Avaliação das emissões superficiais do gás de aterros sanitários de grande porte

The present work showed the results of the biogas surface emissions from two large landfills. The study methodology consisted on escaping biogas analysis on the landfill surface, through the flux box and laboratory analysis. The total average emission of Bandeirantes Landfill was 0.00126 m3.CH4.m-2.h-1 and in Caieiras Landfill it was of 0.01222 m3.CH4.m-2.h-1. Those results were used to determinate the biogas escape both landfills. The total escape in Bandeirantes Landfill biogas accounted for 16% and in Caieiras, 35%. The conclusions demonstrated that there is a significant loss of biogas through the surface in both landfills, thus compromising the efficiency of the capture for using biogas.

Cu2ZnSnS4 absorber layers obtained through sulphurization of metallic precursors: Graphite box versus sulphur flux

In this work we employed a hybrid method, combining RF-magnetron sputtering with evaporation, for the deposition of tailor made metallic precursors, with varying number of Zn/Sn/Cu (ZTC) periods and compared two approaches to sulphurization. Two series of samples with 1×, 2× and 4× ZTC periods have been prepared. One series of precursors was sulphurized in a tubular furnace directly exposed to a sulphur vapour and N2+5% H2 flux at a pressure of 5.0×10+4 Pa. A second series of identical precursors was sulphurized in the same furnace but inside a graphite box where sulphur pellets have been evaporated again in the presence of N2+5% H2 and at the same pressure as for the sulphur flux experiments. The morphological and chemical analyses revealed a small grain structure but good average composition for all three films sulphurized in the graphite box. As for the three films sulphurized in sulphur flux grain growth was seen with the increase of the number of ZTC periods whilst, in terms of composition, they were slightly Zn poor. The films' crystal structure showed that Cu2ZnSnS4 is the dominant phase. However, in the case of the sulphur flux films SnS2 was also detected. Photoluminescence spectroscopy studies showed an asymmetric broad band emission whichoccurs in the range of 1–1.5 eV. Clearly the radiative recombination efficiency is higher in the series of samples sulphurized in sulphur flux. We have found that sulphurization in sulphur flux leads to better film morphology than when the process is carried out in a graphite box in similar thermodynamic conditions. Solar cells have been prepared and characterized showing a correlation between improved film morphology and cell performance. The best cells achieved an efficiency of 2.4%.

Flux Pinning Optimization of MgB(2) Bulk Samples Prepared Using High-Energy Ball Milling and Addition of TaB(2)

MgB(2) is considered to be an important conductor for applications. Optimizing flux pinning in these conductors can improve their critical currents. Doping can influence flux pinning efficiency and grain connectivity, and also affect the resistivity, upper critical field and critical temperature. This study was designed to attempt the doping of MgB(2) on the Mg sites with metal-diborides using high-energy ball milling. MgB(2) samples were prepared by milling pre-reacted MgB(2) and TaB(2) powders using a Spex 8000M mill with WC jars and balls in a nitrogen-filled glove box. The mixing concentration in (Mg(1-x)Ta(x))B(2) was up to x = 0.10. Samples were removed from the WC jars after milling times up to 4000 minutes and formed into pellets using cold isostatic pressing. The pellets were heat treated in a hot isostatic press (HIP) at 1000 degrees C under a pressure of 30 kpsi for 24 hours. The influence that milling time and TaB(2) addition had on the microstructure and the resulting superconducting properties of TaB(2)-added MgB(2) is discussed. Improvement J(c) of at high magnetic fields and of pinning could be obtained in milled samples with added TaB(2) The sample with added 5at.% TaB(2) and milled for 300 minutes showed values of J(c) similar to 7 x 10(5) A/cm(2) and F(p) similar to 14 GN/m(3) at 2T, 4.2 K. The milled and TaB(2)-mixed samples showed higher values of mu(0)H(irr) than the unmilled-unmixed sample.

Hepatocyte nuclear factors 1α/4α and forkhead box A2 regulate the solute carrier 2A2 (Slc2a2) gene expression in the liver and kidney of diabetic rats

