Improvement in the voltage grading (axial and radial) of the generator column of a Van de Graaf generator by the use of a resistor chain

It is well known that the use of a series of resistors, connected between the equipotential rings of a Van de Graaff generator, improves the axial voltage grading of the generator. The work reported in this paper shows how the resistor chain also improves the radial voltage gradient. The electrolytic field mapping technique was adopted in the present work.

Peripheral facial palsy : Grading, Etiology, and Melkersson-Rosenthal Syndrome

The objective of this study was to assess the utility of two subjective facial grading systems, to evaluate the etiologic role of human herpesviruses in peripheral facial palsy (FP), and to explore characteristics of Melkersson-Rosenthal syndrome (MRS). Intrarater repeatability and interrater agreement were assessed for Sunnybrook (SFGS) and House-Brackmann facial grading systems (H-B FGS). Eight video-recorded FP patients were graded in two sittings by 26 doctors. Repeatability for SFGS was from good to excellent and agreement between doctors from moderate to excellent by intraclass correlation coefficient and coefficient of repeatability. For H-B FGS, repeatability was from fair to good and agreement from poor to fair by agreement percentage and kappa coefficients. Because SFGS was at least as good in repeatability as H-B FGS and showed more reliable results in agreement between doctors, we encourage the use of SFGS over H-B FGS. Etiologic role of human herpesviruses in peripheral FP was studied by searching DNA of herpes simplex virus (HSV) -1 and -2, varicella-zoster virus (VZV), human herpesvirus (HHV) -6A, -6B, and -7, Epstein-Barr virus (EBV), and cytomegalovirus (CMV) by PCR/microarray methods in cerebrospinal fluid (CSF) of 33 peripheral FP patients and 36 controls. Three patients and five controls had HHV-6 or -7 DNA in CSF. No DNA of HSV-1 or -2, VZV, EBV, or CMV was found. Detecting HHV-7 and dual HHV-6A and -6B DNA in CSF of FP patients is intriguing, but does not allow etiologic conclusions as such. These DNA findings in association with FP and the other diseases that they accompanied require further exploration. MRS is classically defined as a triad of recurrent labial or oro-facial edema, recurrent peripheral FP, and plicated tongue. All three signs are present in the minority of patients. Edema-dominated forms are more common in the literature, while MRS with FP has received little attention. The etiology and true incidence of MRS are unknown. Characteristics of MRS were evaluated at the Departments of Otorhinolaryngology and Dermatology focusing on patients with FP. There were 35 MRS patients, 20 with FP and they were mailed a questionnaire (17 answered) and were clinically examined (14 patients). At the Department of Otorhinolaryngology, every MRS patient had FP and half had the triad form of MRS. Two patients, whose tissue biopsies were taken during an acute edema episode, revealed nonnecrotizing granulomatous findings typical for MRS, the other without persisting edema and with symptoms for less than a year. A peripheral blood DNA was searched for gene mutations leading to UNC-93B protein deficiency predisposing to HSV-1 infections; no gene mutations were found. Edema in most MRS FP patients did not dominate the clinical picture, and no progression of the disease was observed, contrary to existing knowledge. At the Department of Dermatology, two patients had triad MRS and 15 had monosymptomatic granulomatous cheilitis with frequent or persistent edema and typical MRS tissue histology. The clinical picture of MRS varied according to the department where the patient was treated. More studies from otorhinolaryngology departments and on patients with FP would clarify the actual incidence and clinical picture of the syndrome.

"Standards are living documents ..."

"Standards are living documents which reflect progress in science, technology and systems" - Standards Australia.

Spatialised metaphors of practice: How teacher educators engage with professional standards for teachers

Preservice teacher educators, both nationally and internationally, must negotiate a plethora of expectations including using Professional Standards to enhance teacher quality. In Australia, the recent Teacher Education Ministerial Advisory Group (TEMAG) report highlighted weak application of Standards in Initial Teacher Education (ITE). However, recent findings suggest that education stakeholders feel positive about the implementation of the Australian Professional Standards for Teachers (APSTs). This study responds to these differing viewpoints by exploring how teacher educators in a large metropolitan university in Australia account for the use of Standards in their work. Discourse analytic techniques in conjunction with socio-spatial theory make visible particular metaphors of practice as teacher educators negotiate the real-and-imagined spaces of regulated teacher education programs. The findings highlight the importance of investigating the utility of Standards in the lived experiences of teacher educators, as they are responsible for preparing quality, classroom ready graduates.

Use of Standards for CAD Layers in Building

One of the central issues in making efficient use of IT in the design, construction and maintenance of buildings is the sharing of the digital building data across disciplines and lifecycle stages. One technology which enables data sharing is CAD layering, which to be of real use requires the definition of standards. This paper focuses on the background, objectives and effectiveness of the International standard ISO 13567, Organisation and naming of layers for CAD. In particular the efficiency and effectiveness of the standardisation and standard implementation process are in focus, rather than the technical details. The study was conducted as a qualitative study with a number of experts who responded to a semi-structured mail questionnaire, supplemented by personal interviews. The main results were that CAD layer standards based on the ISO standard have been implemented, particularly in northern European countries, but are not very widely used. A major problem which was identified was the lack of resources for marketing and implementing the standard as national variations, once it had been formally accepted.

