Aggregate stability in soils cultivated with eucalyptus

The objective of this work was to evaluate the aggregate stability of tropical soils under eucalyptus plantation and native vegetation, and assess the relationships between aggregate stability and some soil chemical and physical properties. Argisols, Cambisol, Latosols and Plinthosol within three eucalyptus-cultivated regions, in the states of Espírito Santo, Rio Grande do Sul and Minas Gerais, Brazil, were studied. For each region, soils under native vegetation were compared to those under minimum tillage with eucalyptus cultivation. The aggregate stability was measured using the high-energy moisture characteristic (HEMC) technique, i.e., the moisture release curve at very low suctions. This method compares the resistance of aggregates to slaking on a relative scale from zero to one. Thus, the aggregate stability from different soils and management practices can be directly compared. The aggregate stability ratio was greater than 50% for all soils, which shows that the aggregate stability index is high, both in eucalyptus and native vegetation areas. This suggests that soil management adopted for eucalyptus cultivation does not substantially modify this property. In these soils, the aggregate stability ratio does not show a good relationship with clay or soil organic matter contents. However, soil organic matter shows a positive relationship with clay content and cation exchange capacity.

The Effect of Deicing Salt on Aggregate Durability, Progress Report HR-266, 1985

The Iowa DOT has been using rapid freezing in air and thawing in water to evaluate coarse aggregate durability in concrete since 1962. Earlier research had shown that the aggregate pore system was a major factor in susceptibility to D-cracking rapid deterioration. There are cases were service records show rapid deterioration of concrete containing certain aggregates on heavily salted primary roads and relatively good performance with the same aggregate in secondary pavements with limited use of deicing salt. A five-cycle salt treatment of the coarse aggregate prior to durability testing has yielded durability factors that correlate with aggregate service records on heavily salted primary pavements. X-ray fluorescence analyses have shown that sulfur contents correlate well with aggregate durabilities with higher sulfur contents producing poor durability. Trial additives that affect the salt treatment durabilities would indicate that one factor in the rapid deterioration mechanism is an adverse chemical reaction. The objective· of the current research is to develop a simple method of determining aggregate susceptibility to salt related deterioration. This method of evaluation includes analyses of both the pore system and chemical composition.

Investigation of Rapid Thermal Analysis Procedures for Prediction of the Service Life of PCCP Carbonate Coarse Aggregate: Phase I, Progress Report, HR-337, 1992

The major objective of this research project is to utilize thermal analysis techniques in conjunction with x-ray analysis methods to identify and explain chemical reactions that promote aggregate related deterioration in Portland cement concrete. The first year of this project has been spent obtaining and analyzing limestone and dolomite samples that exhibit a wide range of field service performance. Most of the samples chosen for the study also had laboratory durability test information (ASTM C 666, method B) that was readily available. Preliminary test results indicate that a strong relationship exists between the average crystallite size of the limestone (calcite) specimens and their apparent decomposition temperatures as measured by thermogravimetric analysis. Also, premature weight loss in the thermogravimetric analysis tests appeared to be related to the apparent decomposition temperature of the various calcite test specimens.

The Relationship of Aggregate Durability to Trace Element Content, Interim Report, HR-266, 1984

This report is a brief overview of the recent Iowa Department of Transportation research in the area of durability of Portland cement, concrete under the direction of Wendeli Dubberke. Present plans are to publish a more detailed report on low Portland cement concrete- durability research in January, 1985.

How Do Aggregate Fluctuations Depend on the Network Structure of the Economy?

[spa] En este artículo, analizamos la volatilidad agregada de una economía estilizada donde los agentes estann conectados en redes. Si hay relaciones estratégicas entre las acciones de los agentes, choques idiosincráticos pueden generar fluctuaciones agregadas. Demonstramos que la volatilidad agregada depende de la estructura de redes de la economía de dos maneras. Por un lado, si hay más conexiones en la economía en su conjunto, la volatilidad agregada es más baja. Por otro lado, si las conexiones están más concentradas, la volatilidad agregada es más alta. Presentamos una aplicación de nuestras predicciones teóricas que utiliza datos de EEUU de conexiones intrasectoriales y de diversificación de las empresas.

How Do Aggregate Fluctuations Depend on the Network Structure of the Economy?

[spa] En este artículo, analizamos la volatilidad agregada de una economía estilizada donde los agentes estann conectados en redes. Si hay relaciones estratégicas entre las acciones de los agentes, choques idiosincráticos pueden generar fluctuaciones agregadas. Demonstramos que la volatilidad agregada depende de la estructura de redes de la economía de dos maneras. Por un lado, si hay más conexiones en la economía en su conjunto, la volatilidad agregada es más baja. Por otro lado, si las conexiones están más concentradas, la volatilidad agregada es más alta. Presentamos una aplicación de nuestras predicciones teóricas que utiliza datos de EEUU de conexiones intrasectoriales y de diversificación de las empresas.

Aggregate material formulated with MSWI bottom ash and APC fly ash for use as secondary building material

The main goal of this paper is to obtain a granular material formulated with Municipal Solid Waste Incinerarion (MSWI) bottom ash (BA) and air pollution control (APC) ash to be used as secondary building material. Previously, an optimum concrete mixture using both MSWI residues as aggregates was formulated. A compromise between the environmental behaviour and the economy of the process was considered. Unconfined compressive strength and abrasion resistance values were measured in order to evaluate the mechanical properties. From these results, the granular mixture was not suited for certain applications owing to the high BA/APC content and low cement percentages used to reduce the costs of the final product. Nevertheless, the leaching test performed showed that the concentrations of all heavy metals were below the limits established by the current Catalan legislation for their reutilization. Therefore, the material studied might be mainly used in embankments, where high mechanical properties are not needed and environmental safety is assured.

