Plant traits co-vary with altitude in grasslands and forests in the European Alps

Biological traits that are advantageous under specific ecological conditions should be present in a large proportion of the species within an ecosystem, where those specific conditions prevail. As climatic conditions change, the frequency of certain traits in plant communities is expected to change with increasing altitude. We examined patterns of change for 13 traits in 120 exhaustive inventories of plants along five altitudinal transects (520-3100 m a.s.l.) in grasslands and in forests in western Switzerland. The traits selected for study represented the occupation of space, photosynthesis, reproduction and dispersal. For each plot, the mean trait values or the proportions of the trait states were weighted by species cover and examined in relation to the first axis of a PCA based on local climatic conditions. With increasing altitude in grasslands, we observed a decrease in anemophily and an increase in entomophily complemented by possible selfing; a decrease in diaspores with appendages adapted to ectozoochory, linked to a decrease in achenes and an increase in capsules. In lowlands, pollination and dispersal are ensured by wind and animals. However, with increasing altitude, insects are mostly responsible for pollination, and wind becomes the main natural dispersal vector. Some traits showed a particularly marked change in the alpine belt (e.g., the increase of capsules and the decrease of achenes), confirming that this belt concentrates particularly stressful conditions to plant growth and reproduction (e.g. cold, short growing season) that constrain plants to a limited number of strategies. One adaptation to this stress is to limit investment in dispersal by producing capsules with numerous, tiny seeds that have appendages limited to narrow wings. Forests displayed many of the trends observed in grasslands but with a reduced variability that is likely due to a shorter altitudinal gradient.

Potential impact of climate change on vegetation in the European Alps: a review

Based on conclusions drawn from general climatic impact assessment in mountain regions, the review synthesizes results relevant to the European Alps published mainly from 1994 onward in the fields of population genetics, ecophysiology, phenology, phytogeography, modeling, paleoecology and vegetation dynamics. Other important factors of global change interacting synergistically with climatic factors are also mentioned, such as atmospheric CO2 concentration, eutrophication, ozone or changes in land-use. Topics addressed are general species distribution and populations (persistence, acclimation, genetic variability, dispersal, fragmentation, plant/animal interaction, species richness, conservation), potential response of vegetation (ecotonal shift - area, physiography - changes in the composition, structural changes), phenology, growth and productivity, and landscape. In conclusion, the European Alps appear to have a natural inertia and thus to tolerate an increase of 1-2 K of mean air temperature as far as plant species and ecosystems are concerned in general. However, the impact of land-use is very likely to negate this buffer in many areas. For a change of the order of 3 K or more, profound changes may be expected.

The 2006 Eiger rockslide, European Alps

In July 2006, approximately 2 million m3 of massive limestone began to move on the east flank of the Eiger in central Switzerland. For more than two years after the initial failure, the rock mass moved at rates of up to 70 cm per day. A detailed analysis of the structures and velocities of the different moving blocks was conducted with the aid of terrestrial laser scanning. The moving rock mass included a rear block that subsided, pushing a frontal block forward. Movement directions were controlled by discontinuity sets that formed wedges bounded on one side by sub-vertical bedding planes. The instability was, until recently, buttressed by a glacier. Slope observations and results of continuum and discontinuum modeling indicate that the structure of the rock mass and topography were the main causes of the instability. Progressive weathering and mechanical fatigue of the rock mass appear to have led to the failure. A dynamic analytical model further indicates that the rockslide was primarily controlled by a reduction in the strength of discontinuities, the effects of ice deformation, and ? to a limited extent ? groundwater flow. This study shows that realistic and simple instability models can be constructed for rock-slope failures if high-resolution data are available.

Stable O and H isotopic composition of hydrous minerals as proxies for paleoclimate and -topography : application to the European Alps

