Influence of light and temperature on seed germination of Cereus pernambucensis Lemaire (Cactaceae)

The objective of the present study was to evaluate the effects of light and temperature on germination of Cereus pernambucensis seeds, a species of columnar cactus native to Brazil and naturally incident in the restinga. Cereus pernambucensis seeds were incubated under different temperatures, from 5 to 45 °C, with 5 °C intervals, and under alternating temperatures of 15-20 °C, 15-30 °C, 20-25 °C, 20-30 °C, 20-35 °C, 25-30 °C, 25-35 °C, and 30-35 °C, both under continuous white light and dark. The seeds were also incubated in a gradient of phytochrome photoequilibrium at 25 °C. The highest percentage germination in this species was between 25 and 30 °C. The minimum temperature was between 15 and 20 °C and the maximum between 35 and 40 °C. Alternating temperatures did not affect the percentage of seed germination, but it did alter the rate and synchronization indexes. Seeds incubated in the dark did not germinate under any of the conditions tested, indicating that this species when cultivated present light sensitive seeds controlled by phytochrome. The seeds can tolerate a lot of shade conditions, germinating under very low fluence response of phytochrome.

Cereus peruvianus (Koubo) new cactus fruit for the world

Several different species of the columnar cacti of the genera Stenocereus and Pachycereus, were introduced into different semi-arid ecozones in Israel and most of these efforts were of disappointing outcomes, the only exception being the Cereus peruvianus (L.) Miller,which bore plenty of fruits, some of them of good taste. The original seeds of this plant were obtained from the late Mr. Amram (Ron) Kodish, who collected seeds from various private gardens in Southern California which bore fruits of reasonable qualities. The initial success of this species led us to initiate an intensive research study, and today it is already fruit-crop, marketed mainly in Israel under the name " Koubo" . This paper will describe our work of domestication of this new cactus fruit crop in Israel.

Occurrence of wide-band tracheids in Cactaceae: wood variation during Pilosocereus auriasetus development

Studies of wide-band tracheids (WBTs) have aroused the interest of researchers who have searched to understand their origin, function, and phylogenetic implications. The present research has the objective of studying the distribution of WBTs, together with anatomic aspects of vegetative organs in different stages of Pilosocereus aurisetus, in order to understand the occurrence of WBTs in columnar cacti. Transverse and longitudinal sections of the stem (apex, middle, and base) and the root were made. The epidermis was present in the photosynthetic stem, but was substituted by periderm which was already well established in the root. The differentiation of the cortex is visible in the middle of the stem, becoming homogeneous in the base. WBTs were observed in the base and middle of young stems (WBT monomorphic wood); common in stems of globular cacti. However, WBTs/ fibrous dimorphic wood was observed in the base of adult stems, a result of the cambial activity producing vessel elements and fibers. This wood polymorphism of the Cactaceae can be interpreted as cambial variation, a common character of Caryophyllales. Due to the small size of the plant, the presence of WBTs in the young stem may be related to water retention necessary for its development, rather than to physical support of the plant.

Wide-band tracheids (WBTs) of photosynthetic and non-photosynthetic stems in species of Cactaceae

ARRUDA, E. AND G. F. A. MELO-DE-PINNA (Departamento de Botanica, Instituto de Biociencias. Universidade de Sao Paulo, Rua do Matao, travessa 14, Cidade Universitaria, Butanta, Caixa Postal 11461, 05422-970. Sao Paulo, SP, Brasil). Wide-band tracheids (WBTs) of the photosynthetic and non-photosynthetic stems in species of Cactaceae. J. Torrey Bat. Soc. 137: 16-29. 2010.-The absence of WBTs and wood polymorphisms in some species of the Caryophyllales may be related to the particular area of plant analyzed. The present research has the objective of studying the photosynthetic and non-photosynthetic stems of different species and stages of differentiation to register wood polymorphisms and to understand the distribution and occurrence of WBTs. Wood polymorphism was observed in the non-photosynthetic stern of young and adult plants of Opuntioideae and Cactoideae and is also found in the photosynthetic stem of young plants of some species of Cactoideae. Cactoideae present WBT/fibrous dimorphic wood that can be related to cambial variation associated with growth habits and plant development. As expected, in the photosynthetic stem of the adult columnar cacti the wood is monomorphic fibrous in which WBTs were not found. This wood contains a great amount of fibers due to necessity of the mechanical support. In contrast, the globular species do not possess fibers in this area of the stem in either adult or young plants. Opuntia monacantha Haw. had non-fibrous wood in which WBTs were observed in the axial system and in the inner parts of the rays. Fiber clusters were present in the axial system. This wood represents a variation in the wood types described for Opuntioideae. Also, in O. monacantha, cells similar to the WBTs were observed in the pith, which can be interpreted as variation in the morphogenic processes during the ontogeny of the plant, probably a case of homeosis. Monomorphic fibrous wood without WBTs was found along the entire stem of Pereskia bahiensis Gurke. This feature has been observed in other pereskias, and in addition to the others, indicates its proximity to the ancestral cacti.

