An Attempt to Increase the Permeability and Porosity of the Cut Bank Oil Sand By Treatment with Various Reagents

The purpose of this investigation was to attempt to find some means of increasing the effective porosity and permeabil­ity of the producing sands of the Cut Bank Oil Field, with the hope that thereby the ultimate recovery of petroleum from this field may be increased. Although the percentage increase in production thus effected would undoubtedly be small, it would represent a substantial volume of petroleum in view of the great quantity of oil and gas present in this field.

Permeability and Porosity Studies of the Cut Bank Oil Sand

In studying the Cut Bank field and its numerous wells, it is found that dry holes are surrounded by producing wells, and also that the field as a whole is very irregular; water, oil, and gas zones in many cases following no definite pattern. In some instances, this phenomenon may be due to the lensing and thinning of the producing sands, but it is evident that this is not the only factor. There­fore, the controlling factors must be porosity and permeability.

Report of Investigation on the Physical Characteristics of the Oil Sands from the Cut Bank Field, Montana

The purpose of this research was to study the physical characteristics, mainly, porosity and permeability of the oil sands from the Cut Bank field, Glacier County, Montana. In so doing, a better understanding of the relation­ship of these physical characteristics to one another and to the pool itself could be obtained.

A Research on New Method of Transportation Technics for Heavy Oil and Practice in Oil Field

介绍一种可应用于高粘度稠油管输的新工艺。即用自行研制的蒸汽引射器采用无界引射方式,将蒸汽直接注入到输油管道中,利用蒸汽释放的热量提高稠油温度降低粘度,从而达到降低稠油输送压降的目的,它比间接加热输送工艺所用的蒸汽量或耗煤量大大减少。方法在辽河油田输油管线上进行了工业现场试验,取得了很好的效果。

TIME LAPSE SEISMIC OBSERVATIONS AND EFFECTS OF RESERVOIR COMPRESSIBILITY AT TEAL SOUTH OIL FIELD

One of the original ocean-bottom time-lapse seismic studies was performed at the Teal South oil field in the Gulf of Mexico during the late 1990’s. This work reexamines some aspects of previous work using modern analysis techniques to provide improved quantitative interpretations. Using three-dimensional volume visualization of legacy data and the two phases of post-production time-lapse data, I provide additional insight into the fluid migration pathways and the pressure communication between different reservoirs, separated by faults. This work supports a conclusion from previous studies that production from one reservoir caused regional pressure decline that in turn resulted in liberation of gas from multiple surrounding unproduced reservoirs. I also provide an explanation for unusual time-lapse changes in amplitude-versus-offset (AVO) data related to the compaction of the producing reservoir which, in turn, changed an isotropic medium to an anisotropic medium. In the first part of this work, I examine regional changes in seismic response due to the production of oil and gas from one reservoir. The previous studies primarily used two post-production ocean-bottom surveys (Phase I and Phase II), and not the legacy streamer data, due to the unavailability of legacy prestack data and very different acquisition parameters. In order to incorporate the legacy data in the present study, all three poststack data sets were cross-equalized and examined using instantaneous amplitude and energy volumes. This approach appears quite effective and helps to suppress changes unrelated to production while emphasizing those large-amplitude changes that are related to production in this noisy (by current standards) suite of data. I examine the multiple data sets first by using the instantaneous amplitude and energy attributes, and then also examine specific apparent time-lapse changes through direct comparisons of seismic traces. In so doing, I identify time-delays that, when corrected for, indicate water encroachment at the base of the producing reservoir. I also identify specific sites of leakage from various unproduced reservoirs, the result of regional pressure blowdown as explained in previous studies; those earlier studies, however, were unable to identify direct evidence of fluid movement. Of particular interest is the identification of one site where oil apparently leaked from one reservoir into a “new” reservoir that did not originally contain oil, but was ideally suited as a trap for fluids leaking from the neighboring spill-point. With continued pressure drop, oil in the new reservoir increased as more oil entered into the reservoir and expanded, liberating gas from solution. Because of the limited volume available for oil and gas in that temporary trap, oil and gas also escaped from it into the surrounding formation. I also note that some of the reservoirs demonstrate time-lapse changes only in the “gas cap” and not in the oil zone, even though gas must be coming out of solution everywhere in the reservoir. This is explained by interplay between pore-fluid modulus reduction by gas saturation decrease and dry-frame modulus increase by frame stiffening. In the second part of this work, I examine various rock-physics models in an attempt to quantitatively account for frame-stiffening that results from reduced pore-fluid pressure in the producing reservoir, searching for a model that would predict the unusual AVO features observed in the time-lapse prestack and stacked data at Teal South. While several rock-physics models are successful at predicting the time-lapse response for initial production, most fail to match the observations for continued production between Phase I and Phase II. Because the reservoir was initially overpressured and unconsolidated, reservoir compaction was likely significant, and is probably accomplished largely by uniaxial strain in the vertical direction; this implies that an anisotropic model may be required. Using Walton’s model for anisotropic unconsolidated sand, I successfully model the time-lapse changes for all phases of production. This observation may be of interest for application to other unconsolidated overpressured reservoirs under production.

