Waldo Trench, and others; stories of Americans in Italy,

"Several of the stories composing this volume have appeared in Scribner's magazine."--Note.

A memoir of the Trench family,

Privately printed.

Trench Construction Safety Orders

Mode of access: Internet.

Construction Safety Orders. Trench Construction Safety Orders and Lamp Scaffold and Parallel Safety Orders

Mode of access: Internet.

Efffluent flux prediction in variably saturated soil zones within a septic tank-soil absorption trench

The treatment and hydraulic mechanisms in a septic tank-soil absorption system ( SAS) are highly influenced by the clogging layer or biomat zone which develops on bottom and lower sidewall surfaces within the trench. Flow rates through the biomat and sub-biomat zones are governed largely by the biomat hydraulic properties (resistance and hydraulic conductivity) and the unsaturated hydraulic conductivity of the underlying soil. One- and 2-dimensional models were used to investigate the relative importance of sidewall and vertical flow rates and pathways in SAS. Results of 1-dimensional modelling show that several orders of magnitude variation in saturated hydraulic conductivity (Ks) reduce to a 1 order of magnitude variation in long-term flow rates. To increase the reliability of prediction of septic trench hydrology, HYDRUS-2D was used to model 2-dimensional flow. In the permeable soils, under high trench loading, effluent preferentially flowed in the upper region of the trench where no resistant biomat was present (the exfiltration zone). By comparison, flow was more evenly partitioned between the biomat zones and the exfiltration zones of the low permeability soil. An increase in effluent infiltration corresponded with a greater availability of exfiltration zone, rather than a lower resistance of biomat. Results of modelling simulations demonstrated the important role that a permeable A horizon may play in limiting surface surcharge of effluent under high trench hydraulic loading.

Prediction of steady-state flux through variably saturated zones within a septic absorption trench

This paper describes effluent flow dynamics within a septic absorption system and the prediction of flow through the biomat and sub-biomat zone. Using soil hydraulic properties in a one dimensional model we demonstrate how soil hydraulic properties interact with biomat resistances to determine long-term acceptance rate (LTAR). The LTAR is a key parameter used in the Australian and New Zealand Standard AS1547:2000 to calculate the area of trench required to ensure trenches are not overloaded. Results show that several orders of magnitude variation in saturated hydraulic conductivity (Ks) collapse to a one order of magnitude variation in LTAR. These results are calculated from a model using basic flow theory, allowing LTAR to be estimated for any combination of biomat resistance and soil hydraulic properties. To increase the reliability of prediction of septic trench hydrology, HYDRUS 2D was used to model two dimensional flow. For more permeable soils, the exfiltration zone above sidewall biomat growth is shown to be a key pathway for excess effluent flow.

A geochemical study of crustal plutonic rocks from the southern Mariana Trench forearc: Relationship to volcanic rocks erupted during subduction initiation

Two suites of intermediate-felsic plutonic rocks were recovered by dredges RD63 and RD64 (R/V KK81-06-26) from the northern wall of the Mariana trench near Guam, which is located in the southern part of the Izu-Bonin-Mariana (IBM) island arc system. The locations of the dredges are significant as the area contains volcanic rocks (forearc basalts and boninites) that have been pivotal in explaining processes that occur when one lithospheric plate initially begins to subduct beneath another. The plutonic rocks have been classified based on petrologic and geochemical analyses, which provides insight to their origin and evolution in context of the surrounding Mariana trench. Based on whole rock geochemistry, these rocks (SiO2: 49-78 wt%) have island arc trace element signatures (Ba, Sr, Rb enrichment, Nb-Ta negative anomalies, U/Th enrichment), consistent with the adjacent IBM volcanics. Depletion of rare earth elements (REEs) relative to primitive mantle and excess Zr and Hf compared to the middle REEs indicate that the source of the plutonic rocks is similar to boninites and transitional boninites. Early IBM volcanic rocks define isotopic fields (Sr, Pb, Nd and Hf-isotopes) that represent different aspects of the subduction process (e.g., sediment influence, mantle provenance). The southern Mariana plutonic rocks overlap these fields, but show a clear distinction between RD63 and RD64. Modeling of the REEs, Zr and Hf shows that the plutonic suites formed via melting of boninite crust or by crystallization from a boninite-like magma rather than other sources that are found in the IBM system. The data presented support the hypothesis that the plutonic rocks from RD63 and RD64 are products of subduction initiation and are likely pieces of middle crust in the forearc exposed at the surface by faulting and serpentine mudvolcanoes. Their existence shows that intermediate-felsic crust may form very early in the history of an intra-oceanic island arc system. Plutonic rocks with similar formation histories may exist in obducted suprasubduction zone ophiolites and would be evidence that felsic-intermediate forearc plutonics are eventually accreted to the continents.

