999 resultados para Barometric hypsometry.
Resumo:
Chiefly tables.
Resumo:
"Estr. dagli Atti della Reale accademia delle scienze di Torino, vol. v."
Resumo:
Mode of access: Internet.
Resumo:
Mode of access: Internet.
Resumo:
Stiffness values in geotechnical structures can range over many orders of magnitude for relatively small operational strains. The typical strain levels where soil stiffness changes most dramatically is in the range 0.01-0.1%, however soils do not exhibit linear stress-strain behaviour at small strains. Knowledge of the in situ stiffness at small strain is important in geotechnical numerical modelling and design. The stress-strain regime of cut slopes is complex, as we have different principle stress directions at different positions along the potential failure plane. For example, loading may be primarily in extension near the toe of the slope, while compressive loading is predominant at the crest of a slope. Cuttings in heavily overconsolidated clays are known to be susceptible to progressive failure and subsequent strain softening, in which progressive yielding propagates from the toe towards the crest of the slope over time. In order to gain a better understanding of the rate of softening it would be advantageous to measure changes in small strain stiffness in the field.
Resumo:
Unroofing of the Black Mountains, Death Valley, California, has resulted in the exposure of 1.7 Ga crystalline basement, late Precambrian amphibolite facies metasedimentary rocks, and a Tertiary magmatic complex. The Ar-40/Ar-39 cooling ages, obtained from samples collected across the entire length of the range (>55 km), combined with geobarometric results from synextensional intrusions, provide time-depth constraints on the Miocene intrusive history and extensional unroofing of the Black Mountains. Data from the southeastern Black Mountains and adjacent Greenwater Range suggest unroofing from shallow depths between 9 and 10 Ma. To the northwest in the crystalline core of the range, biotite plateau ages from approximately 13 to 6.8 Ma from rocks making up the Death Valley turtlebacks indicate a midcrustal residence (with temperatures >300-degrees-C) prior to extensional unroofing. Biotite Ar-40/Ar-39 ages from both Precambrian basement and Tertiary plutons reveal a diachronous cooling pattern of decreasing ages toward the northwest, subparallel to the regional extension direction. Diachronous cooling was accompanied by dike intrusion which also decreases in age toward the northwest. The cooling age pattern and geobarometric constraints in crystalline rocks of the Black Mountains suggest denudation of 10-15 km along a northwest directed detachment system, consistent with regional reconstructions of Tertiary extension and with unroofing of a northwest deepening crustal section. Mica cooling ages that deviate from the northwest younging trend are consistent with northwestward transport of rocks initially at shallower crustal levels onto deeper levels along splays of the detachment. The well-known Amargosa chaos and perhaps the Badwater turtleback are examples of this "splaying" process. Considering the current distance of the structurally deepest samples away from moderately to steeply east tilted Tertiary strata in the southeastern Black Mountains, these data indicate an average initial dip of the detachment system of the order of 20-degrees, similar to that determined for detachment faults in west central Arizona and southeastern California. Beginning with an initially listric geometry, a pattern of footwall unroofing accompanied by dike intrusion progress northwestward. This pattern may be explained by a model where migration of footwall flexures occur below a scoop-shaped banging wall block. One consequence of this model is that gently dipping ductile fabrics developed in the middle crust steepen in the upper crust during unloading. This process resolves the low initial dips obtained here with mapping which suggests transport of the upper plate on moderately to steeply dipping surfaces in the middle and upper crust.
Resumo:
The objective of the present study was to assess the validity of barometric whole-body plethysmography (BWBP), to establish reference values, and to standardise a bronchoprovocative test to investigate airway responsiveness using BWBP in healthy dogs. BWBP measurements were obtained from six healthy beagle dogs using different protocols: (1) during three consecutive periods (3.5min each) in two morning and two evening sessions; (2) before and after administration of two protocols of sedation; (3) before and after nebulisation of saline and increasing concentrations of carbachol and histamine both in conscious dogs and in dogs under both protocols of sedation. Enhanced pause (PENH) was used as index of bronchoconstriction. Basal BWBP measurements were also obtained in 22 healthy dogs of different breeds, age and weight. No significant influence of either time spent in the chamber or daytime was found for most respiratory variables but a significant dog effect was detected for most variables. A significant body weight effect was found on tidal volume and peak flow values (P<0.05). Response to carbachol was not reproducible and always associated with side effects. Nebulisation of histamine induced a significant increase in respiratory rate, peak expiratory flow, peak expiratory flow/peak inspiratory flow ratio and PENH (P<0.05). The response was reproduced in each dog at different concentrations of histamine. Sedation with acepromazine+buprenorphine had little influence on basal measurements and did not change the results of histamine challenge. It was concluded that BWBP is a safe, non invasive and reliable technique of investigation of lung function in dogs which provides new opportunities to characterise respiratory status, to evaluate airway hyperresponsiveness and to assess therapeutic interventions.
