昼夜温差对小麦生长特性的影响

在严格控制光照(350μmol photons m -2s-1)和空气相对湿度(75％)的人工气候室内,模拟青海高原昼夜温差较大的环境条件(25℃/10℃,昼/夜),以无昼夜温差的环境条件(25℃/25℃,昼/夜)为对照,对不同环境条件下选育的青海高原338和上海沪麦5号小麦品种的生长发育及经济性状的形成进行了比较研究。结果表明,15℃昼夜温差处理较对照条件下生长的小麦表现较好,总叶面积增加,生育期和叶片寿命延长,植株总干重和每穗粒数及千粒重均显著高于无昼夜温差条件下生长的小麦。因此,较大的昼夜温差环境条件是青海高原小麦易于高产的重要原因。 从品种看,青海的高原338在15℃昼夜温差处理下生长表现显著优于上海的沪 麦5号。而在无昼夜温差条件下，两个品种的生长情况正好相反。由此可以看出，培育适合当地昼夜温差环境因素的品种也是小麦获得高产的主要因素。

Mutual Solubilities of Ammonium-Based Ionic Liquids with Water and with Water/Methanol Mixture

Over the last two decades, ionic liquids have gained importance as alternative solvents to conventional VOCs in the field of homogeneous catalysis. This success is not only due to their ability to dissolve a large amount of metal catalysts, but it is also due to their potential to enhance yields of enantiopure products. The art of preparation of a specific enantiomer is a highly desired one and searched for in pharmaceutical industry. This work presents a study on solubility in water and in water/methanol mixture of a set of ILs composed of the bis (trifluoromethylsulfonyl) imide anion and of the N-alkyl-triethyl-ammonium cation (abbrev. [NR,222][NTf2]) with the alkyl chain R ranging from 6 to 12 carbons. Mutual solubilities between ILs and water, as well as between ILs and methanol/water mixture were investigated in detail. These solubilities were measured using two well-known and accurate experimental techniques based on a volumetric and a cloud-point methods. Both methods enabled us to measure the Tx diagrams reflecting the mutual solubilities between water (or water/methanol) and selected ILs in the temperature range from 293.15 to 338.15 K. The data were fitted by using the modified Flory-Huggins equation proposed by de Sousa and Rebelo and compared also with the prediction carried out by the Cosmo-RS methodology

Proporción de pacientes que presentan hipotermia peri operatoria durante un reemplazo articular de cadera, rodilla u hombro

Introducción: La hipotermia perioperatoria se ha documentado como factor de riesgo para el aumento de la morbimortalidad de los pacientes aumentando morbilidad miocárdica, riesgo de infección, pérdidas sanguíneas y tiempo de hospitalización. La aplicación de anestésicos toma relevancia ya que causa la pérdida de control central de la temperatura. Nuestro objetivo con este estudio fue describir la proporción de casos de hipotermia en la población sometida a un reemplazo articular durante un periodo de cuatro meses. Materiales y métodos: Se realizó un estudio de cohorte prospectivo. La población a estudio fueron los pacientes que fueron sometidos a un reemplazo total de cadera, rodilla u hombro. Se registró la temperatura central en el momento previo a la inducción anestésica, 30, 60 y 90 minutos después, al finalizar el procedimiento y al ingresar a recuperación. Se reportó el porcentaje de pacientes con hipotermia en cada tiempo. Resultados: Se analizaron en total 88 pacientes, el 55,7% fue llevado a cirugía de cadera, 39,7% de rodilla y 4,5% de hombro. El tipo de anestesia más utilizado fue general y la duración promedio de anestesia fue 164 minutos. La medición de la temperatura central se realizó en nasofaringe, esófago o tímpano. La proporción de pacientes que presentaron hipotermia en la inducción fue 21,6%, a 30 minutos 83%, a 60 minutos 73,9%, a 90 minutos 68,2%, al finalizar 59,1% y en recuperación 58%. Se realizó una prueba Chi cuadrado comparando las proporciones entre la inducción y los cinco periodos posteriores, se encontró que la proporción de pacientes con hipotermia en los cinco tiempos posteriores tuvo una diferencia estadísticamente significativa (p=0,00) comparada con la proporción de pacientes con hipotermia durante la inducción. Conclusión: En los pacientes sometidos a un reemplazo articular la hipotermia fue una condición prevalente posterior a la aplicación de los anestésicos sistémicos. Los dispositivos de calentamiento intraoperatorio usados actualmente son insuficientes para evitar la hipotermia, lo que indica concordancia con la literatura en cuanto a las recomendaciones de calentamiento perioperatorio, con énfasis en el precalentamiento, para prevenir la caída significativa de la temperatura y la morbimortalidad asociada.

Energy Analysis within Industrial Hydraulics and Correspondent Solar PV System Design

