Modelling fungal growth on surfaces

Fungal growth in time and space at the substrate surface was modelled for a simple system mimicking solid-state fermentation, using a polycarbonate Nucleopore membrane laid over a glucose solution. Biomass production depends on both tip density and the diffusion of glucose within the fungal hyphae. The model predicts early increases in both height and concentration, followed by a period in which the biomass profile moves with a constant wavefront. The rate of increase in height increases as tip diffusivity increases or as the Monod saturation constant for glucose decreases.

Selection of a strain of Aspergillus for the production of citric acid from pineapple waste in solid-state fermentation

Aspergillus foetidus ACR I 3996 (=FRR 3558) and three strains of Aspergillus niger ACM 4992 (=ATCC 9142), ACM 4993 (=ATCC 10577), ACM 4994 (=ATCC 12846) were compared for the production of citric acid from pineapple peel in solid-state fermentation. A. niger ACM 4992 produced the highest amount of citric acid, with a yield of 19.4 g of citric acid per 100 g of dry fermented pineapple waste under optimum conditions, representing a yield of 0.74 g citric acid/g sugar consumed. Optimal conditions were 65% (w/w) initial moisture content, 3% (v/w) methanol, 30 degrees C, an unadjusted initial pH of 3.4, a particle size of 2 mm and 5 ppm Fe2+. Citric acid production was best in flasks, with lower yields being obtained in tray and rotating drum bioreactors.

A second Candida albicans resistance gene (Carg2) regulates tissue damage, but not fungal clearance, in sub-lethal murine systemic infection

The severity of systemic infection with the yeast Candida albicans has been shown to be under complex genetic control. C57/L mice carry an allele that is associated with an increase in tissue destruction when compared with C57BI/6 mice; however, the gene affects only the severity of tissue lesions, and does not influence the magnitude of the fungal burden in either kidney or brain. Studies in [C57/L x C57BI/6]F1 hybrid mice, and [C57/L x C57BI/6]F1 x C57/L backcross mice, demonstrated that the gene behaves as a simple Mendelian co-dominant. (C) 1998 Academic Press.

The crack tip strain field of AISI 4340 - Part I - Measurement technique

This is the first paper in a study on the influence of the environment on the crack tip strain field for AISI 4340. A stressing stage for the environmental scanning electron microscope (ESEM) was constructed which was capable of applying loads up to 60 kN to fracture-mechanics samples. The measurement of the crack tip strain field required preparation (by electron lithography or chemical etching) of a system of reference points spaced at similar to 5 mu m intervals on the sample surface, loading the sample inside an electron microscope, image processing procedures to measure the displacement at each reference point and calculation of the strain field. Two algorithms to calculate strain were evaluated. Possible sources of errors were calculation errors due to the algorithm, errors inherent in the image processing procedure and errors due to the limited precision of the displacement measurements. Estimation of the contribution of each source of error was performed. The technique allows measurement of the crack tip strain field over an area of 50 x 40 mu m with a strain precision better than +/- 0.02 at distances larger than 5 mu m from the crack tip. (C) 1999 Kluwer Academic Publishers.

The crack tip strain field of AISI 4340 - Part II - Experimental measurements

Crack tip strain maps have been measured for AISI 4340 high strength steel. No significant creep was observed. The measured values of CTOD were greater than expected from the HRR model. Crack tip branching was observed in every experiment. The direction of crack branching was in the same direction as a major ridge'' of epsilon(yy) strain, which in turn was in the same direction as predicted by the HRR model. Furthermore, the measured magnitudes of the epsilon(y)y strain in this same direction were in general greater than the values predicted by the HRR model. This indicates more plasticity in the crack tip region than expected from the HRR model. This greater plasticity could be related to the larger than expected CTOD values. The following discrepancies between the measured strain fields for AISI 4340 and the HRR predictions are noteworthy: (1) The crack branching. (2) Values of CTOD significantly higher than predicted by HRR. (3) The major ridge'' of epsilon(yy) strain an angle of about 60 degrees with the direction of overall propagation of the fatigue precrack, in which the measured magnitudes of the epsilon(yy) strain were greater than the values predicted by the HRR model. (4) Asymmetric shape of the plastic zone as measured by the epsilon(yy) strain. (5) Values of shear strain gamma(xy) significantly higher than predicted by the HRR model. (C) 1999 Kluwer Academic Publishers.

The crack tip strain field of AISI 4340 - Part III - Hydrogen influence

This paper studied the influence of hydrogen and water vapour environments on the plastic behaviour in the vicinity of the crack tip for AISI 4340. Hydrogen and water vapour (at a pressure of 15 Torr) significantly increased the crack tip opening displacement. The crack tip strain distribution in 15 Torr hydrogen was significantly different to that measured in vacuum. In the presence of sufficient hydrogen, the plastic zone was larger, was elongated in the direction of crack propagation and moreover there was significant creep. These observations support the hydrogen enhanced localised plasticity model for hydrogen embrittlement in this steel. The strain distribution in the presence of water vapour also suggests that SCC in AISI 4340 occurs via the hydrogen enhanced localised plasticity mechanism. (C) 1999 Kluwer Academic Publishers.

