Power converter topologies for wind energy conversion systems: Integrated modeling, control strategy and performance simulation

This paper presents new integrated model for variable-speed wind energy conversion systems, considering a more accurate dynamic of the wind turbine, rotor, generator, power converter and filter. Pulse width modulation by space vector modulation associated with sliding mode is used for controlling the power converters. Also, power factor control is introduced at the output of the power converters. Comprehensive performance simulation studies are carried out with matrix, two-level and multilevel power converter topologies in order to adequately assert the system performance. Conclusions are duly drawn.

Fractional-order control and simulation of wind energy systems with PMSG/full-power converter topology

This paper presents a new integrated model for the simulation of wind energy systems. The proposed model is more realistic and accurate, considering a variable-speed wind turbine, two-mass rotor, permanent magnet synchronous generator (PMSG), different power converter topologies, and filters. Additionally, a new control strategy is proposed for the variable-speed operation of wind turbines with PMSG/full-power converter topology, based on fractional-order controllers. Comprehensive simulation studies are carried out with matrix and multilevel power converter topologies, in order to adequately assert the system performance in what regards the quality of the energy injected into the electric grid. Finally, conclusions are duly drawn.

A new control strategy with saturation effect compensation for an autonomous induction generator drivenby wide speed range turbines

This paper presents a variable speed autonomous squirrel cage generator excited by a current-controlled voltage source inverter to be used in stand-alone micro-hydro power plants. The paper proposes a system control strategy aiming to properly excite the machine as well as to achieve the load voltage control. A feed-forward control sets the appropriate generator flux by taking into account the actual speed and the desired load voltage. A load voltage control loop is used to adjust the generated active power in order to sustain the load voltage at a reference value. The control system is based on a rotor flux oriented vector control technique which takes into account the machine saturation effect. The proposed control strategy and the adopted system models were validated both by numerical simulation and by experimental results obtained from a laboratory prototype. Results covering the prototype start-up, as well as its steady-state and dynamical behavior are presented. (C) 2011 Elsevier Ltd. All rights reserved.

Wind turbines equipped with fractional-order controllers: Stress on the mechanical drive train due to a converter control malfunction

This paper is on variable-speed wind turbines with permanent magnet synchronous generator (PMSG). Three different drive train mass models and three different topologies for the power-electronic converters are considered. The three different topologies considered are respectively a matrix, a two-level and a multilevel converter. A novel control strategy, based on fractional-order controllers, is proposed for the wind turbines. Simulation results are presented to illustrate the behaviour of the wind turbines during a converter control malfunction, considering the fractional-order controllers. Finally, conclusions are duly drawn. Copyright (C) 2010 John Wiley & Sons, Ltd.

Adaptable control for electrical generation at irregural wind speeds

The main aims of this work are the development and the validation of one generic algorithm to provide the optimal control of small power wind generators. That means up to 40 kW and blades with fixed pitch angle. This algorithm allows the development of controllers to fetch the wind generators at the desired operational point in variable operating conditions. The problems posed by the variable wind intensity are solved using the proposed algorithm. This is done with no explicit measure of the wind velocity, and so no special equipment or anemometer is required to compute or measure the wind velocity.

Fuzzy, integer and fractional-order control: Application on a wind turbine benchmark model

This paper presents a comparison between proportional integral control approaches for variable speed wind turbines. Integer and fractional-order controllers are designed using linearized wind turbine model whilst fuzzy controller also takes into account system nonlinearities. These controllers operate in the full load region and the main objective is to extract maximum power from the wind turbine while ensuring the performance and reliability required to be integrated into an electric grid. The main contribution focuses on the use of fractional-order proportional integral (FOPI) controller which benefits from the introduction of one more tuning parameter, the integral fractional-order, taking advantage over integer order proportional integral (PI) controller. A comparison between proposed control approaches for the variable speed wind turbines is presented using a wind turbine benchmark model in the Matlab/Simulink environment. Results show that FOPI has improved system performance when compared with classical PI and fuzzy PI controller outperforms the integer and fractional-order control due to its capability to deal with system nonlinearities and uncertainties. © 2014 IEEE.

The AIDS epidemic in the Amazon region: a spatial case-control study in Rondonia, Brazil

OBJECTIVE To analyze spatial changes in the risk of AIDS and the relationship between AIDS incidence and socioeconomic variables in the state of Rondonia, Amazon region. METHODS A spatial, population case-control study in Rondonia, Brazil, based on 1,780 cases reported to the Epidemiological Surveillance System and controls based on demographic data from 1987 to 2006. The cases were grouped into five consecutive four-year periods. A generalized additive model was adjusted to the data; the dependent variable was the status of the individuals (case or control), and the independent variables were a bi-dimensional spline of the geographic coordinates and some municipality-level socioeconomic variables. The observed values of the Moran’s I test were compared to a reference distribution of values generated under conditions of spatial randomness. RESULTS AIDS risk shows a marked spatial and temporal pattern. The disease incidence is related to socioeconomic variables at the municipal level in Rondônia, such as urbanization and human capital. The highest incidence rates of AIDS are in municipalities along the BR-364 highway and calculations of the Moran’s I test show positive spatial correlation associated with proximity of the municipality to the highway in the third and fourth periods (p = 0.05). CONCLUSIONS Incidence of the disease is higher in municipalities of greater economic wealth and urbanization, and in those municipalities bisected by Rondônia’s main roads. The rapid development associated with the opening up of once remote regions may be accompanied by an increase in these risks to health.

