A new tip area function for instrumented nanoindentation at extremely small contact depths

The accuracy of measurement of mechanical properties of a material using instrumented nanoindentation at extremely small penetration depths heavily relies on the determination of the contact area of the indenter. Our experiments have demonstrated that the conventional area function could lead to a significant error when the contact depth was below 40. nm, due to the singularity in the first derivation of the function in this region and thus, the resultant unreasonable sharp peak on the function curve. In this paper, we proposed a new area function that was used to calculate the contact area for the indentations where the contact depths varied from 10 to 40. nm. The experimental results have shown that the new area function has produced better results than the conventional function. © 2011 Elsevier B.V.

Small-signal stability analysis of a DFIG-based wind power system under different modes of operation

This paper focuses on the super/subsynchronous operation of the doubly fed induction generator (DFIG) system. The impact of a damping controller on the different modes of operation for the DFIG-based wind generation system is investigated. The coordinated tuning of the damping controller to enhance the damping of the oscillatory modes using bacteria foraging technique is presented. The results from eigenvalue analysis are presented to elucidate the effectiveness of the tuned damping controller in the DFIG system. The robustness issue of the damping controller is also investigated.

Regulating the cost of small loans : overdue or overkill?

Small-amount short-term lending began in 1994 in response to the initial exemption of such loans from consumer credit regulation. Growing demand for such loans now produces industry turnover of approximately $800 million each year. Regulators recognised early the need for consumer protection due to the vulnerability of borrowers and the emergence of various predatory practices. This led to reforms designed to regulate these loans, prevent particular misconduct and provide remedies against injustice. Some were enacted as part of the National Consumer Credit Protection Act 2009 (Cth), which also imposed licensing and responsible lending requirements on lenders and increased consumer access to remedies. The Government has now introduced the Consumer Credit and Corporations Amendment (Enhancements) Bill 2011 which limits the price that can be charged for credit and restricts access to small loans. This article examines the extensive reforms which have taken place in this sector, and compares these regulatory approaches with the “bright line approach” of the Enhancements Bill. The article argues that the repercussions of this step will require careful monitoring to ensure that further harm is not suffered by those least able to bear it, and that the government will also need to facilitate other, more sustainable, solutions to the problem that small loans are currently used to solve. After we wrote this article, the Report of the Parliamentary Joint Committee on Corporations and Financial Services and the Report of the Senate Economics Legislation Committee on the Enhancements Bill were released. These are referred to in a postscript.

Turbulence measurements in a small subtropical estuary under king tide conditions

In natural waterways and estuaries, the understanding of turbulent mixing is critical to the knowledge of sediment transport, stormwater runoff during flood events, and release of nutrient-rich wastewater into ecosystems. In the present study, some field measurements were conducted in a small subtropical estuary with micro-tidal range and semi-diurnal tides during king tide conditions: i. e., the tidal range was the largest for both 2009 and 2010. The turbulent velocity measurements were performed continuously at high-frequency (50Hz) for 60 h. Two acoustic Doppler velocimeters (ADVs) were sampled simultaneously in the middle estuarine zone, and a third ADV was deployed in the upper estuary for 12 h only. The results provided an unique characterisation of the turbulence in both middle and upper estuarine zones under the king tide conditions. The present observations showed some marked differences between king tide and neap tide conditions. During the king tide conditions, the tidal forcing was the dominant water exchange and circulation mechanism in the estuary. In contrast, the long-term oscillations linked with internal and external resonance played a major role in the turbulent mixing during neap tides. The data set showed further that the upper estuarine zone was drastically less affected by the spring tide range: the flow motion remained slow, but the turbulent velocity data were affected by the propagation of a transient front during the very early flood tide motion at the sampling site. © 2012 Springer Science+Business Media B.V.

A small molecule that walks non-directionally along a track without external intervention

Charge of the light brigade: A molecule is able to walk back and forth upon a five-foothold pentaethylenimine track without external intervention. The 1D random walk is highly processive (mean step number 530) and exchange takes place between adjacent amine groups in a stepwise fashion. The walker performs a simple task whilst walking: quenching of the fluorescence of an anthracene group sited at one end of the track. Copyright © 2012 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.

Biodiversity–productivity relationships in small-scale mixed-species plantations using native species in Leyte province, Philippines

In this study, we investigate the relationship between tree species diversity and production in 18 mixed-species plantations established under the Rainforestation Farming system in Leyte province, the Philippines. The aim was to quantify productivity in the mixed-species plantations in comparison to the monocultures, and identify key drivers of productivity including environmental conditions, stand structural characteristics and surrogate measures of biodiversity, i.e. species richness, Shannon’s diversity index and functional groups. We found that monocultures had a much higher productivity than mixtures of the same and other species. In the mixtures, biodiversity and productivity did not have a simple relationship. Instead the proportion of exotic and native species, and the proportion of fast-growing species had a marginally significant positive effect on stand productivity, but no significant relationship was found with species richness or Shannon’s diversity. Instead stand structural characteristics such as density and age were the strongest drivers of increased productivity. Production levels within the mixed-species plantations varied significantly between sites. Overall, we found that the productivity of mixed species plantations was driven more by the characteristics of species present and stand structural characteristics then by simply the number and abundance of species, which suggests management practices are key for balancing multiple objectives to meet sustainable development needs.

