Case study : South East Busway (SEB), Brisbane, Australia

The South East Busway (SEB) of Brisbane’s busway network is one of the main facilities which provide access to commuters from South East (SE) Brisbane. SEB gives better satisfaction for passengers as far as reliability is considered. The operation procedure of SEB is complex due to its stations, ramps/intersections, bus equipment characteristics, bus service patterns and fare collection method. However, a comprehensive document of SEB is scarce as far as its overall performance is concerned. Therefore this report demonstrates a comprehensive and very strong appreciation of the overall operational processes of the world’s most sophisticated busway.

Investigation of the effects of various types of wind turbine generators on power-system stability

It has become more and more demanding to investigate the impacts of wind farms on power system operation as ever-increasing penetration levels of wind power have the potential to bring about a series of dynamic stability problems for power systems. This paper undertakes such an investigation through investigating the small signal and transient stabilities of power systems that are separately integrated with three types of wind turbine generators (WTGs), namely the squirrel cage induction generator (SCIG), the doubly fed induction generator (DFIG), and the permanent magnet generator (PMG). To examine the effects of these WTGs on a power system with regard to its stability under different operating conditions, a selected synchronous generator (SG) of the well-known Western Electricity Coordinating Council (WECC three-unit nine-bus system and an eight-unit 24-bus system is replaced in turn by each type of WTG with the same capacity. The performances of the power system in response to the disturbances are then systematically compared. Specifically, the following comparisons are undertaken: (1) performances of the power system before and after the integration of the WTGs; and (2) performances of the power system and the associated consequences when the SCIG, DFIG, or PMG are separately connected to the system. These stability case studies utilize both eigenvalue analysis and dynamic time-domain simulation methods.

Space vector based bus clamped PWM algorithms for three level inverters: implementation, performance analysis and application considerations

This paper describes the different types of space vector based bus clamped PWM algorithms for three level inverters. A novel bus clamp PWM algorithm for low modulation indices region is also presented. The principles and switching sequences of all the types of bus clamped algorithms for high switching frequency are presented. Synchronized version of the PWM sequences for high power applications where switching frequency is low is also presented. The implementation details on DSP based digital controller and experimental results are presented. The THD of the output waveforms is studied for the entire operating region and is compared with the conventional space vector PWM technique. The bus clamped techniques can be used to reduce the switching losses or to improve the output voltage quality or both.. Different issues dominate depending on the type of application and power rating of the inverters. The results presented in this paper can be used for judicious use of the PWM techniques, which result in improved system efficiency and performance.

Consumers' health perceptions of three types of milk: a survey in Australia

A survey was conducted among 345 randomly selected shoppers in Melbourne, Australia, to identify their perceptions of the healthiness of whole milk, reduced fat milk and soy milk and to investigate demographic influences on health perceptions and types of milk consumption. The survey revealed major differences in shoppers' perceptions of the three types of milk along the themes of bone health, weight control, disease prevention, and, allergy and disease causation. Generally whole milk was perceived more negatively than soy or reduced fat milk. There were few demographic differences in the shoppers' perceptions of the three products. Reported consumption of reduced fat milk was more frequent among women and elderly people, and whole milk consumption was positively related to parenthood. The findings suggest that previous marketing and education campaigns have been effective but the widespread uncertainty and erroneous beliefs about milk products suggest that many consumers have not assimilated new findings about milk products. This represents a challenge for industry and public health practitioners.

Consumers` sensory and nutritional perceptions of three types of milk

Objective: To identify consumer perceptions of whole milk, reduced-fat milk and soy milk, and to investigate demographic influences on perceptions and types of milk consumption.

Design and setting: Questionnaires covering nutritional and sensory perceptions of three types of milk.

Subjects: Three hundred and sixty-one randomly selected shoppers in Melbourne, Australia.

Results: Generally, respondents held positive perceptions about milk. Milk was considered as having good sensory properties, providing a good source of nutrients, and being a convenient and safe product. However, despite these findings, misperceptions and unawareness about the nutrient content of milk were prevalent. Negative perceptions were most common for whole milk and were mostly related to its perceived high fat, cholesterol and energy contents. Soy milk received lower ratings on sensory quality and convenience than dairy milk. There were few sociodemographic differences in consumers' perceptions. Although reduced-fat milk consumption was more frequent among elderly people and type of milk consumption was related to parenthood, no other significant effects of demographic variables were found on the consumption of specific milk types.

Conclusion: Although positive perceptions were common, negative perceptions and misperceptions appear to be prevalent, presenting a challenge for nutrition education. Sociodemographic factors were not shown to be important predictors of perceptions and type of milk consumption.

