anonymi tractatus de naturis rerum, libris pluribus constans, in quibus de anatomia corporis humani, de anima, de quadrupedibus, de avibus, de monstris marinis, de piscibus, de vermibus, de arboribus communibus, de arboribus aromaticis, de lapidibus pretiosis, de septem metallis, de passionibus aëris, de sideribus, de planetis, et de quatuor elementis disseritur.

Colbertinus

ARIS-Campaign: Intercomparison of three ground based 22 GHz radiometers for middle atmospheric water vapor at the Zugspitze in winter 2009

This paper presents the Alpine Radiometer Intercomparison at the Schneefernerhaus (ARIS), which took place in winter 2009 at the high altitude station at the Zugspitze, Germany (47.42° N, 10.98° E, 2650 m). This campaign was the first direct intercomparison between three new ground based 22 GHz water vapor radiometers for middle atmospheric profiling with the following instruments participating: MIRA 5 (Karlsruhe Institute of Technology), cWASPAM3 (Max Planck Institute for Solar System Research, Katlenburg-Lindau) and MIAWARA-C (Institute of Applied Physics, University of Bern). Even though the three radiometers all measure middle atmospheric water vapor using the same rotational transition line and similar fundamental set-ups, there are major differences between the front ends, the back ends, the calibration concepts and the profile retrieval. The spectrum comparison shows that all three radiometers measure spectra without severe baseline artifacts and that the measurements are in good general agreement. The measurement noise shows good agreement to the values theoretically expected from the radiometer noise formula. At the same time the comparison of the noise levels shows that there is room for instrumental and calibration improvement, emphasizing the importance of low elevation angles for the observation, a low receiver noise temperature and an efficient calibration scheme. The comparisons of the retrieved profiles show that the agreement between the profiles of MIAWARA-C and cWASPAM3 with the ones of MLS is better than 0.3 ppmv (6%) at all altitudes. MIRA 5 has a dry bias of approximately 0.5 ppm (8%) below 0.1 hPa with respect to all other instruments. The profiles of cWASPAM3 and MIAWARA-C could not be directly compared because the vertical region of overlap was too small. The comparison of the time series at different altitude levels show a similar evolution of the H2O volume mixing ratio (VMR) for the ground based instruments as well as the space borne sensor MLS.

Impact of Taylor-Aris diffusivity on analyte and system zone dispersion in CZE assessed by computer simulation and experimental validation.

Application of pressure-driven laminar flow has an impact on zone and boundary dispersion in open tubular CE. The GENTRANS dynamic simulator for electrophoresis was extended with Taylor-Aris diffusivity which accounts for dispersion due to the parabolic flow profile associated with pressure-driven flow. Effective diffusivity of analyte and system zones as functions of the capillary diameter and the amount of flow in comparison to molecular diffusion alone were studied for configurations with concomitant action of imposed hydrodynamic flow and electroosmosis. For selected examples under realistic experimental conditions, simulation data are compared with those monitored experimentally using modular CE setups featuring both capacitively coupled contactless conductivity and UV absorbance detection along a 50 μm id fused-silica capillary of 90 cm total length. The data presented indicate that inclusion of flow profile based Taylor-Aris diffusivity provides realistic simulation data for analyte and system peaks, particularly those monitored in CE with conductivity detection.

Philippe Ariés, Morir en occidente: desde la Edad Media hasta nuestros días, trad. Víctor Goldstein, Adriana Hidalgo editora, Buenos Aires, 2007. ISBN-13: 978-987-9396-38-4. 270 pp.

Fil: Mendoza, José María Felipe.

Anthony J. Bowen, Aeschylus. Suppliant Women. Edited with a Translation, Introduction and Commentary, Aris & Phillips Classical Texts, Oxford, 2013, 374 pp.

Fil: Fernández Deagustini, María del Pilar. Universidad Nacional de La Plata. Facultad de Humanidades y Ciencias de la Educación. Instituto de Investigaciones en Humanidades y Ciencias Sociales (UNLP-CONICET); Argentina.

