NOISE and ULTRAVIOLET DIVERGENCES IN SIMULATIONS of GINZBURG-LANDAU-LANGEVIN TYPE of EQUATIONS

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Effect of the type of environmental stress on the emergence of sunflower (Helianthus annus L.), soybean (Glycine max (L.) Merril) and maize (Zea mays L.) seeds with different levels of vigor

Sowing is a critical time in the cycle of a crop and the seeds are frequently exposed to adverse conditions that may compromise the establishment of seedlings in the field. on this basis, the objective of the present study was to determine the effect of types of environmental stress on the emergence of sunflower, maize and soybean seeds with different levels of vigor. High vigor seeds were artificially aged in order to obtain medium and low vigor seeds and then they were sown in clay soil in plastic boxes and submitted to the following types of environmental stress during the germination process : 1) high temperature (35degreesC), 2) low temperature (15 or 18degreesC), 3) water excess (Psi > -0.0001 MPa), 4) water deficiency (Psi approximately equal to -1.1; -1.2 and -0.6 MPa for sunflower, maize and soybean, respectively), 5) sowing at a depth of 7 cm and 6) pathogenic infection of sunflower seeds with Alternaria helianthi, of maize seeds with Fusarium moniliforme and of soybean seeds with Colletotrichum dematium, var. truncata. The results were compared to those obtained with controls sown under optimal condition. It was concluded that: 1) the effect of seed vigor on emergence depends on the type of enviromental stress to which the seeds are exposed, 2) the stress to which the the seeds demonstrated highest sensitivity varied with species and 3) high temperature stress was the one that most impaired the emergence of the three species.

Open elevated plus maze-induced antinociception in rats: A non-opioid type of pain inhibition?

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Sperm ultrastructure and a new type of spermiogenesis in two species of Pimelodidae, with a comparative review of sperm ultrastructure in Siluriformes (Teleostei : Ostariophysi)

During spermiogenesis, the spermatids of the pimelodid species Pimelodus maculatus and Pseudoplatystoma fasciatum show a central flagellum development, no rotation of the nucleus, and no nuclear fossa formation, in contrast to all previously described spermatids of Teleostei. These characteristics are interpreted as belonging to a new type of spermiogenesis, named here type III, which is peculiar to the family Pimelodidae. In P. maculatus and P. fasciatum, spermatozoa possess a spherical head and no acrosome; their nucleus contains highly condensed, homogeneous chromatin with small electron-lucent areas; and a nuclear fossa is not present. The centriolar complex lies close to the nucleus. The midpiece is small, has no true cytoplasmic channel, and contains many elongate and interconnected vesicles. Several spherical to oblong mitochondria are located around the centriolar complex. The flagellum displays the classical axoneme (9 + 2) and no lateral fins. Only minor differences were observed among the pimelodid species and genera. Otherwise, spermiogenesis and spermatozoa in the two species of Pimelodidae studied exhibit many characteristics that are not found in other siluriform families, mainly the type III spermiogenesis. (C) 2007 Elsevier GmbH. All rights reserved.

Effect of type of cuttings and indolbutyric acid on the rooting of rose (Rosa sp. 'Red success') leafy cuttings during two seasons

The objectives of this study were to evaluate the effect of type of cuttings (apical, intermediate and basal) and different concentrations of IBA (indole-3-butyric acid) on rooting of Red success rose (Rosa sp.) leafy cuttings, during two season of cuttings collection (summer and winter). The investigation was carried out in the farm Irmaos Van Schaik in Holambra-SP, Brazil, from February to April and August to October/1993. The experimental design was a randomized block in a factorial arrangement. It consisted of 12 treatments (3 types of cuttings combined with IBA powder in 4 different concentrations - 0, 1000, 2000 and 4000 ppm) with 3 replicates during 2 seasons. The investigation permitted the following conclusions: the apical and intermediate cuttings showed better results in general when compared to the basal ones in both seasons; the average rooting at the transplanting time were 76%, 70% and 47% (summer) and 80%, 69% and 33% (winter) for apical, intermediate and basal cuttings, respectively; the utilization of IBA did not stimulate rooting. The average rooting for the control cuttings reached 85% (summer) and 78% (winter), regardless the type of cuttings.

The effect of type of vaginal insert and dose of pLH on embryo production, following fixed-time AI in a progestin-based superstimulatory protocol in Nelore cattle