Influence of light and temperature on seed germination of Cereus pernambucensis Lemaire (Cactaceae)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Mechanical Blocking Mechanism for the Columnar to Equiaxed Transition

Mechanical blocking of the columnar front during the columnar to equiaxed transition (CET) is studied by quantitatively comparing the CET positions obtained with one stochastic model and two deterministic models for the unidirectional solidification of an Al-7 (wt pct) Si alloy. One of the deterministic models is based on the solutal blocking of the columnar front, whereas the other model is based on the mechanical blocking. The solutal-blocking model and the mechanical-blocking model with the traditional blocking fraction of 0.49 give columnar zones larger than those predicted with the stochastic model. When a blocking fraction of 0.2 is adopted, however, the agreement is very good for a range of nucleation undercoolings and number density of equiaxed grains. Therefore, changing the mechanical-blocking fraction in deterministic models from 0.49 to 0.2 seems to model more accurately the mechanical-blocking process that can lead to the CET.

Predicting the columnar-to-equiaxed transition for a distribution of nucleation undercoolings

A deterministic mathematical model for steady-state unidirectional solidification is proposed to predict the columnar-to-equiaxed transition. In the model, which is an extension to the classic model proposed by Hunt [Hunt JD. Mater Sci Eng 1984;65:75], equiaxed grains nucleate according to either a normal or a log-normal distribution of nucleation undercoolings. Growth maps are constructed, indicating either columnar or equiaxed solidification as a function of the velocity of isotherms and temperature gradient. The fields A columnar and equiaxed growth change significantly with the spread of the nucleation undercooling distribution. Increasing the spread Favors columnar solidification if the dimensionless velocity of the isotherms is larger than 1. For a velocity less than 1, however, equiaxed solidification is initially favored, but columnar solidification is enhanced for a larger increase in the spread. This behavior was confirmed by a stochastic model, which showed that an increase in the distribution spread Could change the grain structure from completely columnar to 50% columnar grains. (c) 2008 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

Modeling of columnar-to-equiaxed transition in solidified Al-Si alloys

A Cellular-Automaton Finite-Volume-Method (CAFVM) algorithm has been developed, coupling with macroscopic model for heat transfer calculation and microscopic models for nucleation and growth. The solution equations have been solved to determine the time-dependent constitutional undercooling and interface retardation during solidification. The constitutional undercooling is then coupled into the CAFVM algorithm to investigate both the effects of thermal and constitutional undercooling on columnar growth and crystal selection in the columnar zone, and formation of equiaxed crystals in the bulk liquid. The model cannot only simulate microstructures of alloys but also investigates nucleation mechanisms and growth kinetics of alloys solidified with various solute concentrations and solidification morphologies.

Columnar to equiaxed transition of eutectic in hypoeutectic aluminium-silicon alloys

Directional solidification of unmodified and strontium modified binary, high-purity aluminium-7 wt% silicon and commercial A356 alloys has been carried out to investigate the mechanism of eutectic solidification. The microstructure of the eutectic growth inter-face was investigated with optical microscopy and Electron Backscattering Diffraction (EBSD). In the commercial alloys, the eutectic solidification inter-face extends in the growth direction and creates a eutectic mushy zone. A planar eutectic growth front is observed in the high-purity alloys. The eutectic aluminium has mainly the same crystallographic orientation as the dendrites in the unmodified alloys and the strontium modified high-purity alloy. A more complex eutectic grain structure is found in the strontium modified commercial alloy. A mechanism involving constitutional undercooling and a columnar to equiaxed transition explains the differences between pure and commercial alloys. It is probably caused by the segregation of iron and magnesium and the activation of nucleants in the commercial alloy. (C) 2002 Acta Materialia Inc. Published by Elsevier Science Ltd. All rights reserved.