Anthony J. Bowen, Aeschylus. Suppliant Women. Edited with a Translation, Introduction and Commentary, Aris & Phillips Classical Texts, Oxford, 2013, 374 pp.

Fil: Fernández Deagustini, María del Pilar. Universidad Nacional de La Plata. Facultad de Humanidades y Ciencias de la Educación. Instituto de Investigaciones en Humanidades y Ciencias Sociales (UNLP-CONICET); Argentina.

Pro aris et focis; poesía laureada.

Mode of access: Internet.

Anonymi ad Sebastianum Pauli, medicum pisanum, epistola apologetica, De aëris pulmoneo in sanguinem aditu.

Mode of access: Internet.

Johan. Swammerdammii ... Tractatus physico-anatomico-medicus, de respiratione usuque pulmonum : In quo, præter primam respirationi in foetu inchoationem, aëris per circulum propulsio statuminatur, attractio exploditur; experimentaque, ad explicandum sanguinis in corde, tam auctum quam diminutum, motum, in medium producuntur... ; Editio altera, cui subjuncta est D. Alberti Haller ... De diaphragmatis musculis, dissertatio anatomica.

Alberti Haller De diaphragmatis musculis, dissertatio anatomica, en p. 69 a fin.

Observationes quaedam de effectibus variarum aëris specierum in plantas /

Dédicace ms de l'auteur à M. le Baron Cuvier.

A process-based Knowledge Management framework supported by ARIS Enterprise Modelling architecture

Knowledge and its management have been respectively accepted as a critical resource and a core business competency. Despite that literature proves the existence of a gap between the theoretical considerations of Knowledge Management (KM) and their efficient application. Such lacking, we argue, derives from the missing link between a framework of Knowledge Management and the particular methods and guidelines of its implementation. In an attempt to bridge this gap, an original, process- based holistic Knowledge Management framework is proposed, aiming to address the problem of knowledge management application and performance by utilising a set of well accepted Enterprise Modelling (EM) methods and tools.

A quasi four dimensional radiation detector

Techniques for the accurate measurement of ionising radiation have been evolving since Roentgen first discovered x-rays in 1895; until now experimental measurements of radiation fields in the three spatial dimensions plus time have not been successfully demonstrated. In this work, we embed an organic plastic scintillator in a polymer gel dosimeter to obtain the first quasi-4D experimental measurement of a radiation field.

Introduction to the First International Workshop on Empirical Research in Business Process Management (ER-BPM 2009)

Providing effective IT support for business processes has become crucial for enterprises to stay competitive. In response to this need numerous process support paradigms (e.g., workflow management, service flow management, case handling), process specification standards (e.g., WS-BPEL, BPML, BPMN), process tools (e.g., ARIS Toolset, Tibco Staffware, FLOWer), and supporting methods have emerged in recent years. Summarized under the term “Business Process Management” (BPM), these paradigms, standards, tools, and methods have become a success-critical instrument for improving process performance.

Characterisation of flexural bond strength in thin bed concrete masonry

This paper presents an experimental investigation of the flexural bond strength of thin bed concrete masonry. Flexural bond strength of masonry depends upon the mortar type, the techniques of dispersion of mortar and the surface texture (roughness) of concrete blocks. There exists an abundance of literature on the conventional masonry bond containing 10mm thick mortar; however, the 2mm polymer flue mortar bond is not yet well researched. This paper reports a study on the examination of the effect of mortar compositions, dispersion methods and unit surface textures to the flexural bond strength of thin bed concrete masonry. Three types of polymer modified glue mortars, three surface textures and four techniques of mortar dispersion have been used in preparing 108 four point flexural test specimens. All mortar joints have been carefully prepared to ensure achievement of 2mm layer polymer mortar thickness on average. The results exhibit the flexural bond strength of thin bed concrete masonry much is higher than that of the conventional masonry; moreover the unit surface texture and the mortar dispersion methods are found to have significant influence on the flexural bond strength.