Role of five-quark components in radiative and strong decays of the Lambda(1405) resonance

Within an extended chiral constituent quark model, the three- and five-quark structure of the S-01 resonance Lambda(1405) is investigated. Helicity amplitudes for electromagnetic decays [Lambda(1405)->Lambda(1116)gamma, Sigma(1194)gamma] and transition amplitudes for strong decays [Lambda(1405)->Sigma(1194)pi, K- p] are derived, as well as the relevant decay widths. The experimental value for the strong decay width, Gamma(Lambda(1405)->(Sigma pi)degrees) = 50 +/- 2MeV, is well reproduced with about 50% of a five-quark admixture in the Lambda(1405). Important effects owing to the configuration mixing among Lambda P-2(1)A, Lambda P-2(8)M, and Lambda P-4(8)M are found. In addition, transitions between the three- and the five-quark components in the baryons turn out to be significant in both radiative and strong decays of the Lambda(1405) resonance.

Contributions of qqqq(q)over-bar Components to Axial Charges of Proton and N(1440)

The axial charges of the proton and N(1440) are studied in the framework of an extended constituent quark model (CQM) including qqqq (q) over bar components. The cancellation between the contributions of qqq components and qqqq (q) over bar components gives a natural explanation to the experimental value of the proton axial charge, which can not be well reproduced in the traditional CQM even after the SU (6) circle times O(3) symmetry breaking is taken into account. The experimental value of axial charge pins down the proportion of the qqqq (q) over bar component in the proton to about 20%, which is consistent with the ones given by the strong decay widths and helicity amplitudes. Besides, an axial charge for N(1440) about 1 is predicted with 30% qqqq (q) over bar component, which is obtained by the strong and electromagnetic decays.

Absence of gluonic components in axial and tensor mesons

A quarkonium-gluonium mixing scheme previously developed to describe the characteristic of the pseudoscalar mesons is applied to axial and tensor mesons. The parameters of the model are determined by fitting the eigenvalues of a mass matrix. The corresponding eigenvectors give the proportion of light quarks, strange quarks and glueball in each meson. However, the predictions of the model for the branching ratios and electromagnetic decays are incompatible with the experimental results. These results suggest the absence of gluonic components in the states of axial and tensor isosinglet mesons analyzed here.

The pion electromagnetic form factor in a QCD-inspired model

We present detailed numerical results for the pion space-like electromagnetic form factor obtained within a recently proposed model of the pion electromagnetic current in a confining light-front QCD-inspired model. The model incorporates the vector meson dominance mechanism at the quark level, where the dressed photon with q(+) > 0 decays in an interacting quark-antiquark pair, which absorbs the initial pion and produces the pion in the final state.

Lepton transverse polarization in the B -> Dl nu(l) decay due to the electromagnetic final state interaction

The effect of lepton transverse polarization in B-0-->D(-)l(+)nu(l), B+-->(D) over bar (0)l(+)nu(l) decays (l=tau,mu) is analyzed within the framework of the standard model in the leading order of heavy quark effective theory. It is shown that a nonzero transverse polarization appears due to the electromagnetic final state interaction. The diagrams with intermediate D,D* mesons contributing to the nonvanishing P-T are considered. Regarding only the contribution of these mesons, the values of the tau-lepton transverse polarization averaged over the physical region in the B-0-->D(-)tau(+)nu(l) and B+-->(D) over bar (0)tau(+)nu(l) decays are equal to 2.60x10(-3) and -1.59x10(-3), respectively. In the case of muon decay modes the values of [P-T] are equal to 2.97x10(-4) and -6.79x10(-4).

Spacelike and timelike pion electromagnetic form factor and Fock state components within the light-front dynamics

The simultaneous investigation of the pion electromagnetic form factor in the space- and timelike regions within a light-front model allows one to address the issue of nonvalence components of the pion and photon wave functions. Our relativistic approach is based on a microscopic vector-meson-dominance model for the dressed vertex where a photon decays in a quark-antiquark pair, and on a simple parametrization for the emission or absorption of a pion by a quark. The results show an excellent agreement in the space like region up to -10 (GeV/c)(2), while in timelike region the model produces reasonable results up to 10 (GeV/c)(2).

Electromagnetic form factor of the pion in the space- and time-like regions within the front-form dynamics

The pion electromagnetic form factor is calculated in the space- and time-like regions from -10 (GeV/c)2 up to 10 (GeV/c)2, within a front-form model. The dressed photon vertex where a photon decays in a quark-antiquark pair is depicted generalizing the vector meson dominance ansatz, by means of the vector meson vertex functions. An important feature of our model is the description of the on-mass-shell vertex functions in the valence sector, for the pion and the vector mesons, through the front-form wave functions obtained within a realistic quark model. The theoretical results show an excellent agreement with the data in the space-like region, while in the time-like region the description is quite encouraging. © 2003 Elsevier B.V. All rights reserved.