(Table 1) Mineral composition of sand- and silt-sized fractions of bottom sediments from the Romanche Trench

A study was made of mineral composition of sand- and silt-sized fractions of recent clastic (riftogenic) sediments and solidified deposits collected from the bottom of the Romanche Trench during the first voyage of R/V Akademik Kurchatov. Similarity between mineral compositions of sediments and bedrocks (ultrabasites, gabbroids, diabases) was established. This similarity is a basis for considering the mineral complex of the deposits that have been derived from the bedrocks of the trench slopes, and have formed due to their submarine denudation accompanied by tectonic crushing. The same mineral composition was found in pieces of older consolidated deposits; this suggests that conditions of sedimentation similar to those at recent times have existed for a long time in the Romanche Trench.

(Table 1) Radiocarbon ages of Bivalvia shells obtained from core ASV13_1157, Novaya Zemlya Trench

It is shown that sediments accumulated in the Southern Novaya Zemlya Trench at both deglaciation and marine stages. Permanent sea ice sheet existed during the deglaciation, and glacier meltwater was intensely delivered to the bottom layer. Along with the dominant sediment supply from the Southern Island of Novaya Zemlya, southern continental sources also played a noticeable role at that stage. Seasonal sea ice freezing led to the formation of cold brines at the marine stage. Like paleoproductivity, these processes were irregular. Dissolution of calcareous benthic foraminiferal tests considerably intensified after about 7 ka BP owing to a stronger Atlantic water advection into the Western Arctic and consequent increase in paleoproductivity, whereas the relative role of southern sedimentary provenances decreased. Sedimentation rates were constant (45 cm/ka) during the entire marine stage.

Ex situ sulphate reduction and methane oxidation rates of sediment at the rim of a vesicomyd clam colony in the Japan Deep Sea Trench (dive 956)

Sediment samples were collected from the rim of a large vesicomyid clam colony in the Japan Deep Sea Trench. Immediately after sample recovery onboard, the sediment core was sub-sampled for ex situ rate measurements. Sulfate reduction and anaerobic oxidation of methane were measured ex situ by the whole core injection method with three replicate measurements for each method. We incubated the samples at in situ temperature (1.5°C) for 48 hours with either 14C-methane (dissolved in water, 2.5 kBq) or carrier-free 35S-sulfate (dissolved in water, 50 kBq). Sediment was fixed in 25 ml sodium hydroxide (NaOH) solution (2.5%, w/v) or 20 ml ZnAc solution (20%, w/v) for AOM or SR, respectively. Turnover rates were measured as previously described (Kallmeyer et al., 2004; Treude et al., 2003).

Geochemistry of the Japan Trench sediments at DSDP Legs 56-57 Holes

The main objective of this investigation was to study distribution of main chemical constituents and several minor elements in sediment sections drilled during DSDP Legs 56 and 57 in the Japan Trench, in order to infer geochemical features of different lithologic types of sediments, and to find out how the geochemistry is associated with major lithologic constituents, such as terrigenous detrital matter, clay, volcanic ash, and biogenic particles. The geochemical data may help to indicate the nature of the sediments and to interpret sedimentation processes. The analyzed samples seem to be representative of most lithologic units, sub-units, and sediment types drilled at all sites on both legs, except for some shallow-water deposits at Sites 438 and 439. We analyzed bulk-sediment composition by X-ray fluorescence (Kuzmina and Turanskaya) and routine wet-chemical methods (Mikhailov); amorphous SiO2, extracted in a boiling sodium carbonate solution (Analythical Laboratory, P. P. Shirshov Institute of Oceanology); Cr, Zn, Cu, Ni, Co, and Al by atomic absorption (Gordeev); and Sn, Pb, Zn, Cu, Ni, Co, Cr, V, B, and Ag by quantitative spectrographic analyses in both bulk samples and granulometric fractions (Mikhailov). In addition, Fe, Ti, Mn, and CaCO3 have been determined in selected samples by routine wet-chemical methods (Analytical Laboratory, P. P. Shirshov Institute of Oceanology). Murdmaa was responsible for interpretation of the results.