A new experimental procedure to obtain titania powders as anatase phase by a sol-gel process

Titania powders were synthesized by a sol-gel process using titanium tetrabutoxide as precursor. The syntheses were performed in water or in solutions of dimethylformamide (dmf) or dimethylsulfoxide (dmso). It is demonstrated, by X-ray diffraction patterns of the synthesized powders, that the samples obtained in dmf or dmso solutions are crystalline (anatase phase) with some minor amount of brookite phase, whereas the sample synthesized in water is amorphous. The anatase phase can be obtained independently of any previous or further treatment of the synthesized powder, such as hydrothermal or heat treatment, providing a new, simple, quick and inexpensive route to synthesize anatase powders. From the peak broadening of the anatase (101) diffraction, the crystallite sizes were calculated as 6 nm.

Design and validation of a sheet metal shearing experimental procedure

Throughout the industrial processes of sheet metal manufacturing and refining, shear cutting is widely used for its speed and cost advantages over competing cutting methods. Industrial shears may include some force measurement possibilities, but the force is most likely influenced by friction losses between shear tool and the point of measurement, and are in general not showing the actual force applied to the sheet. Well defined shears and accurate measurements of force and shear tool position are important for understanding the influence of shear parameters. Accurate experimental data are also necessary for calibration of numerical shear models. Here, a dedicated laboratory set-up with well defined geometry and movement in the shear, and high measurability in terms of force and geometry is designed, built and verified. Parameters important to the shear process are studied with perturbation analysis techniques and requirements on input parameter accuracy are formulated to meet experimental output demands. Input parameters in shearing are mostly geometric parameters, but also material properties and contact conditions. Based on the accuracy requirements, a symmetric experiment with internal balancing of forces is constructed to avoid guides and corresponding friction losses. Finally, the experimental procedure is validated through shearing of a medium grade steel. With the obtained experimental set-up performance, force changes as result of changes in studied input parameters are distinguishable down to a level of 1%.

Flammability limits: A review with emphasis on ethanol for aeronautical applications and description of the experimental procedure

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Analysis of the Fracture of Reinforced Concrete Flat Elements Subjected to Explosions. Experimental Procedure and Numerical Validation

Many of the material models most frequently used for the numerical simulation of the behavior of concrete when subjected to high strain rates have been originally developed for the simulation of ballistic impact. Therefore, they are plasticity-based models in which the compressive behavior is modeled in a complex way, while their tensile failure criterion is of a rather simpler nature. As concrete elements usually fail in tensión when subjected to blast loading, available concrete material models for high strain rates may not represent accurately their real behavior. In this research work an experimental program of reinforced concrete fíat elements subjected to blast load is presented. Altogether four detonation tests are conducted, in which 12 slabs of two different concrete types are subjected to the same blast load. The results of the experimental program are then used for the development and adjustment of numerical tools needed in the modeling of concrete elements subjected to blast.

Assessment of a simplified experimental procedure to evaluate impact sound reduction of floor coverings

The impact noise reduction provided by floor coverings is usually obtained in laboratory, using the methodology described in the standard EN ISO 140-8, which requires the use of standard acoustic chambers. The construction of such chambers, following the requirements described in the EN ISO 140-1, implies a significant investment, and therefore only a limited number exists in each country. Alternatives to these standard methodologies, that allow a sufficiently accurate evaluation and require lower resources, have been interesting many researchers and manufacturers. In this paper, one such strategy is discussed, where a reduced sized slab is used to determine the noise reduction provided by floor coverings, following the procedure described in the ISO/CD 16251-1 technical document. Several resilient coverings, floating floors and floating slabs are tested and the results are compared with those obtained using the procedures described in the standards EN ISO 140-8 and EN ISO 717-2.

Large scale experiments on gravel and mixed beaches: Experimental procedure, data documentation and initial results

This paper provides information on the experimental set-up, data collection methods and results to date for the project Large scale modelling of coarse grained beaches, undertaken at the Large Wave Channel (GWK) of FZK in Hannover by an international group of researchers in Spring 2002. The main objective of the experiments was to provide full scale measurements of cross-shore processes on gravel and mixed beaches for the verification and further development of cross-shore numerical models of gravel and mixed sediment beaches. Identical random and regular wave tests were undertaken for a gravel beach and a mixed sand/gravel beach set up in the flume. Measurements included profile development, water surface elevation along the flume, internal pressures in the swash zone, piezometric head levels within the beach, run-up, flow velocities in the surf-zone and sediment size distributions. The purpose of the paper is to present to the scientific community the experimental procedure, a summary of the data collected, some initial results, as well as a brief outline of the on-going research being carried out with the data by different research groups. The experimental data is available to all the scientific community following submission of a statement of objectives, specification of data requirements and an agreement to abide with the GWK and EU protocols. (C) 2005 Elsevier B.V. All rights reserved.

