Miocene through Pleistocene dinoflagellates from ODP Site 170-1039

Palynological data from offshore Costa Rica, allow us to investigate the relationship between dinoflagellate cyst assemblages and changes in regional oceanic primary productivity. From Miocene to Pleistocene, productivity at ODP Site 1039 was influenced by tectonic drift, as Site 1039 approached the continent, from the Equator to its current position at ~10°N. In addition, dinoflagellate abundance is modulated by regional productivity events, which modified primary productivity, as also indicated by available data on calcareous nannofossils, diatoms, TOC, and CaCO3 content. Five palynomorph intervals are defined. The early-late Miocene one, dominated by Batiacasphaera, represents relatively stable, productive oceanic conditions before the closure of the Indonesian and Panama Seaways. The late Miocene decrease in palynomorph recovery is related to the Carbonate Crash Event. The high abundance and diversity of the assemblages at the end of the late Miocene to early Pliocene indicate increased productivity related to the Global Biogenic Bloom, and a change in dominance from Batiacasphaera to Impagidinium to Nematosphaeropsis. The low abundance of the late Pliocene interval is related to El Niño-like conditions, and there is another change related to the disappearance of Batiacasphaera and dominance of Impagidinium, Nematosphaeropsis, and Operculodinium. The abundant Pleistocene assemblages represent increased marine productivity, and a high influx of continental palynomorphs and bissacate pollen, associated with the proximity of the Costa Rica Dome. Pleistocene dinoflagellates are characterized by Spiniferites and Selenopemphix, together with rare Impagidinium and Nematosphaeropsis.

Carbon and oxygen isotopic composition and age dating of sediments from ODP Leg 170 sites and Hole 205-1253A

In this data report we present results from stable isotope measurements (d13C and d18O) on bulk sediment at several sites located on a transect along a subduction margin offshore Costa Rica (Ocean Drilling Program Sites 1039, 1040, and 1253). Comparison of stable isotope compositions (d13C and d18O) of the pelagic carbonates Subunit U3C between the reference sites (Site 1039 and 1253) and the underthrust section (Site 1040) reveals similar d13C values and minor differences in d18O values within four specific intervals. Isotope stratigraphy was then used to further constrain the shipboard age models based on bio- and magnetostratigraphy. The resulting age models are in agreement with those derived from biostratigraphy and confirm that the sedimentation rate of the lower Subunit 3C is roughly constant on the order of 50 m/m.y. This is in contrast with the postulated very high sedimentation rates at ~12.7 Ma and lower sedimentation rates (~18 m/m.y.) in the lower part of the section between 16 and 13 Ma, as suggested by shipboard magnetostratigraphic datums.

(Table 1) Results from XRD analysis as well as sediment type and selected results from ring shear experiments

The location of the seaward tip of a subduction thrust controls material transfer at convergent plate margins, and hence global mass balances. At approximately half of those margins, the material of the subducting plate is completely underthrust so that no accretion or even subduction erosion takes place. Along the remaining margins, material is scraped off the subducting plate and added to the upper plate by frontal accretion. We here examine the physical properties of subducting sediments off Costa Rica and Nankai, type examples for an erosional and an accretionary margin, to investigate which parameters control the level where the frontal thrust cuts into the incoming sediment pile. A series of rotary-shear experiments to measure the frictional strength of the various lithologies entering the two subduction zones were carried out. Results include the following findings: (1) At Costa Rica, clay-rich strata at the top of the incoming succession have the lowest strength (µres = 0.19) while underlying calcareous ooze, chalk and diatomite are strong (up to µres = 0.43; µpeak = 0.56). Hence the entire sediment package is underthrust. (2) Off Japan, clay-rich deposits within the lower Shikoku Basin inventory are weakest (µres = 0.13-0.19) and favour the frontal proto-thrust to migrate into one particular horizon between sandy, competent turbidites below and ash-bearing mud above. (3) Taking in situ data and earlier geotechnical testing into account, it is suggested that mineralogical composition rather than pore-pressure defines the position of the frontal thrust, which locates in the weakest, clay mineral-rich (up to 85 wt.%) materials. (4) Smectite, the dominant clay mineral phase at either margin, shows rate strengthening and stable sliding in the frontal 50 km of the subduction thrust (0.0001-0.1 mm/s, 0.5-25 MPa effective normal stress). (5) Progressive illitization of smectite cannot explain seismogenesis, because illite-rich samples also show velocity strengthening at the conditions tested.

Highlights from Faraday discussion 170: Challenges and opportunities of modern mechanochemistry, Montreal, Canada, 2014

The Faraday Discussion Mechanochemistry: From Functional Solids to Single Molecules which took place 21-23 May 2014 in Montreal, Canada, brought together a diversity of academic and industrial researchers, experimentalists and theoreticians, students, as well as experienced researchers, to discuss the changing face of mechanochemistry, an area with a long history and deep connections to manufacturing, that is currently undergoing vigorous renaissance and rapid expansion in a number of areas, including supramolecular chemistry, smart polymers, metal-organic frameworks, pharmaceutical materials, catalytic organic synthesis, as well as mineral and biomass processing and nanoparticle synthesis.