). This is a notice of the 43rd annual meeting of the shareholders of the Lincoln Paper Mills Company, Limited. This is accompanied by an envelope, Feb. 7, 1921.

Letter to Mrs. A.L. Woodruff from S. Mitchell, secretary of the Lincoln Paper Mills Company

Letter to Mrs. A.L. Woodruff from S. Mitchell, secretary of the Lincoln Paper Mills Company (1 page, printed). This is a notice of the 43rd annual meeting of the shareholders of the Lincoln Paper Mills Company, Limited. This is accompanied by an envelope, Feb. 7, 1921.

Letter to Dr. T.A. Woodruff from S. Mitchell, secretary of the Lincoln Paper Mills Company

Letter to Dr. T.A. Woodruff from S. Mitchell, secretary of the Lincoln Paper Mills Company (1 page, printed). This is a notice of the 43rd annual meeting of the shareholders of the Lincoln Paper Mills Company, Limited. This is accompanied by an envelope, Feb. 7, 1921.

Allocation of GHG emissions in a paper mill, an application tool to reduce emissions

El sector de pasta i paper és considerat un dels set sectors industrials més intensius en consum energètic. La producció i consum d'electricitat i de vapor esdevenen les fonts majoritàries d'emissions de gasos d'efecte hivernacle en aquest sector industrial. Les fàbriques papereres poden assolir objectius de reducció d'emissions mitjançant reducció en origen (substitució de combustibles, introducció d'energies renovables) o bé a partir de mesures d'eficiència energètica en el propi procés. En aquest context, s'ha desenvolupat un mètode de distribució d'emissions que permet assignar a cada unitat d'operació del procés paperer, el seu grau de responsabilitat en emissions. També s'han avaluat diferents mètodes de càlcul de factors d'emissió de vapor i electricitat, tant per plantes de cogeneració com per sistemes individuals. A partir d'aquesta avaluació s'han proposat nous mètodes alternatius als analitzats. Aquests mètodes i els factors d'emissions s'han aplicat a dues fàbriques papereres catalanes.