Neuronal maturation in an experimental model of brain tissue heterotopia in the lung

Neural maturation involves diverse interaction and signaling mechanisms that are essential to the development of the nervous system. However, little is known about the development of neurons in heterotopic brain tissue in the lung, a rare abnormality observed in malformed babies and fetuses. The aim of this study was to identify the neurons and to investigate their maturation in experimental brain tissue heterotopia during fetal and neonatal periods. The fetuses from 24 pregnant female Swiss mice were used to induce brain tissue heterotopia on the 15th gestational day. Briefly, the brain of one fetus of each dam was extracted, disaggregated, and injected into the right hemithorax of siblings. Six of these fetuses with pulmonary brain tissue implantation were collected on the 18th gestational day (group E18), and six others were collected on the 8th postnatal day (group P8). The brain of each fetus from dams not submitted to any experimental procedure was collected on the 18th gestational day (group CE18) and on the 8th postnatal day (group CP8) to serve as a control for neuronal quantitation and maturation. Immunohistochemical staining of NeuN was used to assess neuron quantity and maturation. The NeuN labeling index was greater in the postnatal period than in the fetal period for the experimental and control groups (138 > E18 and CP8 > CE18), although there were fewer neurons in experimental than in control groups (P8 < CP8 and El 8 < CE1 8) (P < 0.005). These results indicate that fetal neuroblasts/neurons not only survive a dramatic event such as mechanical disaggregation, in the same way as it happens in human cases, but also they retain their development in heterotopia, irrespective of local tissue influences.

Experimental design for acquiring relevant data to address the issue of comparing consecutively manufactured tools and firearms

The comparison of consecutively manufactured tools and firearms has provided much, but not all, of the basis for the profession of firearm and toolmark examination. The authors accept the fundamental soundness of this approach but appeal to the experimental community to close two minor gaps in the experimental procedure. We suggest that "blinding" and attention to appropriateness of other experimental conditions that would consolidate the foundations of our profession. We do not suggest that previous work is unsound.

Investigando cinza da casca do arroz como fase estacionária em cromatografia: uma proposta de aula experimental nos cursos de graduação

This article describes an experiment that involves the extraction and separation of the pigments of spinach extract by column chromatography using the silica obtained from rice husk ash as a stationary phase. The experimental procedure is very simple to apply in the chemistry laboratory, and allowed to illustrate some concepts of organic chemistry: structure of organic molecules, solubility, polarity, extraction, partition coefficient, adsorption and retention factor (Rf), as well as objectives and fundamentals of chromatographic methods. The experiment can be carried out in a 4 h period.

Experimental chronic entrapment of the sciatic nerve in adult hamsters: an ultrastructural and morphometric study

Entrapment neuropathy is a group of clinical disorders involving compression of a peripheral nerve and interference with nerve function mostly through traction injury. We have investigated the chronic compression of peripheral nerves as an experimental procedure for detecting changes in ultrastructural nerve morphology. Adult hamsters (Mesocricetus auratus, N = 30) were anesthetized with a 25% pentobarbital solution and received a cuff around the right sciatic nerve. Left sciatic nerves were not operated (control group). Animals survived for varying times (up to 15 weeks), after which they were sacrificed and both sciatic nerves were immediately fixed with a paraformaldehyde solution. Experimental nerves were divided into segments based upon their distance from the site of compression (proximal, entrapment and distal). Semithin and ultrathin sections were obtained and examined by light and electron microscopy. Ultrastructural changes were qualitatively described and data from semithin sections were morphometrically analyzed both in control and in compressed nerves. We observed endoneurial edema along with both perineurial and endoneurial thickening and also the existence of whorled cell-sparse structures (Renaut bodies) in the subperineurial space of compressed sciatic nerves. Morphometric analyses of myelinated axons at the compression sites displayed a remarkable increase in the number of small axons (up to 60%) in comparison with the control axonal number. The distal segment of compressed nerves presented a distinct decrease in axon number (up to 40%) comparatively to the control group. The present experimental model of nerve entrapment in adult hamsters was shown to promote consistent histopathologic alterations analogous to those found in chronic compressive neuropathies.

Experimental model of pulmonary carcinogenesis in Wistar rats

Purpose: To elaborate an experimental model of pulmonary carcinogenesis in Wistar rats. Methods: Male Rattus norvegicus albinus, Wistar lineage was carried through an intra-pulmonary instillation of the Benzo[a]pyrene (B[a]P) dilution in alcohol 70%, a polycyclic aromatic hydrocarbon widely known by its power of tumoral induction. Three experimental groups had been formed with 08 animals each: Control Group (Alcohol 70%); B[a]P Group 10 mg/kg; e B[a]P Group 20mg/ kg, submitted to euthanasia 08, 10, 12 and 14 weeks after the experimental procedure. The pulmonary sections had been colored by hematoxilin-eosin (HE) and submitted to the morphometrical analysis to describe the tissue alterations. Results: The presence of diffuse inflammatory alterations was observed in all groups, however, at the analysis of the pulmonary tissue of the experimental groups, it had been observed hyperplasic alterations (BALT hyperplasia), and in one of the animals of the experimental group 20mg/kg (12 weeks), it was noticed the presence of cellular epithelial tracheal pleomorphism, suggesting the adenocarcinoma formation in situ. Conclusion: The main secondary alterations to the intra-pulmonary instillation of B[a]P in Wistar rats were: cellular proliferation, inflammatory alterations of several degrees and nodular lymphoid hyperplasias. The association of an activator agent of the pulmonary metabolic reply is necessary to establish the ideal reply-dose to the development of the lung cancer.

An experimental verification of newton's second law

We describe an experimental procedure to probe the validity of Newton's second law. The experimental arrangement allows us to accelerate a glider on an air track by means of forces that are both steady and known. We also show how to determine acceleration from average speeds calculated for successive time intervals of the motion measured by using several electronic counters connected to a single-crystal oscillator circuit. Within experimental errors, the experiments clearly show the proportionality between acceleration and force for a fixed mass and between acceleration and inverse of mass for a fixed force. © by the Sociedade Brasileira de Física.