The objective was to analyze and report field data focusing on the effect of type of progesterone-releasing vaginal insert and dose of pLH on embryo production, following a superstimulatory protocol involving fixed-time artificial insemination (FTAI) in Nelore cattle (Bos taurus indicus). Donor heifers and cows (n = 68; 136 superstimulations over 2 years) received an intravaginal, progesterone-releasing insert (CIDR® or DIB®, with 1.9 or 1.0 g progesterone, respectively) and 3-4 mg of estradiol benzoate (EB) i.m. at random stages of the estrous cycle. Five days later (designated Day 0), cattle were superstimulated with a total of 120-200 mg of pFSH (Folltropin-V®), given twice daily in decreasing doses from Days 0 to 3. All cattle received two luteolytic doses of PGF2α at 08:00 and 20:00 h on Day 2 and progesterone inserts were removed at 20:00 h on Day 3 (36 h after the first PGF2α injection). Ovulation was induced with pLH (Lutropin-V®, 12.5 or 25 mg, i.m.) at 08:00 h on Day 4 with FTAI 12, 24 and in several cases, 36 h later. Embryos were recovered on Days 11 or 12, graded and transferred to synchronous recipients. Overall, the mean (±S.E.M.) number of total ova/embryos (13.3 ± 0.8) and viable embryos (9.4 ± 0.6) and pregnancy rate (43.5%; 528/1213) did not differ among groups, but embryo viability rate (overall, 70.8%) was higher in donors with a DIB (72.3%) than a CIDR (68.3%, P = 0.007). In conclusion, the administration of pLH 12 h after progesterone removal in a progestin-based superstimulatory protocol facilitated fixed-time AI in Nelore donors, with embryo production, embryo viability and pregnancy rates after embryo transfer, comparable to published results where estrus detection and AI was done. Results suggested a possible alternative, which would eliminate the need for estrus detection in donors. © 2006 Elsevier Inc. All rights reserved.

Influence of grinding on the roundness, residual stresses and microstructure of VC131 steel analysed by varying the type of cutting fluid

This paper by R. E. Catai, E. C. Bianchi, P. R de Águia and M. C. Alves reports on the results of an analysis made of roundness errors, residual stresses, and SEM micrographs of VC131 steel. The analysis involved workpieces ground with two types of cutting fluid: synthetic cutting fluid and emulsive oil. In this study, the cutting parameters were kept constant while the type of cutting fluid was varied. The amount of cutting fluid injected in the process was also varied, aiming to identify the ideal amount required to obtain good results without causing structural damage to the workpiece. The SEM analyses of roundness errors and residual stresses revealed that, of the two cutting fluids, emulsive oil provided better tensions due to its greater lubricating power.

La informática y otro desarrollo para la región = Information sciences and a different type of development for the region

Incluye Bibliografía

Type of Intercept Trap Not Important for Capturing Female Sirex noctilio and S-nigricornis (Hymenoptera: Siricidae) in North America

Current detection tools for Sirex noctilio F. (Hymenoptera: Siricidae) in North America are poor. To determine the importance of intercept trap type for capturing females of S. noctilio and its native congener, Sirex nigricornis F., in eastern North America, we report on seven trap comparison studies from different years and geographic locations. Among studies, total numbers of S. noctilio captured were low (mean of <= 1waspper trap). Total numbers of S. nigricornis caught were generally greater, andranged from ameanof 1-13 wasps per trap. Nearly all studies found no significant differencesamongintercept trap types in the number of woodwasps caught. For future studies, we recommend that either panel or 12-unit Lindgren funnel traps be used to catch S. noctilio or S. nigricornis in eastern North America.

Effect of root canal preparation, type of endodontic post and mechanical cycling on root fracture strength

Objective: To evaluate the impact of the type of root canal preparation, intraradicular post and mechanical cycling on the fracture strength of roots. Material and Methods: Eighty human single rooted teeth were divided into 8 groups according to the instruments used for root canal preparation (manual or rotary instruments), the type of intraradicular post (fiber posts-FRC and cast post and core-CPC) and the use of mechanical cycling (MC) as follows: Manual and FRC; Manual, FRC and MC; Manual and CPC; Manual, CPC and MC; Rotary and FRC; Rotary, FRC and MC; Rotary and CPC; Rotary, CPC and MC. The filling was performed by lateral compactation. All root canals were prepared for a post with a 10 mm length, using the custom # 2 bur of the glass fiber post system. For mechanical cycling, the protocol was applied as follows: an angle of incidence of 45 degrees, 37 degrees C, 88 N, 4 Hz, 2 million pulses. All groups were submitted to fracture strength test in a 45 degrees device with 1 mm/min cross-head speed until failure occurred. Results: The 3-way ANOVA showed that the root canal preparation strategy (p<0.03) and post type (p<0.0001) affected the fracture strength results, while mechanical cycling (p=0.29) did not. Conclusion: The root canal preparation strategy only influenced the root fracture strength when restoring with a fiber post and mechanical cycling, so it does not seem to be an important factor in this scenario.

Morphological traits and type of dairy goats registered in Brazil from 1976 to 2009

Data from 2439 goats of the Saanen, Alpine, Anglo Nubian and Toggenburg breeds recorded from 1976 to 2009 by the Association of Goats and Sheep Breeders of Minas Gerais were used in principal component analysis. After consistency of data, six morphological variables (thorax perimeter, body length, withers height, height, width and length of the rump) and 12 variables related to breed standard score and fitness (breed characteristic, head, palette and topline, feet and legs, dairy type, body capacity, udder, rear and front ligament, udder texture, teat and final score) were analyzed. Based on the magnitude of the eigenvalue (lower than 0.7), eleven variables considered redundant were discarded, resulting in reduced costs of technician labor to evaluate the animals. Maintenance of records on height, length, rump width, breed characteristic, dairy type, front ligament and udder texture is recommended.

Roughness and morphology of composites: influence of type of material, fluoride solution, and time

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)