Evaluation of the binding ability of a novel dioxatetraazamacrocyclic receptor that contains two phenanthroline units: selective uptake of carboxylate anions

The novel dioxatetraaza macrocycle [26]phen(2)N(4)O(2), which incorporates two phenanthroline units, has been synthesized, and its acid-base behavior has been evaluated by potentiometric and H-1 NMR methods. Six protonation constants were determined, and the protonation sequence was established by NMR. The location of the fifth proton on the phen nitrogen was confirmed by X-ray determinations of the crystal structures of the receptor as bromide and chloride salts. The two compounds have the general molecular formula {(H-5[26]phen(2)N(4)O(2))X-n(H2O)(5-n)}X(n-1)(.)mH(2)O, where X = Cl, n = 3, and m = 6 or X = Br, n = 4, and m = 5.5. In the solid state, the (H-5[26]phen(2)N(4)O(2))(5+) cation adopts a "horseshoe" topology with sufficient room to encapsulate three or four halogen anions through the several N-(HX)-X-... hydrogen-bonding interactions. Two supermolecules {(H-5[26]phen(2)N(4)O(2))X-n(H2O)(5-n)}((5-n)+) form an interpenetrating dimeric species, which was also found by ESI mass spectrum. Binding studies of the protonated macrocycle with aliphatic (ox(2-), mal(2-), suc(2-), cit(3-), cta(3-)) and aromatic (bzc(-), naphc(-), anthc(-), pyrc(-), ph(2-), iph(2-), tph(2-), btc(3-)) anions were determined in water by potentiometric methods. These studies were complemented by H-1 NMR titrations in D2O of the receptor with selected anions. The H-i[26]phen(2)N(4)O(2)(i+) receptor can selectively uptake highly charged or extended aromatic carboxylate anions, such as btc(3-) and pyrc(-), in the pH ranges of 4.0-8.5 and < 4.0, respectively, from aqueous solution that contain the remaining anions as pollutants or contaminants. To obtain further insight into these structural and experimental findings, molecular dynamics (MD) simulations were carried out in water solution.

Perspectives on experiences of innovation: the development of an assessment methodology appropriate to construction project organizations

The UK construction industry is in the process of trying to adopt a new culture based on the large-scale take up of innovative practices. Through the Demonstration Project process many organizations are implementing changed practices and learning from the experiences of others. This is probably the largest experiment in innovation in any industry in recent times. The long-term success will be measured by the effectiveness of embedding the new practices in the organization. As yet there is no recognized approach to measuring the receptivity of the organization to the innovation process as an indication of the likelihood of long-term development. The development of an appropriate approach is described here. Existing approaches to the measurement of the take up of innovation were reviewed and where appropriate used as the base for the development of a questionnaire. The questionnaire could be applicable to multi-organizational construction project situations such that the output could determine an individual organization's innovative practices via an innovation scorecard, a project team's approach or it could be used to survey a wide cross-section of the industry.

Tales of the expected: investigating the rhetorical strategies of innovation champions

Innovation continues to be high on the agenda in construction. It is widely considered to be an essential prerequisite of improved performance both for the sector at large and for individual firms. Success stories dominate the parts of the academic literature that rely heavily on the recollections of key individuals. A complementary interpretation focuses on the way innovation champions in hindsight interpret, justify and legitimize the diffusion of innovations. Emphasis is put on the temporal dimension of interpretation and how this links to rhetorical strategies and impression management tactics. Rhetorical theories are drawn upon to analyse the accounts given by innovation champions in seven facilities management organizations. In particular, the three persuasive appeals in classic rhetoric are used to highlight the rhetorical justifications mobilized in the descriptions of what took place. The findings demonstrate the usefulness of rhetorical theories in complementing studies of innovation.

Learning across business sectors: facets of innovation in aerospace and construction

Innovation is notoriously difficult to define and is invariably intertwined with issues of knowledge creation, continuous improvement and organisational change. An extensive literature classifies numerous types of innovation and militates against any simplistic attempt at definition. It is widely accepted that innovation is at least partly dependent upon the surrounding environment. Industry recipes and institutionally embedded practices shape the environment within which innovation occurs. Recent research directions have addressed the diffusion of innovation and its dependence upon social and institutional structures. In this respect, it is highly pertinent to compare the way that innovation is interpreted and enacted in different industrial sectors. The comparison between UK aerospace and construction is especially revealing because the two sectors are so different and therefore constitute radically different climates for innovation. Empirical research is reported based on semi-structured interviews with practitioners from both sectors. Interpretations of innovation are found to differ dramatically between aerospace and construction. Within the context of an ongoing struggle to define innovation, both industries are striving to become more innovative. The aerospace sector is found to emphasise technical innovation whereas the construction sector emphasises process innovation. An overriding cultural bias in Western economies towards technological innovation results in the common perception that aerospace is much more innovative than construction. The experienced realities of practitioners in the two sectors are much more complex.