Acute susceptibility of aged mice to infection with Candida albicans

The effect of aging on host resistance to systemic candidosis was assessed by monitoring the course of infection in 16-month-old CBA/CaH mice (aged non-immune) and in a comparable group that had been infected with a sublethal dose of Candida albicans at 6 weeks of age (aged immune). Aged non-immune mice showed rapid progression of the disease, with a marked increase in the number of mycelia in the brain and kidney, and early morbidity, Foci of myocardial necrosis were evident, but inflammatory cells were sparse. The histological picture in the aged immune mice was similar to that in the aged non-immune group, although fewer mycelial aggregates were seen. Both groups of aged mice showed a significantly lower fungal burden in the brain on day 1 of infection, but on day 4, colony counts increased significantly in the aged non-immune mice, Comparison of cytokine gene expression in the infected brains showed that the relative amount of interferon-gamma and tumour necrosis factor-alpha cDNA were similar in all three groups. Interleukin-6 was elevated in both infected non-immune and uninfected aged mice. Aged immune mice showed no morbidity after challenge, and both colonisation and tissue damage were reduced in comparison with the aged non-immune animals.

Strain-dependent fluid flow defined through rock mass classification schemes

Strain-dependent hydraulic conductivities are uniquely defined by an environmental factor, representing applied normal and shear strains, combined with intrinsic material parameters representing mass and component deformation moduli, initial conductivities, and mass structure. The components representing mass moduli and structure are defined in terms of RQD (rock quality designation) and RMR (rock mass rating) to represent the response of a whole spectrum of rock masses, varying from highly fractured (crushed) rock to intact rock. These two empirical parameters determine the hydraulic response of a fractured medium to the induced-deformations The constitutive relations are verified against available published data and applied to study one-dimensional, strain-dependent fluid flow. Analytical results indicate that both normal and shear strains exert a significant influence on the processes of fluid flow and that the magnitude of this influence is regulated by the values of RQD and RMR.

The moderating role of social support in Karasek's job strain model

This paper examines whether social support is a boundary-determining criterion in the job strain model of Karasek (1979). The particular focus is the extent to which different sources of social support, work overload and task control influence job satisfaction, depersonalization and supervisor assessments of work performance. Hypotheses are tested using prospective survey data from 80 clerical staff in a university setting. Results revealed 3-way interactions among levels of support (supervisor, co-worker, non-work), perceived task control and work overload on levels of work performance and employee adjustment (self-report). After controlling for levels of negative affect in all analyses, there was evidence that high levels of supervisor support mitigated against the negative effects of high strain jobs on levels of job satisfaction and reduced reported levels of depersonalization. Moreover, high levels of non-work support and co-worker support also mitigated against the negative effects of high strain jobs on levels of work performance. The results are discussed in terms of the importance of social support networks both at, and beyond, the work context.

Aspergillicins A-E: five novel depsipeptides from the marine-derived fungus Aspergillus carneus

A search for new antiparasitic agents from a strain of the fungus Aspergillus carneus isolated from an estuarine sediment collected in Tasmania, Australia, yielded the known terrestrial fungal metabolite marcfortine A ( 1) as an exceptionally potent antiparasitic agent. This study also yielded a series of new depsipeptides, aspergillicins A - E ( 2 - 6) and the known terrestrial fungal metabolite acyl aszonalenin ( 7). Marcfortine A ( 1) and acyl aszonalenin ( 7) were identified by spectroscopic analysis, with comparison to literature data. Complete stereostructures were assigned to aspergillicins A - E ( 2 - 6) on the basis of detailed spectroscopic analysis, together with ESIMS analysis of the free amino acids generated by acid hydrolysis, and HPLC analysis of Marfey derivatives prepared from the acid hydrolysate. The peptide amino acid sequence for all aspergillicins was unambiguously assigned by MSn ion-trap ESI mass spectrometry.

Apparent strain localization and shear wave dispersion in elastic fault gouge with microrotations

Shear deformation of fault gouge or other particulate materials often results in observed strain localization, or more precisely, the localization of measured deformation gradients. In conventional elastic materials the strain localization cannot take place therefore this phenomenon is attributed to special types of non-elastic constitutive behaviour. For particulate materials however the Cosserat continuum which takes care of microrotations independent of displacements is a more appropriate model. In elastic Cosserat continuum the localization in displacement gradients is possible under some combinations of the generalized Cosserat elastic moduli. The same combinations of parameters also correspond to a considerable dispersion in shear wave propagation which can be used for independent experimental verification of the proposed mechanism of apparent strain localization in fault gouge.

Potential triggers for akinete differentiation in an Australian strain of the cyanobacterium Cylindrospermopsis raciborskii (AWT 205/1)

Understanding the triggers for some cyanobacteria of the Nostocales and Stigonematales orders to produce specialised reproductive cells termed akinetes, is very important to gain further insights into their ecology. By improving our understanding of their life cycle, appropriate management options may be devised to control the formation of these cells, and therefore the potential bloom inoculum which they are thought to provide, may be reduced. This study investigated the effect of chemical (phosphorus limitation), and environmental variables (temperature shock) on akinete differentiation in the freshwater cyanobacterium Cylindrospermopsis raciborskii (AWT 205/1). From the preliminary results, it is suggested that the availability of phosphorus and changes in temperature were a necessary requirement for the formation of akinetes in this particular strain of C. raciborskii. In the four phosphorus treatments investigated (0, 3, 38 and 75 mug l(-1) P), only the two higher treatments produced akinetes (approximately 220 ml(-1)). When the first akinetes were observed in the 38 and 75 mug l(-1) P treatments, filterable reactive phosphorus (FRP) concentrations in the medium were approximately 22 and 52 mug l(-1) P, respectively, indicating that there was no phosphorus limitation. In the temperature shock experiment, akinetes were observed in the 15 and 20degreesC treatments. However, akinetes were degraded (pale yellow colour, limited swelling and shrivelled edges) and in much lower concentrations, which was thought to be a result of the daily temperature shock. We suggest that the formation of akinetes in C. raciborskii (AWT 205/1) can be triggered by an initial temperature shock and that phosphorus is a necessary requirement to allow further growth and full development of akinetes.