Estudo da tratabilidade de água pluvial utilizando coagulante natural a base de tanino visando fins não potáveis

This paper aimed to study the treatability of rainwater collected in Rio Claro, SP, using natural coagulant tannin based. The tannin was compared with other too primary coagulants, namely ferric chloride and corn starch. Assays were performed in laboratory scale using equipment known as Jarteste and aimed to study the conditions most suitable dosage and coagulation pH. First tests were conducted to compare the coagulating and determination of the conditions to be used in the following tests, taking as a criterion the greatest efficiency for water treatment. Also performed were performed tests to construct the tannin coagulation diagram, using the optimal concentration found in the previous phase, by varying the dosage of coagulant and the pH of clotting in order to determine the isoefficiency regions for apparent color and turbidity. Finally, tests were performed cyclically filtration with filter paper. Preliminary tests indicated that the vegetable tannin concentration 3% (m/m) from the commercial solution was presented the best set of results (84.3% removal of apparent color and 82.51% removal of turbidity) compared to ferric chloride (66.25% removal efficiency and apparent color of turbidity 67.82%) and starch (73.68% removal efficiency apparent color and turbidity to 67.19%). The coagulation diagrams indicate that the best region to work with vegetable tannin 3% is where the coagulant dosage ranges from 15 mg/L to about 37.5 mg/L and coagulation pH ranging from about 6.5 to 7.5. The cyclic filtration showed to be not efficient for the best dosage of coagulant, due to the process of clogging of the filter paper, but proved to be efficient for other dosages. Thus, for the waters studied, the results indicate that the natural coagulant based tannin is an alternative to conventional coagulants, possessing benefits of technical and environmental

Tratabilidade de águas pluviais utilizando coagulante natural a base de tanino visando fins não potáveis

This paper aimed to study the treatability of rainwater using natural coagulant tannin based. Assays were performed in laboratory scale and aimed to study the conditions most suitable for dosage and for pH of coagulation. Preliminary tests indicated that tannin concentration of 3% (m/m) prepared from the commercial solution presented the best set of results (84.3% of removal for apparent color and 82.51% for turbidity) compared to ferric chloride (66.25% of removal for apparent color and 67.82% for turbidity) and starch (73.68% of removal for apparent color and 67.19% for turbidity). The coagulation diagrams indicate that the best region for dosage ranges from 15 mg/L to about 37.5 mg/L and for pH ranging from about 6.5 to 7.5. The results indicate that the tannin based natural coagulant may be an alternative to conventional coagulants for rainwater treatment seeking non potable uses.

Usos potenciais de moringa oleifera lam., uma matriz para produção de biodiesel e tratamento de água no semiárido nordestino

The current environmental crisis demands transformations in the relations among society, nature and development, considering sustainability. In this context, an important theme is replacing fossil fuels with biofuels, such as biodiesel. Moringa oleifera Lam. is a species that can be used as a raw material to produce biodiesel. Besides, it is a multiple purposes plant, which can be used also in water treatment. Thus, the aims of this work were to analyze the anatomical adaptations found in the stem and in the leaf and the seed s oil stores of M. oleifera., to investigate chemical characteristics of M. oleifera s seed oil, considering biodiesel production, and to evaluate the coagulation activity of these seeds in water treatment. Semipermanent histological laminas were made and it follows that the stem has thick cuticle, stomata whose cells guard are below the epidermis line, hollow medulla, druses and tector trichomes as adaptations to climate and soil conditions in which the species is found and the leaf is dorsiventral and it has thick cuticle, tector trichomes and druses. The seed has great reserves of oil. These features favor the use of Moringa oleifera Lam. as a raw material to produce biodiesel in Brazil s Northeast semiarid region. Chemical analysis were made through oil solvent extraction using mechanic stirrer. The oil was analyzed in UV spectrophotometer. A transesterification was made and biodiesel was analyzed in gas chromatography. Oil yield was high and good quality biodiesel was obtained. To evaluate seeds coagulantion activity, coagulation and flocculation essays in jartest were made, using seed extract to treat raw water. Seeds were efficient in cogulation process to treat water. So, they can be used in rudimentary systems or as a raw material to coagulant proteins extraction, as an alternative to traditional coagulants. M. oleifera has characteristics that favor its use to biodiesel production and water treatment

Avaliação do desempenho de uma unidade em escala real para tratamento de água pluvial empregando a filtração direta por meio de filtro de pressão e amido natural de milho como coagulante primário

The aim of this study was to investigate the performance of an experimental rainwater treatment system for non-potable uses. Without the first-flush discharge it was expected to control the quality of captured rainwater and to minimize the rainwater by-pass caused by the first-flush strategy. A full-scale direct filtration unit was operated and a solution of natural corn starch was used as the primary coagulant. The color, turbidity e coliform efficiencies of the unit was analyzed based on filtration loads and the net water production was estimated. The results pointed out turbidity removal up to 70.8% and color removal up to 61.0%. The backwash of the filtering system was completed in 3 minutes at the rate of 1,440 m3/m2day with consumption of treated water from 0.5% to 2.2%, based on the potentially harvesting.

