Load leveling in LV network using coordianted Energy Storage Units

This paper proposes a new distributed coordination approach to make load leveling, using Energy Storage Units (ESUs) in LV network. The proposed distributed control strategy is based on consensus algorithm which shares the required active power equally among the ESUs with respect to their rating. To show the effectiveness of the proposed approach, a typical radial LV network is simulated as a case study.

A supervisory load-leveling approach to improve the voltage profile in distribution network

This paper suggests a supervisory control for storage units to provide load leveling in distribution networks. This approach coordinates storage units to charge during high generation and discharge during peak load times, while utilized to improve the network voltage profile indirectly. The aim of this control strategy is to establish power sharing on a pro rata basis for storage units. As a case study, a practical distribution network with 30 buses is simulated and the results are provided.

Mean sea surface heights of the South and East China Seas from ocean circulation model and geodetic leveling

The mean sea surface heights (sea surface topography) of the South China, East China, Yellow and Bohai Seas are derived from an ocean general circulation model and surface air pressure. The circulation model covers the global oceans, with fine grid (1/6degrees) covering the East Asian marginal seas and coarse grid (31) covering the rest part of the global oceans. The result shows that the China 1985 National Altitude Datum is 24.7 cm above the me-an sea surface height of the world oceans. The mean sea surface in the coastal ocean adjacent to China is higher in the south than in the north. Intercomparison of the model results with the geodetic leveling measurements at 28 coastal tidal stations shows a standard deviation of 4.8 cm and a fitting coefficient of 95.3%. After correction through linear regression, the standard deviation is reduced to 4.5 cm. This indicates that the accuracy of model results is sufficient for practical application. Based on the model results, the mean sea surface heights for the study area with a resolution of 1/6 degree are given. This result also links the mean sea levels at islands with those on the mainland coast and gives the mean sea surface heights at tidal stations in the Taiwan Island, the Dongsha Islands, the Yisha Islands and the Nansha Islands relative to the China 1985 National Altitude Datum.

Effects of leveling agent on the uptake of reactive dyes by untreated and plasma-treated wool

Atmospheric-pressure plasma treatment of wool fabric produced a significantly higher level of adsorbed fiber-reactive dye when applied at 50 °C (pH 3.0–6.0) in the absence of any organic leveling agent. In addition, color yields indicated that dye was more uniformly adsorbed by the plasma-treated fabric compared with the untreated material. When untreated fabric was dyed in the presence of a leveling agent (Albegal B), the extent and levelness of dye sorption were enhanced. These enhancements were, however, relatively small on the plasma-treated wool compared with those on untreated wool. A ‘surface’ mechanism, similar to that proposed when plasma-treated wool is dyed in the absence of leveling agent, can explain the leveling ability of Albegal B under adsorption conditions. Increasing the dyebath temperature to 90 °C resulted in dye penetration of the fibers. Under these conditions, any enhancements of dye uptake produced by the plasma treatment, as well as the use of Albegal B, were relatively small, in contrast to the behavior at 50 °C. Improvements in the uniformity of dye sorption observed at 50 °C were, however, maintained at the higher temperature. It is concluded that the inability of reactive dyes to migrate (and so promote leveling and uniformity) once they have reacted with the fiber, means that differences in the uniformity of dye sorbed at 50 °C are still apparent at equilibrium.

Effect of roller leveling on the bending behaviour of aged steel strip

The common grades of steel used in roll forming are: hot rolled carbon steel, high strength low alloy and recovery annealed cold rolled sheet. These steels are prone to ageing and are often skin passed and/or roller leveled to eliminate ageing as it can lead to problems in forming. In roll forming, shape defects such as bow, twist and camber are considered to be related to very small plastic strains in the longitudinal direction and hence knowledge of the material properties in the elastic plastic transition range is necessary if the process is to be modelled accurately. Previous studies with aluminium have indicated that skin pass rolling can lead to residual stresses in the strip. In this work, the study was extended to aged carbon steel and to the effect of roller leveling on both aged material and strip that had been given a light cold rolling to simulate a skin pass treatment. The results suggest that roller leveling reduced the magnitude of residual stresses resulting from skin pass rolling.

The significant differences observed between tensile and bending test results, at and near, the elastic plastic transition reinforces the need to consider bending properties when assessing the effect of prior processing on strip for roll forming.

Preemptive carprofen for peri-operative analgesia in dogs undergoing Tibial Plateau Leveling Osteotomy (TPLO): a prospective, randomized, blinded, placebo controlled clinical trial

Eighteen client-owned dogs undergoing Tibial Plateau Leveling Osteotomy (TPLO) were included in this blinded clinical study and randomly assigned to one of two treatment groups. Group C (carprofen) received intravenous (IV) carprofen, 4 mg/kg, prior to anesthesia, whereas group P (placebo) received IV saline. General anesthesia was maintained with isoflurane in oxygen and a constant rate infusion (CRI) of sufentanyl IV. Intra-operatively, assessment of nociception was based on changes in physiological parameters and on the analgesics requirement, whereas in the post-operative period evaluation of pain was performed by using a Hellyer and Gaynor pain score and by comparing the doses of rescue buprenorphine required by the two treatment groups. Although no statistically significant differences in intra-operative sufentanyl doses were found between treatment groups, group C had superior cardiovascular stability, and lower post-operative pain scores and rescue buprenorphine doses than group P. Our results indicate that administration of carprofen prior to surgery was effective in improving peri-operative analgesia in dogs undergoing TPLO.

Smart Hybrid Polymers for Advanced Damascene Electroplating: Combination of Superfill and Leveling Properties

A successful bottom-up fill of single Damascene test features is achieved by using a two-component additive package consisting of bis-(sodium-sulfopropyl)-disulfide (SPS) and Imep polymers (polymerizates of imidazole and epichlorohydrin). In addition, a remarkable leveling effect is observed. Clearly, the Imep additive combines bottom-up fill capabilities with leveling characteristics in one single polymer component. These unique hybrid properties of the Imep are rationalized on the basis of an extended N-NDR (N-shaped negative differential resistance) being present in the linear-sweep voltammogram of the SPS/Imep additive system during Cu electrodeposition.

Results of spirit leveling in New York, 1906 to 1911, inclusive,

Mode of access: Internet.

Results of spirit leveling in Pennsylvania, 1899 to 1911, inclusive.

Mode of access: Internet.

Results of spirit leveling in Idaho, 1896 to 1914, inclusive,

Mode of access: Internet.

Results of spirit leveling in Iowa, 1896 to 1913, inclusive. Work done in cooperation with the State of Iowa from 1907 to 1913, inclusive.

Mode of access: Internet.

Results of spirit leveling in Nebraska, 1896 to 1913, inclusive. Work done in cooperation with the State from 1911 to 1913, inclusive, through the Board of regents of the University of Nebraska.

Mode of access: Internet.