Ben Huff and Jarrett Irons, UM Football, vs Boston College, 1996

[l-r: defensive coordinator Greg Mattison, Ben Huff, Jarrett Irons]

Characterization of cast irons for optimum performance by overall rating method

An experimental investigation was carried out to Characterise the performance of four types of cast iron under adhesive wear, erosive wear, cavitation erosion and low frequency thermal cycling. Results indicate that vermicular graphite iron has the best rating among the cast irons investigate,based on the overall performance as well as cost consideration.

Wear of hardfacing white cast irons by solid particle erosion

The response of three commercial weld-hardfacing alloys to erosive wear has been studied. These were high chromium white cast irons, deposited by an open-arc welding process, widely used in the mineral processing and steelmaking industries for wear protection. Erosion tests were carried out with quartz sand, silicon carbide grit and blast furnace sinter of two different sizes, at a velocity of 40 m s-1 and at impact angles in the range 20° to 90°. A monolithic white cast iron and mild steel were also tested for comparison. Little differences were found in the wear rates when silica sand or silicon carbide grit was used as the erodent. Significant differences were found, however, in the rankings of the materials. Susceptibility to fracture of the carbide particles in the white cast irons played an important role in the behaviour of the white cast irons. Sinter particles were unable to cause gross fracture of the carbides and so those materials with a high volume fraction of carbides showed the greatest resistance to erosive wear. Silica and silicon carbide were capable of causing fracture of the primary carbides. Concentration of plastic strain in the matrix then led to a high wear rate for the matrix. At normal impact with silica or silicon carbide erodents mild steel showed a greater resistance to erosive wear than these alloys. © 1995.

Dr. Leslie Boldt-Irons

Professor of French.

Receipt from David Stiven, blacksmith for irons

Receipt from David Stiven, blacksmith for irons, Sept. 26, 1876.

Viscoplastic behaviour of porous bronzes and irons

An experimental investigation is presented for the viscoplastic behaviour of porous metals. The interest is in the influence of porosity on the deformation behaviour of such materials under loading at various strain rates. Material samples of bronze with 10% tin and pure iron were fabricated by powder metallurgy technology with porosity ranging from 10 to 40%. The samples were then subjected to a large uniaxial compression under both quasi-static and dynamic loading with the maximum strain rate at 10 s−1. The materials show behaviour in an approximately bi-linear nature for strain up to 0.4. The data will be used to develop simple phenomenological constitutive models, which incorporate the volume fraction as a control factor.