Avaliação do soro de leite como coagulante do látex de borracha natural

Pós-graduação em Ciência dos Materiais - FEIS

Tratamento de água pluvial para fins não potáveis com utilização de amido de milho como coagulante em filtração cíclica em escala de laboratório

The aim of the present work is to investigate a simplified rainwater treatment strategy for nonpotable use. For this, there were simulated in laboratory scale the treatment conditions of a system that employs Corn Starch as a coagulant in cyclic filtration (from 1 to 5 filtration cycles). A commercial Corn Starch in different dosages was used (0,1; 0,2; 0,4; 0,6; 0,8; 1,0; 1,5; 2,0; 2,5; 3,0; 3,5; 4,0; 4,5; 5,0; 5,5; 6,0; 6,5; 7,0; 7,5; 8,0; 8,5 e 9,0 mg/L). The NBR 15527/07 recommended parameters were monitored on the inflow and outflow and compared to different first flushes (0.5; 1.0 and 1.5mm). The obtained results indicate that the 6.0mg/L dosage presented the best results (removal efficiency of 86% of turbidity; 88% of apparent color and absent of total and faecal coliform residuals). However, it was not possible to prove the filtration cycles benefit, in laboratory scale, because for some Corn Starch dosages the water did not present better quality when increasing the number of cycles.

Avaliação do amido natural como alternativa simples para tratamento de águas pluviais para fins de aproveitamento não potável

This work aims to evaluate a simple procedure for rainwater treatment by applying natural corn starch as primary coagulant for non-potable harvesting households. For this purpose, coagulation, flocculation and filtration were carried out in lab essays in samples of roof and floor catchment without first-flush. There were investigated corn starch dosages from 1 to 12 mg/L in pH values around 6,0. The apparent color and turbidity were measured and the results were statistically presented. Results pointed out reductions around 70 and 80% for apparent color and turbidity (residuals of 53Hu and 13Tu), respectively.

Particle and gaseous emissions from compressed natural gas and ultralow sulphur diesel-fuelled buses at four steady engine loads

Exhaust emissions from thirteen compressed natural gas (CNG) and nine ultralow sulphur diesel in-service transport buses were monitored on a chassis dynamometer. Measurements were carried out at idle and at three steady engine loads of 25%, 50% and 100% of maximum power at a fixed speed of 60 kmph. Emission factors were estimated for particle mass and number, carbon dioxide and oxides of nitrogen for two types of CNG buses (Scania and MAN, compatible with Euro 2 and 3 emission standards, respectively) and two types of diesel buses (Volvo Pre-Euro/Euro1 and Mercedez OC500 Euro3). All emission factors increased with load. The median particle mass emission factor for the CNG buses was less than 1% of that from the diesel buses at all loads. However, the particle number emission factors did not show a statistically significant difference between buses operating on the two types of fuel. In this paper, for the very first time, particle number emission factors are presented at four steady state engine loads for CNG buses. Median values ranged from the order of 1012 particles min-1 at idle to 1015 particles km-1 at full power. Most of the particles observed in the CNG emissions were in the nanoparticle size range and likely to be composed of volatile organic compounds The CO2 emission factors were about 20% to 30% greater for the diesel buses over the CNG buses, while the oxides of nitrogen emission factors did not show any difference due to the large variation between buses.

A natural model for architecture : the nature of the evolutionary model 1995

John Frazer's architectural work is inspired by living and generative processes. Both evolutionary and revolutionary, it explores informatin ecologies and the dynamics of the spaces between objects. Fuelled by an interest in the cybernetic work of Gordon Pask and Norbert Wiener, and the possibilities of the computer and the "new science" it has facilitated, Frazer and his team of collaborators have conducted a series of experiments that utilize genetic algorithms, cellular automata, emergent behaviour, complexity and feedback loops to create a truly dynamic architecture. Frazer studied at the Architectural Association (AA) in London from 1963 to 1969, and later became unit master of Diploma Unit 11 there. He was subsequently Director of Computer-Aided Design at the University of Ulter - a post he held while writing An Evolutionary Architecture in 1995 - and a lecturer at the University of Cambridge. In 1983 he co-founded Autographics Software Ltd, which pioneered microprocessor graphics. Frazer was awarded a person chair at the University of Ulster in 1984. In Frazer's hands, architecture becomes machine-readable, formally open-ended and responsive. His work as computer consultant to Cedric Price's Generator Project of 1976 (see P84)led to the development of a series of tools and processes; these have resulted in projects such as the Calbuild Kit (1985) and the Universal Constructor (1990). These subsequent computer-orientated architectural machines are makers of architectural form beyond the full control of the architect-programmer. Frazer makes much reference to the multi-celled relationships found in nature, and their ongoing morphosis in response to continually changing contextual criteria. He defines the elements that describe his evolutionary architectural model thus: "A genetic code script, rules for the development of the code, mapping of the code to a virtual model, the nature of the environment for the development of the model and, most importantly, the criteria for selection. In setting out these parameters for designing evolutionary architectures, Frazer goes beyond the usual notions of architectural beauty and aesthetics. Nevertheless his work is not without an aesthetic: some pieces are a frenzy of mad wire, while others have a modularity that is reminiscent of biological form. Algorithms form the basis of Frazer's designs. These algorithms determine a variety of formal results dependent on the nature of the information they are given. His work, therefore, is always dynamic, always evolving and always different. Designing with algorithms is also critical to other architects featured in this book, such as Marcos Novak (see p150). Frazer has made an unparalleled contribution to defining architectural possibilities for the twenty-first century, and remains an inspiration to architects seeking to create responsive environments. Architects were initially slow to pick up on the opportunities that the computer provides. These opportunities are both representational and spatial: computers can help architects draw buildings and, more importantly, they can help architects create varied spaces, both virtual and actual. Frazer's work was groundbreaking in this respect, and well before its time.

The role of natural ventilation in building sustainable subdivisions in south east Queensland

The objective of the consultative phase is to examine the role that natural ventilation has and can play in the subdivision planning process in SEQ. The Centre for Subtropical Design at QUT coordinated the consultative phase and has conducted a workshop, and interviews, with stakeholders including developers, land development consultants, land surveyors, urban designers and regulators, to identify current understanding of the impact of urban subdivision on natural ventilation, and the role of natural ventilation in achieving energy efficiency for dwellings. This report details the findings.