Harmonics filtering and detection of disturbances using wavelets

Traditional mathematical tools, like Fourier Analysis, have proven to be efficient when analyzing steady-state distortions; however, the growing utilization of electronically controlled loads and the generation of a new dynamics in industrial environments signals have suggested the need of a powerful tool to perform the analysis of non-stationary distortions, overcoming limitations of frequency techniques. Wavelet Theory provides a new approach to harmonic analysis, focusing the decomposition of a signal into non-sinusoidal components, which are translated and scaled in time, generating a time-frequency basis. The correct choice of the waveshape to be used in decomposition is very important and discussed in this work. A brief theoretical introduction on Wavelet Transform is presented and some cases (practical and simulated) are discussed. Distortions commonly found in industrial environments, such as the current waveform of a Switched-Mode Power Supply and the input phase voltage waveform of motor fed by inverter are analyzed using Wavelet Theory. Applications such as extracting the fundamental frequency of a non-sinusoidal current signal, or using the ability of compact representation to detect non-repetitive disturbances are presented.

Scalable distributed virtual environments using multicast application level

Most of architectures proposed for developing Distributed Virtual Environment (DVE) allow limited number of users. To support the development of applications using the internet infrastructure, with hundred or, perhaps, thousands users logged simultaneously on DVE, several techniques for managing resources, such as bandwidth and capability of processing, must be implemented. The strategy presented in this paper combines methods to attain the scalability required, In special the multicast protocol at application level.

Identification and filtering of uncharacteristic noise in the CMS hadron calorimeter

Commissioning studies of the CMS hadron calorimeter have identified sporadic uncharacteristic noise and a small number of malfunctioning calorimeter channels. Algorithms have been developed to identify and address these problems in the data. The methods have been tested on cosmic ray muon data, calorimeter noise data, and single beam data collected with CMS in 2008. The noise rejection algorithms can be applied to LHC collision data at the trigger level or in the offline analysis. The application of the algorithms at the trigger level is shown to remove 90% of noise events with fake missing transverse energy above 100 GeV, which is sufficient for the CMS physics trigger operation. © 2010 IOP Publishing Ltd and SISSA.

Filtering for discrete-time Markov jump systems with network transmitted mode

This paper is concerned with ℋ 2 and ℋ ∞ filter design for discrete-time Markov jump systems. The usual assumption of mode-dependent design, where the current Markov mode is available to the filter at every instant of time is substituted by the case where that availability is subject to another Markov chain. In other words, the mode is transmitted to the filter through a network with given transmission failure probabilities. The problem is solved by modeling a system with N modes as another with 2N modes and cluster availability. We also treat the case where the transition probabilities are not exactly known and demonstrate our conditions for calculating an ℋ ∞ norm bound are less conservative than the available results in the current literature. Numerical examples show the applicability of the proposed results. ©2010 IEEE.

Digital filtering of oscillations intrinsic to transmission line modeling based on lumped parameters

A correction procedure based on digital signal processing theory is proposed to smooth the numeric oscillations in electromagnetic transient simulation results from transmission line modeling based on an equivalent representation by lumped parameters. The proposed improvement to this well-known line representation is carried out with an Finite Impulse Response (FIR) digital filter used to exclude the high-frequency components associated with the spurious numeric oscillations. To prove the efficacy of this correction method, a well-established frequency-dependent line representation using state equations is modeled with an FIR filter included in the model. The results obtained from the state-space model with and without the FIR filtering are compared with the results simulated by a line model based on distributed parameters and inverse transforms. Finally, the line model integrated with the FIR filtering is also tested and validated based on simulations that include nonlinear and time-variable elements. © 2012 Elsevier Ltd. All rights reserved.

