Characterization of the Pulp and Kernel Oils from Syagrus oleracea, Syagrus romanzoffiana, and Acrocomia aculeata

Vegetable oils are important sources of essential fatty acids. It is, therefore, important to characterize plant species that can be used as new oil sources. This study aimed to characterize the oils from guariroba (Syagrus oleracea), jeriva (Syagrus romanzoffiana), and macauba (Acrocomia aculeata). The physicochemical characterization was performed using official analytical methods for oils and fats, free fatty acids, peroxide value, refractive index, iodine value, saponification number, and unsaponifiable matter. The oxidative stability was determined using the Rancimat at 110 degrees C. The fatty acid composition was performed by gas chromatography. The results were submitted to Tukey's test for the medium to 5% using the ESTAT program. The pulp oils were more unsaturated than kernel oils, as evidenced by the higher refractive index and iodine value, especially the macauba pulp oil which gave 1.4556 and 80 g I(2)/100 g, respectively, for these indices. The kernel oils were less altered by oxidative process and had high induction period, free fatty acids below 0.5%, and peroxide value around 0.19 meq/kg. The guariroba kernel oil showed the largest induction period, 91.82 h.

INFLUENCE of ENCAPSULATING MATERIALS on WATER SORPTION ISOTHERMS of VACUUM-DRIED PERSIMMON PULP POWDER

Water sorption isotherms for vacuum-dried persimmon pulp (PP) powder were determined in the temperature range of 20-50C, and the effects of maltodextrin (MD) or gum arabic (GA) addition on the water sorption behavior of the dried powders were analyzed. Several models were evaluated to fit the experimental data and the Guggenheim-Anderson-de Boer model was selected as the most adequate to describe the observed behavior. Addition of encapsulants affected the isotherms: at the same water activity, PP powder with added GA (PP + GA) or MD (PP + MD) presented lower equilibrium water content than pure PP and were less affected by temperature variations. Samples of PP + MD presented lower equilibrium moisture content than those of PP + GA. The isosteric heats of sorption of pulp powders with encapsulants were higher (less negative) than those of PP, suggesting that there are more active polar sites in PP than in pulp powder containing encapsulants.PRACTICAL APPLICATIONSThe choice of persimmon to carry out this work was due to the large persimmon production available in Brazil; moreover, persimmon pulp is rich in vitamin C, vitamin A and iron, as well as in phenolic compounds. Drying of fruit pulps with high sugar content presents technical difficulties because the hygroscopicity and thermoplasticity of the resulting powders when exposed to high temperature and relative humidity. For this reason, addition of high-molar-mass biopolymers, such as maltodextrin or gum arabic, is a strategy to aid drying and to improve storage stability. Knowledge of water sorption isotherms and net isosteric heats of sorption is important to various food processing operations, including drying, storage and packaging. They are useful in calculating time and energy consumptions during drying, modeling moisture changes during storage and predicting shelf life of food products.

Thermophysical properties of mango pulp (Mangifera indica L. cv. Tommy Atkins)

The density, heat capacity and thermal conductivity of mango pulp (Mangifera indica L. cv. Tommy Atkins) were determined at moisture contents of between 0.9 and 0.52 kg kg(-1) (w.b.) and temperatures of between 20 and 80 degrees C. The experimental data were satisfactorily fitted (explained variation values >99.1%) as functions of the moisture content and temperature by using multivariate linear models. In the range of conditions considered, the moisture content exhibits a greater influence on the studied properties than temperature. (C) 2009 Elsevier Ltd. All rights reserved.

Role of enthalpy and entropy in moisture sorption behavior of pineapple pulp powder produced by different drying methods

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Characterization of a cellulase-free xylanase producing Bacillus sp for biobleaching of kraft pulp

Application of the xylanase in the pulp bleaching process has been shown to be effective in decreasing the amount of chlorinating agents in the process and improving the brightness of the pulp. The use of thermostable cellulase-free xylanase might enhance both the technical and economic feasibility of the process. In this work an alkalophylic strain of Bacillus sp 77-2, was isolated which showed a high production of xylanase and free cellulases. The xylanase of Bacillus sp displayed an optimum pH of 6.0 (with 70% activity at pH 9.0), all optimum temperature of 60 degrees C, pH stability in the range 5-10 and thermal stability of 50 degrees C. These characteristics are important to the kraft pulp bleaching because they are similar to those found in the industrial paper environment.

