An analytical investigation into shear wall and slab interconnections between reinforced concrete modules for high -rise buildings utilising modular construction under extreme seismic and wind loading

This research investigates a new structural system utilising modular construction. Five-sided boxes are cast on-site and stacked together to form a building. An analytical model was created of a typical building in each of two different analysis programs utilising the finite element method (Robot Millennium and ETABS). The pros and cons of both Robot Millennium and ETABS are listed at several key stages in the development of an analytical model utilising this structural system. Robot Millennium was initially utilised but created an analytical model too large to be successfully run. The computation requirements were too large for conventional computers. Therefore Robot Millennium was abandoned in favour of ETABS, whose more simplistic algorithms and assumptions permitted running this large computation model. Tips are provided as well as pitfalls signalled throughout the process of modelling such complex buildings of this type. ^ The building under high seismic loading required a new horizontal shear mechanism. This dissertation has proposed to create a secondary floor that ties to the modular box through the use of gunwales, and roughened surfaces with epoxy coatings. In addition, vertical connections necessitated a new type of shear wall. These shear walls consisted of waffled external walls tied through both reinforcement and a secondary concrete pour. ^ This structural system has generated a new building which was found to be very rigid compared to a conventional structure. The proposed modular building exhibited a period of 1.27 seconds, which is about one-fifth of a conventional building. The maximum lateral drift occurs under seismic loading with a magnitude of 6.14 inches which is one-quarter of a conventional building's drift. The deflected shape and pattern of the interstorey drifts are consistent with those of a coupled shear wall building. In conclusion, the computer analysis indicate that this new structure exceeds current code requirements for both hurricane winds and high seismic loads, and concomitantly provides a shortened construction time with reduced funding. ^

Estimation of sea surface temperatures and salinity of ODP Site 177-1089 (Appendix A)

ODP Site 1089 is optimally located in order to monitor the occurrence of maxima in Agulhas heat and salt spillage from the Indian to the Atlantic Ocean. Radiolarian-based paleotemperature transfer functions allowed to reconstruct the climatic history for the last 450 kyr at this location. A warm sea surface temperature anomaly during Marine Isotope Stage (MIS) 10 was recognized and traced to other oceanic records along the surface branch of the global thermohaline (THC) circulation system, and is particularly marked at locations where a strong interaction between oceanic and atmospheric overturning cells and fronts occurs. This anomaly is absent in the Vostok ice core deuterium, and in oceanic records from the Antarctic Zone. However, it is present in the deuterium excess record from the Vostok ice core, interpreted as reflecting the temperature at the moisture source site for the snow precipitated at Vostok Station. As atmospheric models predict a subtropical Indian source for such moisture, this provides the necessary teleconnection between East Antarctica and ODP Site 1089, as the subtropical Indian is also the source area of the Agulhas Current, the main climate agent at our study location. The presence of the MIS 10 anomaly in the delta13C foraminiferal records from the same core supports its connection to oceanic mechanisms, linking stronger Agulhas spillover intensity to increased productivity in the study area. We suggest, in analogy to modern oceanographic observations, this to be a consequence of a shallow nutricline, induced by eddy mixing and baroclinic tide generation, which are in turn connected to the flow geometry, and intensity, of the Agulhas Current as it flows past the Agulhas Bank. We interpret the intensified inflow of Agulhas Current to the South Atlantic as responding to the switch between lower and higher amplitude in the insolation forcing in the Agulhas Current source area. This would result in higher SSTs in the Cape Basin during the glacial MIS 10, due to the release into the South Atlantic of the heat previously accumulating in the subtropical and equatorial Indian and Pacific Ocean. If our explanation for the MIS 10 anomaly in terms of an insolation variability switch is correct, we might expect that a future Agulhas SSST anomaly event will further delay the onset of next glacial age. In fact, the insolation forcing conditions for the Holocene (the current interglacial) are very similar to those present during MIS 11 (the interglacial preceding MIS 10), as both periods are characterized by a low insolation variability for the Agulhas Current source area. Natural climatic variability will force the Earth system in the same direction as the anthropogenic global warming trend, and will thus lead to even warmer than expected global temperatures in the near future.

