Clay and smectite analysis of sediment core CRP-2A

Sediments of the CRP-2/2A drill core from the continental shelf of McMurdo Sound in Ross Sea, Pacific sector of the Southern Ocean, have been investigated for their clay mineral assemblages, especially for the smectite contents and smectite crystallinities. Highest smectite amounts and best crystallinities occur in three intervals below 485 mbsf in CRP-2/2A. They indicate deposition of sediments during a time when chemical weathering was active on large ice-free areas on the nearby Antarctic continent. In he upper part of the core, smectite contents are much lower and crystallinities are worse. This clay mineral composition indicates deposition of sediments during a time when physical weathering prevailed on an ice-covered continent. At deep-sea sites around Antarctica the shift from smectite-dominated to smectite-poor and illite-rich assemblages is well dated as earliest Oligocene, 33.9-33.1 Ma, and documents the onset of continental glaciation in East Antarctica. At CIROS-1 a corresponding shift in the clay mineralogy was observed at a depth of 425-445 mbsf.

Electron microprobe results of clay minerals from samples of the Frankenwald and the Thüringer Wald

Late Devonian (Frasnian) pillow basalts from the Frankenwald and Thüringer Wald within the Saxothuringian zone in Germany were found to contain abundant putative biogenic filaments, indicating that the volcanic rocks once harbored microbial life. The mineralized filaments are found in calcite-filled amygdules (former vesicles), where they started to form on internal surfaces of vesicles after seawater ingress. The filaments postdate an early fibrous carbonate cement but predate later equant calcite spar, revealing syngenetic formation. A biogenic origin of filaments is indicated by their size and morphology resembling modern microorganisms, their independence of crystal faces and cleavage plans, complex branching patterns, and internal segmentation. The filamentous microorganisms represent cryptoendoliths that lived in structural cavities of the basalt. They became preserved upon microbial clay authigenesis similar to the encrustation of modern prokaryotes in iron-rich environments. Filaments consist of clay minerals with the endmember composition berthierine-chamosite and illite-glauconite. Based on the discovery of fossilized filamentous microorganisms in Late Devonian pillow basalts of the Saxothurigian zone that are similar to filaments previously found in Middle Devonian pillow basalts of the Rhenohercynian zone, it is apparent that cryptoendolithic life was more widespread than previously recognized. Structural cavities within seafloor basalt may thus represent a common, perhaps universal niche for life in the oceanic crust.

Clay-based polymer nanocomposites: Research and commercial development

This paper reviews the recent research and development of clay-based polymer nanocomposites. Clay minerals, due to their unique layered structure, rich intercalation chemistry and availability at low cost, are promising nanoparticle reinforcements for polymers to manufacture low-cost, lightweight and high performance nanocomposites. We introduce briefly the structure, properties and surface modification of clay minerals, followed by the processing and characterization techniques of polymer nanocomposites. The enhanced and novel properties of such nanocomposites are then discussed, including mechanical, thermal, barrier, electrical conductivity, biodegradability among others. In addition, their available commercial and potential applications in automotive, packaging, coating and pigment, electrical materials, and in particular biomedical fields are highlighted. Finally, the challenges for the future are discussed in terms of processing, characterization and the mechanisms governing the behaviour of these advanced materials.

Organic carbon and nitrogen, sediment composition, and clay mineralogy of Deep Sea Drilling Project Site 603, western Atlantic Ocean

Sediment and interstitial water samples recovered during DSDP Leg 93 at Site 603 (lower continental rise off Cape Hatteras) were analyzed for a series of geochemical facies indicators to elucidate the nature and origin of the sedimentary material. Special emphasis was given to middle Cretaceous organic-matter-rich turbidite sequences of Aptian to Turanian age. Organic carbon content ranges from nil in pelagic claystone samples to 4.2% (total rock) in middle Cretaceous carbonaceous mudstones of turbiditic origin. The organic matter is of marine algal origin with significant contributions of terrigenous matter via turbidites. Maturation indices (vitrinite reflectance) reveal that the terrestrial humic material is reworked. Maturity of autochthonous material (i.e., primary vitrinite) falls in the range of 0.3 to 0.6% Carbohydrate, hydrocarbon, and microscopic investigations reveal moderate to high microbial degradation. Unlike deep-basin black shales of the South and North Atlantic, organic-carbon-rich members of the Hatteras Formation lack trace metal enrichment. Dissolved organic carbon (DOC) in interstitial water samples ranges from 34.4 ppm in a sandstone sample to 126.2 ppm in an organic-matter-rich carbonaceous claystone sample. One to two percent of DOC is carbohydratecarbon.

