Alteration and Contamination of Archaeological Ceramics: the Perturbation Problem

Alteration and contamination processes modify the chemical composition of ceramic artefacts. This is not restricted solely to the affected elements, but also affects general concentrations. This is due to the compositional nature of chemical data, enclosed by the restriction of unit sum. Since it is impossible to know prior to data treatment whether the original compositions have been changed by such processes, the methodological approach used in provenance studies must be robust enough to handle materials that might have been altered or contaminated. The ability of the logratio transformation proposed by Aitchison to handle compositional data is studied and compared with that of present data treatments. The logaratio transformation appears to offer the most robust approach

Implications of burial alterations on luminescence dating of archaeological ceramics

Recent mineralogical studies on archaeological pottery samples report significant variations in alkali metal concentrations due to environmental alterations during burial. Here we examine the effects of potassium (K) leaching on luminescence dating. The effect on the estimation of the dose rate is studied by considering four models of leaching (exponential, linear, early and late) and their impact on fine- and coarse-grain dating are calculated. The modeling approaches are applied to two cases of pottery in which evidence for alteration was found. Additionally, TL dating performed on pottery of one of the studied cases, indicates the importance of leaching effects on absolute dating measurements.

Standardisation of elemental analytical techniques applied to provenance studies of archaeological ceramics: an inter laboratory calibration study

Chemical analysis is a well-established procedure for the provenancing of archaeological ceramics. Various analytical techniques are routinely used and large amounts of data have been accumulated so far in data banks. However, in order to exchange results obtained by different laboratories, the respective analytical procedures need to be tested in terms of their inter-comparability. In this study, the schemes of analysis used in four laboratories that are involved in archaeological pottery studies on a routine basis were compared. The techniques investigated were neutron activation analysis (NAA), X-ray fluorescence analysis (XRF), inductively coupled plasma optical emission spectrometry (ICP-OES) and inductively coupled plasma mass spectrometry (ICP-MS). For this comparison series of measurements on different geological standard reference materials (SRM) were carried out and the results were statistically evaluated. An attempt was also made towards the establishment of calibration factors between pairs of analytical setups in order to smooth the systematic differences among the results.

Rehydroxylation Dating: Assessment for Archaeological Application

Investigations are carried out into the mass gain behaviour of fired clay ceramics following drying (130°C) and reheating (500°C), and the application of these mass gain properties to the dating of archaeological ceramics using a modified rehydroxylation dating (RHX) methodology, a component based approach. Gravimetric analysis is conducted using a temperature and humidity controlled glove box arrangement (featuring a top-loading balance) on eighteen samples of varied known ages and contexts; this occurs following transfer from environmentally controlled chambers where subsamples of these samples are aged at three temperatures (25°C, 35°C, 45°C) following drying and reheating. The sample set consists principally of post-medieval bricks, but also includes some post-medieval pottery as well as both Etruscan and Roman ceramics. A suite of techniques are applied to characterise these ceramics, including XRD, FTIR, p-XRF, thin-section petrography, BET analysis, TG-MS and permeametry.

Chemical variability in clays and pottery from a traditional cooking pot production village: Testing assumptions in Pereruela

This paper explores analytically the contemporary pottery-making community of Pereruela (north-west Spain) that produces cooking pots from a mixture of red clay and kaolin. Analyses by different techniques (XRF, NAA, XRD, SEM and petrography) showed an extremely high variability for cooking ware pottery produced in a single production centre, by the same technology and using local clays. The main source of chemical variation is related to the use of different red clays and the presence of non-normally distributed inclusions of monazite. These two factors induce a high chemical variability, not only in the output of a single production centre, but even in the paste of a single pot, to an extent to which chemical compositions from one"workshop", or even one"pot", could be classified as having different provenances. The implications for the chemical characterization and for provenance studies of archaeological ceramics are addressed.

PXRF and multivariate statistics analysis of pre-colonial pottery from northeast of Brazil

Portable system of energy dispersive X-ray fluorescence was used to determine the elemental composition of 68 pottery fragments from Sambaqui do Bacanga, an archeological site in Sao Luis, Maranhao, Brazil. This site was occupied from 6600 BP until 900 BP. By determining the element chemical composition of those fragments, it was possible to verify the existence of engobe in 43 pottery fragments. Obtained from two-dimensional graphs and hierarchical cluster analysis performed in fragments of stratigraphies from surface and 113-cm level, and 10 to 20, 132 and 144-cm level, it was possible to group these fragments in five distinct groups, according to their stratigraphies. The results of data grouping (two-dimensional graphics) are in agreement with hierarchical cluster analysis by Ward method. Copyright (C) 2011 John Wiley & Sons, Ltd.

