Sorption kinetics and intrapaticulate diffusivity of As(III) bioremediation from aqueous solution, using modified and unmodified coconut fiber

The pollution and toxicity problems posed by arsenic in the environment have long been established. Hence, the removal and recovery remedies have been sought, bearing in mind the efficiency, cost effectiveness and environmental friendliness of the methods employed. The sorption kinetics and intraparticulate diffusivity of As (III) bioremediation from aqueous solution using modified and unmodified coconut fiber was investigated. The amount adsorbed increased as time increased, reaching equilibrium at about 60 minutes. The kinetic studies showed that the sorption rates could be described by both pseudo-first order and pseudo-second order process with the later showing a better fit with a value of rate constant of 1.16 x 10-4 min-1 for the three adsorbent types. The mechanism of sorption was found to be particle diffusion controlled. The diffusion and boundary layer effects were also investigation. Therefore, the results show that coconut fiber, both modified and unmodified is an efficient sorbent for the removal of As (III) from industrial effluents with particle diffusion as the predominant mechanism.

Accumulation of nutrients in sweet peppers cultivated in coconut fiber

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Growth analysis of sweet pepper cultivated in coconut fiber in a greenhouse

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

CHEMICAL MODIFICATION EFFECT on THE MECHANICAL PROPERTIES of HIPS/COCONUT FIBER COMPOSITES

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Nitrogen and potassium concentrations in the nutrients solution for melon plants growing in coconut fiber without drainage

With the objective of evaluating the effects of N and K concentrations for melon plants, an experiment was carried out from July 1, 2011 to January 3, 2012 in Muzambinho city, Minas Gerais State, Brazil. The Bonus no. 2 was cultivated at the spacing of 1.1 × 0.4. The experimental design was a randomized complete block with three replications in a 4 × 4 factorial scheme with four N concentrations (8, 12, 16, and 20 mmol L-1) and four K concentrations (4, 6, 8, and 10 mmol L-1). The experimental plot constituted of eight plants. It was observed that the leaf levels of N and K, of N-NO3 and of K, and the electrical conductivity (CE) of the substrate increased with the increment of N and K in the nutrients' solution. Substratum pH, in general, was reduced with increments in N concentration and increased with increasing K concentrations in the nutrients' solution. Leaf area increased with increments in N concentration in the nutrients solution. Fertigation with solutions stronger in N (20 mmol L-1) and K (10 mmol L-1) resulted in higher masses for the first (968 g) and the second (951 g) fruits and crop yield (4,425 gm-2). © 2013 Luiz Augusto Gratieri et al.

Covalent immobilization of laccase in green coconut fiber and use in clarification of apple juice

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Performance of cucumber hybrids cultivated in coconut fiber and soil

The objective of this work was to evaluate the performance of three Japanese group cucumber hybrids, which were cultivated in two cultivation systems. The experiment was designed in a split-plot randomized block design with two cultivation systems (coconut fiber and soil) for commercial Japanese cucumber hybrids ('Tsuyataro', 'Yoshinari' and 'Nankyoku'). After harvesting the cucumbers, we evaluated the number of marketable fruits per plant, the average fruit length, the mean fruit diameter, the bottom fruit diameter, the marketable production of fruits per plant and the marketable yield per hectare. There were significant interactions between the cultivation system and the hybrid, as indicated by the number of marketable fruits. The Nankyoku hybrid had the highest average (14.54 fruits pl(-1)), although it did not differ from the Yoshinari hybrid when grown in coconut fiber. In soil culture, the Yoshinari hybrid had the highest average number of fruits per plant (10.12 fruits pl(-1)) and did not differ from the Tsuyataro hybrid. Cultivation in coconut fiber provided better results for production traits and plant productivity. 'Yoshinari' and 'Nankyoku' were the most productive hybrids. Based on the cucumber cultivation results from a protected environment, the cultivation of hybrid Japanese cucumbers and Yoshinari and Nankyoku hybrids in coconut fiber is recommended.

Particulate composite based on coconut fiber and castor oil polyurethane adhesive: An eco-efficient product

This paper presents a study on the potential use of coconut fiber as material to produce particleboards, with two different densities (0.8 g/cm(3) and 1.0 g/cm3), using castor oil-based polyurethane adhesive and urea-formaldehyde. The quality of the product that can be produced by industry was evaluated according to the normative NBR 14.810:2006, where density, thickness swell (TS), absorption, modulus of elasticity (MOE), modulus of rupture (MOR) in static bending and internal bond (IB) were determined. From the results, there was a decrease in TS and increase in MOR of coconut fiber panels with polyurethane resin panels compared with coconut fiber and resin urea-formaldehyde. Scanning microscopy electronic images (SEM) indicated that castor oil-based polyurethane adhesive occupies the gaps between the particles, a factor that contributes to improved physical and mechanical properties of the panels. The assessment of durability through accelerated aging tests shows that panels protected with waterproofing material can be used in environments that have contact with moisture. (C) 2012 Elsevier B.V. All rights reserved.