Evaluating the ability of a numerical weather prediction model to forecast tracer concentrations during ETEX 2

In this paper the meteorological processes responsible for transporting tracer during the second ETEX (European Tracer EXperiment) release are determined using the UK Met Office Unified Model (UM). The UM predicted distribution of tracer is also compared with observations from the ETEX campaign. The dominant meteorological process is a warm conveyor belt which transports large amounts of tracer away from the surface up to a height of 4 km over a 36 h period. Convection is also an important process, transporting tracer to heights of up to 8 km. Potential sources of error when using an operational numerical weather prediction model to forecast air quality are also investigated. These potential sources of error include model dynamics, model resolution and model physics. In the UM a semi-Lagrangian monotonic advection scheme is used with cubic polynomial interpolation. This can predict unrealistic negative values of tracer which are subsequently set to zero, and hence results in an overprediction of tracer concentrations. In order to conserve mass in the UM tracer simulations it was necessary to include a flux corrected transport method. Model resolution can also affect the accuracy of predicted tracer distributions. Low resolution simulations (50 km grid length) were unable to resolve a change in wind direction observed during ETEX 2, this led to an error in the transport direction and hence an error in tracer distribution. High resolution simulations (12 km grid length) captured the change in wind direction and hence produced a tracer distribution that compared better with the observations. The representation of convective mixing was found to have a large effect on the vertical transport of tracer. Turning off the convective mixing parameterisation in the UM significantly reduced the vertical transport of tracer. Finally, air quality forecasts were found to be sensitive to the timing of synoptic scale features. Errors in the position of the cold front relative to the tracer release location of only 1 h resulted in changes in the predicted tracer concentrations that were of the same order of magnitude as the absolute tracer concentrations.

In vitro examination of the effect of Orlistat on the ability of the faecal microbiota to utilize dietary lipids

Orlistat is an anti-obesity treatment with which several gastrointestinal (GI) side-effects are commonly associated in the initial stages of therapy. There is no physiological explanation as to why two-thirds of those who take the drug experience one or more side-effects. It has been hypothesized that the GI microbiota may protect from or contribute to these GI disturbances. Using in vitro batch culture and human gut model systems, studies were conducted to determine whether increased availability of dietary lipids and/or orlistat affect the composition and/or activity of the faecal microbiota. Results from 24-h batch culture fermentation experiments demonstrated no effect of orlistat in the presence or absence of a dietary lipid (olive oil) on the composition of bacterial communities [as determined by fluorescence in situ hybridization (FISH) and denaturing gradient gel electrophoresis (DGGE) analyses], but did show there was great variability in the lipolytic activities of the microbiotas of individuals, as determined by gas chromatography analysis of long-chain fatty acids in samples. Subsequent studies focused on the effect of orlistat in the presence and absence of lipid in in vitro human gut model systems. Systems were run for 14 days with gut model medium (GMM) only (to steady state, SS), then fed at 12-h intervals with 50 mg orlistat, 2 g olive oil or a mixture of both for 14 days. FISH and DGGE were used to monitor changes in bacterial populations. Bacteria were cultivated from the GMM only (control) systems at SS. All strains isolated were screened for lipolytic activity using tributyrin agar. FISH and DGGE demonstrated that none of the compounds (singly or in combination) added to the systems had any notable effect on microbial population dynamics for any of the donors, although Subdoligranulum populations appeared to be inhibited by orlistat in the presence or absence of lipid. Orlistat had little or no effect on the metabolism of indigenous and added lipids in the fermentation systems, but there was great variability in the way the faecal microbiotas of the donors were able to degrade added lipids. Variability in lipid degradation could be correlated with the number and activity of isolated lipolytic bacteria. The mechanism by which orlistat and the GI microbiota cause side-effects in individuals is unknown, but several hypotheses have been proposed to account for their manifestation. The demonstration of great variability in the lipolytic activity of microbiotas to degrade lipids led to a large-scale cultivation-based study of lipolytic/lipase-positive bacteria present in the human faecal microbiota. Of 4,000 colonies isolated from 15 donors using five different agars, 378 strains were identified that had lipase activity. Molecular identification of strains isolated from five donors demonstrated that lipase activity is more prevalent in the human GI microbiota than previously thought, with members of the phyla Firmicutes, Bacteroidetes and Actinobacteria identified. Molecular identification and characterization of the substrate specificities of the strains will be carried out as part of ongoing work.

The competitive ability of pea-barley intercrops against weeds and the interactions with crop productivity and soil N availability

Grain legumes, such as peas (Pisum sativum L.), are known to be weak competitors against weeds when grown as the sole crop. In this study, the weed-suppression effect of pea–barley (Hordeum vulgare L.)intercropping compared to the respective sole crops was examined in organic field experiments across Western Europe (i.e., Denmark, the United Kingdom, France, Germany and Italy). Spring pea (P) and barley(B) were sown either as the sole crop, at the recommended plant density (P100 and B100, respectively), or in replacement (P50B50) or additive (P100B50)intercropping designs for three seasons (2003–2005). The weed biomass was three times higher under the pea sole crops than under both the intercrops and barley sole crops at maturity. The inclusion of joint experiments in several countries and various growing conditions showed that intercrops maintain a highly asymmetric competition over weeds, regardless of the particular weed infestation (species and productivity), the crop biomass or the soil nitrogen availability. The intercropping weed suppression was highly resilient, whereas the weed suppression in pea sole crops was lower and more variable. The pea–barley intercrops exhibited high levels of weed suppression, even with a low percentage of barley in the total biomass. Despite a reduced leaf area in the case of a low soil N availability, the barley sole crops and intercrops displayed high weed suppression, probably because of their strong competitive capability to absorb soil N. Higher soil N availabilities entailed increased leaf areas and competitive ability for light, which contributed to the overall competitive ability against weeds for all of the treatments. The contribution of the weeds in the total dry matter and soil N acquisition was higher in the pea sole crop than in the other treatments, in spite of the higher leaf areas in the pea crops.