969 resultados para Processing technique of resin transfer molding (RTM)


Relevância:

100.00% 100.00%

Publicador:

Resumo:

Direct numerical simulation (DNS) of supercritical CO2 turbulent channel flow has been performed to investigate the heat transfer mechanism of supercritical fluid. In the present DNS, full compressible Navier-Stokes equations and Peng-Robison state equation are solved. Due to effects of the mean density variation in the wall normal direction, mean velocity in the cooling region becomes high compared with that in the heating region. The mean width between high-and low-speed streaks near the wall decreases in the cooling region, which means that turbulence in the cooling region is enhanced and lots of fine scale eddies are created due to the local high Reynolds number effects. From the turbulent kinetic energy budget, it is found that compressibility effects related with pressure fluctuation and dilatation of velocity fluctuation can be ignored even for supercritical condition. However, the effect of density fluctuation on turbulent kinetic energy cannot be ignored. In the cooling region, low kinematic viscosity and high thermal conductivity in the low speed streaks modify fine scale structure and turbulent transport of temperature, which results in high Nusselt number in the cooling condition of the supercritical CO2.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

The growth process of 2-inch silicon carbide (SiC) single crystals by the physical vapor transport method (or modified Lely method) has been modeled and simulated. The comprehensive process model incorporates the calculations of radio frequency (RF) induction heating, heat and mass transfer and growth kinetics. The transport equations for electromagnetic field, heat transfer, and species transport are solved using a finite volume-based numerical scheme called MASTRAPP (Multizone Adaptive Scheme for Transport and Phase Change Process). Temperature distribution for a 2-inch growth system is calculated, and the effects of induction heating frequency and current on the temperature distribution and growth rate are investigated. The predicted results have been compared with the experimental data.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Processing simulation is at the bottom of the coral technology of VM and is also difficult due to the complexity of mechanism and diversity of parameters. Previously much research has been mainly carried out on the geometrical simulation or physical simulation respectively. The aim of this paper is to study the processing simulation in laser surface treatment based on the mechanism, put forward the architecture of the whole processing simulation and give the models of the processing. As a result the data structure layers in the whole simulation is presented.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Direct numerical simulation (DNS) of supercritical CO2 turbulent channel flow has been performed to investigate the heat transfer mechanism of supercritical fluid. In the present DNS, full compressible Navier-Stokes equations and Peng-Robison state equation are solved. Due to effects of the mean density variation in the wall normal direction, mean velocity in the cooling region becomes high compared with that in the heating region. The mean width between high-and low-speed streaks near the wall decreases in the cooling region, which means that turbulence in the cooling region is enhanced and lots of fine scale eddies are created due to the local high Reynolds number effects. From the turbulent kinetic energy budget, it is found that compressibility effects related with pressure fluctuation and dilatation of velocity fluctuation can be ignored even for supercritical condition. However, the effect of density fluctuation on turbulent kinetic energy cannot be ignored. In the cooling region, low kinematic viscosity and high thermal conductivity in the low speed streaks modify fine scale structure and turbulent transport of temperature, which results in high Nusselt number in the cooling condition of the supercritical CO2.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Santamaría, José Miguel; Pajares, Eterio; Olsen, Vickie; Merino, Raquel; Eguíluz, Federico (eds.)

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Fry supply is still the most serious problem yet to be solved in the culture of Clarias lazera in ponds. The object of the experiment is to compare the effect of fresh pituitary extract with that of the synthetic hormone with a view to determining the dosage. Ten trial runs were made using either the fresh pituitary extract of the human chorionic gonadotropin (HCG) at various concentrations. It was however, noted that the response of a particular set varies with the concentration. The actual result achieved from each set is highlighted under each experiment

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Apart from activities of some foreign-based vessels, commercial exploitation of pelagic fishery resources in Nigeria has been limited to inland and inshore waters. Estimated potential for the inshore pelagic fishery is 70,000-90,000 tonnes while the small pelagic resources in the near offshore as well as tuna and tuna-like fishes further offshore have potentials of about 10,000 metric tonnes each. Despite the abundance of tuna within and adjoining the Nigerian EEZ, and its importance in the international market, only foreign-flagged vessels take advantage. In addition, the inshore pelagic fisheries in Nigeria have for long remained underexploited. The most common processing method has remained the age-old traditional smoke-drying, which is inadequate resulting in colossal waste through denaturation and incessant infestations by insects and moulds among other causes. The use of modern smoking techniques coupled with effective distribution systems can undoubtedly reduce waste. However, these are often not within the reach of most artisanal processors. It is proposed that the organised private sector should invest on simple but proven processing equipment such as smoking kilns. The inshore pelagic fish species and other small fishes can sustain cottage canning industries sited in fishing villages/settlements while larger canning factories should be based on offshore resources. Modalities for successful investments are highlighted, while a major consideration is given to joint ventures

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Several schemes for coherent quantum control of atomic and molecular processes have been proposed and investigated by using the techniques of adiabatic passage and ultrashort pulses, respectively. Some interesting results have been found.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

This partial translation of the original paper provides the summary of this study of the mechanism of mass transfer in the formation of hydrothermal deposits of sulphides. For determining the solubility of sulphides of iron, the radioactive isotope Fe59 was used. The solubility of two sulphides was determined.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Part I

The mechanism of the hydroformylation reaction was studied. Using cobalt deuterotetracarbonyl and 1-pentene as substrates, the first step in the reaction, addition of cobalt tetracarbonyl to an olefin, was shown to be reversible.

Part II

The role of coenzyme B12 in the isomerization of methylmalonyl coenzyme A to succinyl coenzyme A by methylmalonyl coenzyme A mutase was studied. The reaction was allowed to proceed to partial completion using a mixture of methylmalonyl coenzyme A and 4, 4, 4-tri-2H-methylmalonyl coenzyme A as substrate. The deuterium distribution in the product, succinyl coenzyme A, was shown to best fit a model in which hydrogen is transferred from C-4 of methylmalonyl coenzyme A to C-5’ of the adenosyl moiety of coenzyme B12 in the rate determining step. The three hydrogens at the 5’-adenosyl position of the coenzyme B12 intermediate are then able to become enzymatically equivalent before hydrogen is transferred from the coenzyme B12 intermediate to form succinyl coenzyme A.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

A scheme using a lens array and the technique of spectral dispersion is presented to improve target illumination uniformity in laser produced plasmas. Detailed two-dimensional simulation shows that a quasi-near-field target pattern, of steeper edges and without side lobes, is achieved with a lens array, while interference stripes inside the pattern are smoothed out by the use of the spectral dispersion technique. Moving the target slightly from the exact focal plane of the principal focusing lens can eliminate middle-scale-length intensity fluctuation further. Numerical results indicate that a well-irradiated laser spot with small nonuniformity and great energy efficiency can be obtained in this scheme. (c) 2007 American Institute of Physics.