Resumo:
At head of title: Solar Physics Committee.
Resumo:
Mode of access: Internet.
Resumo:
Современный этап развития комплексов автоматического управления и навигации малогабаритными БЛА многократного применения предъявляет высокие требования к автономности, точности и миниатюрности данных систем. Противоречивость требований диктует использование функционального и алгоритмического объединения нескольких разнотипных источников навигационной информации в едином вычислительном процессе на основе методов оптимальной фильтрации. Получили широкое развитие бесплатформенные инерциальные навигационные системы (БИНС) на основе комплексирования данных микромеханических датчиков инерциальной информации и датчиков параметров движения в воздушном потоке с данными спутниковых навигационных систем (СНС). Однако в современных условиях такой подход не в полной мере реализует требования к помехозащищённости, автономности и точности получаемой навигационной информации. Одновременно с этим достигли значительного прогресса навигационные системы, использующие принципы корреляционно экстремальной навигации по оптическим ориентирам и цифровым картам местности. Предлагается схема построения автономной автоматической навигационной системы (АНС) для БЛА многоразового применения на основе объединения алгоритмов БИНС, спутниковой навигационной системы и оптической навигационной системы. The modern stage of automatic control and guidance systems development for small unmanned aerial vehicles (UAV) is determined by advanced requirements for autonomy, accuracy and size of the systems. The contradictory of the requirements dictates novel functional and algorithmic tight coupling of several different onboard sensors into one computational process, which is based on methods of optimal filtering. Nowadays, data fusion of micro-electro mechanical sensors of inertial measurement units, barometric pressure sensors, and signals of global navigation satellite systems (GNSS) receivers is widely used in numerous strap down inertial navigation systems (INS). However, the systems do not fully comply with such requirements as jamming immunity, fault tolerance, autonomy, and accuracy of navigation. At the same time, the significant progress has been recently demonstrated by the navigation systems, which use the correlation extremal principle applied for optical data flow and digital maps. This article proposes a new architecture of automatic navigation management system (ANMS) for small UAV, which combines algorithms of strap down INS, satellite navigation and optical navigation system.
Resumo:
The maximum height of a siphon is generally assumed to be dependent on barometric pressure—about 10 m at sea level. This limit arises because the pressure in a siphon above the upper reservoir level is below the ambient pressure, and when the height of a siphon approaches 10 m, the pressure at the crown of the siphon falls below the vapour pressure of water causing water to boil breaking the column. After breaking, the columns on either side are supported by differential pressure between ambient and the low-pressure region at the top of the siphon. Here we report an experiment of a siphon operating at sea level at a height of 15 m, well above 10 m. Prior degassing of the water prevented cavitation. This experiment provides conclusive evidence that siphons operate through gravity and molecular cohesion.
Resumo:
We share our experience in planning, designing and deploying a wireless sensor network of one square kilometre area. Environmental data such as soil moisture, temperature, barometric pressure, and relative humidity are collected in this area situated in the semi-arid region of Karnataka, India. It is a hope that information derived from this data will benefit the marginal farmer towards improving his farming practices. Soon after establishing the need for such a project, we begin by showing the big picture of such a data gathering network, the software architecture we have used, the range measurements needed for determining the sensor density, and the packaging issues that seem to play a crucial role in field deployments. Our field deployment experiences include designing with intermittent grid power, enhancing software tools to aid quicker and effective deployment, and flash memory corruption. The first results on data gathering look encouraging.