Tecnología cerámica : estudios experimentales sobre la cerámica del sitio arqueológico San Ignacio (Noroeste de Mendoza)

El propósito de este trabajo es explorar la disponibilidad de materias primas que pudieron ser utilizadas en el proceso de manufactura de la cerámica gris del sitio arqueológico San Ignacio, en el Valle de Potrerillos, ubicado al Norte de la provincia de Mendoza (640 dC). Se pretende, además, reproducir las técnicas de producción y cocción cerámica, a fin de obtener un producto de características análogas a las de la colección estudiada. La metodología utilizada presentó las siguientes etapas: recolección de materiales arcillosos; caracterización de las propiedades físicas en estado crudo; análisis químicos; desarrollo experimental de cocción y ensayos post-cocción de los mismos. Los productos obtenidos muestran una buena estructura y sinterización, aunque no se logró una atmósfera completamente reductora con este tipo de combustible.

ICP-MS Trace Element Analysis of Song Dynasty Porcelains from Ding, Jiexiu and Guantai kilns, North China

Bodies of Ding kiln white porcelains and their imitations from Guantai and Jiexiu kilns of the Chinese Song dynasty (960-1279 AD) were analysed for 40 trace elements by inductively coupled plasma mass spectrometry (ICP-MS). Numerous trace element compositions and ratios allow these visually similar products to be distinguished, and a Ding-style shard of uncertain origin is identified as a likely genuine Ding product. In Jiexiu kiln, Ding-style products have trace element features distinctive from blackwares of an inferior quality intended for the lower end market. Based on geochemical behaviour of these trace elements, we propose that geochemically distinctive raw materials were used for Ding-style products of a higher quality, which possibly also underwent purification by levigation prior to use. Capable of analysing over 40 elements with a typical long term precision of < 2%, this high precision ICP-MS method proves to be very powerful for grouping and characterising archaeological ceramics. Combined with geochemical interpretation, it can provide insights into the raw materials and techniques used by ancient potters. (C) 2004 Elsevier Ltd. All rights reserved.

Potential of Sr isotopic analysis in ceramic provenance studies: Characterisation of Chinese stonewares

We compare the trace element and Sr isotopic compositions of stoneware bodies made in Yaozhou and Jizhou to characterise these Chinese archaeological ceramics and examine the potential of Sr isotopes in provenance studies. Element concentrations determined by ICP-MS achieve distinct characterisation for Jizhou samples due to their restricted variation, yet had limited success with Yaozhou wares because of their large variability. In contrast, Sr-87/Sr-86 ratios in Yaozhou samples have a very small variation and are all significantly lower than those of Jizhou samples, which show a large variation and cannot be well characterised with Sr isotopes. Geochemical interpretation reveals that Sr-87/Sr-86 ratios will have greater potential to characterise ceramics made of low Rb/Sr materials such as kaolin clay, yet will show larger variations in ceramics made of high Rb/Sr materials such as porcelain stone. (c) 2005 Elsevier B.V. All rights reserved.

Technological characterization of molded islamic pottery from Iberian Peninsula

The thesis examines the technical aspects of unglazed molded ceramics from Mértola, in the context of Islamic archaeology of the Iberian Peninsula (Almohad period, end of 12th and the beginning of 13th century). Ceramics of the time period under discussion (12th – 13th century) are understudied, including in what concern to shaping and firing of ceramic vessels, the origin of raw materials used in ceramics and glazes, and decoration methods such as slip painting and/or colored glazes. Moreover, the use of archaeometry tools is rare. Along with providing a general picture of molded ceramic production in Mértola, this work provides a new dimension to the discipline of Islamic ceramic studies by the analytical tool used and demonstrating the importance of archaeological ceramics of the western peripheries to the understanding the production of ceramics and the transmission of knowledge and cultural traditions within the Islamic caliphate. The chemical and mineralogical characterization of 12th/13th century Almohad unglazed molded ware from Mértola was accomplished through multi – analytical approach combining SEM, Powder/uXRD and LA-ICP-MS methods. In this paper unglazed and glazed samples were analyzed but the attention was given to unglazed specimens, while the glazed samples were used for the comparison with the previous group in order to determine possible similarities or dissimilarities, thus providing enough data to discuss about technical aspects and potential provenance; Resumo: A tese debruça-se sobre os aspetos técnicos de cerâmica de molde não-vidrada de Mértola, no contexto da arqueologia islâmica da Península Ibérica (período Almóada, final de XII e início do século XIII). A cerâmica do período em discussão (séculos XII-XIII) é pouco estudada inclusive no que concerne ao fabrico e à cozedura, à de fonte de matérias-primas, na pasta ou nos esmaltes e aos métodos de decoração, como pintura, presença de engobes ou esmaltes. Além disso, o uso de ferramentas de Arqueometria é raro. Para fornecer uma visão geral da produção de cerâmica moldada em Mértola, este trabalho oferece uma nova dimensão para a disciplina de cerâmica islâmicas pelas ferramentas analíticas utilizadas. Demonstrando a importância da cerâmica arqueológica da periferia ocidental para a compreensão da produção cerâmica e a transmissão de conhecimentos e tradições culturais no califado islâmico. A caracterização mineralógica e química das cerâmicas de molde e não-vidrada, Almóada, dos séculos XII-XIII de Mértola foi realizada através de uma abordagem multi-analítica que combina métodos de SEM-EDS, uXRD e LA-ICP-MS. Neste trabalho, as cerâmicas vidradas e não-vidradas foram analisadas conjuntamente, dando mais atenção aos espécimes não vidrados. As amostras de cerâmicas vidradas foram utilizados para a comparação com o grupo anterior, a fim de determinar as possíveis semelhanças ou diferenças, proporcionando, assim, dados suficientes para discutir os aspetos técnicos e o potencial de proveniência das cerâmicas não vidradas

