Color centers and charge state change in Ce : YAG crystals grown by temperature gradient techniques

Color centers and impurity defects of Ce:YAG crystals grown in reduction atmosphere by temperature gradient techniques have been investigated by means of gamma irradiation and thermal treatments. Four absorption bands associated with color centers or impurity defects at 235, 255, 294 and 370 nm were observed in as-grown crystals. Changes in optical intensity of the 235 and 370 nm bands after gamma irradiation indicate that they are associated with F+-type color center. Charge state change processes of Fe3+ impurity and Ce3+ ions take place in the irradiation process. The variations of Ce3+ ions concentration clearly indicate that Ce4+ ions exist in Ce:YAG crystals and gamma irradiations could increase the concentration of Ce3+ ions. Annealing treatments and the changes in optical density suggest that a heterovalent impurity ion associated with the 294 nm band seems to be present in the crystals. (c) 2005 Elsevier B.V. All rights reserved.

Color centers in Yb : YAG crystals grown by temperature-gradient techniques

Yb: YAG (Yb: Y3Al5O12) crystals have been grown by temperature-gradient techniques (TGT) and their color centers and impurity defects were investigated by means of gamma irradiations and thermal treatment. Two color centers located at 255 and 290 nm were observed in the as-grown TGT-Yb: YAG. Analysis shows that the 255 nm band may be associated with Fe3+ ions. Absorption intensity changes of the 290 nm band after gamma irradiation and thermal treatment indicate that this band may be associated with oxygen-vacancy defects. (c) 2006 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.

温度梯度法生长Nd：YAG晶体的1200W激光输出

用温度梯度法（TGT）生长了大尺寸的Nd：YAG激光晶体，测试了室温下的吸收谱并利用吸收谱研究了Nd离子在YAG晶体中的分布。比较了温度梯度法与提拉法生长晶体的区别。根据热容激光的原理，利用生长的Nd：YAG激光晶体片设计了热容激光器，利用侧面抽运，获得了1200w的激光输出，工作时间为2s，光-光转换效率为30％。

国产Nd：YAG陶瓷获得激光输出

近年来Nd：YAG多晶陶瓷作为激光介质得到了越来越多的重视，我国在这个方向也开展了大量的研究工作，Nd：YAG多晶陶瓷与Nd：YAG单晶相比有很多优点：容易制造、成本低、可以制造大尺寸和高掺杂浓度的材料，且无浓度梯度，机械特性良好，硬度比单晶大1．5倍，断裂韧度比单晶大5倍，并且可制备多层和多功能的陶瓷结构、可大批量生产，已经获得了比Nd：YAG单晶更高的效率，因此钇铝石榴石透明陶瓷是理想的钇铝石榴石单晶激光介质材料替代品。但国产陶瓷由于质量不佳，透明度不是很高，一直未能获得激光输出。

Cr,Yb:YAG晶体的自调Q激光性能

用光纤耦合激光二极管抽运Cr,Yb:YAG晶体获得了1.03 μm的自调Q激光输出,输出的调Q脉冲非常稳定,抽运阈值功率为680 mW,脉冲宽度为3.3 ns,获得的平均功率为156 mW,斜率效率为18.5%。随着抽运功率的增大,重复频率成线性增长,而脉宽略有减少,单脉冲能量和峰值功率都始终呈增大趋势。光束质量因子M2为1.17。

提拉法Tm：YAG晶体的生长缺陷研究

采用提拉法(CZ)生长了质量优异的Tm：YAG晶体．部分晶片在1000℃的空气气氛中退火25h．借助光学显微镜、扫描电子显微镜(SEM)，结合化学腐蚀法，对Tm：YAG晶体退火前后(111)面的缺陷特征进行了研究．Tm：YAG晶体(111)面的位错腐蚀坑呈三角形．在偏光显微镜下观察了退火前后Tm：YAG晶体(111)面的应力双折射．同时应用高分辨X射线衍射法测定了晶体的完整性．实验结果表明，长时间空气气氛下高温退火有效降低了晶体中总的位错密度，提高了晶体质量．

Yb：YAG晶体的闪烁特性

通过不同Yb^3＋掺杂浓度（5％-30％，原子数分数）的Yb：YAG晶体的阴极射线发光谱、衰减时间、光输出及其温度依赖关系的测量，研究了Yb：YAG晶体的闪烁性能。不同Yh^3＋掺杂浓度的Yb：YAG晶体具有不同的光输出和猝灭温度，光输出随Yb^3＋掺杂浓度的增大而降低，猝灭温度则随掺杂浓度的增大而升高。室温下Yb：YAG晶体的发光衰减时间较短，均小于50ns。Yb^3＋掺杂浓度为5％的Yb：YAG晶体具有较高的光输出和较低的猝灭温度。

