A novel in-situ spectroelectrochemical technique with probe beam deflection: For study of the ion exchange between films on electrode surface and solutions

A novel in-situ spectroelectrochemical technique, the combination of probe beam deflection (PBD) with cyclic voltammetry (CV), was used to study the ion exchange process of prussian blue(PB) modified film electrode in contact with various electrolyte solutions. The ion exchange mechanism was verified as following: (K2Fe2+FeII)(CN)(6) -e(-)-k(+)reversible arrow +e(-)+k(+) (KFe3+FeII)(CN)(6) -ke(-)-xk(+)reversible arrow +xe(-)+kk(+) [(Fe3+FeIII)(CN)(6)](x)[(KFe3+FeII)(CN)(6)](1-x) where on reduction PB film in contact with an acidic KCl electrolyte, it was confirmed that protons enter into the PB film before K+ cations.

STUDY ON THE COMPLEXATION OF ACENAPHTHENE AND FLUORANTHENE WITH CYCLODEXTRINS BY MEANS OF TIME-RESOLVED FLUORESCENCE TECHNIQUE

The complexation of acenaphthene and fluoranthene with beta-cyclodextrin (CD) in aqueous solutions in the presence and absence of ethanol was investigated by means of the time-resolved fluorescence technique. The appearance of a longer lifetime component and the increase of its fraction relative to that of the shorter lifetime component with increasing CD concentration demonstrate the formation of inclusion complex between the guest molecule and CD. The formation constants for complexation were derived from the pre-exponential factor A(i) of fluorescence decay curves. The presence of ethanol in the reaction systems enhanced the inclusion to a large extent.

A technique for mapping three-dimensional number densities of species in laser produced plumes

The potential of a diagnostic technique to provide quantitative three-dimensional (3D) density distributions of species in a low temperature laser-produced plume is shown. An expanded, short pulse, tunable dye laser is used to probe the plume at a set time during the expansion. Simultaneous recording of two-dimensional in-line absorbance maps and orthogonal recording of laser induced fluorescence permits the 3D density mapping by scanning the dye laser frequency. Preliminary data, supported by a simple model, is presented for the case of Ba II ions in a YBCO plume heated by a KrF laser. (C) 1996 American Institute of Physics.

An in situ spatially resolved analytical technique to simultaneously probe gas phase reactions and temperature within the packed bed of a plug flow reactor

This paper reports the detailed description and validation of a fully automated, computer controlled analytical method to spatially probe the gas composition and thermal characteristics in packed bed systems. As an exemplar, we have examined a heterogeneously catalysed gas phase reaction within the bed of a powdered oxide supported metal catalyst. The design of the gas sampling and the temperature recording systems are disclosed. A stationary capillary with holes drilled in its wall and a moveable reactor coupled with a mass spectrometer are used to enable sampling and analysis. This method has been designed to limit the invasiveness of the probe on the reactor by using the smallest combination of thermocouple and capillary which can be employed practically. An 80 mu m (O.D.) thermocouple has been inserted in a 250 mu m (O.D.) capillary. The thermocouple is aligned with the sampling holes to enable both the gas composition and temperature profiles to be simultaneously measured at equivalent spatially resolved positions. This analysis technique has been validated by studying CO oxidation over a 1% Pt/Al2O3 catalyst and the spatial resolution profiles of chemical species concentrations and temperature as a function of the axial position within the catalyst bed are reported.

Diffusion dans un hydrogel : applications aux biocapteurs et optimisation de la technique de spectroscopie par corrélation de fluorescence (FCS)

Mémoire numérisé par la Division de la gestion de documents et des archives de l'Université de Montréal

Étude des mécanismes moléculaires de formation des pores des toxines formeuses de pores par la spectroscopie de fluorescence