Learning in and beyond small business advisory programmes

The purpose of this paper is to analyse how participants learn in small business advisory programmes and to explore the impact of these learning programmes on the development of reflective learning dispositions in participants. The research involves two case studies of small business advisory programmes in Queensland, a state of Australia. One involves training in the use of GPS/GIS technology amongst rural SMEs and the other seeks to develop improved management and operational capabilities in regional and metropolitan manufacturing SMEs. Face to face semi-structured interviews were conducted throughout rural, regional and metropolitan Queensland with participants, trainers and senior executives in the administering organisations that ran the programmes. Learning in these programmes occurs through a combination of interaction with others and the adoption of practice-based and learner-centred processes. The impact of the programmes on participants includes the development of reflective learning dispositions, improved confidence in learning and appreciation of the value of new knowledge to their business. The research suggests that small business training programmes have the potential to affect the development of critical reflective learning dispositions in participants which is of fundamental importance to the development of a learning or knowledge economy.

Towards the development of a gas sensor system for monitoring pollutant gases in the low troposphere using small unmanned aerial vehicles

The world is facing problems due to the effects of increased atmospheric pollution, climate change and global warming. Innovative technologies to identify, quantify and assess fluxes exchange of the pollutant gases between the Earth’s surface and atmosphere are required. This paper proposes the development of a gas sensor system for a small UAV to monitor pollutant gases, collect data and geo-locate where the sample was taken. The prototype has two principal systems: a light portable gas sensor and an optional electric–solar powered UAV. The prototype will be suitable to: operate in the lower troposphere (100-500m); collect samples; stamp time and geo-locate each sample. One of the limitations of a small UAV is the limited power available therefore a small and low power consumption payload is designed and built for this research. The specific gases targeted in this research are NO2, mostly produce by traffic, and NH3 from farming, with concentrations above 0.05 ppm and 35 ppm respectively which are harmful to human health. The developed prototype will be a useful tool for scientists to analyse the behaviour and tendencies of pollutant gases producing more realistic models of them.

PARP inhibition induces BAX/BAK-independent synthetic lethality of BRCA1-deficient non-small cell lung cancer

Evasion of apoptosis contributes to both tumourigenesis and drug resistance in non-small cell lung carcinoma (NSCLC). The pro-apoptotic BCL-2 family proteins BAX and BAK are critical regulators of mitochondrial apoptosis. New strategies for targeting NSCLC in a mitochondria-independent manner should bypass this common mechanism of apoptosis block. BRCA1 mutation frequency in lung cancer is low; however, decreased BRCA1 mRNA and protein expression levels have been reported in a significant proportion of lung adenocarcinomas. BRCA1 mutation/deficiency confers a defect in homologous recombination DNA repair that has been exploited by synthetic lethality through inhibition of PARP (PARPi) in breast and ovarian cells; however, it is not known whether this same synthetic lethal mechanism exists in NSCLC cells. Additionally, it is unknown whether the mitochondrial apoptotic pathway is required for BRCA1/PARPi-mediated synthetic lethality. Here we demonstrate that silencing of BRCA1 expression by RNA interference sensitizes NSCLC cells to PARP inhibition. Importantly, this sensitivity was not attenuated in cells harbouring mitochondrial apoptosis block induced by co-depletion of BAX and BAK. Furthermore, we demonstrate that BRCA1 inhibition cannot override platinum resistance, which is often mediated by loss of mitochondrial apoptosis signalling, but can still sensitize to PARP inhibition. Finally we demonstrate the existence of a BRCA1-deficient subgroup (11–19%) of NSCLC patients by analysing BRCA1 protein levels using immunohistochemistry in two independent primary NSCLC cohorts. Taken together, the existence of BRCA1-immunodeficient NSCLC suggests that this molecular subgroup could be effectively targeted by PARP inhibitors in the clinic and that PARP inhibitors could be used for the treatment of BRCA1-immunodeficient, platinum-resistant tumours.

