960 resultados para Cut thickness
Resumo:
Ultraviolet radiation has been generated by tangentially phase-matched sum-frequency mixing in biaxial L-arginine phosphate (LAP) crystal for the first time using Nd:YAG output at 1064 nm and Rh 6G dye laser output at 560 nm as the two input sources. Characterization has also been made of such a cheap, biaxial crystal for its possible use in devices for tangentially phase-matched short wavelength generation. If the crystal is of proper cut, thickness and quality so that its maximum capability can be exploited it can replace the potassium dihydrogen phosphate (KDP) group of crystals for various applications.
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
We present a physics-based closed form small signal Nonquasi-static (NQS) model for a long channel Common Double Gate MOSFET (CDG) by taking into account the asymmetry that may prevail between the gate oxide thickness. We use the unique quasi-linear relationship between the surface potentials along the channel to solve the governing continuity equation (CE) in order to develop the analytical expressions for the Y parameters. The Bessel function based solution of the CE is simplified in form of polynomials so that it could be easily implemented in any circuit simulator. The model shows good agreement with the TCAD simulation at-least till 4 times of the cut-off frequency for different device geometries and bias conditions.
Resumo:
The focused ion beam microscope has been used to cut parallel-sided {100}-oriented thin lamellae of single crystal barium titanate with controlled thicknesses, ranging from 530 nm to 70 nm. Scanning transmission electron microscopy has been used to examine domain configurations. In all cases, stripe domains were observed with {011}-type domain walls in perovskite unit-cell axes, suggesting 90 degrees domains with polarization in the plane of the lamellae. The domain widths were found to vary as the square root of the lamellar thickness, consistent with Kittel's law, and its later development by Mitsui and Furuichi and by Roytburd. An investigation into the manner in which domain period adapts to thickness gradient was undertaken on both wedge-shaped lamellae and lamellae with discrete terraces. It was found that when the thickness gradient was perpendicular to the domain walls, a continuous change in domain periodicity occurred, but if the thickness gradient was parallel to the domain walls, periodicity changes were accommodated through discrete domain bifurcation. Data were then compared with other work in literature, on both ferroelectric and ferromagnetic systems, from which conclusions on the widespread applicability of Kittel's law in ferroics were made.
Resumo:
The focused ion beam microscope (FIB) has been used to fabricate thin parallel-sided ferroelectric capacitors from single crystals of BaTiO3 and SrTiO3. A series of nano-sized capacitors ranging in thickness from similar to660 nm to similar to300 nm were made. Cross-sectional high resolution transmission electron microscopy (HRTEM) revealed that during capacitor fabrication, the FIB rendered around 20 nm of dielectric at the electrode-dielectric interface amorphous, associated with local gallium impregnation. Such a region would act electrically in series with the single crystal and would presumably have a considerable negative influence on the dielectric properties. However, thermal annealing prior to gold electrodes deposition was found to fully recover the single crystal capacitors and homogenise the gallium profile. The dielectric testing of the STO ultra-thin single crystal capacitors was performed yielding a room temperature dielectric constant of similar to300, as is the case in bulk. Therefore, there was no evidence of a collapse in dielectric constant associated with thin film dimensions.
Resumo:
Carambola fruit ('Fwang Tung') were picked at two stages of maturity: mature-green (50% yellow) and mature (100% yellow). Fruit were washed with water, dipped in NaOCl solution (200 mg.L-1 for 5 minutes), and stored over night at 10°C. Fruit were sliced manually in to pieces of approximately 1 cm thickness. Slices were rinsed with NaOCl solution at 20 mg.L-1, drained for 3 minutes, and packaged in polyethylene tereftalate (PET) trays provided with a fit cover (Neoform® N94). Packages were stored at 6.5°C and 85% RH for 9 days, and samples taken every 3 days for physical, chemical and biochemical analysis, respiration, and internal atmosphere composition. Immediately after cutting, slices at both stages of maturity showed a wounding response with a 5-fold increase in respiration rate. Polygalacturonase (PG) and polyphenol oxidase (PPO) activity did not differ between stages of maturity. Despite the less mature stage being less preferred at the sensory evaluation owing to its greenish peel, the best stage of maturity for carambola fresh-cut production was mature-green, due to a higher resistance to cutting, and presenting a better colour and appearance maintenance for up to 9 days.