Clay mineralogy of South Atlantic surface sediments

Surface samples, mostly from abyssal sediments of the South Atlantic, from parts of the equatorial Atlantic, and of the Antarctic Ocean, were investigated for clay content and clay mineral composition. Maps of relative clay mineral content were compiled, which improve previous maps by showing more details, especially at high latitudes. Large-scale relations regarding the origin and transport paths of detrital clay are revealed. High smectite concentrations are observed in abyssal regions, primarily derived from southernmost South America and from minor sources in Southwest Africa. Near submarine volcanoes of the Antarctic Ocean (South Sandwich, Bouvet Island) smectite contents exhibit distinct maxima, which is ascribed to the weathering of altered basalts and volcanic glasses. The illite distribution can be subdivided into five major zones including two maxima revealing both South African and Antarctic sources. A particularly high amount of Mg- and Fe-rich illites are observed close to East Antarctica. They are derived from biotite-bearing crystalline rocks and transported to the west by the East Antarctic Coastal Current. Chiorite and well-crystallized dioctaedral illite are typical minerals enriched within the Subantarctic and Polarfrontal-Zone but of minor importance off East Antarctica. Kaolinite dominates the clay mineral assemblage at low latitudes, where the continental source rocks (West Africa, Brazil) are mainly affected by intensive chemical weathering. Surprisingly, a slight increase of kaolinite is observed in the Enderby Basin and near the Filchner-Ronne Ice shelf. The investigated area can be subdivided into ten, large-scale clay facies zones with characteristic possible source regions and transport paths. Clay mineral assemblages of the largest part of the South Atlantic, especially of the western basins are dominated by chlorite and illite derived from the Antarctic Peninsula and southernmost South America and supported by advection within the Circumantarctic Deep Water flow. In contrast, the East Antarctic provinces are relatively small. Assemblages of the eastern basins north of 30°S are strongly influenced by African sources, controlled by weathering regimes on land and by a complex interaction of wind, river and deep ocean transport. The strong gradient in clay mineral composition at the Brazilian slope indicate a relatively low contribution of tropically derived assemblages to the western basins.

Crystalline polymorph transition in poly(vinylidene fluoride) (PVDF)/acrylic rubber(ACM)/clay partially miscible hybrid

This study investigates the intercalation of nanoclay in partially miscible blends of poly(vinylidene fluoride) (PVDF) and acrylic rubber(ACM). Transmission electron microscopy and X-ray diffraction technique were used to investigate the formation of nanoscale polymer blend/clay hybrids. Using Infrared spectroscopy and X-ray analysis, the different polymorph formation in PVDF nanocomposite and conjugated phases of partially miscible nanocomposite was studied. Nanoclay was found to induce β and γ polymorphs while ACM tend to induce α phase in this polymer system. It was shown that PVDF chains in ACM-rich phase of partially miscible nanocomposites interact with ACM chains which in return form α polymorph in the presence of ACM. Further observations revealed that nanoclay in α polymorph is wrapped by ACM molecules.

Gender effects in orientation on primary students’ performance on items rich in graphics

This study investigated the longitudinal performance of 378 students who completed mathematics items rich in graphics. Specifically, this study explored student performance across axis (e.g., numbers lines), opposed-position (e.g., line and column graphs) and circular (e.g., pie charts) items over a three-year period (ages 9-11 years). The results of the study revealed significant performance differences in the favour of boys on graphics items that were represented in horizontal and vertical displays. There were no gender differences on items that were represented in a circular manner.

Smectite flocculation structure modified by AI13 macromolecules; as revealed by the Transmission X-ray Microscopy (TXM)

The aggregate structure which occurs in aqueous smectitic suspensions is responsible for poor water clarification, difficulties in sludge dewatering and the unusual rheological behaviour of smectite rich soils. These macroscopic properties are dictated by the 3-D structural arrangement of smectite finest fraction within flocculated aggregates. Here, we report results from a relatively new technique, Transmission X-ray Microscopy (TXM), which makes it possible to investigate the internal structure and 3-D tomographic reconstruction of the smectite clay aggregates modified by Al13 keggin macro-molecule [Al13(O)4(OH)24(H2O)12 ]7+. Three different treatment methods were shown resulted in three different micro-structural environments of the resulting flocculation.

Darjeeling, a feature-rich VM for the resource poor

The programming and retasking of sensor nodes could benefit greatly from the use of a virtual machine (VM) since byte code is compact, can be loaded on demand, and interpreted on a heterogeneous set of devices. The challenge is to ensure good programming tools and a small footprint for the virtual machine to meet the memory constraints of typical WSN platforms. To this end we propose Darjeeling, a virtual machine modelled after the Java VM and capable of executing a substantial subset of the Java language, but designed specifically to run on 8- and 16-bit microcontrollers with 2 - 10 KB of RAM. The Darjeeling VM uses a 16- rather than a 32-bit architecture, which is more efficient on the targeted platforms. Darjeeling features a novel memory organisation with strict separation of reference from non-reference types which eliminates the need for run-time type inspection in the underlying compacting garbage collector. Darjeeling uses a linked stack model that provides light-weight threads, and supports synchronisation. The VM has been implemented on three different platforms and was evaluated with micro benchmarks and a real-world application. The latter includes a pure Java implementation of the collection tree routing protocol conveniently programmed as a set of cooperating threads, and a reimplementation of an existing environmental monitoring application. The results show that Darjeeling is a viable solution for deploying large-scale heterogeneous sensor networks. Copyright 2009 ACM.