Application of crude xylanase from Bacillus licheniformis 77-2 to the bleaching of eucalyptus Kraft pulp

Alkalophilic Bacillus licheniformis 77-2 produced an extracellular alkali-tolerant xylanase with negligible cellulase activity in medium containing corn straw. The effectiveness of crude xylanase on treatment of eucalyptus Kraft pulp was evaluated. A biobleaching experiment was carried out to compare the chlorine saving with pulp treated and untreated by the enzyme. Two-stage bleaching was employed, using a ClO2 chlorination and NaOH extraction (DE sequence). With the enzymatic treatment, in order to obtain the same value of Kappa number and brightness, respectively 28.5 and 30% less ClO2 was required in comparison to the enzymatically untreated samples.

Cytotoxicity and genotoxicity of pulp capping materials in two cell lines

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Peroxide penetration from the pulp chamber to the external root surface after internal bleaching

Purpose: To quantify the amount of peroxide penetration from the pulp chamber to the external surface of teeth during the walking bleaching technique. Methods: Seventy-two bovine lateral incisors were randomly divided over five experimental groups and one control (n = 12 per group): (1) 35% hydrogen peroxide (HP); (2) 35% carbamide peroxide (CP); (3) sodium perborate (SP); (4) (HP+SP); (5) (CP+SP) and (6) Control (CG), deionized water. All groups were treated according to the walking bleach technique. After 7 days at 37 degrees C in an acetate buffer solution, 100 mu l violet leukocrystal coloring and 50 mu l peroxidase was added, producing a blue stain that could be measured in a spectrophotometer and then converted into peroxide mu g/ml. Results: G5 exhibited the greatest penetration, while G2 and G3 produced the lowest values. All bleaching agents penetrated from the pulp chamber to the external root surface. There was a direct correlation between the presence of oxidative agents and penetration potential. Sodium perborate in distilled water was less oxidative and appeared to be the least aggressive bleaching agent. (Am J Dent 2010;23:171-174).

The Effectiveness of Low-Intensity Red Laser for Activating a Bleaching Gel and Its Effect in Temperature of the Bleaching Gel and the Dental Pulp

Statement of the Problem: The effectiveness of low-intensity red laser for activating a bleaching gel and its effect in pulp temperature was not investigated in dental literature. Purpose: The objective of this study was to assess the effectiveness of low-intensity red laser for activating a bleaching gel, as well as its effect in temperature of the bleaching gel and the dental pulp. Materials and Methods: Forty extracted bovine teeth were immersed in a solution of coffee 14 days for darkening. The initial colors were recorded by spectrophotometric analysis. The specimens were randomly distributed into two groups (N = 20): the control, which did not receive light and the experimental group that received light from an appliance fitted with three red light-emitting laser diodes (? = 660 nm). A green-colored, 35% H2O2based bleaching gel was applied for 30 minutes, and changed three times. After bleaching, the colors were again measured to obtain the L*a*b* values. Color variation was calculated (?E) and the data submitted to the non-paired t-test (5%). To assess temperature, 10 human incisors were prepared, in which one thermocouple was placed on the bleaching gel applied on the surface of the teeth and another inside the pulp chamber. Results: There was a significant difference between the groups (p = 0.016), and the experimental group presented a significantly higher mean variation (7.21 +/- 2.76) in comparison with the control group (5.37 +/- 1.76). There was an increase in pulp temperature, but it was not sufficient to cause damage to the pulp. Conclusion: Bleaching gel activation with low-intensity red laser was capable of increasing the effectiveness of bleaching treatment and did not increase pulp temperature to levels deleterious to the pulp. CLINICAL SIGNIFICANCE The application of a low-intensity red laser was effective for activating a bleaching gel with green dye, without any deleterious increases in pulpal temperature. (J Esthet Restor Dent 24:126134, 2012)

Effect of drying method on the adsorption isotherms and isosteric heat of passion fruit pulp powder

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Study of adsorption isotherms of green coconut pulp

