Construção de um interferômetro de Bath para análise do comportamento da superfície de vidros usados na confecção de espelhos côncavos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Development and fabrication of an optimized thermo-electro-optic device using a Mach-Zehnder interferometer

The development and fabrication of a thermo-electro-optic sensor using a Mach-Zehnder interferometer and a resistive micro-heater placed in one of the device`s arms is presented. The Mach-Zehnder structure was fabricated on a single crystal silicon substrate using silicon oxynitride and amorphous hydrogenated silicon carbide films to form an anti-resonant reflective optical waveguide. The materials were deposited by Plasma enhanced chemical vapor deposition technique at low temperatures (similar to 320 degrees C). To optimize the heat transfer and increase the device response with current variation, part of the Mach-Zehnder sensor arm was suspended through front-side bulk micromachining of the silicon substrate in a KOH solution. With the temperature variation caused by the micro-heater, the refractive index of the core layer of the optical waveguide changes due to the thermo-optic effect. Since this variation occurs only in one of the Mach-Zehnder`s arm, a phase difference between the arms is produced, leading to electromagnetic interference. In this way, the current applied to the micro-resistor can control the device output optical power. Further, reactive ion etching technique was used in this work to define the device`s geometry, and a study of SF6 based etching rates on different composition of silicon oxynitride films is also presented. (C) 2007 Elsevier B.V. All rights reserved.

Study of copper electrodeposition mechanism from a strike alkaline bath prepared with 1-hydroxyethane-1,1-diphosphonic acid through cyclic voltammetry technique

Copper strike baths are extensively used in metal plating industry as they present the ability to plate adherent copper layers on less-noble metal substrates such as steel and zinc die castings. However, in the last few years, due to environmental controls and safety policies for operators, the plating industry has been interested in replacing the toxic cyanide copper strike baths with environmentally friendly baths. A broad bibliographic review showed that the published papers, referring to the new nontoxic copper strike baths, are patents, having little or no emphasis focused on electrodeposition mechanisms. Therefore, it was decided to study the copper electrodeposition mechanism from a strike alkaline bath prepared with one of the most nontoxic chelating agents cited in many patents which is the 1-hydroxyethane-1,1-diphosphonic acid, known as HEDP. This acid forms very stable water soluble complexes with Cu(2+) ions, thus cupric sulfate was used for preparing the plating bath. The results obtained through a cyclic voltammetry technique showed that Cu(2+) ion reduction to Cu from an HEDP electrodeposition bath occurs via a direct reduction reaction without a formation of Cu(+) intermediates. (C) 2010 Elsevier Ltd. All rights reserved.

Bath house, Cleveland Point House, Cleveland

New bath house under construction (centre), with existing buildings to either side.

Bath house, Cleveland Point House, Cleveland

Bath house under construction, as seen looking towards water from deck area.

Bath house, Cleveland Point House, Cleveland

As seen looking towards water from deck area.

Bath house hip rafters, Cleveland Point House, Cleveland

Timber framing to new bath house.

Bath house section, Cleveland Point House, Cleveland

Section taken through new bath house.

Bath house, Cleveland Point House, Cleveland

Timber framing to new bath house, as seen from beachfront.

Bath house, Cleveland Point House, Cleveland

Timber framing to new bath house, as seen looking towards water from deck area (to be constructed).

Bath house, Cleveland Point House, Cleveland

As seen looking towards water from deck area.

Bath house, Cleveland Point House, Cleveland

New bath house (centre), with existing buildings to either side.

Bath house pavilion, Lake Weyba House, Sunshine Coast

South-West elevation. Paved seating area in foreground.

Bath house pavilion, Lake Weyba House, Sunshine Coast

Link to bedroom pavilion on right; roof of main pavilion on left.

Two-wire waveguide and interferometer for cold atoms

A versatile miniature de Broglie waveguide is formed by two parallel current-carrying wires in the presence of a uniform bias field. We derive a variety of analytical expressions to describe the guide and present a quantum theory to show that it offers a remarkable range of possibilities for atom manipulation on the submicron scale. These include controlled and coherent splitting of the wave function as well as cooling, trapping, and guiding. In particular, we discuss a novel microscopic atom interferometer with the potential to be exceedingly sensitive.