Resumo:
The co-organized Alliance for Coastal Technologies (ACT) and National Data Buoy Center (NDBC) Workshop "Meteorological Buoy Sensors Workshop" convened in Solomons, Maryland, April 19 to 21,2006, sponsored by the University of Maryland Center for Environmental Science (UMCES) Chesapeake Bay Laboratory (CBL), an ACT partner institution. Participants from various sectors including resource managers and industry representatives collaborated to focus on technologies and sensors that measure the near surface variables of wind speed and direction, barometric pressure, humidity and air temperature. The vendor list was accordingly targeted at companies that produced these types of sensors. The managers represented a cross section of federal, regional and academic marine observing interests from around the country. Workshop discussions focused on the challenges associated with making marine meteorological observations in general and problems that were specific to a particular variable. Discussions also explored methods to mitigate these challenges through the adoption of best practices, improved technologies and increased standardization. Some of the key workshop outcomes and recommendations included: 0cean.US should establish a committee devoted to observations. The committee would have a key role in developing observing standards. The community should adopt the target cost, reliability and performance standards drafted for a typical meteorological package to be used by a regional observing system. A forum should be established to allow users and manufacturers to share best practices for the employment of marine meteorological sensors. The ACT website would host the forum. Federal activities that evaluate meteorological sensors should make their results publicly available. ACT should extend their evaluation process to include meteorological sensors. A follow on workshop should be conducted that covers the observing of meteorological variables not addressed by this workshop. (pdf contains 18 pages)
Resumo:
This is the Gunnislake Fish Counter Annual Report 2002 from the Environment Agency South West Region, which was held on March 2002. It presents the daily upstream counts of migratory salmonids recorded on the River Tamar at Gunnislake Weir fish counting station in 2002. The data within this report covers the period of the commercial migratory salmonid net buy-back scheme and the National Spring Salmon Bylaws. The report contains section on Net Buy-Back; Species Apportionment; Validation of counter efficiency; results as total number of migratory salmonid (salmon and Sea Trout) counted moving upstream in 2002 at Gunnislake; video validation and Counter Efficiency; and Discussion. The section Discussion includes Salmon and Sea Trout counts recorded on the River Tamar 1995-2002, other fish species observed as sea lamprey and Environmental Factors (river flows, water temperature, and barometric pressure).
Resumo:
A avaliação da qualidade dos solos e a redução da Mata Atlântica tem sido alvo de diversas pesquisas no Brasil e no mundo, principalmente quando estes estão atrelados ao recorte espacial de Unidades de Conservação. No entanto, tem sido difícil para os gestores dessas unidades a avaliação dos impactos ambientais gerados ao longo dos anos nas bacias hidrográficas, principalmente pela falta de investimentos. Esta dissertação teve por objetivo geral avaliar o atual estágio de degradação da bacia hidrográfica do Córrego da Caçada pertencente à Área de Proteção Ambiental Federal de Cairuçu, no município de Paraty RJ, analisando quantitativamente e qualitativamente a redução dos fragmentos de Mata Atlântica e estabelecendo relações com a degradação física e química dos solos dentro e fora dos fragmentos florestais. A metodologia utilizada para a redução ou avanço dos fragmentos de Mata Atlântica baseou-se no uso de fotografias aéreas do ano de 1956 e imagens de satélite de 2012, onde possibilitou a avaliação espaço-temporal do uso e cobertura das terras, através da produção de um mapa temático final. Além disso, foram elaborados mapas temáticos de reconhecimento da área de estudo, como o de hipsometria, de declividade, de orientação e forma das encostas, além da geração de perfis topográficos. Para a avaliação da qualidade física, química e biológica dos solos foram determinadas as curvas de distribuição granulométrica, a densidade relativa dos grãos sólidos e a densidade aparente, porosidade total, os limites de liquidez e plasticidade, a estabilidade dos agregados em água, análises morfológicas, a saturação de bases, a capacidade de troca catiônica (CTC), a saturação por alumínio, fósforo, pH e o carbono orgânico. Para tal, foi realizada a abertura de três perfis, sendo um em área de fragmento florestal e dois em áreas de pasto. O resultado das análises permitiu, segundo a Sociedade Brasileira de Ciência do solo, a classificação de dois tipos de solos na bacia, sendo: Cambissolo Háplico Tb Distrófico Típico em área fragmento florestal e em área de pasto, e um Latossolo Amarelo Tb Distrófico Típico em área de pasto. Os resultados de laboratório mostraram que os solos avaliados têm baixa fertilidade e valores variados nos resultados de física do solo. No entanto, além do histórico de uso do solo caracterizado pelas práticas rudimentares do manejo empregado pelos Caiçaras, o clima predominante na região possibilita um regime pluviométrico anual que passa dos 2.000mm de chuva/ano, caracterizando solos muito lixiviados e pobres quimicamente. Portanto, conclui-se que a relação das propriedades físicas e químicas avaliadas junto ao manejo inadequado ao longo dos anos tem apresentado um cenário de grandes dificuldades para a recuperação florestal na bacia hidrográfica do Córrego da Caçada, o que mostra a importância da avaliação dos impactos ambientais não só pelo recorte de bacias hidrográficas, como contextualizar seu posicionamento dentro de Unidades de Conservação, com legislações e objetivos específicos.