A study of the endocervical columnar cells I - morphology and frequency

After the observation of many thousands of histological sections of the endocervical mucosa it became evident that its columnar cells present a great variety of aspects not only those of the surface of the canal but also those of the glands. A classification of these cells was made taking into account the staining affinity, the intensity staining of the cytoplasm, the presence or absence of cilia, the shape and location of the nucleus. The various combinations of these different data made possible the characterization of 26 types of cells which we labelled by the alphabetical letters. Two hundred and fifty cervices obtained by cervical amputation and by hysterectomy were studied. The uteri presented lesions in the course of routine laboratory examination. In each of the 250 histological sections there were specifically counted 2,000 columnar cells which cover the cervical canal and 2,000columnar cells which form the glands. A graphic representation of the frequency of both the superficial and glandular columnar cells was presented; this was given the name EPITHELIOGRAM. The variation of the cellular "composition" of each epithelium is discussed and the frequency of the various cellular types after the count of one million of cells is presented.

A study of the endocervical columnar cells II - effects of physiological changes and of oathological lesions of the uterus on the specific numerical composition of the endocervical epithelium

In the second part of this paper we nalysed the correlation between the clinical pathological alterations and the sum of the types of columnar cells of 300 histological sections of cervix. Fifty histological sections of normal cervix of sexually mature women were selected and considered as normal in pattern. The specific counts of the columnar cells which line the endocervical mucosa and those of the glands of 50 normal cervices were compared with other similar counts made in 50 histological sections of cervices of old women and emphasized the differences. Comparisons were made also between 50 normal cervices and 50 sections of cervices with chronic inflammation, 50 cervices with epidermoid metaplasia and 50 cervices with myoma of the corpus. Counts were made from 50 cervices of patients who on the occasion of the surgical operation were in the proliferative phase of the menstrual cycle; these were compared with the counts of 50 cervices of uteri in the luteal phase. Finally, the numerical frequency of the following data encountered in the 300 cervices was recorded: 1. aspects of the ectocervical epithelium; 2. number of Nabothian cysts; 3. number of cervical glands; 5. number of deliveries and 6. aspect of the material within the cervical canal.

Dynamical scaling of imbibition in columnar geometries

compatible with the usual nonlocal model governed by surface tension that results from a macroscopic description. To explore this discrepancy, we exhaustively analyze numerical integrations of a phase-field model with dichotomic columnar disorder. We find that two distinct behaviors are possible depending on the capillary contrast between the two values of disorder. In a high-contrast case, where interface evolution is mainly dominated by the disorder, an inherent anomalous scaling is always observed. Moreover, in agreement with experimental work, the interface motion has to be described through a local model. On the other hand, in a lower-contrast case, the interface is dominated by interfacial tension and can be well modeled by a nonlocal model. We have studied both spontaneous and forced-flow imbibition situations, giving a complete set of scaling exponents in each case, as well as a comparison to the experimental results.

Vine-cacti pitayas: the new crops of the world

Until 1994, only scarce research existed on these plants; however the worldwide interest in this novel fruit crop is evident, as numbers of pitaya-related publications have grown rapidly, especially during the past decade .There is a big confusion about both botanical and commercial names and there is a need to clear this point. Herein, we attempt to review existing knowledge on the taxonomy, breeding and other horticultural characteristics of this unique crop. This paper comments abou taxonomy,breeding,physiology and horticultura e chatera ristics,postsharvest and uses.

Fabrication of thin films and nano columnar structures of Fe-Ni amorphous alloys and modification of its surface properties by thermal annealing and swift heavy ion irradiation for tailoring the magnetic properties

Department of Physics, Cochin University of Science and Technology