Evaluation of Sperm Kinetics and Plasma Membrane Integrity of Frozen Equine Semen in Different Storage Volumes and Freezing Conditions

In the present study, different freezing systems (Styrofoam box and Mini Digitcool ZH 400) and storage volumes (0.5- and 0.25-mL straws) were compared with regard to sperm kinetics and plasma membrane integrity of frozen and thawed semen. For that, three ejaculates from four animals were frozen in Styrofoam box and Mini Digitcool ZH 400 machine. The 0.5-mL straws were thawed at 46°C for 20 seconds, and the 0.25-mL straws were thawed at 46°C for 12 seconds. Statistical analysis was performed using program R of descriptive analysis box plot, followed by analysis of variance using PROC MIXED of SAS 9.1 package. Variances of 5% were considered as different. There was no interaction between the straw sizes and volumes; however, statistical differences were observed between the semen storage volumes. The 0.5-mL straws had higher total motility (%), progressive motility (%), average path velocity (μm/s), straight-line velocity (μm/s), curvilinear velocity (μm/s), and rapid sperm percentage (%) than the 0.25-mL straws. However, plasma membrane integrity analysis did not differ between the two straws. Thus, it is possible to conclude that equine sperm cryopreserved in 0.5-mL straws has better sperm kinetics than when stored in 0.25-mL straws. Additionally, it is possible to conclude that automated systems that enable faster freezing rates result in a seminal quality that is similar to the one obtained by the conventional system using Styrofoam boxes. © 2013 Elsevier Inc.

(Table 3) Basal melting rates under the Amery Ice Shelf, East Antarctica

The basal melting and freezing rates under the Amery Ice Shelf, East Antarctica, are evaluated, and their spatial distributions mapped. Ice velocity, surface elevation and accumulation rate datasets are employed in the analysis, along with a column-averaged ice density model. Our analysis shows that the total area of basal melting is 34 700 km**2, with a total annual melt of 62.5 ± 9.3 Gt and an average melting rate of 1.8 ± 0.3 m/a. Basal freezing mainly occurs in the northwestern part of the ice shelf, over a total area of 26100 km**2 and with a maximum freezing rate of 2.4 ± 0.4 m/a. The total marine ice that accretes to the ice-shelf base is estimated to be 16.2 ± 2.4 Gt/a. Using a redefined grounding line and geometry of the Amery Ice Shelf, we estimate the net melt over the ice-shelf base is about 46.4 ± 6.9 Gt/a, which is higher than previous modeling and oceanographic estimates. Net basal melting accounts for about half of the total ice-shelf mass loss, with the rest being from iceberg discharge. Our basal melting and freezing distribution map provides a scientific basis for quantitative analysis of ice-ocean interaction at the ice-shelf-ocean interface.

Development and standardization of a protocol for sperm cryopreservation of two important commercial oyster species

Dissertação de mestrado, Aquacultura e Pescas, Faculdade de Ciências e Tecnologia, Universidade do Algarve, 2015

Ice Shelf Water plume flow beneath Filchner-Ronne Ice Shelf, Antarctica

[1] A two-dimensional plume model is used to study the interaction between Filchner-Ronne Ice Shelf, Antarctica and its underlying ocean cavity. Ice Shelf Water (ISW) plumes are initiated by the freshwater released from a melting ice shelf and, if they rise, may become supercooled and deposit marine ice due to the pressure increase in the in situ freezing temperature. The aim of this modeling study is to determine the origin of the thick accretions of marine ice at the base of Filchner-Ronne Ice Shelf and thus improve our understanding of ISW flow paths. The model domain is defined from measurements of ice shelf draft, and from this ISW the model is able to predict plumes that exit the cavity in the correct locations. The modeled plumes also produce basal freezing rates that account for measured marine ice thicknesses in the western part of Ronne Ice Shelf. We find that the freezing rate and plume properties are significantly influenced by the confluence of plumes from different meltwater sources. We are less successful in matching observations of marine ice under the rest of Filchner-Ronne Ice Shelf, which we attribute primarily to this model’s neglect of circulations in the ocean outside the plume.