Pore-water concentration of chloride in sediment cores and equilibrium temperatures and gas bubble analysis at ROV stations from the Vodyanitskii mud volcano

Vodyanitskii mud volcano is located at a depth of about 2070 m in the Sorokin Trough, Black sea. It is a 500-m wide and 20-m high cone surrounded by a depression, which is typical of many mud volcanoes in the Black Sea. 75 kHz sidescan sonar show different generations of mud flows that include mud breccia, authigenic carbonates, and gas hydrates that were sampled by gravity coring. The fluids that flow through or erupt with the mud are enriched in chloride (up to 650 mmol L**-1 at 150-cm sediment depth) suggesting a deep source, which is similar to the fluids of the close-by Dvurechenskii mud volcano. Direct observation with the remotely operated vehicle Quest revealed gas bubbles emanating at two distinct sites at the crest of the mud volcano, which confirms earlier observations of bubble-induced hydroacoustic anomalies in echosounder records. The sediments at the main bubble emission site show a thermal anomaly with temperatures at 60 cm sediment depth that were 0.9 °C warmer than the bottom water. Chemical and isotopic analyses of the emanated gas revealed that it consisted primarily of methane (99.8%) and was of microbial origin (dD-CH4 = -170.8 per mil (SMOW), d13C-CH4 = -61.0 per mil (V-PDB), d13C-C2H6 = -44.0 per mil (V-PDB)). The gas flux was estimated using the video observations of the ROV. Assuming that the flux is constant with time, about 0.9 ± 0.5 x 10**6 mol of methane is released every year. This value is of the same order-of-magnitude as reported fluxes of dissolved methane released with pore water at other mud volcanoes. This suggests that bubble emanation is a significant pathway transporting methane from the sediments into the water column.

Sea ice and wind variability during the Holocene in East Antarctica

A high-resolution continuous record of diatom census counts and diatom specific biomarkers in sediment core NBP0101-JPC24 allows assessment of oceanographic and environmental conditions in eastern Prydz Bay during the deglaciation (11 100-9000 cal yr BP) at decadal timescale. Our study improves previous snapshots investigations based on resin-embedded thin sections and presents a new proxy that compliments the diatom census counts. Our results suggest that the ice sheet retreat over the core site is dated at ~11 100 cal yr BP, setting the onset of local deglaciation and subsequent open marine conditions. The glacial retreat in Prydz Bay is due to global warming initiated at 18 cal ka BP and the regional development of the Prydz Bay cyclonic gyre. Our results further demonstrate that the deglaciation in eastern Prydz Bay can be separated in four phases: the first between 11 100 and 10 900 cal yr BP when the ice shelf was proximal and sea ice was almost perennial; the second and the third phases between 10 900-10 400 cal yr BP and 10 400-9900 cal yr BP, respectively, when the ice shelf retreated and seasonal sea ice cycle consequently developed promoting warmer water to pump into the bay within the gyre, which in turn forced the ice shelf recession and the yearly sea ice cycle establishment; and the fourth between 9900 and 9000 cal yr BP when Holocene condition were set with a recurrent seasonal sea ice cycle and a well established Prydz Bay gyre.

(Table 1) Mean annual ground temperatures and description of permafrost boreholes in Russia

The results of the International Permafrost Association's International Polar Year Thermal State of Permafrost (TSP) project are presented based on field measurements from Russia during the IPY years (2007-09) and collected historical data. Most ground temperatures measured in existing and new boreholes show a substantial warming during the last 20 to 30 years. The magnitude of the warming varied with location, but was typically from 0.5°C to 2°C at the depth of zero annual amplitude. Thawing of Little Ice Age permafrost is ongoing at many locations. There are some indications that the late Holocene permafrost has begun to thaw at some undisturbed locations in northeastern Europe and northwest Siberia. Thawing of permafrost is most noticeable within the discontinuous permafrost domain. However, permafrost in Russia is also starting to thaw at some limited locations in the continuous permafrost zone. As a result, a northward displacement of the boundary between continuous and discontinuous permafrost zones was observed. This data set will serve as a baseline against which to measure changes of near-surface permafrost temperatures and permafrost boundaries, to validate climate model scenarios, and for temperature reanalysis.