Les toxines formeuses de pore (PFTs) sont des protéines exogènes responsables d’un grand nombre de maladies infectieuses qui perméabilisent les membranes cellulaires de leur hôte. La formation des pores ou l’introduction d’une enzyme dans le cytoplasme peut entrainer l’apparition de symptômes de maladies connues (l’anthrax, le botulisme) et, dans le pire des cas, la mort. Les mécanismes d’infection et de destruction des cellules infectées sont bien caractérisés. Toutefois, l’aspect dynamique des changements de conformation durant le processus de perméabilisation reste à découvrir pour la majorité des toxines formeuses de pore. Le but de cette thèse est d’étudier les mécanismes d’oligomérisation des PFTs, ainsi que la formation des pores à la membrane lipidique grâce à la spectroscopie de fluorescence. Nous avons choisi la toxine Cry1Aa, un bio pesticide produit par le bacille de Thuringe et qui a été rigoureusement caractérisé, en tant que modèle d’étude. La topologie de la Cry1Aa à l’état actif et inactif a pu être résolue grâce à l’utilisation d’une technique de spectroscopie de fluorescence, le FRET ou transfert d’énergie par résonance entre un fluorophore greffé au domaine formeur de pore (D1) et un accepteur non fluorescent (le DPA ou dipicrylamine) localisé dans la membrane et qui bouge selon le potentiel membranaire. Le courant électrique, ainsi que la fluorescence provenant de la bicouche lipidique membranaire horizontale ont été enregistrés simultanément. De cette manière, nous avons pu localiser toutes les boucles reliant les hélices de D1 avant et après la formation des pores. Dans la forme inactive de la toxine, toutes ces boucles se trouvent du côté interne de la bicouche lipidique, mais dans sa forme active l’épingle α3-α4 traverse du côté externe, alors que toutes les autres hélices demeurent du côté interne. Ces résultats suggèrent que α3-α4 forment le pore. Nous avons découvert que la toxine change significativement de conformation une fois qu’elle se trouve dans la bicouche lipidique, et que la Cry1Aa attaque la membrane lipidique de l’extérieur, mais en formant le pore de l’intérieur. Dans le but de caractériser la distribution de toxines à chaque extrémité de la bicouche, nous avons utilisé une technique de double FRET avec deux accepteurs ayant des vitesses de translocation différentes (le DPA et l’oxonol) dans la membrane lipidique. De cette manière, nous avons déterminé que la toxine était présente des deux côtés de la bicouche lipidique durant le processus de perméabilisation. La dynamique d’oligomérisation de la toxine dans une bicouche lipidique sans récepteurs a été étudiée avec une technique permettant le compte des sauts de fluorescence après le photoblanchiment des fluorophore liés aux sous unités composant un oligomère présent dans la bicouche lipidique supportée. Nous avons confirmé de cette manière que la protéine formait ultimement des tétramères, et que cet état résultait de la diffusion des monomères de toxine dans la bicouche et de leur assemblage subséquent. Enfin nous avons voulu étudier le « gating » de la colicine Ia, provenant de la bactérie E.Coli, dans le but d’observer les mouvements que font deux positions supposées traverser la bicouche lipidique selon le voltage imposé aux bornes de la bicouche. Nos résultats préliminaires nous permettent d’observer un mouvement partiel (et non total) de ces positions, tel que le suggèrent les études de conductances du canal.

Laser Induced Fluorescence Based Optical Fiber Probe for Analyzing Bacteria

Optical fiber based laser induced fluorescence (LIF) measurements were carried out using Rhodamine B to analyze two different species of bacteria , a Gram-positive bacteria namely Bacillus smithii , and fibrin alginolvticus, a Gram- negative bacteria . The fiber sensor was clearly able to distinguish between the two species of bacteria . Quenching effect of the dye Rhodamine B by Bacillus smithii was observed . The effect of dye on the samples was also studied in detail.

Laser induced fluorescence based optical fiber probe for analyzing bacteria

Optical fiber based laser induced fluorescence (LIF) measurements were carried out using Rhodamine B to analyze two different species of bacteria , a Gram-positive bacteria namely Bacillus .cmithii , and fibrin alginolvticus, a Gram-' negative bacteria . The fiber sensor was clearly able to distinguish between the two species of bacteria . Quenching effect of the dye Rhodamine B by Bacillus smitltii was observed . The effect of dye on the samples was also studied in detail.

Measurement of the absolute fluorescence quantum yield of rhodamine B solution using a dual-beam thermal lens technique

The dual-beam thermal lens technique has been found to be very effective for the measurement of fluorescence quantum yields of dye solutions. The concentration-dependence of the quantum yield of rhodamine B in methanol is studied here using this technique. The observed results are in line with the conclusion that the reduction in the quantum yield in the quenching region is essentially due to the non-radiative relaxation of the absorbed energy. The thermal lens has been found to become abberated above 40 mW of pump laser power. This low value for the upper limit of pump power is due to the fact that the medium is a resonantly absorbing one.

Studies on Fluorescence Efficiency and Photodegradation of Rhodamine 6G Doped PMMA Using a Dual Beam Thermal Lens Technique

In this paper we report the use of the dual beam thermal lens technique as a quantitative method to determine absolute fluorescence quantum efficiency and concentration quenching of fluorescence emission from rhodamine 6G doped Poly(methyl methacrylate) (PMMA), prepared with different concentrations of the dye. A comparison of the present data with that reported in the literature indicates that the observed variation of fluorescence quantum yield with respect to the dye concentration follows a similar profile as in the earlier reported observations on rhodamine 6G in solution. The photodegradation of the dye molecules under cw laser excitation is also studied using the present method.

Solvent Effect on Absolute Fluorescence Quantum Yield of Rhodamine 6G Determined Using Transient Thermal Lens Technique

Dual beam thermal lens tecbnique is successfully employed for the determination of absolute Fluorescence quantum yield of rhodamine 6G lnser dye in different solvents. A 532 nm radiation from a Q-switched Nd:YAG laser was used for the excitation purpose. The fluorescence quantum yield values are found to be strongly influenced by environmental effects. It has been observed that fluorescence yield is greater for rhodamine 6G in ethylene glycol system than in water or in methanol. Our results also indicate that parameters like concentration of the dye solution, aggregate formation and excited state absorption affect the absolute values of fluorescence yield significantly.

Fluorescence quantum yield of rhodamine 6G using pulsed photoacoustic technique

Experimental method for measuring photoacoustic(PA) signals generated by a pulsed laser beam in liquids is described. The pulsed PA technique is found to be a convenient and accurate method for determination of quantum yield in fluorescent dye solutions. Concentration dependence of quantum yield of rhodamine 6G in water is studied using the above method. The results indicate that the quantum yield decreases with increase in concentration in the quenching region in agreement with the existing reports based on radiometric measurements.