O Brasil é considerado um dos maiores produtores e consumidores de frutas tropicais. O coco verde (Cocos nucifera L.) se destaca tanto em termos de produção e consumo quanto em quantidade de resíduos gerada por indústrias de água de coco e pelo consumo in natura. Portanto, existe uma necessidade de aproveitamento deste subproduto. Este trabalho teve por objetivo estudar as isotermas de adsorção da polpa de coco verde e determinação do calor isostérico de sorção. As isotermas de adsorção para as temperaturas de 30, 40, 50, 60 e 70 °C foram analisadas e evidenciaram curvas do tipo III, típicas de alimentos ricos em açúcares. Os dados experimentais de umidade de equilíbrio foram correlacionados por modelos da literatura. O modelo de GAB apresentou melhor concordância com os dados experimentais, entre os modelos avaliados. O calor isostérico de sorção é considerado um indicativo de forças atrativas intermoleculares entre os sítios de sorção de vapor de água, consequentemente, um importante fator para predizer a vida de prateleira de produtos desidratados.

Temporary storage of jussara palm seeds: effects of time, temperature and pulp on germination and vigor

As sementes da palmeira juçara (Euterpe edulis Mart.) são recalcitrantes, apresentando baixa longevidade e sensibilidade à desidratação e ao armazenamento em temperaturas baixas. Neste trabalho foram estudadas condições de temperatura mais adequadas ao armazenamento temporário destas sementes com e sem a polpa. Frutos maduros foram colhidos em 24 plantas provenientes da coleção de palmeiras do Instituto Agronômico (IAC) localizada em Ubatuba, estado de São Paulo, e encaminhadas, em embalagem impermeável, à Faculdade de Ciências Agronômicas da UNESP, Campus de Botucatu (SP). Metade dos frutos foi despolpada e outra metade foi mantida com polpa, sendo ambas armazenadas em sacos fechados de polietileno (20 µm de espessura) mantidos em temperaturas de 5; 10; 15 e 20-30ºC. Amostras para os testes de qualidade foram retiradas aos 0; 3; 6; 9 e 12 dias após a colheita dos frutos. As sementes armazenadas com polpa foram despolpadas imediatamente antes da instalação dos testes. Foram avaliados o grau de umidade das sementes, porcentagem de germinação, comprimento e matéria seca das plântulas. Os resultados mostraram que há efeito positivo de pós-amadurecimento em sementes de Euterpe edulis. Um período de armazenamento de 9 a 12 dias, após a colheita e antes da semeadura, favoreceu a germinação e o vigor das sementes de juçara. Os efeitos foram maiores para sementes armazenadas sem polpa do que com polpa. Temperaturas na faixa de 5 a 20-30ºC são igualmente adequadas para o armazenamento temporário de sementes sem polpa. No entanto, para sementes com polpa, a temperatura de armazenamento não deve exceder a 20ºC, visto que um decréscimo na germinação e no vigor e um acréscimo no número de botões germinativos apodrecidos e sementes mortas foram observados na temperatura de 20-30ºC.

Histomorphological response of dogs' dental pulp capped with white mineral trioxide aggregate

Foi objetivo deste trabalho estudar a reação do tecido pulpar ao capeamento com agregado de trióxido mineral (MTA) branco. Para isto, foram utilizados 15 dentes de cães, onde após o preparo de cavidades na região cervical da face vestibular e exposição pulpar, estas foram capeadas com MTA branco. Os animais foram sacrificados após 60 dias do término dos procedimentos clínicos e os dentes processados em laboratório para obtenção de cortes histológicos. Foi observada formação de ponte de tecido duro em todas as polpas. em alguns casos, não havia dentina tubular mas somente uma estrutura de aspecto morfológico peculiar, selando a cavidade de exposição pulpar. Apenas dois casos apresentaram inflamação pulpar. Conclui-se que o MTA branco possui as características necessárias de um material para capeamento pulpar.

Water adsorption isotherms and isosteric sorption heat of spray-dried and freeze-dried dehydrated passion fruit pulp with additives and skimmed milk

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effect of maltodextrin on the freezing point and thermal conductivity of uvaia pulp (Eugenia piriformis Cambess)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)