Resumo:
Subglacial hydrology in East Antarctica is poorly understood, yet may be critical to the manner in which ice flows. Data from a new regional airborne geophysical survey (ICECAP) have transformed our understanding of the topography and glaciology associated with the 287,000 km**2 Aurora Subglacial Basin in East Antarctica. Using these data, in conjunction with numerical ice sheet modeling, we present a suite of analyses that demonstrate the potential of the 1000 km-long basin as a route for subglacial water drainage from the ice sheet interior to the ice sheet margin. We present results from our analysis of basal topography, bed roughness and radar power reflectance and from our modeling of ice sheet flow and basal ice temperatures. Although no clear-cut subglacial lakes are found within the Aurora Basin itself, dozens of lake-like reflectors are observed that, in conjunction with other results reported here, support the hypothesis that the basin acts as a pathway allowing discharge from subglacial lakes near the Dome C ice divide to reach the coast via the Totten Glacier.
Resumo:
Purpose: To investigate whether eyes with diabetic macular edema (DME) and central retinal thickness (CRT) >400 μm had better visual and anatomical outcomes compared to eyes with a CRT <400 μm when treated with intravitreal bevacizumab in a real-world setting. Patients and methods: Patients undergoing intravitreal bevacizumab therapy for DME were identified from the departmental database of a tertiary referral unit. Following the initial injection, a retreatment was performed for any persistent macular edema, unless there had been no previous response to repeated doses. Recorded parameters included visual acuity, CRT on optical coherence tomography (spectral domain optical coherence tomography [SD-OCT]), and SD-OCT characteristics. Comparisons were made between data at baseline and 12 months after the first injection, and differences were tested for statistical significance using the Student's t-test. Results: In all, 175 eyes of 142 patients were analyzed. Patients in group 2 (CRT >400 μm) had significantly more injections than group 1 (CRT <400 μm) (4.0 versus 3.3; P=0.003). Both groups had similar numbers of eyes with preexisting epiretinal membrane and/or vitreomacular traction at baseline. The reduction in CRT was significantly greater in group 2 when compared to group 1 (P<0.0001). In terms of visual gain between baseline and month 12, each gained significantly by a mean of 0.12 logarithm of the minimum angle of resolution units (P=0.0001), but there was no difference between groups 1 and 2 (P=0.99). Conclusion: These results do not support a 400 μm baseline CRT cut-off for treating DME with bevacizumab, in contrast to published data on ranibizumab. Our results also indicate that patients with a thicker CRT require more bevacizumab injections, making treatment less cost-effective for these patients. Our results could be used by practitioners to support the use of bevacizumab in DME without applying a CRT cut-off. © 2014 Mushtaq et al.
Resumo:
OBJECTIVES: The aims of this study were to establish a Colombian smoothed centile charts and LMS tables for tríceps, subscapular and sum tríceps+subscapular skinfolds; appropriate cut-offs were selected using receiver operating characteristic analysis based in a populationbased sample of schoolchildren in Bogota, Colombia and to compare them with international studies. METHODS: A total of 9 618 children and adolescents attending public schools in Bogota, Colombia (55.7% girls; age range of 9–17.9 years). Height, weight, body mass index (BMI), waist circumference, triceps and subscapular skinfold measurements were obtained using standardized methods. We have calculated tríceps+subscapular skinfold (T+SS) sum. Smoothed percentile curves for triceps and subscapular skinfold thickness were derived by the LMS method. Receiver operating characteristics curve (ROC) analyses were used to evaluate the optimal cut-off point of tríceps, subscapular and sum tríceps+subscapular skinfolds for overweight and obesity based on the International Obesity Task Force (IOTF) definitions. Data were compared with international studies. RESULTS: Subscapular, triceps skinfolds and T+SS were significantly higher in girls than in boys (P <0.001). The median values for triceps, subscapular as well as T+SS skinfold thickness increased in a sex-specific pattern with age. The ROC analysis showed that subscapular, triceps skinfolds and T+SS have a high discrimination power in the identification of overweight and obesity in the sample population in this study. Based on the raw non-adjusted data, we found that Colombian boys and girls had high triceps and subscapular skinfolds values than their counterparts from Spain, UK, German and US. CONCLUSIONS: Our results provide sex- and age-specific normative reference standards for the triceps and subscapular skinfold thickness values in a large, population-based sample of 3 schoolchildren and adolescents from an Latin-American population. By providing LMS tables for Latin-American people based on Colombian reference data, we hope to provide quantitative tools for the study of obesity and its complications.