Efeito da velocidade de congelamento sobre a liofilização, reidratação e atributos de qualidade de fatias de maçã

Pós-graduação em Engenharia e Ciência de Alimentos - IBILCE

Comparação entre diferentes taxas de sêmen na viabilidade espermática em garanhões de alta e baixa congelabilidade

Pós-graduação em Medicina Veterinária - FMVZ

An investigation into the similarities and differences governing the cryopreservation success of koala (Phascolarctos cinereus: goldfuss) and common wombat (Vombatus ursinus: shaw) spermatozoa

The aim of this study was to determine the relative cryopreservation success of koala and wombat spermatozoa and to investigate reasons for their respective post-thaw survival by examining the sperm's response to a range of osmotic media and determining the presence and distribution of F-actin. An hypothesis was proposed that F-actin may be imparting a degree of structural inflexibility to the koala sperm plasma membrane; hence, exposure of spermatozoa to cytochalasin D (5 mu M), a F-actin depolymerisation agent, should result in increased plasticisation of the membrane and greater tolerance of cell volume changes that typically occur during cryopreservation. In experiment 1, koala (n = 4) and wombat (n = 4) spermatozoa packaged in 0.25 mL straws were cryopreserved using two freezing rates (fast-3 cm above liquid N2 interface; slow-6 degrees C/min in a freezing chamber) and two glycerol concentrations (8 and 14% v/v) in a tris-citrate glucose buffer with 15% (v/v) egg yolk. Wombat spermatozoa showed better (P < 0.01) post-thaw survival (% motile, % intact plasma membranes, % decondensed sperm heads) than koala spermatozoa. When exposed to media of varying osmolality, koala spermatozoa were less tolerant (% intact plasma membrane) of hyper-osmotic conditions (920 and 1410mOsmol/kg) than wombat spermatozoa. F-actin was localised using a monoclonal antibody but only found in the wombat sperm head. When koala and wombat spermatozoa were exposed to media of varying osmolality, cytochalasin D had no beneficial effect on sperm survival (% intact plasma membranes). This study has demonstrated that wombat spermatozoa are highly tolerant of cryopreservation when compared to koala sperm but that spermatozoa from both species show greatest post-thaw survival when frozen slowly in 14% glycerol. Koala sperm are also particularly susceptible to hyper-osmotic environments but lack of detectable F-actin in the koala spermatozoan suggests that poor cryopreservation success in this species is unlikely to be associated with F-actin induced plasma membrane inflexibility. (c) 2006 Elsevier Inc. All rights reserved.

Pharmaceutical process optimisation of bulk lyophilisates:implications of powder handling

Lyophilisation or freeze drying is the preferred dehydrating method for pharmaceuticals liable to thermal degradation. Most biologics are unstable in aqueous solution and may use freeze drying to prolong their shelf life. Lyophilisation is however expensive and has seen lots of work aimed at reducing cost. This thesis is motivated by the potential cost savings foreseen with the adoption of a cost efficient bulk drying approach for large and small molecules. Initial studies identified ideal formulations that adapted well to bulk drying and further powder handling requirements downstream in production. Low cost techniques were used to disrupt large dried cakes into powder while the effects of carrier agent concentration were investigated for powder flowability using standard pharmacopoeia methods. This revealed superiority of crystalline mannitol over amorphous sucrose matrices and established that the cohesive and very poor flow nature of freeze dried powders were potential barriers to success. Studies from powder characterisation showed increased powder densification was mainly responsible for significant improvements in flow behaviour and an initial bulking agent concentration of 10-15 %w/v was recommended. Further optimisation studies evaluated the effects of freezing rates and thermal treatment on powder flow behaviour. Slow cooling (0.2 °C/min) with a -25°C annealing hold (2hrs) provided adequate mechanical strength and densification at 0.5-1 M mannitol concentrations. Stable bulk powders require powder transfer into either final vials or intermediate storage closures. The targeted dosing of powder formulations using volumetric and gravimetric powder dispensing systems where evaluated using Immunoglobulin G (IgG), Lactate Dehydrogenase (LDH) and Beta Galactosidase models. Final protein content uniformity in dosed vials was assessed using activity and protein recovery assays to draw conclusions from deviations and pharmacopeia acceptance values. A correlation between very poor flowability (p<0.05), solute concentration, dosing time and accuracy was revealed. LDH and IgG lyophilised in 0.5 M and 1 M mannitol passed Pharmacopeia acceptance values criteria with 0.1-4 while formulations with micro collapse showed the best dose accuracy (0.32-0.4% deviation). Bulk mannitol content above 0.5 M provided no additional benefits to dosing accuracy or content uniformity of dosed units. This study identified considerations which included the type of protein, annealing, cake disruption process, physical form of the phases present, humidity control and recommended gravimetric transfer as optimal for dispensing powder. Dosing lyophilised powders from bulk was demonstrated as practical, time efficient, economical and met regulatory requirements in cases. Finally the use of a new non-destructive technique, X-ray microcomputer tomography (MCT), was explored for cake and particle characterisation. Studies demonstrated good correlation with traditional gas porosimetry (R2 = 0.93) and morphology studies using microscopy. Flow characterisation from sample sizes of less than 1 mL was demonstrated using three dimensional X-ray quantitative image analyses. A platinum-mannitol dispersion model used revealed a relationship between freezing rate, ice nucleation sites and variations in homogeneity within the top to bottom segments of a formulation.