Measurement of electrons from heavy-flavour hadron decays in p-Pb collisions at $\\sqrt{s_{NN}} = 5.02$ TeV using TPC and EMCal detectors with ALICE at LHC

Heavy-ion collisions are a powerful tool to study hot and dense QCD matter, the so-called Quark Gluon Plasma (QGP). Since heavy quarks (charm and beauty) are dominantly produced in the early stages of the collision, they experience the complete evolution of the system. Measurements of electrons from heavy-flavour hadron decay is one possible way to study the interaction of these particles with the QGP. With ALICE at LHC, electrons can be identified with high efficiency and purity. A strong suppression of heavy-flavour decay electrons has been observed at high $p_{m T}$ in Pb-Pb collisions at 2.76 TeV. Measurements in p-Pb collisions are crucial to understand cold nuclear matter effects on heavy-flavour production in heavy-ion collisions. The spectrum of electrons from the decays of hadrons containing charm and beauty was measured in p-Pb collisions at $\\sqrt = 5.02$ TeV. The heavy flavour decay electrons were measured by using the Time Projection Chamber (TPC) and the Electromagnetic Calorimeter (EMCal) detectors from ALICE in the transverse-momentum range $2 < p_ < 20$ GeV/c. The measurements were done in two different data set: minimum bias collisions and data using the EMCal trigger. The non-heavy flavour electron background was removed using an invariant mass method. The results are compatible with one ($R_ \\approx$ 1) and the cold nuclear matter effects in p-Pb collisions are small for the electrons from heavy-flavour hadron decays.

A hybrid approach for resolving the electromagnetic fields inside a waveguide loaded with a lossy medium

In this work a novel hybrid approach is presented that uses a combination of both time domain and frequency domain solution strategies to predict the power distribution within a lossy medium loaded within a waveguide. The problem of determining the electromagnetic fields evolving within the waveguide and the lossy medium is decoupled into two components, one for computing the fields in the waveguide including a coarse representation of the medium (the exterior problem) and one for a detailed resolution of the lossy medium (the interior problem). A previously documented cell-centred Maxwell’s equations numerical solver can be used to resolve the exterior problem accurately in the time domain. Thereafter the discrete Fourier transform can be applied to the computed field data around the interface of the medium to estimate the frequency domain boundary condition in-formation that is needed for closure of the interior problem. Since only the electric fields are required to compute the power distribution generated within the lossy medium, the interior problem can be resolved efficiently using the Helmholtz equation. A consistent cell-centred finite-volume method is then used to discretise this equation on a fine mesh and the underlying large, sparse, complex matrix system is solved for the required electric field using the iterative Krylov subspace based GMRES iterative solver. It will be shown that the hybrid solution methodology works well when a single frequency is considered in the evaluation of the Helmholtz equation in a single mode waveguide. A restriction of the scheme is that the material needs to be sufficiently lossy, so that any penetrating waves in the material are absorbed.

Analysis of electromagnetic forces in high voltage superconducting fault current limiters with saturated core

This paper presents a three-dimensional numerical analysis of the electromagnetic forces within a high voltage superconducting Fault Current Limiter (FCL) with a saturated core under short-circuit conditions. The effects of electrodynamics forces in power transformer coils under short-circuit conditions have been reported widely. However, the coil arrangement in an FCL with saturated core differs significantly from existing reactive devices. The boundary element method is employed to perform an electromagnetic force analysis on an FCL. The analysis focuses on axial and radial forces of the AC coil. The results are compared to those of a power transformer and important design considerations are highlighted.

Volume estimation from multiplanar 2D ultrasound images using a remote electromagnetic position and orientation sensor

A system is described for calculating volume from a sequence of multiplanar 2D ultrasound images. Ultrasound images are captured using a video digitising card (Hauppauge Win/TV card) installed in a personal computer, and regions of interest transformed into 3D space using position and orientation data obtained from an electromagnetic device (Polbemus, Fastrak). The accuracy of the system was assessed by scanning 10 water filled balloons (13-141 ml), 10 kidneys (147  200 ml) and 16 fetal livers (8  37 ml) in water using an Acuson 128XP/10 (5 MHz curvilinear probe). Volume was calculated using the ellipsoid, planimetry, tetrahedral and ray tracing methods and compared with the actual volume measured by weighing (balloons) and water displacement (kidneys and livers). The mean percentage error for the ray tracing method was 0.9 ± 2.4%, 2.7 ± 2.3%, 6.6 ± 5.4% for balloons, kidneys and livers, respectively. So far the system has been used clinically to scan fetal livers and lungs, neonate brain ventricles and adult prostate glands.