Resumo:
We present a new penalty-based genetic algorithm for the multi-source and multi-sink minimum vertex cut problem, and illustrate the algorithm’s usefulness with two real-world applications. It is proved in this paper that the genetic algorithm always produces a feasible solution by exploiting some domain-specific knowledge. The genetic algorithm has been implemented on the example applications and evaluated to show how well it scales as the problem size increases.
Resumo:
Purpose: To investigate associations between the diurnal variation in a range of corneal parameters, including anterior and posterior corneal topography, and regional corneal thickness. ----- Methods: Fifteen subjects had their corneas measured using a rotating Scheimpflug camera (Pentacam) every 3-7 hours over a 24-hour period. Anterior and posterior corneal axial curvature, pachymetry and anterior chamber depth were analysed. The best fitting corneal sphero-cylinder from the axial curvature, and the average corneal thickness for a series of different corneal regions were calculated. Intraocular pressure and axial length were also measured at each measurement session. Repeated measures ANOVA were used to investigate diurnal change in these parameters. Analysis of covariance was used to examine associations between the measured ocular parameters. ----- Results: Significant diurnal variation was found to occur in both the anterior and posterior corneal curvature and in the regional corneal thickness. Flattening of the anterior corneal best sphere was observed at the early morning measurement (p < 0.0001). The posterior cornea also underwent a significant steepening (p < 0.0001) and change in astigmatism 90/180° at this time. A significant swelling of the cornea (p < 0.0001) was also found to occur immediately after waking. Highly significant associations were found between the diurnal variation in corneal thickness and the changes in corneal curvature. ----- Conclusions: Significant diurnal variation occurs in the regional thickness and the shape of the anterior and posterior cornea. The largest changes in the cornea were typically evident upon waking. The observed non-uniform regional corneal thickness changes resulted in a steepening of the posterior cornea, and a flattening of the anterior cornea to occur at this time.
Resumo:
Objective: To investigate the acute effects of isolated eccentric and concentric calf muscle exercise on Achilles tendon sagittal thickness. ---------- Design: Within-subject, counterbalanced, mixed design. ---------- Setting: Institutional. ---------- Participants: 11 healthy, recreationally active male adults. ---------- Interventions: Participants performed an exercise protocol, which involved isolated eccentric loading of the Achilles tendon of a single limb and isolated concentric loading of the contralateral, both with the addition of 20% bodyweight. ---------- Main outcome measurements: Sagittal sonograms were acquired prior to, immediately following and 3, 6, 12 and 24 h after exercise. Tendon thickness was measured 2 cm proximal to the superior aspect of the calcaneus. ---------- Results: Both loading conditions resulted in an immediate decrease in normalised Achilles tendon thickness. Eccentric loading induced a significantly greater decrease than concentric loading despite a similar impulse (−0.21 vs −0.05, p<0.05). Post-exercise, eccentrically loaded tendons recovered exponentially, with a recovery time constant of 2.5 h. The same exponential function did not adequately model changes in tendon thickness resulting from concentric loading. Even so, recovery pathways subsequent to the 3 h time point were comparable. Regardless of the exercise protocol, full tendon thickness recovery was not observed until 24 h. ---------- Conclusions: Eccentric loading invokes a greater reduction in Achilles tendon thickness immediately after exercise but appears to recover fully in a similar time frame to concentric loading.