Modeling and optimization of frequencies on congested bus lines

In this paper some mathematical programming models are exposed in order to set the number of services on a specified system of bus lines, which are intended to assist high demand levels which may arise because of the disruption of Rapid Transit services or during the celebration of massive events. By means of this model two types of basic magnitudes can be determined, basically: a) the number of bus units assigned to each line and b) the number of services that should be assigned to those units. In these models, passenger flow assignment to lines can be considered of the system optimum type, in the sense that the assignment of units and of services is carried out minimizing a linear combination of operation costs and total travel time of users. The models consider delays experienced by buses as a consequence of the get in/out of the passengers, queueing at stations and the delays that passengers experience waiting at the stations. For the case of a congested strategy based user optimal passenger assignment model with strict capacities on the bus lines, the use of the method of successive averages is shown.

Diesel bus emissions of submicrometer particles measured in a tunnel study

The emission factors of a bus fleet consisting of approximately three hundreds diesel powered buses were measured in a tunnel study under well controlled conditions during a two-day monitoring campaign in Brisbane. The number concentration of particles in the size range 0.017-0.7 m was monitored simultaneously by two Scanning Mobility Particle Sizers located at the tunnel’s entrance and exit. The mean value of the number emission factors was found to be (2.44±1.41)×1014 particles km-1. The results are in good agreement with the emission factors determined from steady-state dynamometer testing of 12 buses from the same Brisbane City bus fleet, thus indicating that when carefully designed, both approaches, the dynamometer and on-road studies, can provide comparable results, applicable for the assessment of the effect of traffic emissions on airborne particle pollution.

Airborne particulate matter at a bus station : concentration levels and governing parameters

Traffic emissions are an important contributor to ambient air pollution, especially in large cities featuring extensive and high density traffic networks. Bus fleets represent a significant part of inner city traffic causing an increase in exposure to general public, passengers and drivers along bus routes and at bus stations. Limited information is available on quantification of the levels, and governing parameters affecting the air pollution exposure at bus stations. The presented study investigated the bus emissions-dominated ambient air in a large, inner city bus station, with a specific focus on submicrometer particles. The study’s objectives were (i) quantification of the concentration levels; (ii) characterisation of the spatio-temporal variation; (iii) identification of the parameters governing the emissions levels at the bus station and (iv) assessment of the relationship between particle concentrations measured at the street level (background) and within the bus station. The results show that up to 90% of the emissions at the station are ultrafine particles (smaller than 100 nm), with the concentration levels up to 10 times the value of urban ambient air background (annual) and up to 4 times the local ambient air background. The governing parameters affecting particle concentration at the station were bus flow rate and meteorological conditions (wind velocity). Particle concentration followed a diurnal trend, with an increase in the morning and evening, associated with traffic rush hours. Passengers’ exposure could be significant compared to the average outdoor and indoor exposure levels.

Determination of particle concentration in the breathing zone for four different types of office ventilation systems

Many factors affect the airflow patterns, thermal comfort, contaminant removal efficiency and indoor air quality at individual workstations in office buildings. In this study, four ventilation systems were used in a test chamber designed to represent an area of a typical office building floor and reproduce the real characteristics of a modern office space. Measurements of particle concentration and thermal parameters (temperature and velocity) were carried out for each of the following types of ventilation systems: a) conventional air distribution system with ceiling supply and return; b) conventional air distribution system with ceiling supply and return near the floor; c) underfloor air distribution system; and d) split system. The measurements aimed to analyse the particle removal efficiency in the breathing zone and the impact of particle concentration on an individual at the workstation. The efficiency of the ventilation system was analysed by measuring particle size and concentration, ventilation effectiveness and the Indoor/Outdoor ratio. Each ventilation system showed different airflow patterns and the efficiency of each ventilation system in the removal of the particles in the breathing zone showed no correlation with particle size and the various methods of analyses used.

Defining friendworks : communication perspective on social networks types

This paper introduces friendwork as a new term in social networks studies. A friendwork is a network of friends. It is a specific case of an interpersonal social network. Naming this seemingly well known and familiar group of people as a friendwork facilitates its differentiation from the overall social network, while highlighting this subgroup's specific attributes and dynamics. The focus on one segment within social networks stimulates a wider discussion regarding the different subgroups within social networks. Other subgroups also discussed in this paper are: family dependent, work related, location based and virtual acquaintances networks. This discussion informs a larger study of social media, specifically addressing interactive communication modes that are in use within friendworks: direct (face-to-face) and mediated (mainly fixed telephone, internet and mobile phone). It explores the role of social media within friendworks while providing a communication perspective on social networks.