986 resultados para Forage machinery


Relevância:

20.00% 20.00%

Publicador:

Resumo:

The objective of this study was to use 15N to label microbial cells to allow development of equations for estimating the microbial contamination in ruminal in situ incubation residues of forage produced under tropical conditions. A total of 24 tropical forages were ruminal incubated in 3 steers at 3 separate times. To determine microbial contamination of the incubated residues, ruminal bacteria were labeled with 15N by continuous intraruminal infusion 60 h before the first incubation and continued until the last day of incubation. Ruminal digesta was collected for the isolation of bacteria before the first infusion of 15N on adaptation period and after the infusion of 15N on collection period. To determine the microbial contamination of CP fractions, restricted models were compared with the full model using the model identity test. A value of the corrected fraction A was estimated from the corresponding noncorrected fraction by this equation: Corrected A fraction (ACPC) = 1.99286 + 0.98256 × A fraction without correction (ACPWC). The corrected fraction B was estimated from the corresponding noncorrected fraction and from CP, NDF, neutral detergent insoluble protein (NDIP), and indigestible NDF (iNDF) using the equation corrected B fraction (BCPC) = -17.2181 - 0.0344 × fraction B without correction (BCPWC) + 0.65433 × CP + 1.03787 × NDF + 2.66010 × NDIP - 0.85979 × iNDF. The corrected degradation rate of B fraction (kd)was estimated using the equation corrected degradation rate of B fraction (kdCPC) = 0.04667 + 0.35139 × degradation rate of B fraction without correction (kdCPWC) + 0.0020 × CP - 0.00055839 × NDF - 0.00336 × NDIP + 0.00075089 × iNDF. This equation was obtained to estimate the contamination using CP of the feeds: %C = 79.21 × (1 - e-0.0555t) × e-0.0874CP. It was concluded that A and B fractions and kd of CP could be highly biased by microbial CP contamination, and therefore these corrected values could be obtained mathematically, replacing the use of microbial markers. The percentage of contamination and the corrected apparent degradability of CP could be obtained from values of CP and time of incubation for each feed, which could reduce cost and labor involved when using 15N. © 2013 American Society of Animal Science. All rights reserved.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Sorghum is an excellent alternative to other grains in poor soil where corn does not develop very well, as well as in regions with warm and dry winters. Intercropping sorghum [Sorghum bicolor (L.) Moench] with forage crops, such as palisade grass [Brachiaria brizantha (Hochst. ex A. Rich) Stapf] or guinea grass (Panicum maximum Jacq.), provides large amounts of biomass for use as straw in no-tillage systems or as pasture. However, it is important to determine the appropriate time at which these forage crops have to be sown into sorghum systems to avoid reductions in both sorghum and forage production and to maximize the revenue of the cropping system. This study, conducted for three growing seasons at Botucatu in the State of São Paulo in Brazil, evaluated how nutrient concentration, yield components, sorghum grain yield, revenue, and forage crop dry matter production were affected by the timing of forage intercropping. The experimental design was a randomized complete block design. Intercropping systems were not found to cause reductions in the nutrient concentration in sorghum plants. The number of panicles per unit area of sorghum alone (133,600), intercropped sorghum and palisade grass (133,300) and intercropped sorghum and guinea grass (134,300) corresponded to sorghum grain yields of 5439, 5436 and 5566kgha-1, respectively. However, the number of panicles per unit area of intercropped sorghum and palisade grass (144,700) and intercropped sorghum and guinea grass (145,000) with topdressing of fertilizers for the sorghum resulted in the highest sorghum grain yields (6238 and 6127kgha-1 for intercropping with palisade grass and guinea grass, respectively). Forage production (8112, 10,972 and 13,193Mg ha-1 for the first, second and third cuts, respectively) was highest when sorghum and guinea grass were intercropped. The timing of intercropping is an important factor in sorghum grain yield and forage production. Palisade grass or guinea grass must be intercropped with sorghum with topdressing fertilization to achieve the highest sorghum grain yield, but this significantly reduces the forage production. Intercropping sorghum with guinea grass sown simultaneously yielded the highest revenue per ha (€ 1074.4), which was 2.4 times greater than the revenue achieved by sowing sorghum only. © 2013 Elsevier B.V.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Pós-graduação em Agronomia (Ciência do Solo) - FCAV

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Two experiments evaluated the influence of supplement composition on ruminal forage disappearance, performance, and physiological responses of Angus x Hereford cattle consuming a low-quality cool-season forage (8.7% CP and 57% TDN). In Exp. 1, 6 rumen-fistulated steers housed in individual pens were assigned to an incomplete 3 x 2 Latin square design containing 2 periods of 11 d each and the following treatments: 1) supplementation with soybean meal (PROT), 2) supplementation with a mixture of cracked corn, soybean meal, and urea (68:22:10 ratio, DM basis; ENER), or 3) no supplementation (CON). Steers were offered meadow foxtail (Alopecurus pratensis L.) hay for ad libitum consumption. Treatments were provided daily at 0.50 and 0.54% of shrunk BW/steer for PROT and ENER, respectively, to ensure that PROT and ENER intakes were isocaloric and isonitrogenous. No treatment effects were detected on rumen disappearance parameters of forage DM (P >= 0.33) and NDF (P >= 0.66). In Exp. 2, 35 pregnant heifers were ranked by initial BW on d -7 of the study, allocated into 12 feedlot pens (4 pens/treatment), and assigned to the same treatments and forage intake regimen as in Exp. 1 for 19 d. Treatments were fed once daily at 1.77 and 1.92 kg of DM/heifer for PROT and ENER, respectively, to achieve the same treatment intake as percent of initial BW used in Exp. 1 (0.50 and 0.54% for PROT and ENER, respectively). No treatment effects (P = 0.17) were detected on forage DMI. Total DMI was greater (P < 0.01) for PROT and ENER compared with CON and similar between PROT and ENER (P = 0.36). Accordingly, ADG was greater (P = 0.01) for PROT compared with CON, tended to be greater for ENER compared with CON (P = 0.08), and was similar between ENER and PROT (P = 0.28). Heifers receiving PROT and ENER had greater mean concentrations of plasma glucose (P = 0.03), insulin (P <= 0.09), IGF-I (P <= 0.04), and progesterone (P = 0.01) compared to CON, whereas ENER and PROT had similar concentrations of these variables (P >= 0.15). A treatment x hour interaction was detected (P < 0.01) for plasma urea N (PUN), given that PUN concentrations increased after supplementation for ENER and PROT (time effect, P < 0.01) but did not change for CON (time effect, P = 0.62). In conclusion, beef cattle consuming low-quality cool-season forages had similar ruminal forage disappearance and intake, performance, and physiological status if offered supplements based on soybean meal or corn at 0.5% of BW.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The present study aimed to develop a methodology for the collection, transfer, storage and processing of vibration levels emitted in jobs occupied in agricultural machinery. The reason of this work is the study the vibration dose applied to operators of heavy vehicles and its relation to occupational health, linking the still high number of accidents involving farm machinery in relation to overturning (tipping). There is a need for the development and improvement of efficient tools in measuring vibration and tilt machine work, which minimize damage to health and accident risks for operators.