Dimensionality effects in the local density of states of ferromagnetic hosts probed via STM: Spin-polarized quantum beats and spin filtering

We theoretically investigate the local density of states (LDOS) probed by an STM tip of ferromagnetic metals hosting a single adatom and a subsurface impurity. We model the system via the two-impurity Anderson Hamiltonian. By using the equation of motion with the relevant Green's functions, we derive analytical expressions for the LDOS of two host types: a surface and a quantum wire. The LDOS reveals Friedel-like oscillations and Fano interference as a function of the STM tip position. These oscillations strongly depend on the host dimension. Interestingly, we find that the spin-dependent Fermi wave numbers of the hosts give rise to spin-polarized quantum beats in the LDOS. Although the LDOS for the metallic surface shows a damped beating pattern, it exhibits the opposite behavior in the quantum wire. Due to this absence of damping, the wire operates as a spatially resolved spin filter with a high efficiency. © 2013 American Physical Society.

On the Acoustic Filtering of the Pipe and Sensor in a Buried Plastic Water Pipe and its Effect on Leak Detection: An Experimental Investigation

Acoustic techniques have been used for many years to find and locate leaks in buried water distribution systems. Hydrophones and accelerometers are typically used as sensors. Although geophones could be used as well, they are not generally used for leak detection. A simple acoustic model of the pipe and the sensors has been proposed previously by some of the authors of this paper, and their model was used to explain some of the features observed in measurements. However, simultaneous measurements of a leak using all three sensor-types in controlled conditions for plastic pipes has not been reported to-date and hence they have not yet been compared directly. This paper fills that gap in knowledge. A set of measurements was made on a bespoke buried plastic water distribution pipe test rig to validate the previously reported analytical model. There is qualitative agreement between the experimental results and the model predictions in terms of the differing filtering properties of the pipe-sensor systems. A quality measure for the data is also presented, which is the ratio of the bandwidth over which the analysis is carried out divided by the centre frequency of this bandwidth. Based on this metric, the accelerometer was found to be the best sensor to use for the test rig described in this paper. However, for a system in which the distance between the sensors is large or the attenuation factor of the system is high, then it would be advantageous to use hydrophones, even though they are invasive sensors.

Spin-dependent beating patterns in thermoelectric properties: Filtering the carriers of the heat flux in a Kondo adatom system

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

EDGE-PRESERVING SPECKLE TEXTURE REMOVAL BY INTERFERENCE-BASED SPECKLE FILTERING FOLLOWED BY ANISOTROPIC DIFFUSION

Ultrasonography has an inherent noise pattern, called speckle, which is known to hamper object recognition for both humans and computers. Speckle noise is produced by the mutual interference of a set of scattered wavefronts. Depending on the phase of the wavefronts, the interference may be constructive or destructive, which results in brighter or darker pixels, respectively. We propose a filter that minimizes noise fluctuation while simultaneously preserving local gray level information. It is based on steps to attenuate the destructive and constructive interference present in ultrasound images. This filter, called interference-based speckle filter followed by anisotropic diffusion (ISFAD), was developed to remove speckle texture from B-mode ultrasound images, while preserving the edges and the gray level of the region. The ISFAD performance was compared with 10 other filters. The evaluation was based on their application to images simulated by Field II (developed by Jensen et al.) and the proposed filter presented the greatest structural similarity, 0.95. Functional improvement of the segmentation task was also measured, comparing rates of true positive, false positive and accuracy. Using three different segmentation techniques, ISFAD also presented the best accuracy rate (greater than 90% for structures with well-defined borders). (E-mail: fernando.okara@gmail.com) (C) 2012 World Federation for Ultrasound in Medicine & Biology.

Progettazione e realizzazione di un applicativo per la distribuzione di dati finanziari tramite multicast

Analisi, progettazione e realizzazione di un applicativo per la distribuzione di dati finanziari in realtime attraverso l'utilizzo della tecnologia multicast in contesto produttivo reale con studio grafico dei miglioramenti qualitativi ottenuti.