Fuzzy, integer and fractional-order control: application on a wind turbine benchmark model

This paper presents a comparison between proportional integral control approaches for variable speed wind turbines. Integer and fractional-order controllers are designed using linearized wind turbine model whilst fuzzy controller also takes into account system nonlinearities. These controllers operate in the full load region and the main objective is to extract maximum power from the wind turbine while ensuring the performance and reliability required to be integrated into an electric grid. The main contribution focuses on the use of fractional-order proportional integral (FOPI) controller which benefits from the introduction of one more tuning parameter, the integral fractional-order, taking advantage over integer order proportional integral (PI) controller. A comparison between proposed control approaches for the variable speed wind turbines is presented using a wind turbine benchmark model in the Matlab/Simulink environment. Results show that FOPI has improved system performance when compared with classical PI and fuzzy PI controller outperforms the integer and fractional-order control due to its capability to deal with system nonlinearities and uncertainties. © 2014 IEEE.

Implementation contexts of a Tuberculosis Control Program in Brazilian prisons

OBJECTIVE To analyze the influence from context characteristics in the control of tuberculosis in prisons, and the influence from the program implementation degrees in observed effects.METHODS A multiple case study, with a qualitative approach, conducted in the prison systems of two Brazilian states in 2011 and 2012. Two prisons were analyzed in each state, and a prison hospital was analyzed in one of them. The data were submitted to a content analysis, which was based on external, political-organizational, implementation, and effect dimensions. Contextual factors and the ones in the program organization were correlated. The independent variable was the program implementation degree and the dependent one, the effects from the Tuberculosis Control Program in prisons.RESULTS The context with the highest sociodemographic vulnerability, the highest incidence rate of tuberculosis, and the smallest amount of available resources were associated with the low implementation degree of the program. The results from tuberculosis treatment in the prison system were better where the program had already been partially implemented than in the case with low implementation degree in both cases.CONCLUSIONS The implementation degree and its contexts – external and political-organizational dimensions – simultaneously contribute to the effects that are observed in the control of tuberculosis in analyzed prisons.

On performance of distributed model predictive control in power system frequency regulation

This paper describes the implementation of a distributed model predictive approach for automatic generation control. Performance results are discussed by comparing classical techniques (based on integral control) with model predictive control solutions (centralized and distributed) for different operational scenarios with two interconnected networks. These scenarios include variable load levels (ranging from a small to a large unbalance generated power to power consumption ratio) and simultaneously variable distance between the interconnected networks systems. For the two networks the paper also examines the impact of load variation in an island context (a network isolated from each other).

Estudio de la gestión de la variable ambiental en la generación termoeléctrica

En la actualidad, el cambio climático es uno de los temas de mayor preocupación para la población mundial y los científicos de todo el mundo. Debido al crecimiento de la población de forma exponencial, la demanda de energía aumenta acorde con ello, por lo que las actividades de producción energética aumentan consecuentemente, siendo éstas las principales causantes de la aceleración del cambio climático. Pese a que muchos países previamente habían apostado por la producción energética mediante tecnologías limpias a partir de energías renovables, hoy en día es imposible prescindir de los combustibles fósiles pues, junto a la energía nuclear, suponen el mayor porcentaje dentro del mix energético de los países más grandes del mundo, por lo que el cambio debe ser global y con todos los países implicados al unísono. Por ello, los países desarrollados decidieron acordar una serie de leyes y normas para la regulación y el control de la expansión energética en el mundo, mediante programas de incentivo a las empresas para la producción de energía limpia, libre de emisiones, sustituyendo y mejorando los procesos tecnológicos para que garanticen un desarrollo sostenible. De esta forma, se conseguiría también reducir la dependencia energética de los países productores de los recursos fósiles más importantes y a su vez, ayudar a otros sectores a diversificar su negocio y mejorar así la economía de las áreas colindantes a las centrales de producción térmica. Gracias a estos programas de incentivo o, también llamados mecanismos de flexibilidad, las empresas productoras de energía, al acometer inversiones en tecnologia limpia, dejan de emitir gases de efecto invernadero a la atmósfera. Por tanto, gracias al comercio de emisiones y al mercado voluntario, las empresas pueden vender dichas emisiones aumentando la rentabilidad de sus proyectos, haciendo más atractivo de por sí el hecho de invertir en tecnología limpia. En el proyecto desarrollado, se podrá comprobar de una forma más extensa todo lo anteriormente citado. Para ello, se desarrollará una herramienta de cálculo que nos permitirá analizar los beneficios obtenidos por la sustitución de un combustible fósil, no renovable, por otro renovable y sostenible, como es la biomasa. En esta herramienta se calcularán, de forma estimada, las reducciones de las emisiones de CO2 que supone dicha sustitución y se hallará, en función del valor de las cotizaciones de los bonos de carbono en los diferentes mercados, cuál será el beneficio económico obtenido por la venta de las emisiones no emitidas que supone esta sustitución. Por último, dicho beneficio será insertado en un balance económico de la central donde se tendrán en cuenta otras variables como el precio del combustible o las fluctuaciones del precio de la electricidad, para hallar finalmente la rentabilidad que supondría la inversión de esta adaptación en la central. Con el fin de complementar y aplicar la herramienta de cálculo, se analizarán dos casos prácticos de una central de carbón, en los cuales se decide su suscripción dentro del contexto de los mecanismos de flexibilidad creados en los acuerdos internacionales.