Nd：YAG透明陶瓷的烧成及其显微结构

由溶胶一凝胶／燃烧合成结合法合成了Nd：YAG(掺钕钇铝石榴石，neodymium—doped yttrium aluminium garnet)粉体，用真空烧结法制备了Nd：YAG透明陶瓷。研究了显微结构随烧结温度和保温时间的变化，并对透明陶瓷的晶界结构和成分分布进行了表征。随着烧结温度的提高和保温时间的延长，Nd：YAG陶瓷的密度增大，晶形发育完整，透过率提高。晶粒内部和晶界的化学组成基本相同。所制备的Nd：YAG透明陶瓷在激光工作波长1064nm的透过率达到75％。

Yb：YAG及Cr，Yb：YAG晶体的发光特性

研究了室温下Yb：YAG的上转换荧光光谱，此荧光归因于Yb^3＋离子的“合作”发光和Yb抖离子到稀土杂质离子的能量转移。测试了Yb；YAG晶体的X射线荧光，发光峰对应于电荷迁移态到Yb^3＋离子的基态、激光态间的跃迁。研究了Cr，Yb：YAG晶体的荧光光谱。讨论了Cr^4＋激光输出的可能性。

Tm：YAG晶体的研究进展

Tm：YAG晶体是性能优异的LD泵浦激光晶体。本文总结了Tm：YAG晶体的生长、光谱性质以及激光性能的研究和发展，并指出了Tm：YAG晶体发展中需要解决的问题。

Optimization of thermal environment during crystal growth of large-sized Nd : YAG by Temperature Gradient Technique

A finite-element model is employed to analysis the thermal environments in Temperature Gradient Technique (TGT) furnace during the growth of large-sized Nd:YAG crystal. The obtained results show that when the crucible is located at the lower position inside of the heater, a flatter solid-liquid interface is established, which makes it easier to obtain the core-free Nd:YAG crystal. Meanwhile, the lower crucible position can induce higher axial temperature gradient, which is beneficial to the release of latent heat. (c) 2007 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.

Spectral properties of Ho : GdVO4 single crystal

Absorption and emission spectral properties of GdVO4 single crystal doped with Ho3+ ions were investigated at room temperature. Polarized absorption cross section is calculated in the range of 400-2200nm. Results were analyzed and parameters were calculated based on Judd-Ofelt theory, the emission spectrum shows that the emission intensity around the wavelength of 546 nm associated with transition S-5(2) -> I-5(8) is much stronger than other bands in the observed range and potentially enable the green light output around this emission band in this crystal. (c) 2006 Elsevier B.V. All rights reserved.

Diode-pumped passively q-switched Nd : YAG ceramic laser with a Cr4+: YAG crystal-satiable absorber

Transparent polycrystalline Nd:YAG ceramics were fabricated by solid-state reactive sintering a mixture of commercial Al2O3,Y2O3, and Nd2O3 powders. The powders were mixed in ethanol and doped with 0.5 wt% tetraethoxysilane, dried, and pressed. Pressed samples were sintered at 1750 degrees C in vacuum. Transparent fully dense samples with average grain sizes of 10 mu m were obtained. The 1 at.% Nd:YAG ceramic was used to research passively Q-switched laser output with a Cr4+:YAG crystal as a saturable absorber. An average output power of 94 mW with a pulse width of 50 ns was obtained when the incident pump power was 750 mW. The slope efficiency was 13%. The pulse energy is 5 mu J, and the peak power is about 100 W.

Diode-pumped Yb : YAG ceramic laser

Transparent polycrystalline Yb:YAG ceramics were fabricated by solid-state reactive sintering a mixture of commercial Al2O3, Y2O3, and Yb2O3 powders. The powders were mixed in ethanol and doped with 0.5 wt% tetraethoxysilane, dried, and pressed. Pressed samples were sintered at 1730 degrees C in vacuum. Transparent fully dense samples with grain sizes of several micrometers were obtained. The phase from 1500 degrees to 1700 degrees C was important for the grain growth, in which the grains grew quickly and a mass of pores were eliminated from the body of the sample. Annealing was an important step to remove the vacancies of oxygen and transform Yb2+ to Yb3+. The 1 at.% Yb:YAG ceramic sample was pumped by a diode laser to study the laser properties. The maximum output power of 1.02 W was obtained with a slope efficiency of 25% at 1030 nm. The size of the lasering sample was 4 mm x 4 mm x 3 mm.

Infrared to visible upconversion fluorescence in Yb,Tm : YAG single crystal

Absorption spectrum from 400 to 2000 run and upconversion fluorescence spectra under 940 nm pumping of YAG single crystal codoped with 5 at.% Yb3+ and 4 at.% Tm3+ were studied at room temperature. The blue upconversion emission centered at 483 nm corresponds to the transition (1)G(4) -> H-3(6), the emission band around 646 nm corresponds to the transition (1)G(4) -> F-3(4) of Tm3+. Energy transfer from Yb3+ to Tm3+ is mainly nonradiative and the transfer efficiency was experimentally assessed. The line strengths, transition probabilities and radiative lifetimes of (1)G(4) level were calculated by using Judd-Ofelt theory. Gain coefficient calculated from spectra shows that the upconversion corresponding with transitions (1)G(4) -> H-3(6) in YAG doped with Yb3+ and Tm3+ is potentially useful for blue light Output. (c) 2006 Elsevier B.V. All rights reserved.