Progettazione e implementazione di un sistema dinamico per la gestione del packet filtering

Un livello di sicurezza che prevede l’autenticazione e autorizzazione di un utente e che permette di tenere traccia di tutte le operazioni effettuate, non esclude una rete dall’essere soggetta a incidenti informatici, che possono derivare da tentativi di accesso agli host tramite innalzamento illecito di privilegi o dai classici programmi malevoli come virus, trojan e worm. Un rimedio per identificare eventuali minacce prevede l’utilizzo di un dispositivo IDS (Intrusion Detection System) con il compito di analizzare il traffico e confrontarlo con una serie d’impronte che fanno riferimento a scenari d’intrusioni conosciute. Anche con elevate capacità di elaborazione dell’hardware, le risorse potrebbero non essere sufficienti a garantire un corretto funzionamento del servizio sull’intero traffico che attraversa una rete. L'obiettivo di questa tesi consiste nella creazione di un’applicazione con lo scopo di eseguire un’analisi preventiva, in modo da alleggerire la mole di dati da sottoporre all’IDS nella fase di scansione vera e propria del traffico. Per fare questo vengono sfruttate le statistiche calcolate su dei dati forniti direttamente dagli apparati di rete, cercando di identificare del traffico che utilizza dei protocolli noti e quindi giudicabile non pericoloso con una buona probabilità.

Studio ed integrazione di un sistema di collaborative filtering su piattaforma e-commerce business to consumer

I sistemi di raccomandazione sono una tipologia di sistemi di filtraggio delle informazioni che cercano di prevedere la valutazione o la preferenza che l'utente potrebbe dare ad un elemento. Sono diventati molto comuni in questi ultimi anni e sono utilizzati da una vasta gamma di applicazioni, le più popolari riguardano film, musica, notizie, libri, articoli di ricerca e tag di social networking. Tuttavia, ci sono anche sistemi di raccomandazione per i ristoranti, servizi finanziari, assicurazioni sulla vita e persone (siti di appuntamenti online, seguaci di Twitter). Questi sistemi, tuttora oggetto di studi, sono già applicati in un'ampia gamma di settori, come ad esempio le piattaforme di scoperta dei contenuti, utilizzate on-line per aiutare gli utenti nella ricerca di trasmissioni televisive; oppure i sistemi di supporto alle decisioni che utilizzano sistemi di raccomandazione avanzati, basati sull'apprendimento delle conoscenze, per aiutare i fruitori del servizio nella soluzioni di problemi complessi. Inoltre, i sistemi di raccomandazione sono una valida alternativa agli algoritmi di ricerca in quanto aiutano gli utenti a scoprire elementi che potrebbero non aver trovato da soli. Infatti, sono spesso implementati utilizzando motori di ricerca che indicizzano dati non tradizionali.

Tuning remoto di filtering, pre-processing e buffering per scenari internet of things

La tesi propone una soluzione middleware per scenari in cui i sensori producono un numero elevato di dati che è necessario gestire ed elaborare attraverso operazioni di preprocessing, filtering e buffering al fine di migliorare l'efficienza di comunicazione e del consumo di banda nel rispetto di vincoli energetici e computazionali. E'possibile effettuare l'ottimizzazione di questi componenti attraverso operazioni di tuning remoto.

Information Filtering for Ultrasound-based Real-time Registration

This paper presents methods based on Information Filters for solving matching problems with emphasis on real-time, or effectively real-time applications. Both applications discussed in this work deal with ultrasound-based rigid registration in computer-assisted orthopedic surgery. In the first application, the usual workflow of rigid registration is reformulated such that registration algorithms would iterate while the surgeon is acquiring ultrasound images of the anatomy to be operated. Using this effectively real-time approach to registration, the surgeon would then receive feedback in order to better gauge the quality of the final registration outcome. The second application considered in this paper circumvents the need to attach physical markers to bones for anatomical referencing. Experiments using anatomical objects immersed in water are performed in order to evaluate and compare the different methods presented herein, using both 2D as well as real-time 3D ultrasound.