Influence of soil grading on the characteristics of cement stabilised soil compacts

The paper deals with experimental investigations aiming at specifying optimum soil grading limits for the production of cement stabilised soil bricks (CSSB). Wide range of soil grading curves encompassing both fine and coarse grained soils were considered. Strength, durability and absorption characteristics of CSSB were examined considering 14 different types of soil grading curves and three cement contents. The investigations show that there is optimum clay content for the soil mix which yields maximum compressive strength for CSSB and the optimum clay content is about 10 and 14 % for fine grained and coarse grained soils respectively. Void ratio of the compacted specimens is the lowest at the optimum clay content and therefore possesses maximum strength at that point. CSSB using fine grained soils shows higher strength and better durability characteristics when compared to the bricks using coarse grained soils.

Interlaboratory comparison of magnesium isotopic compositions of 12 felsic to ultramafic igneous rock standards analyzed by MC-ICPMS

To evaluate the interlaboratory mass bias for high-precision stable Mg isotopic analysis of natural materials, a suite of silicate standards ranging in composition from felsic to ultramafic were analyzed in five laboratories by using three types of multicollector inductively coupled plasma mass spectrometer (MC-ICPMS). Magnesium isotopic compositions from all labs are in agreement for most rocks within quoted uncertainties but are significantly (up to 0.3 parts per thousand in Mg-26/Mg-24, > 4 times of uncertainties) different for some mafic samples. The interlaboratory mass bias does not correlate with matrix element/Mg ratios, and the mechanism for producing it is uncertain but very likely arises from column chemistry. Our results suggest that standards with different matrices are needed to calibrate the efficiency of column chemistry and caution should be taken when dealing with samples with complicated matrices. Well-calibrated standards with matrix elements matching samples should be used to reduce the interlaboratory mass bias.

Finite Element Solutions for Plane Strain Mode I Crack with Strain Grading Effect

In this paper, a new phenomenological theory with strain gradient effects is proposed to account for the size dependence of plastic deformation at micro- and submicro-length scales. The theory fits within the framework of general couple stress theory and three rotational degrees of freedom omega(i) are introduced in addition to the conventional three translational degrees of freedom mu(i). omega(i) is called micro-rotation and is the sum of material rotation plus the particles' relative rotation. While the new theory is used to analyze the crack tip field or the indentation problems, the stretch gradient is considered through a new hardening law. The key features of the theory are that the rotation gradient influences the material character through the interaction between the Cauchy stresses and the couple stresses; the term of stretch gradient is represented as an internal variable to increase the tangent modulus. In fact the present new strain gradient theory is the combination of the strain gradient theory proposed by Chen and Wang (Int. J. Plast., in press) and the hardening law given by Chen and Wang (Acta Mater. 48 (2000a) 3997). In this paper we focus on the finite element method to investigate material fracture for an elastic-power law hardening solid. With remotely imposed classical K fields, the full field solutions are obtained numerically. It is found that the size of the strain gradient dominance zone is characterized by the intrinsic material length l(1). Outside the strain gradient dominance zone, the computed stress field tends to be a classical plasticity field and then K field. The singularity of stresses ahead of the crack tip is higher than that of the classical field and tends to the square root singularity, which has important consequences for crack growth in materials by decohesion at the atomic scale. (C) 2002 Elsevier Science Ltd. All rights reserved.

Environmental quality standards to protect identified uses of controlled waters: salmonid fisheries, cyprinid fisheries, migratory fisheries, commercial harvesting of marine fish for public consumption, commercial harvesting of shellfish for for public consumption

This report considers the development of environmental quality standards (EQSs) for the salmonid fishery, cyprinid fishery, migratory fishery, commercial harvesting of marine fish for public consumption and commercial harvesting of shellfish for public consumption uses of controlled surface waters. Previous reports have been used to identify those parameters necessary for the maintenance of these five uses. Each water use is considered in a separate section within which identified parameters are discussed and standards proposed, a summary of the proposed standards is presented at the beginning of the relevant section. For salmonid, cyprinid and migratory fisheries, EQSs for substances in water have been proposed for the protection of these fisheries. For the commercial harvesting of marine fish and shellfish for public consumption uses 'Warning Levels' of substances in waters have been proposed. These 'Warning Levels' have been proposed by considering data on bioaccumulation and food standards and aim to prevent acceptable intake values and concentrations in fish/shellfish flesh exceeding statutory or recommended levels. For the commercial harvesting of marine fish for public consumption it has been concluded that the current EQSs for most List II substances for the protection of salt water life should be adequately stringent to protect this use, however for the commercial harvesting of shellfish for public consumption, these List II EQSs do not appear adequate to protect this use and more stringent 'Warning Levels' have been proposed. For all five uses considered in this report there has been found to be limited information on a number of the parameters considered and in general for indigenous species, this has been found to be especially so when considering migratory fisheries and the commercial harvesting of marine fish and shellfish.