The ceramic artifacts in archaeological black earth (terra preta) from lower Amazon region, Brazil: mineralogy

Several archaeological black earth (ABE) sites occur in the Amazon region. They contain fragments of ceramic artifacts, which are very important for the archaeological purpose. In order to improve the archaeological study in the region we carried out a detailed mineralogical and chemical study of the fragments of ceramic artifacts found in the two ABE sites of Cachoeira-Porteira, in the Lower Amazon Region. Their ceramics comprise the following tempers: cauixi, cariapé, sand, sand +feldspars, crushed ceramic and so on and are composed of quartz, clay equivalent material (mainly burned kaolinite), feldspars, hematite, goethite, maghemite, phosphates, anatase, and minerals of Mn and Ba. Cauixi and cariapé, siliceous organic compounds, were found too. The mineralogical composition and the morphology of their grains indicate a saprolite (clayey material rich on quartz) derived from fine-grained felsic igneous rocks or sedimentary rocks as source material for ceramic artifacts, where silica-rich components such cauixi, cariapé and/or sand (feldspar and rock fragments) were intentionally added to them. The high content of (Al,Fe)-phosphates, amorphous to low crystalline, must be product of the contact between the clayey matrix of pottery wall and the hot aqueous solution formed during the daily cooking of animal foods (main source of phosphor). The phosphate crystallization took place during the discharge of the potteries put together with waste of organic material from animal and vegetal origin, and leaving to the formation of the ABE-soil profile.

The ceramic artifacts in archaeological black earth (terra preta) from Lower Amazon Region, Brazil: chemistry and geochemical evolution

This paper carried out a chemical investigation of archaeological ceramic artifacts found in archaeological sites with Black Earth (ABE) in the Lower Amazon Region at Cachoeira-Porteira, State of Pará, Brazil. The ceramic artifacts, mostly of daily use, belong to Konduri culture (from 900 to 400 years BP). They are constituted of SiO2, Al2O3, Fe2O3, Na2O and P2O5; SiO2 and Al2O3 together add up to 80 % and indicate influence of acid rocks, transformed into clay minerals basically kaolinite. The relative high contents of P2O5 (2.37 % in average) come out as (Al,Fe)-phosphate, an uncommon fact in primitive red ceramics, but found in some roman and egyptian archaeological sites. The contents of the trace elements are similar or below the Earth's crust average. This chemical composition (except P2O5) detaches saprolite material derived acid igneous rocks or sedimentary ones as the main raw material of the ceramics. The contents of K, Na and Ca represent the feldspars and rock fragments possibly introduced into saprolitic groundmass, indicated by mineralogical studies. The presence of cauixi and cariapé as well as quartz sand was confirmed by optical microscope, SEM analyses and by the high silica contents of ceramic fragments. Phosphorus was possibly incorporated into groundmass during cooking of foods, and ABE soil profile formation developed on yellow Latosols. The raw materials and its tempers (cauixi, or cariapé, feldspar, crushed rocks, old ceramic artifacts and quartz fragments) are found close to the sites and therefore and certainly came from them.

Analcime crystallization and compositional profiles - Comparing approaches to detect post-depositional alterations in archaeological pottery

The approaches of comparative studies and profile measurements, often used in order to detect post-depositional alterations of ceramics, have been applied simultaneously to two sets of Roman pottery, both of which include altered individuals. As analytical techniques, Neutron Activation Analysis and X-Ray Diffraction have been used. Both approaches lead to substantially different results. This shows that they detect different levels of alteration and should complement each other rather than being used exclusively. For the special process of a glassy phase decomposition followed by a crystallization of the Na-zeolite analcime, the results suggest that it changes high-fired calcareous pottery rapidly, and so fundamentally that the results of various archaeometric techniques can be severely disturbed.