Quantum suppression of shot noise in field emitters

We have analyzed the shot noise of electron emission under strong applied electric fields within the Landauer-Bttiker scheme. In contrast to the previous studies of vacuum-tube emitters, we show that in new generation electron emitters, scaled down to the nanometer dimensions, shot noise much smaller than the Schottky noise is observable. Carbon nanotube field emitters are among possible candidates to observe the effect of shot-noise suppression caused by quantum partitioning.

Shot-noise spectroscopy of energy resolved ballistic currents

We investigate the shot noise of nonequilibrium carriers injected into a ballistic conductor and interacting via long-range Coulomb forces. Coulomb interactions are shown to act as an energy analyzer of the profile of injected electrons by means of the fluctuations of the potential barrier at the emitter contact. We show that the details in the energy profile can be extracted from shot-noise measurements in the Coulomb interaction regime, but cannot be obtained from time-averaged quantities or shot-noise measurements in the absence of interactions.

Effect of long-range Coulomb interaction on shot-noise suppression in ballistic transport

We present a microscopic analysis of shot-noise suppression due to long-range Coulomb interaction in semiconductor devices under ballistic transport conditions. An ensemble Monte Carlo simulator self-consistently coupled with a Poisson solver is used for the calculations. A wide range of injection-rate densities leading to different degrees of suppression is investigated. A sharp tendency of noise suppression at increasing injection densities is found to scale with a dimensionless Debye length related to the importance of space-charge effects in the structure.

A three-shot improvement scheme for hard-decision based linear decorrelating detector in DS/CDMA

This paper proposes a three-shot improvement scheme for the hard-decision based method (HDM), an implementation solution for linear decorrelating detector (LDD) in asynchronous DS/CDMA systems. By taking advantage of the preceding (already reconstructed) bit and the matched filter output for the following two bits, the coupling between temporally adjacent bits (TABs), which always exists for asynchronous systems, is greatly suppressed and the performance of the original HDM is substantially improved. This new scheme requires no signaling overhead yet offers nearly the same performance as those more complicated methods. Also, it can easily accommodate the change in the number of active users in the channel, as no symbol/bit grouping is involved. Finally, the influence of synchronisation errors is investigated.

One-shot near-far resistant CDMA detection in multipath fading channels-an O^3 BPSK based system

This paper applies O3BPSK (orthogonal on-off PSK) signaling scheme to multipath fading CDMA channels, for the purpose of near-far resistant detection in the reverse link. Based on the maximum multipath spreading delay, a minimum duration of “off” is suggested, with which the temporally adjacent bits (TABs) from different users at the receiver are decoupled. As a result, a Rake-type one-shot linear decorrelating detector (LDD) is obtained. Since no knowledge of echo amplitudes is needed, a blind detection can be realised.

A new signaling scheme for one-shot near-far resistant detection in DS/CDMA

This paper proposes a new signaling scheme: orthogonal on-off BPSK (O3BPSK), for near-far resistant detection in the asynchronous DS/CDMA systems (up-link). The temporally adjacent bits from different users in the received signals are decoupled by using the on-off signaling, and the original data rate is maintained with no increase in transmission rate by adopting an orthogonal structure. The detector at the receiver is a one-shot linear decorrelating detector, which depends upon neither hard-decision nor specific channel coding. Some computer simulations are shown to confirm the theoretical analysis.

Shot by both sides: Punk, politics and the end of “Consensus”

This article examines the ways in which political organisations of the far left and far right responded to punk-informed youth culture in Britain during the late 1970s. It examines how both tried to understand punk within their own ideological framework, particularly in relation to the perceived socio-economic and political crises of the late 1970s, before then endeavouring to appropriate—or use—punk for their own ends. Ultimately, however, the article suggests that while punk may indeed be seen as a cultural response to the breakdown of what some have described as the post-war ‘consensus’ in the 1970s, the far left and far right's focus on cultural expression cut across the basic foundations on which they had been built. Consequently, neither left nor right proved able to provide an effective political conduit through which the disaffections expressed by punk could be channelled.

Shot Noise in a Spin-Diode Geometry

We apply the master equation technique to calculate shot noise in a system composed of single level quantum dot attached to a normal metal lead and to a ferromagnetic lead (NM-QD-FM). It is known that this system operates as a spin-diode, giving unpolarized currents for forward bias and polarized current for reverse bias. This effect is observed when only one electron can tunnel at a time through the dot, due to the strong intradot Coulomb interaction. We find that the shot noise also presents a signature of this spin-diode effect, with a super-Poissonian shot noise for forward and a sub-Poissonian shot noise for reverse bias voltages. The shot noise thus can provide further experimental evidence of the spin-rectification in the NM-QD-FM geometry.

Three-dimensional Finite Element modelling of laser shock peening process

Laser shock peening (LSP) is an innovative surface treatment technique for metal alloys, with the great improvement of their fatigue, corrosion and wear resistance performance. Finite element method has been widely applied to simulate the LSP to provide the theoretically predictive assessment and optimally parametric design. In the current work, 3-D numerical modelling approaches, combining the explicit dynamic analysis, static equilibrium analysis algorithms and different plasticity models for the high strain rate exceeding 106s-1, are further developed. To verify the proposed methods, 3-D static and dynamic FEA of AA7075-T7351 rods subject to two-sided laser shock peening are performed using the FEA package–ABAQUS. The dynamic and residual stress fields, shock wave propagation and surface deformation of the treated metal from different material modelling approaches have a good agreement.

Study of shot length and motion as contributing factors to movie tempo

This work seeks to lay the framework of film grammar over the video to be analyzed. We use the shot attributes of motion and shot length to produce a novel continuous measure of one of the aesthetic elements of films, namely the movie tempo. We refer to our previous work detailing the study of this construct and its automatic derivation, and also demonstrating its usefulness as an expressive element and as a sound basis for higher semantic descriptions such as dramatic events and story elements. Initial assessment of tempo was performed in our study on the basis that the relative importance of both shot length and motion in formulating the tempo function was the same. In this paper, we analyze their relative contributions to tempo, and demonstrate how these two factors can be manipulated to influence audience perception of movie time.

Role of shot length in characterizing tempo and dramatic story sections in motion pictures

Motivated by existing cinematic conventions known as film grammar, we proposed a computational approach to determine tempo as a high-level movie content descriptor as well as means for deriving dramatic story sections and events occurring in movies. Movie tempo is extracted from two easily computed aspects in our approach: shot length and motion. Story sections and events are generally associated with changes in tempo, and are thus identified by edges located in the tempo function. In this paper, we analyze our initial founding of the tempo function on the basis that the distribution of both shot length and motion in movies is normal. Given that the distribution of shot length is approximately Weibull as confirmed in our experiments, we examine the impact of modelling and modifying the contributions of shot length to tempo. We derive an appropriate normalization function that faithfully encapsulates the role of shot length in tempo perception, and analyze the changes to the story sections identified in films.