Quality in work and aggregate productivity

We explore the relationship between quality in work and aggregate productivity in regions and sectors. Using recent Spanish aggregate data for the period 2001-2006, we find that quality in work may be an important factor to explain productivity levels in sectors and regions. We use two alternatives definitions of quality in work: one from survey data and the other from a social indicators approach. We also use two different measurements of labour productivity to test the robustness of our results. The estimates are run using a simultaneous equation model for our panel of data, and find important differences between high tech and low tech sectors: a positive relationship between quality in work and productivity in the former case, and a negative relationship in the latter. Consequently, on the one hand we see that quality in work is not only an objective per se, but may also be a production factor able to increase the wealth of regions; on the other hand, at the aggregate level, we may also find that high productivity levels coincide with lower quality in work conditions.

Soil CO2 emission as related to incorporation of sugarcane crop residues and aggregate breaking after rotary tiller

Soil tillage is a process that accelerates soil organic matter decomposition transferring carbon to atmosphere, mainly in the CO2 form. In this study, the effect of rotary tillage on soil CO2 emission was investigated, including the presence of crop residues on the surface.Emissions were evaluated during 15 days after tillage in 3 plots: 1) non-tilled and without crop residues on soil surface (NTwo), 2) rotary tiller without the presence of crop residues on soil surface (RTwo), and 3) rotary tiller with the presence of crop residues in soil surface (RTw). Emissions from the RTw plot were higher than the other plots, (0.777 g CO2 m-2 h-1), with the lowest emissions recorded in the NTwo plot (0.414 g CO2 m-2 h-1). Total emission indicates that the difference of C-CO2 emitted to atmosphere corresponds to 3% of the total additional carbon in the crop residues in the RTw plot compared to RTwo. The increase in the RTwo emission in comparison to NTwo was followed by changes in the aggregate size distribution, especially those with average diameter lower than 2 mm. The increase in emission from the RTw plot in relation to RTwo was related to a decrease in crop residue mass on the surface, and its higher fragmentation and incorporation in soil. When the linear correlation between soil CO2 emission, and soil temperature and soil moisture is considered, only the RTw treatment showed significant correlation (p<0.05) with soil moisture.

A Test of New Aggregate Damand Curvature Properties.

In This Paper We Present and Implement an Econometric Test of Both Negative Semi-Definiteness of the Matrix of Compensated Price Effects and of the Negative Quasi-Definiteness of the Matrix of Uncompensated Price Effects. This Test Allows Us to Evaluate Two Alternative Characterizations of Aggregate Demand Systems: the First, That They Behave Like Individual Demand Fuctions, and the Second, That They Respect the Properties Implied by the Assumptions Proposed by Hidebrand (1983) Or Grandmont (1984).

The Transformation Problem : an Aleternative Solution with an Identical Aggregate Profit Rate in the Labor value and the Monetary Space.

The aim of this paper is to demonstrate that, even if Marx's solution to the transformation problem can be modified, his basic conclusions remain valid. the proposed alternative solution which is presented hare is based on the constraint of a common general profit rate in both spaces and a money wage level which will be determined simultaneously with prices.

Why Have Aggregate Skilled Hours Become So Cyclical Since the Mid-1980's?

This paper documents and discusses a dramatic change in the cyclical behavior of aggregate hours worked by individuals with a college degree (skilled workers) since the mid-1980’s. Using the CPS outgoing rotation data set for the period 1979:1-2003:4, we find that the volatility of aggregate skilled hours relative to the volatility of GDP has nearly tripled since 1984. In contrast, the cyclical properties of unskilled hours have remained essentially unchanged. We evaluate the extent to which a simple supply/demand model for skilled and unskilled labor with capital-skill complementarity in production can help explain this stylized fact. Within this framework, we identify three effects which would lead to an increase in the relative volatility of skilled hours: (i) a reduction in the degree of capital-skill complementarity, (ii) a reduction in the absolute volatility of GDP (and unskilled hours), and (iii) an increase in the level of capital equipment relative to skilled labor. We provide empirical evidence in support of each of these effects. Our conclusion is that these three mechanisms can jointly explain about sixty percent of the observed increase in the relative volatility of skilled labor. The reduction in the degree of capital-skill complementarity contributes the most to this result.

The Transformation Problem : an Aleternative Solution with an Identical Aggregate Profit Rate in the Labor value and the Monetary Space.

The aim of this paper is to demonstrate that, even if Marx's solution to the transformation problem can be modified, his basic conclusions remain valid. the proposed alternative solution which is presented hare is based on the constraint of a common general profit rate in both spaces and a money wage level which will be determined simultaneously with prices.

Sectoral Price Rigidity and Aggregate Dynamics

In this paper, we study the macroeconomic implications of sectoral heterogeneity and, in particular, heterogeneity in price setting, through the lens of a highly disaggregated multi-sector model. The model incorporates several realistic features and is estimated using a mix of aggregate and sectoral U.S. data. The frequencies of price changes implied by our estimates are remarkably consistent with those reported in micro-based studies, especially for non-sale prices. The model is used to study (i) the contribution of sectoral characteristics to the observed cross sectional heterogeneity in sectoral output and inflation responses to a monetary policy shock, (ii) the implications of sectoral price rigidity for aggregate output and inflation dynamics and for cost pass-through, and (iii) the role of sectoral shocks in explaining sectoral prices and quantities.