Delta 44/40 Ca, Mg/Ca and Sr/Ca record of Globigerinoides sacculifer and calculated temperatures and salinity changes of ODP Hole 165-999A

The delta18O values of planktonic foraminifera increased in the Caribbean by about 0.5? relative to the equatorial East Pacific values between 4.6 and 4.2 Ma as a consequence of the closure of the Central American Gateway (CAG). This increase in delta18O can be interpreted either as an increase in Caribbean sea surface (mixed layer) salinity (SSS) or as a decrease in sea surface temperatures (SST). This problem represents an ideal situation to apply the recently developed paleotemperature proxy delta44/40Ca together with Mg/Ca and d18O on the planktic foraminifer Globigerinoides sacculifer from ODP Site 999. Although differences in absolute temperature calibration of delta44/40Ca and Mg/Ca exist, the general pattern is similar indicating a SST decrease of about 2-3 8C between 4.4 and 4.3 Ma followed by an increase in the same order of magnitude between 4.3 and 4.0 Ma. Correcting the delta18O record for this temperature change and assuming that changes in global ice volume are negligible, the salinity-induced planktonic delta18O signal decreased by about 0.4? between 4.4 and 4.3 Ma and increased by about 0.9? between 4.3 and 4.0 Ma in the Caribbean. The observed temperature and salinity trends are interpreted to reflect the restricted exchange of surface water between the Caribbean and the Pacific in response to the shoaling of the Panamanian Seaway, possibly accompanied by a southward shift of the Intertropical Convergence Zone (ITCZ) between 4.4 and 4.3 Ma. Differences in Mg/Ca- and delta44/40Ca-derived temperatures can be reconciled by corrections for secular variations of the marine Mg/Ca[sw] and delta44/40Ca, a salinity effect on the Mg/Ca ratio and a constant temperature offset of ~2.5 °C between both SST proxy calibrations.

Tidal and wind influences on circulation in the southern mouth of the Ría de Vigo (NW Iberian Peninsula)

Tidal and wind influences on the velocity field in the Ría de Vigo were assessed using atmospheric data from two meteorological stations located at Bouzas port and on an oceanic buoy off Silleiro Cape along with oceanic data from an ADCP moored in the Ría for a 72-day period. A two-layer circulation pattern was observed. Near-surface and near-bottom currents are primarily influenced by wind (especially remote winds), separated by an intermediate layer dominated by tidal variability. At subtidal frequencies, residual currents are well correlated with wind variability. Remote wind forcing exhibited a markedly high correlation with surface layer currents, indicating the major role played by wind in the long-term upwelling-modulated circulation of the Ría.

Tidal and wind influences on circulation in the southern mouth of the Ría de Vigo (NW Iberian Peninsula)

Tidal and wind influences on the velocity field in the Ría de Vigo were assessed using atmospheric data from two meteorological stations located at Bouzas port and on an oceanic buoy off Silleiro Cape along with oceanic data from an ADCP moored in the Ría for a 72-day period. A two-layer circulation pattern was observed. Near-surface and near-bottom currents are primarily influenced by wind (especially remote winds), separated by an intermediate layer dominated by tidal variability. At subtidal frequencies, residual currents are well correlated with wind variability. Remote wind forcing exhibited a markedly high correlation with surface layer currents, indicating the major role played by wind in the long-term upwelling-modulated circulation of the Ría.

Tris(2-ethylhexyl) trimellitate (TOTM) as a potential industrial reference fluid for viscosity at high temperatures and high pressures: New viscosity, density and surface tension measurements

Tris(2-ethylhexyl) trimellitate (TOTM) was recently suggested as a reference fluid for industrial use associated with high viscosity at elevated temperature and pressure. Viscosity and density data have already been published on one sample covering the temperature range (303-373) K and at pressures up to about 65 MPa. The viscosity covered a range from about (9 to 460) mPa s. In the present article we study several other characteristics of TOTM that must be available if it were to be adopted as a standard. First, we present values for the viscosity and density obtained with a different sample of TOTM to examine the important feature of consistency among different samples. Vibrating-wire viscosity measurements were performed at pressures from (5 to 100) MPa, along 6 isotherms between (303 and 373) K. Density measurements were carried out from (293 to 373) K up to 68 MPa, along 4 isotherms, using an Anton Paar DMA HP vibrating U-tube densimeter. Secondly, we report a study of the effect of water contamination on the viscosity of TOTM, performed using an Ubbelhode viscometer under atmospheric pressure. Finally, in order to support the use of TOTM as a reference liquid for the calibration of capillary viscometers, values of its surface tension, obtained by the pendant drop method, are provided. (C) 2016 Elsevier B.V. All rights reserved.