Small and medium enterprises sourcing software as a service – a dynamic perspective on IS capabilities

Software as a Service (SaaS) is a promising approach for Small and Medium Enterprises (SMEs) firms, in particular those that are focused on growing fast and leveraging new technology, due to the potential benefits arising from its inherent scalability, reduced total cost of ownership and the ease of access to global innovations. This paper proposes a dynamic perspective on IS capabilities to understand and explain SMEs sourcing and levering SaaS. The model is derived from combining the IS capabilities of Feeny and Willcocks (1998) and the dynamic capabilities of Teece (2007) and contextualizing it for SMEs and SaaS. We conclude that SMEs sourcing and leveraging SaaS require leadership, business systems thinking and informed buying for sensing and seizing SaaS opportunities and require leadership and vendor development for transforming in terms of aligning and realigning specific tangible and intangible assets.

Small business entity tax concessions : through the eyes of the practitioner

The often competing imperatives of equity, simplicity and efficiency in the income tax regime, particularly the notion of simplicity, has been most evident within Australia’s small business sector over the last decade. In an attempt to provide tax simplification and reduce the tax compliance burden faced by Australian small businesses, provisions collectively referred to as the ‘simplified tax system’ or STS were introduced. The STS was designed to provide eligible small businesses with the option of adopting a range of ‘simplified’ tax measures designed to simplify their tax affairs whilst at the same time, reducing their tax compliance costs. Ultimately, a low take-up rate and accompanying criticisms led to a remodelled and rebadged concessionary regime known as the ‘Small Business Entity’ (SBE) regime which came into effect from 1 July 2007. This paper, through a pilot study, investigates the SBE regime though the eyes of the practitioner. In line the Australian Federal Government’s objective of simplification and reduced compliance costs, the purpose of the study was to (1) determine the extent to which the SBE concessions are being adopted by tax practitioners on behalf of their clients, (2) gain an understanding as to which individual SBE tax concessions are most favoured by practitioners, (3) determine the primary motivation as to why tax practitioners recommend particular SBE concessions to their clients, and (4) canvass the opinions of practitioners as to whether they believed that the introduction of the SBE concessions had met their stated objective of reducing tax compliance costs for small businesses. The findings of this research indicate that, while there is a perception that the SBE concessions are worth embracing, contrary to the policy intent, the reasons behind adopting the concessions was the opportunity to minimise a clients’ tax liability. It was revealed that adopting particular concessions had nothing to do with compliance costs savings and, in fact, the SBE concessions merely added another layer of complexity to an already cumbersome and complex tax code, which resulted in increased compliance costs for their small businesses clients. Further, the SBE concessions allowed tax practitioners the opportunity to engage in effective tax minimisation, thereby fulfilling the client advocacy role of the tax practitioner in maximising their clients’ tax preferences.

Explaining internationalisation of small to medium sized enterprises within the Queensland food and beverage industry

The prevalence of International New Ventures (INVs) has increased during the past twenty years. Nevertheless, to date there has been no general consensus within the literature on an explanation as to the rapid internationalisation of some firms. Do they follow a similar process to other firms that internationalise based on a more ‘measured’ incremental sequential process of internationalisation. This paper proposes and tests an innovation diffusion model of the internationalisation of small firm INVs and others by drawing on key innovation diffusion models from the literature. The results of this analysis indicate that the synthesised model of export adoption is effective in explaining the internationalisation process of INVs and other firms within the Queensland Food and Beverage Industry. Significantly, the features of the original innovation diffusion models developed in the consumer behaviour literature, which had limited examination within the internationalisation literature, were confirmed. This includes the ability of firms, or specifically decision-makers, to skip stages based on previous experience.

The effect of very small air gaps on small field dosimetry

The purpose of this study was to investigate the effect of very small air gaps (less than 1 mm) on the dosimetry of small photon fields used for stereotactic treatments. Measurements were performed with optically stimulated luminescent dosimeters (OSLDs) for 6 MV photons on a Varian 21iX linear accelerator with a Brainlab μMLC attachment for square field sizes down to 6 mm × 6 mm. Monte Carlo simulations were performed using EGSnrc C++ user code cavity. It was found that the Monte Carlo model used in this study accurately simulated the OSLD measurements on the linear accelerator. For the 6 mm field size, the 0.5 mm air gap upstream to the active area of the OSLD caused a 5.3 % dose reduction relative to a Monte Carlo simulation with no air gap. A hypothetical 0.2 mm air gap caused a dose reduction > 2 %, emphasizing the fact that even the tiniest air gaps can cause a large reduction in measured dose. The negligible effect on an 18 mm field size illustrated that the electronic disequilibrium caused by such small air gaps only affects the dosimetry of the very small fields. When performing small field dosimetry, care must be taken to avoid any air gaps, as can be often present when inserting detectors into solid phantoms. It is recommended that very small field dosimetry is performed in liquid water. When using small photon fields, sub-millimetre air gaps can also affect patient dosimetry if they cannot be spatially resolved on a CT scan. However the effect on the patient is debatable as the dose reduction caused by a 1 mm air gap, starting out at 19% in the first 0.1 mm behind the air gap, decreases to < 5 % after just 2 mm, and electronic equilibrium is fully re-established after just 5 mm.