Simplified Mathematical Model for Effects of Freezing on the Low-Temperature Performance of the Lead-Acid Battery

Discharge periods of lead-acid batteries are significantly reduced at subzero centigrade temperatures. The reduction is more than what can he expected due to decreased rates of various processes caused by a lowering of temperature and occurs despite the fact that active materials are available for discharge. It is proposed that the major cause for this is the freezing of the electrolyte. The concentration of acid decreases during battery discharge with a consequent increase in the freezing temperature. A battery freezes when the discharge temperature falls below the freezing temperature. A mathematical model is developed for conditions where charge-transfer reaction is the rate-limiting step. and Tafel kinetics are applicable. It is argued that freezing begins from the midplanes of electrodes and proceeds toward the reservoir in-between. Ionic conduction stops when one of the electrodes freezes fully and the time taken to reach that point, namely the discharge period, is calculated. The predictions of the model compare well to observations made at low current density (C/5) and at -20 and -40 degrees C. At higher current densities, however, diffusional resistances become important and a more complicated moving boundary problem needs to be solved to predict the discharge periods. (C) 2009 The Electrochemical Society.

Freezing of stallion epididymal sperm

Inseminations with frozen-thawed epididymal sperm have resulted in low-pregnancy rates of mares. If fertility of epididymal sperm could be improved, it would help to preserve genetic material from stallions that have suffered severe injuries, been castrated or have died. The aim of the present study was to investigate the effect of different extenders and pre-freezing addition of capacitation media on freezability of epididymal sperm and on storage at 5 degrees C for 24 h. In experiment 1, epididymal sperm samples were diluted and subsequently frozen with three different extenders: Botu-Crio((R)), EDTA-Lactose and INRA-82. Motility analysis using computer assisted sperm analyzer (CASA) demonstrated better motility for sperm in Botu-Crio((R)) than in the other extenders; EDTA-Lactose yielded better motility than INRA-82 on most evaluated parameters. There was no difference in membrane integrity among the studied extenders. From 18 inseminated mares, 12 (66%) were pregnant 15 days after AI with frozen-thawed epididymal sperm showing that Botu-Crio((R)) was able to maintain the fertility potential. In experiment 2, the effect of incubation of epididymal sperm before freezing in three capacitation media (Fert Talp, Sperm Talp, Talp + Progesterone), seminal plasma, or control was tested. Based on post-thaw motility evaluation by CASA, samples incubated in Sperm Talp showed better motility values. There were no differences in plasma or acrosomal membranes or in mitochondrial potential among groups. We concluded that Botu-Crio((R)) was better than the other extenders in the ability to preserve epididymal sperm and that pre-freeze addition of Sperm Talp was also beneficial. (c) 2008 Published by Elsevier B.V.

Post-thaw viability of in vivo-produced canine blastocysts cryopreserved by slow freezing

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)