Energy efficiency and renewable energy use are two main priorities leading to industrial sustainability nowadays according to European Steel Technology Platform (ESTP). Modernization efforts can be done by industries to improve energy consumptions of the production lines. These days, steel making industrial applications are energy and emission intensive. It was estimated that over the past years, energy consumption and corresponding CO2 generation has increased steadily reaching approximately 338.15 parts per million in august 2010 [1]. These kinds of facts and statistics have introduced a lot of room for improvement in energy efficiency for industrial applications through modernization and use of renewable energy sources such as solar Photovoltaic Systems (PV).The purpose of this thesis work is to make a preliminary design and simulation of the solar photovoltaic system which would attempt to cover the energy demand of the initial part of the pickling line hydraulic system at the SSAB steel plant. For this purpose, the energy consumptions of this hydraulic system would be studied and evaluated and a general analysis of the hydraulic and control components performance would be done which would yield a proper set of guidelines contributing towards future energy savings. The results of the energy efficiency analysis showed that the initial part of the pickling line hydraulic system worked with a low efficiency of 3.3%. Results of general analysis showed that hydraulic accumulators of 650 liter size should be used by the initial part pickling line system in combination with a one pump delivery of 100 l/min. Based on this, one PV system can deliver energy to an AC motor-pump set covering 17.6% of total energy and another PV system can supply a DC hydraulic pump substituting 26.7% of the demand. The first system used 290 m2 area of the roof and was sized as 40 kWp, the second used 109 m2 and was sized as 15.2 kWp. It was concluded that the reason for the low efficiency was the oversized design of the system. Incremental modernization efforts could help to improve the hydraulic system energy efficiency and make the design of the solar photovoltaic system realistically possible. Two types of PV systems where analyzed in the thesis work. A method was found calculating the load simulation sequence based on the energy efficiency studies to help in the PV system simulations. Hydraulic accumulators integrated into the pickling line worked as energy storage when being charged by the PV system as well.

アフリカにおける株式市場の発展とその経済効果

本稿では、アフリカにおいて発展しつつある株式市場が、アフリカの各国経済に与える影響を分析する。最初に、アフリカの株式市場が、世界と比較すれば金額では小さいものの、アフリカの中ですでに活用されており、国際投資家からも注目されているという現実を明らかにする。次に、Sugimoto, Matsuki and Yoshida［2014］を概説し、アフリカ主要7カ国の株式市場のリターン（収益率）は、2004年以降、グローバル市場の動きから最も影響を受けており、世界金融危機などの際には平時よりも大きなグローバルショックを受けていたことを示す。最後に、アフリカ16カ国における株式市場の域内相互依存度を、固定相関係数（CCC-GARCH）モデルを用いて比較し、2012年以降、各地域共通の証券取引所創設にむけて積極的に連携姿勢を示すアフリカ諸国の間で、株式市場の地域的な連動性が高まってきていることを確認する。

Lipid extraction has little effect on the delta N-15 of aquatic consumers

Proper application of stable isotopes (e. g., delta N-15 and delta C-13) to food web analysis requires an understanding of all nondietary factors that contribute to isotopic variability. Lipid extraction is often used during stable isotope analysis (SIA), because synthesized lipids have a low delta C-13 and can mask the delta C-13 of a consumer's diet. Recent studies indicate that lipid extraction intended to adjust delta C-13 may also cause shifts in delta N-15, but the magnitude of and reasons for the shift are highly uncertain. We examined a large data set (n = 854) for effects of lipid extraction (using Bligh and dyer's [ 1959] chloroform-methanol solvent mixtures) on the delta N-15 of aquatic consumers. We found no effect of chemically extracting lipids on the delta N-15 of whole zooplankton, unionid mussels, and fish liver samples, and found a small increase in fish muscle delta N-15 of similar to 0.4%. We also detected a negative relationship between the shift in delta N-15 following extraction and the C:N ratio in muscle tissue, suggesting that effects of extraction were greater for tissue with lower lipid content. As long as appropriate techniques such as those from Bligh and dyer (1959) are used, effects of lipid extraction on delta N-15 of aquatic consumers need not be a major consideration in the SIA of food webs.

A 330-360 GHz spectral survey of G34.3+0.15 - III. The outer halo

We have undertaken a 330-360 GHz molecular line survey of the halo gas surrounding the hot core associated with G34.26+0.15. In contrast to our molecular line survey of the hot core itself, where 338 lines from at least 38 species were detected, only 18 lines from 9 species were detected in the halo. The lines are mainly single transitions of simple di atomic and triatomic molecules. Lower limits to their column densities have been evaluated by an LTE method. In the case of methanol, where four transitions were detected, the rotation temperature and column density have been evaluated by the rotation diagram technique. We have modified the previous depth-dependent chemical model developed in Paper II to calculate the column densities observed along a general line of sight drawn through the model cloud. The model is also extended to produce beam-averaged column densities for better comparison with those observed. We compare the model column densities with those observed and make recommendations for future depth-dependent chemical modelling of hot cores.

A 330-360 GHz spectral survey of G 34.3+0.15 .1. Data and physical analysis

A 330--360 GHz spectral survey of the hot molecular core associated with the 'cometary' ultracompact HII region G 34.3+/-0.15 observed with the James Clerk Maxwell Telescope has detected 338 spectral lines from at least 35 distinct chemical species plus 19 isotopomers. 70 lines remain unidentified. Chemical abundance and rotation temperature have been determined by rotation diagram analysis for 12 species, and lower limits to abundance found for 38 others.

(Table 11-I, page 338) Metal contents (%) of a representative sampling of manganese nodules from the North Pacific high-grade region

Two types of deep-sea dredges are currently under development for the mining of the manganese nodules, a deep-sea hydraulic dredge and a mechanical cable-bucket system. Both systems offer some advantages with the hydraulic system appearing to be advantageous in themining of a specific deposit for which it is designed while the cable-bucket system appears to be somewhat more flexible in working in a variety of deposits, topographic environments, and water depths. Environmental studies conducted in conjunction with deep-sea tests of the two types of mining systems currently indicate that substantially no environmental damage will be done in the mining of the deep-sea nodules. Because of the nature of the deposits and the way in which they can be mined, the manganese nodules appear to be a relatively pollution free and energy-saving source of a number of industrially important metals.