Flyer about the Dominion Power and Transmission Company bonds from R.W. Harris and Co. Bankers

Flyer (2 double sided pages, printed) about the Dominion Power and Transmission Company bonds from R.W. Harris and Co. Bankers, New York, n.d.

Receipt from N. W. Harris and Co., Bankers, New York

Receipt from N. W. Harris and Co., Bankers, New York for installment on Dominion Power and Transmission Co., Dec. 19, 1907.

Power control and transmission scheduling for network utility maximization in wireless networks

We consider a joint power control and transmission scheduling problem in wireless networks with average power constraints. While the capacity region of a wireless network is convex, a characterization of this region is a hard problem. We formulate a network utility optimization problem involving time-sharing across different "transmission modes," where each mode corresponds to the set of power levels used in the network. The structure of the optimal solution is a time-sharing across a small set of such modes. We use this structure to develop an efficient heuristic approach to finding a suboptimal solution through column generation iterations. This heuristic approach converges quite fast in simulations, and provides a tool for wireless network planning.

TCP Optimization through FEC, ARQ and Transmission Power Tradeoffs

TCP performance degrades when end-to-end connections extend over wireless connections-links which are characterized by high bit error rate and intermittent connectivity. Such link characteristics can significantly degrade TCP performance as the TCP sender assumes wireless losses to be congestion losses resulting in unnecessary congestion control actions. Link errors can be reduced by increasing transmission power, code redundancy (FEC) or number of retransmissions (ARQ). But increasing power costs resources, increasing code redundancy reduces available channel bandwidth and increasing persistency increases end-to-end delay. The paper proposes a TCP optimization through proper tuning of power management, FEC and ARQ in wireless environments (WLAN and WWAN). In particular, we conduct analytical and numerical analysis taking into "wireless-aware" TCP) performance under different settings. Our results show that increasing power, redundancy and/or retransmission levels always improves TCP performance by reducing link-layer losses. However, such improvements are often associated with cost and arbitrary improvement cannot be realized without paying a lot in return. It is therefore important to consider some kind of net utility function that should be optimized, thus maximizing throughput at the least possible cost.

Analysis and Design of Class-E3F and Transmission-Line Class-E3F2 Power Amplifiers

In this paper, analysis and synthesis approach for two new variants within the Class-EF power amplifier (PA) family is elaborated. These amplifiers are classified here as Class-E3 F2 and transmission-line (TL) Class-E3 F 2. The proposed circuits offer means to alleviate some of the major issues faced by existing topologies such as substantial power losses due to the parasitic resistance of the large inductor in the Class-EF load network and deviation from ideal Class-EF operation due to the effect of device output inductance at high frequencies. Both lumped-element and transmission-line load networks for the Class-E 3 F PA are described. The load networks of the Class-E3 F and TL Class-E 3 F2amplifier topologies developed in this paper simultaneously satisfy the Class-EF optimum impedance requirements at fundamental frequency, second, and third harmonics as well as simultaneously providing matching to the circuit optimum load resistance for any prescribed system load resistance. Optimum circuit component values are analytically derived and validated by harmonic balance simulations. Trade-offs between circuit figures of merit and component values with some practical limitations being considered are discussed. © 2010 IEEE.

The manufacture of basic industrial equipment in Argentina: III: Generation and transmission of electric power = Estudios sobre la fabricación de equipos industriales de base en la Argentina: III: Generación y transmisión de energía eléctrica

Includes bibliography

Power and its transmission; a practical handbook for the factory and works manager,

Mode of access: Internet.

Direct and general support and depot maintenance repair parts and special tools lists : tractor, full tracked, low speed : diesel engine, medium drawbar pull, oscillating track, 74-in. minimum gage, power shift transmission, w/bulldozer, hydraulic-tilting, w/backrip scarifier, w/winch, reversible, rear, 1 drum (Allis-Chalmers model HD16M) ....

"April 1972."

DS, GS, and depot maintenance manual : tractor, full tracked, low speed, diesel engine, medium drawbar pull, oscillating tract, 74-in. minimum gage, power shift transmission w/bulldozer, hydraulic tilting w/back rip scarifier, w/winch reversible, rear, 1 drum (Allis-Chalmers model HD16M) FSN 2410-078-6483 w/ripper, hydraulic (Allis-Chalmers model HD16M) FSN 2410-078-6484.

Includes index.

Relative electrical distance concept for evaluation of network reactive power and loss contributions in a deregulated system

With the liberalisation of electricity market it has become very important to determine the participants making use of the transmission network.Transmission line usage computation requires information of generator to load contributions and the path used by various generators to meet loads and losses. In this study relative electrical distance (RED) concept is used to compute reactive power contributions from various sources like generators, switchable volt-amperes reactive(VAR) sources and line charging susceptances that are scattered throughout the network, to meet the system demands. The transmission line charge susceptances contribution to the system reactive flows and its aid extended in reducing the reactive generation at the generator buses are discussed in this paper. Reactive power transmission cost evaluation is carried out in this study. The proposed approach is also compared with other approaches viz.,proportional sharing and modified Y-bus.Detailed case studies with base case and optimised results are carried out on a sample 8-bus system. IEEE 39-bus system and a practical 72-bus system, an equivalent of Indian Southern grid are also considered for illustration and results are discussed.