Improving tuberculosis control through the partnership between university and the health system

INTRODUCTION: Tuberculosis (TB) control is linked to the availability of qualified methods for microbiological diagnostics; however, microscopy with limited sensitivity is the only method available in many locations. The objective of this study was to evaluate the introduction of culture, drug susceptibility testing (DST), and genotyping in the routine of a Municipal Program of Tuberculosis Control. METHODS: Direct microscopy of sputum and culture in Ogawa-Kudoh were performed on 1,636 samples from 787 patients. DST of positive cultures was performed by resazurin microtiter assay and genotyping by mycobacterial interspersed repetitive units-variable number tandem repeat. RESULTS: A total 91 patients with TB were identified. The culture increased case detection by 32% compared with the microscopy; acquired resistance was 3.3% and the genotyping showed high genetic diversity. CONCLUSIONS: Ogawa-Kudoh contributed significantly to the increase in case detection and is suitable for implementation in poor-resource locations. The acquired resistance rate was lower than that reported in a recent Brazilian survey. The high genetic diversity is possibly related to the high TB prevalence in the population, as well as to early detection and suitable treatment of patients. The interaction between research and health care is important for reorienting the practice, transferring technology, and improving TB control.

The residual effect of deltametrine in the control of Malaria as observed on fifferent types Of walls In the Brazilian Amazon 1

The residual power of deltametrine FW (25 mg 1 .a/m2) was evaluated and compared to that of DDT (2 g i.a./m2) by means of biological tests. The different kinds of material used in constructing houses in Amazonia, such as: masonry, wood, and wattle and daub, were used. Data from logistic regression showed that the drop in mortality, the inclination of the curve in relation to time, was similar for the two insecticides in the first samples. The negative coeficient for the variable, months after application, confirmed a reduction in the activity of both insecticides. Wooden and wattle walls showed positive and negative coeficiencies respectively from the beginning. The wooden walls retained a residual effect but the wattle walls were shown to be the least indicated for the application of insecticides The experiments demonstrated a more prolonged residual effect for deltametrine as compared to DDT, and that insecticides work better on brick and cement and wooden walls than they do on wattle and daub constructions. For these reasons, it would be necessary to spray brick and cement walls every 8 months, wooden ones every 9 months and wattle constructions every 7 months to control the vectors of malaria.

Patrones de tomate: resistencia variable frente al nematodo Meloidogyne

Los patrones de tomate se han propuesto como una alternativa no química al uso del bromuro de metilo. En este estudio se evaluó la respuesta de resistencia de diez patrones de tomate (comerciales y experimentales) a nematodos del género Meloidogyne mediante un ensayo de campo realizado en un invernadero de plástico cuyo suelo se hallaba infestado por Meloidogyne javanica. Al finalizar la campaña agrícola (marzo a julio), siete de los patrones ensayados mostraron altos niveles de resistencia, uno presentó resistencia intermedia y dos resultaron ser susceptibles al nematodo.

Species identification in mammals from mixed biological samples based on mitochondrial DNA control region length polymorphism.

The ability to identify the species origin of an unknown biological sample is relevant in the fields of human and wildlife forensics. However, the detection of several species mixed in the same sample still remains a challenge. We developed and tested a new approach for mammal DNA identification in mixtures of two or three species, based on the analysis of mitochondrial DNA control region interspecific length polymorphism followed by direct sequencing. Contrary to other published methods dealing with species mixtures, our protocol requires a single universal primer pair and is not based on a pre-defined panel of species. Amplicons can be separated either on agarose gels or using CE. The advantages and limitations of the assay are discussed under different conditions, such as variable template concentration, amplicon sizes and size difference among the amplicons present in the mixture. For the first time, this protocol provides a simple, reliable and flexible method for simultaneous identification of multiple mammalian species from mixtures, without any prior knowledge of the species involved.