A model for acoustic absorbent materials derived from coconut fiber

In the present paper, a methodology is proposed for obtaining empirical equations describing the sound absorption characteristics of an absorbing material obtained from natural fibers, specifically from coconut. The method, which was previously applied to other materials, requires performing measurements of air-flow resistivity and of acoustic impedance for samples of the material under study. The equations that govern the acoustic behavior of the material are then derived by means of a least-squares fit of the acoustic impedance and of the propagation constant. These results can be useful since they allow the empirically obtained analytical equations to be easily incorporated in prediction and simulation models of acoustic systems for noise control that incorporate the studied materials.

Chemical and physical properties of organic residues

Due to human activity, large amounts of organic residue are generated daily. Therefore, an adequate use in agricultural activities requires the characterization of the main properties. The chemical and physical characterization is important when planning the use and management of organic residue. In this study, chemical and physical properties of charcoal, coffee husk, pine-bark, cattle manure, chicken manure, coconut fiber, sewage sludge, peat, and vermiculite were determined. The following properties were analyzed: N-NH4+, N-N0(3)-, and total concentrations of N, P, S, K, Ca, Mg, Mn, Zn, Cu, and B, as well as pH, Electrical Conductivity (EC) and bulk density. Coffee husk, sewage sludge, chicken manure and cattle manure were generally richer in nutrients. The EC values of these residues were also the highest (0.08 - 40.6 dS m-1). Peat and sewage sludge had the highest bulky density. Sodium contents varied from 0 to 4.75 g kg-1, with the highest levels in chicken manure, cattle manure and sewage sludge. Great care must be taken when establishing proportions of organic residues in the production of substrates with coffee husk, cattle or chicken manure or sewage sludge in the calculation of the applied fertilizer quantity in crop fertilization programs.

Evaluation of substrates on the emergence of "araticum-de-terra-fria" (Annona emarginata (Schltdl.) H. Rainer) Seedlings

Choosing a substrate is the determinant factor for the seedling producer; thus, the aim of this study was to evaluate the effect of different types of substrates on the emergence of "araticum-de-terra-fria" (Annona emarginata (Schltdl.) H. Rainer) seedlings. The experiment was carried out in a greenhouse and the experimental design was in randomized blocks, with three treatments and five replicates of 72 seeds per plot. The treatments consisted of the following substrates: coconut fiber, vermiculite and Plantmax® Citrus. The number of emerged seedlings was weekly counted for 105 days. Data regarding seedling height were obtained, and the emergence velocity index and mean time, besides total emergence percentage and that over time were calculated. Results from total mean emergence percentage, seedling height, emergence velocity index (EVI), and mean emergence time (MET) were subjected to analysis of variance and means were compared by the Tukey's test at 5% significance. The curves concerning the emergence percentage over time were fit by the logistic growth equation for each treatment and the means of each parameter (A, B, C) were compared by the Duncan's test at 5% significance. The substrates vermiculite led to the highest values of emergence percentage differing from the PlantMax® Citrus, but not of the coconut fiber, however the vermiculite promoted seedling height in a shorter time; therefore, this substrate is recommended for the initial development of "araticum-de-terra-fria" (Annona emarginata (Schltdl.) H. Rainer) seedlings.

THE LYCHEE TREE PROPAGATION BY LAYERING

The aim of the study was to assess the influence of season and different substrates on rooting of air layers of lychee (Litchi chinensisSonn.) for the production of seedlings to ensure the formation of uniform and productive orchards. Air layers were done in plants of the Bengal cultivar using leafy and healthy woody branches, with about 0.010 to 0.015 m in diameter, in which were performed complete girdling with 0.020 m wide at a distance of 0.30 to 0.40 m below the apex. Then the branches were wrapped in moistened substrate. The layering was made at six times of theyear (January, March, May, July, September and November) and two substrates were used (coconut fiber and sphagnum) in a 6 x 2 factorial design in a randomized block with ten replicates. After 90 days, layers were separated from the matrix plant and evaluated for rooting and callus formation, root number, considering only the primary roots, length, area and volume of the roots, beyond the dry weight of roots and calluses. The months of January, March, September and November showed the best results for all analyzed variables related to rooting. With respect to the substrates, the only difference was in January and March to the root number and dry weight of roots, where the sphagnum showed the best results. The month of July was more conducive to the formation of calluses. The period between September and March was more suitable to the propagation of lychee, when there were rooting percentages above 90%, in addition to the formation of large amount of roots.