AIMS: Solute carrier 2a2 (Slc2a2) gene codifies the glucose transporter GLUT2, a key protein for glucose flux in hepatocytes and renal epithelial cells of proximal tubule. In diabetes mellitus, hepatic and tubular glucose output has been related to Slc2a2/GLUT2 overexpression; and controlling the expression of this gene may be an important adjuvant way to improve glycemic homeostasis. Thus, the present study investigated transcriptional mechanisms involved in the diabetes-induced overexpression of the Slc2a2 gene. MAIN METHODS: Hepatocyte nuclear factors 1α and 4α (HNF-1α and HNF-4α), forkhead box A2 (FOXA2), sterol regulatory element binding protein-1c (SREBP-1c) and the CCAAT-enhancer-binding protein (C/EBPβ) mRNA expression (RT-PCR) and binding activity into the Slc2a2 promoter (electrophoretic mobility assay) were analyzed in the liver and kidney of diabetic and 6-day insulin-treated diabetic rats. KEY FINDINGS: Slc2a2/GLUT2 expression increased by more than 50% (P<0.001) in the liver and kidney of diabetic rats, and 6-day insulin treatment restores these values to those observed in non-diabetic animals. Similarly, the mRNA expression and the binding activity of HNF-1α, HNF-4α and FOXA2 increased by 50 to 100% (P<0.05 to P<0.001), also returning to values of non-diabetic rats after insulin treatment. Neither the Srebf1 and Cebpb mRNA expression, nor the SREBP-1c and C/EBP-β binding activity was altered in diabetic rats. SIGNIFICANCE: HNF-1α, HNF-4α and FOXA2 transcriptional factors are involved in diabetes-induced overexpression of Slc2a2 gene in the liver and kidney. These data point out that these transcriptional factors are important targets to control GLUT2 expression in these tissues, which can contribute to glycemic homeostasis in diabetes.

The water vapour flux above Switzerland and its role in the August 2005 extreme precipitation and flooding

The water budget approach is applied to an atmospheric box above Switzerland (hereafter referred to as the “Swiss box”) to quantify the atmospheric water vapour flux using ECMWF ERA-Interim reanalyses. The results confirm that the water vapour flux through the Swiss box is highly temporally variable, ranging from 1 to 5 · 107 kg/s during settled anticyclonic weather, but increasing in size by a factor of ten or more during high speed currents of water vapour. Overall, Switzerland and the Swiss box “import” more water vapour than it “exports”, but the amount gained remains only a small fraction (1% to 5%) of the total available water vapour passing by. High inward water vapour fluxes are not necessarily linked to high precipitation episodes. The water vapour flux during the August 2005 floods, which caused severe damage in central Switzerland, is examined and an assessment is made of the computed water vapour fluxes compared to high spatio-temporal rain gauge and radar observations. About 25% of the incoming water vapour flux was stored in Switzerland. The computed water vapour fluxes from ECMWF data compare well with the mean rain gauge observations and the combined rain-gauge radar precipitation products.

Planktonic foraminiferal abundance and flux in the Porcupine Seabight, Northeast Atlantic

Modern planktonic foraminifera collected with a sediment trap and subfossil assemblages from surface sediments from Galway Mound in the Porcupine Seabight off southwestern Ireland, northeastern Atlantic, were studied to show recent assemblage variations. The sediment trap operated from April to August 2004 and covers the spring bloom and early summer conditions with sampling intervals of 8 days. Eleven different species were recorded. Glorotalia hirsuta, Turborotalita quinqueloba and Globigerinita glutinata appeared predominately in spring. Neogloboquadrina incompta, Globigerina bulloides and Globorotalia inflata were abundant in spring and summer. The highest foraminiferal tests flux occured in June. The faunal composition was similar to subfossil assemblages from surface sediments, but the species proportions were different. This was mainly affected by the subtropical G. hirsuta, which was frequent in 2004 and rare in surface sediment samples and in earlier plankton collections from the southern Porcupine Seabight that were performed during the 1990s. The weight of deposited foraminifera is mainly influenced by spring bloom as indicated by sea-surface chlorophyll-a data. The top three-ranked species, G. hirsuta, N. incompta and G. bulloides contributed 87 % to the foraminiferal carbonate flux at Galway Mound. Foraminiferal carbonate and shell flux as well as the shell size revealed variations, which are related to lunar periodicity. The data infer a lunar pacing of reproduction for the main species as well as for G. glutinata and G. inflata, which was not recorded before.

Organic carbon flux through the benthic community in the temperate abyssal Northeast Atlantic

In order to assess the carbon flux through the deep-sea benthic boundary layer, sediment community oxygen consumption (SCOC) was measured in different months and years at the BIOTRANS area in the abyssal northeastern Atlantic. SCOC varied seasonally with a maximum in July/August. Evidence is given for a direct coupling between a substantial sedimentation of phytodetritus and the seasonal increase in SCOC. Rapid colonization, growth and decomposition rates indicate that the deep-sea benthic microbial and protozoan biota can react quickly to substantial falls of particulate organic matter. They seem to be the most important groups to generate seasonal changes in deep-sea benthic carbon flux rates.