A comparative analysis of Texas and Louisiana Oil-field NORM Waste Policy

NORM (Naturally Occurring Radioactive Material) Waste Policies for the nation's oil and gas producing states have been in existence since the 1980's, when Louisiana was the first state to develop a NORM regulatory program in 1989. Since that time, expectations for NORM Waste Policies have evolved, as Health, Safety, Environment, and Social responsibility (HSE & SR) grows increasingly important to the public. Therefore, the oil and gas industry's safety and environmental performance record will face challenges in the future, about its best practices for managing the co-production of NORM wastes. ^ Within the United States, NORM is not federally regulated. The U.S. EPA claims it regulates NORM under CERCLA (superfund) and the Clean Water Act. Though, there are no universally applicable regulations for radium-based NORM waste. Therefore, individual states have taken responsibility for developing NORM regulatory programs, because of the potential radiological risk it can pose to man (bone and lung cancer) and his environment. This has led to inconsistencies in NORM Waste Policies as well as a NORM management gap in both state and federal regulatory structures. ^ Fourteen different NORM regulations and guidelines were compared between Louisiana and Texas, the nation's top two petroleum producing states. Louisiana is the country's top crude oil producer when production from its Federal offshore waters are included, and fourth in crude oil production, behind Texas, Alaska, and California when Federal offshore areas are excluded. Louisiana produces more petroleum products than any state but Texas. For these reasons, a comparative analysis between Louisiana and Texas was undertaken to identify differences in their NORM regulations and guidelines for managing, handling and disposing NORM wastes. Moreover, this analysis was undertaken because Texas is the most explored and drilled worldwide and yet appears to lag behind its neighboring state in terms of its NORM Waste Policy and developing an industry standard for handling, managing and disposing NORM. As a result of this analysis, fourteen recommendations were identified.^

Effects of waste water disposal, Fruitvale Oil Field, Kern County: cooperative water quality investigation, conducted by U.S. Dept. of the Interior, Geological Survey and the Dept. of Water Resources.

At head of title: State of California, the Resources Agency of California, Dept. of Water Resources.

Treating oil field emulsion.

Mode of access: Internet.

Oil field engineering.

Mode of access: Internet.

Effects of Enhanced Oil Recovery on Production Engineers, Elm Coulee Field, Bakken Reservoir, Richland County, Montana

This presentation describes research at Montana Tech to improve oil recovery rates in the Elm Coulee Oil Field in the Bakken Reservoir, Richmond County, Montana. The slides display current recovery rate predictions, enhanced oil recovery methods, reservoir model building and history matching strategies. Recommended development strategies include implementing hydrocarbon gas injection operations to improve current oil recovery rates by more than 75%. The impact of increased production on Production Engineers is also described. The Principal Investigators include John Evans, Leo Heath, David Reichhardt and Burt Todd in the Petroleum Engineering Department.

Oil and Gas Production Methods in Montana

Montana's oil and gas industries aggregate a gross income of over 12,000,000 annually to the state. Oil and gas fields have been thoroughly discussed in liter­ature as to geology, location, production and future possibilities. The specific object of this report has been to compile a comprehensive study of the production methods as they occur.

Numerical Simulation of Particle Separation in An Oil-Sand Separator

The gathering systems of crude oil are greatly endangered by the fine sand and soil in oil. Up to now , how to separate sand from the viscid oil is still a technical problem for oil production home or abroad. Recently , Institute of Mechanics in Chinese Academy of Sciences has developed a new type of oil-sand separator , which has been applied successfully in oil field in situ. In this paper, the numerical method of vortex-stream function is used to predict the liquid-solid separating course and the efficiency for this oil-sand separator. Results show that the viscosity and particle diameter have much influence on the particle motion. The calculating separating efficiency is compared with that of experiment and indicates that this method can be used to model the complex two-phase flow in the separator.

Avaliação do possível impacto das técnicas de MEOR (Microbial Enhanced Oil Recovery) no fator de recuperação das reservas de petróleo e gás do Brasil

Os métodos tradicionais de estimular a produção de petróleo, envolvendo a injeção de água, vapor, gás ou outros produtos, estabeleceram a base conceitual para novos métodos de extração de óleo, utilizando micro-organismos e processos biológicos. As tecnologias que empregam os processos de bioestimulação e bioaumentação já são amplamente utilizadas em inúmeras aplicações industriais, farmacêuticas e agroindustriais, e mais recentemente, na indústria do petróleo. Dada a enorme dimensão econômica da indústria do petróleo, qualquer tecnologia que possa aumentar a produção ou o fator de recuperação de um campo petrolífero gera a expectativa de grandes benefícios técnicos, econômicos e estratégicos. Buscando avaliar o possível impacto de MEOR (microbial enhanced oil recovery) no fator de recuperação das reservas de óleo e gás no Brasil, e quais técnicas poderiam ser mais indicadas, foi feito um amplo estudo dessas técnicas e de diversos aspectos da geologia no Brasil. Também foram realizados estudos preliminares de uma técnica de MEOR (bioacidificação) com possível aplicabilidade em reservatórios brasileiros. Os resultados demonstram que as técnicas de MEOR podem ser eficazes na produção, solubilização, emulsificação ou transformação de diversos compostos, e que podem promover outros efeitos físicos no óleo ou na matriz da rocha reservatório. Também foram identificadas bacias petrolíferas brasileiras e recursos não convencionais com maior potencial para utilização de determinadas técnicas de MEOR. Finalmente, foram identificadas algumas técnicas de MEOR que merecem maiores estudos, entre as técnicas mais consolidadas (como a produção de biossurfatantes e biopolímeros, e o controle da biocorrosão), e as que ainda não foram completamente viabilizadas (como a gaseificação de carvão, óleo e matéria orgânica; a dissociação microbiana de hidratos de gás; a bioconversão de CO2 em metano; e a bioacidificação). Apesar de seu potencial ainda não ser amplamente reconhecido, as técnicas de MEOR representam o limiar de uma nova era na estimulação da produção de recursos petrolíferos existentes, e até mesmo para os planos de desenvolvimento de novas áreas petrolíferas e recursos energéticos. Este trabalho fornece o embasamento técnico para sugerir novas iniciativas, reconhecer o potencial estratégico de MEOR, e para ajudar a realizar seu pleno potencial e seus benefícios.