The isotopie composition of clay minerals can be used to gain information on paleoaltitude, -topography and -climate during the time of their formation, as they form in isotopie equilibrium with ambient water, which has an isotopie composition that is determined by previous rain-out. In this thesis, the usability of this approach is evaluated for sample material from both the North Alpine Foreland Basin and internal parts of the European Alps. The isotopie composition of precipitation is determined by the air temperature and the extent of previous rain-out, which in turn is affected by the distance to the point of origin of the water vapor and the condensation conditions. An orographic barrier leads to uplift and adiabatic cooling of air masses and thereby enhances rainfall with a characteristic depletion in heavy 0 and H isotopes. Processes such as evaporation and mixing of water with different origin affect the isotopie composition further on the surface. Clay minerals are hydrous phyllosilicates that can form during weathering or pedogenesis in isotopie equilibrium with the present water and inherit its isotopie composition with a characteristic fractionation. If their isotopie composition was preserved after formation and the necessary parameters are known, it is possible to calculate the isotopie composition of the ambient water and thereby reconstruct climatic and topographic conditions during their formation. Due to the hygroscopic behavior of the sample material, analytical procedures needed to be modified to allow an analysis of the oxygen and hydrogen isotopie composition of the hydroxyl water built into their crystal structure and not the one of recently adsorbed water. In order to determine typical 5lsO and 8D values of meteoric water and minerals in the weathering environment in high Alpine regions, samples of surface water and soils from the valley of Visp in the Swiss Alps were studied that were collected along a transect with varying altitudes and host rock lithologies. The actual aim to attempt the reconstruction of Alpine paleoelevations was addressed by the analysis of sediments deposited under marine and terrestrial conditions during the Miocene and Oligocene, which were sampled from different locations in Switzerland, Germany and Austria. Further bentonite and fault gouge clay samples were used as reference material from low and high elevations. Results show that the isotopie composition of clay minerals can be influenced by several factors, such as the mode and site of their formation, possible isotope exchange (which is evident for 8D values), the samples' mineral composition (such as the presence of detrital material) and the deposition environment. With a consideration of these parameters and limitation to certain sample material, conclusions are drawn on the isotopie composition of the water from which the clay minerals formed. Most of the obtained values lie in the same range as has been reported in literature for foreland precipitation. The reconstruction of paleoelevation might be possible for selected sites with a geographical setting close to the Alpine chain or for intramontane basins. - La composition isotopique des argiles, qui se forment typiquement en contact avec des eaux superficielles, peut être utilisée pour obtenir des informations sur la paléoaltitude, la paléotopographie et le paléoclimat pendant leur création. La composition en isotopes stable (oxygène et hydrogène) des eaux de pluie est déterminée par l'altitude, la température, la distance depuis le lieu d'évaporation et par le taux de précipitation. Certains processus comme l'évaporation, l'interaction avec des minéraux et le mélange d'eaux d'origines variées peuvent aussi changer la composition des eaux de surface. Les argiles sont des pliyllosilicates hydratés qui sont crées par l'altération des roches au contact de ces eaux de surface et ils acquièrent une composition isotopique qui est soumise à un certain fractionnement. L'objectif de cette thèse est d'évaluer si l'effet de l'altitude des Alpes, est détectable dans la composition isotopique des sédiments du bassin d'avant-pavs pendant le Miocène. Après avoir établi la procédure analytique, des compositions isotopiques typiques de régions de hautes altitudes ont été determine sur les eaux de surfaces (rivières) et sur des échantillons de sols, le long d'une coupe dans la valée de Visp, dans les Alpes Suisses. Une reconstruction des paléoaltitudes Miocènes Alpines a ensuite été mené par l'analyse de sédiments marins et terrestres en utilisant des échantillons d'âges variés et provenant de Suisse, d'Allemagne et d'Autriche. Les résultats montrent que la composition isotopique des échantillons est impactée par de multiples facteurs, tels que le mode de et le lieu de formation. un possible échange isotopique tardif (surtout pour 5D). leur composition minéralogique et l'environnement de leur sédimentation. Après un examen prudent de ces paramètres, et en se limitant à un certain assortiment d'échatillons, on peut tirer des conclusions sur la composition isotopique des eaux originelles pour en déduire l'effet du climat et de la topographie.

Daily precipitation statistics in regional climate models: evaluation and intercomparison for the European Alps

An evaluation is undertaken of the statistics of daily precipitation as simulated by five regional climate models using comprehensive observations in the region of the European Alps. Four limited area models and one variable-resolution global model are considered, all with a grid spacing of 50 km. The 15-year integrations were forced from reanalyses and observed sea surface temperature and sea ice (global model from sea surface only). The observational reference is based on 6400 rain gauge records (10–50 stations per grid box). Evaluation statistics encompass mean precipitation, wet-day frequency, precipitation intensity, and quantiles of the frequency distribution. For mean precipitation, the models reproduce the characteristics of the annual cycle and the spatial distribution. The domain mean bias varies between −23% and +3% in winter and between −27% and −5% in summer. Larger errors are found for other statistics. In summer, all models underestimate precipitation intensity (by 16–42%) and there is a too low frequency of heavy events. This bias reflects too dry summer mean conditions in three of the models, while it is partly compensated by too many low-intensity events in the other two models. Similar intermodel differences are found for other European subregions. Interestingly, the model errors are very similar between the two models with the same dynamical core (but different parameterizations) and they differ considerably between the two models with similar parameterizations (but different dynamics). Despite considerable biases, the models reproduce prominent mesoscale features of heavy precipitation, which is a promising result for their use in climate change downscaling over complex topography.